Comparative study of extraction methods for the determination of PAHs from contaminated soils and sediments

The following four methods were compared on the extraction efficiency of 16 EPA (US Environmental Protection Agency) polycyclic aromatic hydrocarbons (PAHs): German method of the Verband Deutscher Landwirtschaftlicher Untersuchungs und Forschungsanstalten (VDLUFA), two methods of the International Organization for Standardization using shaking (ISO A) and Soxhlet extraction (ISO B) and an ultrasonic method. Recovery rates of 16 PAHs were determined in two soils. Extraction efficiency was evaluated in five soils and three sediments. Effect of drying soils and sediments on extraction efficiency was tested using the VDLUFA and the ultrasonic methods. Our study shows that the number of aromatic rings, rather than extraction procedures, significantly influenced recovery rates of individual PAHs. No significant differences in extraction efficiency of the four methods were observed for less polluted samples. For highly polluted soils, extraction efficiency decreased in the following order: VDLUFA method > ISO A > ultrasonic method > ISO B. Influence of soil moisture on extraction efficiency depended to some extent on both solvent used and content of PAHs in samples. A mixture of dichloromethane/acetone (5:1) is recommended for PAH extraction from moist samples when the ultrasonic method is used.     

Redox-active ligands in artificial photosynthesis: a review

Environmental Chemistry Letters - Given the rising socioeconomic issues of fossil fuels, efficient artificial photosynthesis would be an important milestone toward a sustainable world. A key step...     

Biodegradation of phthalate esters by two bacteria strains

In this study two aerobic phthalic acid ester (PAE) degrading bacteria strains, DK4 and O18, were isolated from river sediment and petrochemical sludge, respectively. The two strains were found to rapidly degrade PAE with shorter alkyl-chains such diethyl phthalate (DEP), dipropyl phthalate (DPrP), di-n-butyl phthalate (DBP), benzylbutyl phthalate (BBP) and diphenyl phthalate (DPP) are very easily biodegraded, while PAE with longer alkyl-chains such as dicyclohexyl phthalate (DCP) and dihexyl phthalate (DHP) and di-(2-ethylhexyl) phthalate (DEHP) are poorly degraded. The degradation rates of the eight PAEs were higher for strain DK4 than for strain O18. In the simultaneous presence of strains DK4 and O18, the degradation rates of the eight PAEs examined were enhanced. When the eight PAEs were present simultaneously, degradation rates were also enhanced. We also found that PAE degradation was delayed by the addition of nonylphenol or selected polycyclic aromatic hydrocarbons (PAHs) at a concentration of 1 microg/g in the sediment. The bacteria strains isolated, DK4 and O18, were identified as Sphigomonas sp. and Corynebacterium sp., respectively.     

Isotopic characterisation of lead in contaminated soils from the vicinity of a non-ferrous metal smelter near Plovdiv, Bulgaria

Soil samples from the vicinity of a non-ferrous metal smelter near Plovdiv, Bulgaria contained very high concentrations of cadmium, lead and zinc (up to 140, 4900 and 5900 mg kg(-1), respectively). A roadside soil in a relatively uncontaminated area also contained high concentrations of the same metals (24, 1550 and 1870 mg kg(-1), respectively) indicating that the transport of ores could be a source of contamination. Even though the lead isotope ratios in all the samples fell within a very narrow range (for example, 1.186-1.195 for (206)Pb/(207)Pb), the samples could be differentiated into three distinct groups: ores ((206)Pb/(207)Pb and (208)Pb/(207)Pb ratios of 1.1874-1.1884 and 2.4755-2.4807, respectively), current deposition (1.1864 and 2.4704-2.4711, respectively) and local background (1.1927-1.1951 and 2.4772-2.4809, respectively). Although most of the current deposition has its origin in the ores used at the smelter, up to 12% could be from other sources such as petrol lead.     

Toxicity of acid-sulphate soil leachate and aluminium to the embryos and larvae of Australian bass (Macquaria novemaculeata) in estuarine water

The toxicity of leachate water from acid-sulphate soil to the early life stages of Australian bass, Macquaria novemaculeata, incubated in seawater was evaluated. Acid-sulphate soil leachate water (pH> or =6.8) delayed the hatching of fertilised eggs, but after 48 h the per cent hatching was normal. In comparison, acidic saline water (25 per thousand salinity) at pH 4.0 or less prevented embryos from hatching. The survival of yolk-sac larvae exposed to acid-sulphate soil leachate water at a concentration of 32% in seawater and an initial pH of 7.2, was significantly different to controls after 96 hours. In corresponding tests with only acidified saline water (20 per thousand salinity), pH levels equal to or below 5.0 killed yolk-sac larvae after 96 h exposure. Aluminum showed a pH dependent toxicity to yolk-sac larvae, with added aluminium as low as 200 microg litre(-1) having a significant effect on larval survival at pH 5.5, and concentrations of 600-800 microg litre(-1) having a significant effect on larval survival at an initial pH range of 6.0 < pH < 6.8. It was concluded that significant mortality of the early life stages of Australian bass would occur if they are exposed to acid-sulphate soil leachate that results in a pH in the receiving estuarine water below 5.5, or when the pH is below 6.8 and aluminium is present at a total concentration of 800 microg litre(-1) or greater.     

