Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.     

Performance evaluation of a sorbent tube sampling method using short path thermal desorption for volatile organic compounds

Air sampling, using sorbents, thermal desorption and gas chromatography, is a versatile method for identifying and quantifying trace levels of volatile organic compounds (VOCs). Thermal desorption can provide high sensitivity, appropropriate choices of sorbents and method parameters can accommodate a wide range of compounds and high humidity, and automated short-path systems can minimize artifacts, losses and carry-over effects. This study evaluates the performance of a short-path thermal desorption method for 77 VOCs using laboratory and field tests and a dual sorbent system (Tenax GR, Carbosieve SIII). Laboratory tests showed that the method requirements for ambient air sampling were easily achieved for most compounds, e.g., using the average and standard deviation across target compounds, blank emissions were < or = 0.3 ng per sorbent tube for all target compounds except benzene, toluene and phenol; the method detection limit was 0.05 +/- 0.08 ppb, reproducibility was 12 +/- 6%, linearity, as the relative standard deviation of relative response factors, was 16 +/- 9%, desorption efficiency was 99 +/- 28%, samples stored for 1-6 weeks had recoveries of 87 +/- 9%, and high humidity samples had recoveries of 102 +/- 12%. Due to sorbent, column and detector characteristics, performance was somewhat poorer for phenol groups, ketones, and nitrogen containing compounds. The laboratory results were confirmed in an analysis of replicate samples collected in two field studies that sampled ambient air along roadways and indoor air in a large office building. Replicates collected under field conditions demonstrated good agreement except for very low concentrations or large (> 41 volume) samples of high humidity air. Overall, the method provides excellent performance and satisfactory throughput for many applications.     

Temporal variation in a coral reef community at Pattaya Bay,Gulf of Thailand

Changes in the fringing coral reef community of a small island (Ko Nok) at Pattaya Bay, Gulf of Thailand, were examined at the beginning and at the end of a 3-year period using 7m×7m permanent quadrats for benthic organisms, and visual census along 100m transects for fish. The coral community was dominated by Porites lutea in terms of colony number and areal cover throughout the period. Variations in the community structure parameters on opposite sides of the island indicated increasing dissimilarity with time. Little variation in live coral cover was noted, but colony number and species diversity declined on both sides. The abundance of edible fish species dropped while that of non-edible species increased over the 3-year period, indicating selective removal of the former category through fishing. Impacts from both human and natural influences are implicated in these changes.     

Organochlorine and mercury residues in Swainson's and ferruginous hawk eggs collected in North and South Dakota, 1974–79

Residues of organochlorine pesticides, polychlorinated biphenyls (PCBs), and mercury were measured in eggs of Swainson's hawks (Buteo swainsoni) and ferruginous hawks (B. regalis) collected in North and South Dakota during 1974–79. DDE was the most common compound detected in the eggs, but residues were below levels known to have adverse effects on reproduction. Other organochlorine compounds and mercury were found at low levels. Eggs of ferruginous hawks tended to contain more compounds with higher residues than eggs of Swainson's hawks.     

An evaluation of in situ microcosms for validating aquatic fate and transport models

The fates of two compounds, 2,4 Dichlorophenoxy Acetic Acid Butoxyethyl Ester (2,4-DBEE) and 1,4 Dichlorobenzene (1,4-DCB), were examined in in situ microcosms placed in a pond and compared with the fates in the pond itself. Results also were compared with predictions of an aquatic fate and transport model (EXAMS). Decay rates of 2,4-DBEE were not significantly different among the microcosms, pond and model predictions. The decay rate of 1,4-DCB in the microcosms was significantly lower than the rate for the pond, and lower than the rate predicted by the model. The low volatility of 1,4-DCB in the microcosms is attributed primarily to lack of water surface turbulence in the microcosms.     

Second derivative spectroscopy for the determination of volatilized ammonia from urea-amended soil

A second derivative spectrometer custom fitted with a 1 m stainless steel White cell and maintained at 105°C is used to make real-time measurements of volatilized NH₃ from urea-amended soil. Comparison of the technique to impinger data shows a 5–16% discrepancy between the two techniques; however, other experiments presented suggests that this is not real. Sulfur dioxide and nitrous oxide interferences are discussed, though they were not found to be present in this study. Instrument response time is shown to be fast if 67% of the total response is achieved in less than 5 min. Fast response is achieved for ammonia if wall-adsorption effects are minimal and if ammonia mass flow is maintained at 0.2 μg min^-1.     

Transportation and fate of cationic surfactant in river water

The degradation, sorption, transportation and material balance of cationic surfactants discharged from domestic waste into river water was studied. Ion-pair solid-phase extraction behavior showed that the sorption of cationic surfactants as an ion-pair with anionic surfactant onto river sediment was so strong that little cationic surfactant was found in the bulk water. Cationic surfactant was found in river sediment at more than 500 times higher concentration than that in the bulk water. The degradation of the cationic surfactant was very slow in river water and much slower in the sediment. A material balance of cationic surfactant was estimated for a river running through Toyama City by measuring the flow rate and the concentration of cationic surfactant in the water at several points. It was found that more than 30% of cationic surfactant introduced to the river was lost during the river running through ca. 3 km in 3 h. This reduction probably comes from a quick transfer of the cationic surfactant from river water to sediment and water weed by means of adsorption or precipitation with suspending solids.     

A new device for measuring fluctuations in plant stem diameter: Implications for monitoring plant responses

An electrical device capable of continuously measuring micronsized changes in stem diameter of woody and herbaceous plants is described. Fumigation of sunflowers with automotive exhaust was used to test the ability of the device to detect short-term plant responses.     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Emissions of gaseous and particulate pollutants in a port and harbour region in India

Ports can generate large quantity of pollutants in the atmosphere due to various activities like loading and unloading,transportation, and construction operations. Determination of the character and quantity of emissions from individual sources is an essential step in any project to control and minimize the emissions.In this study a detailed emission inventory of total suspendedparticulate matter (TSP), particulate matter less than 10 m(PM₁₀), sulfur dioxide (SO₂) and nitrogen oxides (NO_x) for a port and harbour project near Mumbai is compiled. Results show that the total annual average contributions of TSP and PM₁₀ from all the port activitieswere 872 and 221 t yr^-1, respectively. Annual average emissions of gaseous pollutants SO₂ and NO_xwere 56 and 397 t yr^-1, respectively, calculatedby using emission factors for different port activities. The maximum TSP emission (419 t yr ^-1) was from paved roads, while the least (0.4 t yr^-1) was from bulk handling activity. The maximum PM₁₀ emission (123 t yr^-1) was from unpaved roads and minimum (0.2 t yr^-1) from bulk handling operations. Similarly the ratio of TSP and PM₁₀ emission was highest (5.18) from paved roads and least (2.17) from bulk handling operations. Regression relation was derivedfrom existing emission data of TSP and PM₁₀ from variousport activities. Good correlation was observed between TSP andPM₁₀ having regression coefficient >0.8.