On-road motor vehicle emissions and fuel consumption in urban driving conditions

This paper reports on the analysis of on-road vehicle speed, emission, and fuel consumption data collected by four instrumented vehicles. Time-, distance-, and fuel-based average fuel consumption, as well as CO, HC, NOx, and soot emission factors, were derived. The influences of instantaneous vehicle speed on emissions and fuel consumption were studied. It was found that the fuel-based emission factors varied much less than the time- and distance-based emission factors as instantaneous speed changed. The trends are similar to the results obtained from laboratory tests. The low driving speed contributed to a significant portion of the total emissions over a trip. Furthermore, the on-road data were analyzed using the modal approach. The four standard driving modes are acceleration, cruising, deceleration, and idling. It was found that the transient driving modes (i.e., acceleration and deceleration) were more polluting than the steady-speed driving modes (i.e., cruising and idling) in terms of g/km and g/sec. These results indicated that the on-road emission measurement is feasible in deriving vehicle emissions and fuel consumption factors in urban driving conditions.     

Nitrogen balance and groundwater nitrate contamination: comparison among three intensive cropping systems on the North China Plain

The annual nitrogen (N) budget and groundwater nitrate-N concentrations were studied in the field in three major intensive cropping systems in Shandong province, north China. In the greenhouse vegetable systems the annual N inputs from fertilizers, manures and irrigation water were 1358, 1881 and 402 kg N ha(-1) on average, representing 2.5, 37.5 and 83.8 times the corresponding values in wheat (Triticum aestivum L.)-maize (Zea mays L.) rotations and 2.1, 10.4 and 68.2 times the values in apple (Malus pumila Mill.) orchards. The N surplus values were 349, 3327 and 746 kg N ha(-1), with residual soil nitrate-N after harvest amounting to 221-275, 1173 and 613 kg N ha(-1) in the top 90 cm of the soil profile and 213-242, 1032 and 976 kg N ha(-1) at 90-180 cm depth in wheat-maize, greenhouse vegetable and orchard systems, respectively. Nitrate leaching was evident in all three cropping systems and the groundwater in shallow wells (<15 m depth) was heavily contaminated in the greenhouse vegetable production area, where total N inputs were much higher than crop requirements and the excessive fertilizer N inputs were only about 40% of total N inputs.     

Degradation of ethinyl estradiol by nitrifying activated sludge

Degradation of ethinyl estradiol (EE2) by nitrifying activated sludge was studied with micro-organisms grown in a reactor with feedback of sludge fed with only a mineral salts medium containing ammonium as the sole energy source. Ammonium was oxidised by this sludge at a rate of 50 mg NH4+ g(-1) DW h(-1). This activated sludge was also capable of degrading EE2 at a maximum rate of 1 microg g(-1) DW h(-1). Using sludge with an insignificant nitrifying capacity of 1 mg NH4+ g(-1) DW h(-1), no degradation of EE2 was detected. Oxidation of EE2 by nitrifying sludge resulted in the formation of hydrophilic compounds, which were not further identified. Most probably degradation by nitrifying sludge results in a loss of estrogenic activity, as hydroxylated derivatives of EE2 are known to have a substantially lower pharmacological activity than EE2.     

Evaluation of ecological disturbance and intrinsic bioremediation potential of pulp mill-contaminated lake sediment using key enzymes as probes

A rapid protocol was developed to measure 10 different enzymic activities from a large number of 1-cm-sliced freshly collected lake sediments. Layers heavily polluted by organic halogens (4900 mg Cl kg(-1)) revealed severe depression of phosphatase, sulfatase, leucine-aminopeptidase, chitinase, acetate esterase and butyrate esterase activities as compared to layers above and below the most polluted zone. alpha-Glucosidase, beta-glucosidase, beta-xylosidase and palmitate esterase were less affected. Methane oxidation potential was dramatically depressed in the polluted strata whereas tetrachloromethane dehalogenating activity was observed in the polluted sediment only. The sediment layers formed after the chlorine discharges into the lake had diminished to 1/10, and showed restoration of the activities close to those observed in non-recipient sediment, in spite of the persisting presence of >1000 mg of organic chlorine (kg dry wt)(-1). We conclude that certain enzymic activities involved in breakdown or oxidation of organic matter in the sediments are useful probes for assessing the degree of ecological damage and its potential for restoration in recipient lakes of industrial discharges.