附加电场对中空纤维膜污染的减缓作用

通过对新型附加电场的中空纤维膜组件的实验室研究,探讨了电场对缓解微滤膜污染的作用.在恒定流量下过滤含有20mg/L腐殖酸的原水,无电压时,跨膜压力从0.0200MPa上升到0.0300MPa耗时2h,而施加60V电压时该时间段延长至10h.研究表明,原水中的腐殖酸在电场中发生电泳迁移,减少了向膜表面的移动,其对膜的污染被减缓;同时腐殖酸在电场中发生凝聚现象,沉积在膜表面形成疏松的滤饼层,是跨膜压力增加缓慢的另一原因.     

Investigation of PM2.5 pollution during COVID-19 pandemic in Guangzhou, China

The COVID-19 pandemic has raised awareness about various environmental issues,including PM_2.5 pollution.Here,PM_2.5 pollution during the COVID-19 lockdown was traced and analyzed to clarify the sources and factors influencing PM_2.5 in Guangzhou,with an emphasis on heavy pollution.The lockdown led to large reductions in industrial and traffic emissions,which significantly reduced PM_2.5 concentrations in Guangzhou.Interestingly,the trend of PM_2.5     

大型水生植物混合腐解对入湖河口水质的影响及适宜生物量研究

为探究水生植物腐解释放的营养盐在泥-水-植物系统中迁移规律以及冬春季衰亡期大型水生植物的最适生物量,在塑料通风大棚内,开展不同梯度生物量下多种水生植物混合腐解试验.选择冬季蠡湖-陆典桥浜河口区的水生植物为研究对象,根据实际收割规律,设定腐解试验的生物量依次为除根部以外总生物量的0%、20%、40%、60%、80%、100%,于2018年12月25日开展试验,共150 d.结果表明:①与恒温室内条件相比,近自然条件下多种混合水生植物腐解的前2个阶段具有长时性和持续性.②水生植物腐解致使含C、N、P元素的指标在0~30 d内快速升高,70 d左右达到峰值,100 d后缓慢降低直至稳定,整个变化过程持续近120 d,但植物茎叶未彻底分解,多数沉积在底泥表面.③泥-水-植物系统中,试验初期底泥以释放营养盐为主,30 d后以吸附为主;相关性分析表明,茎叶生物量与水体和底泥中养分浓度均呈正相关.研究显示,与其他试验组相比,收割后水生植物生物量剩余20%时更有利于入湖河口水质的改善.      

Modeling the e ects of constructed wetland on nonpoint source pollution control and reservoir water quality improvement

This article describes the integrated modeling approach for planning the size and the operation of constructed wetlands for maximizing retention of nonpoint source pollutant loads and reservoir water-quality improvement at a catchment scale. The experimental field-scale wetland systems (four sets, 0.88 ha each) have been in operation since 2002, where water depth was maintained at 30–50 cm and hydraulic loading rate was at 6.3–18.8 cm/day. The wetland system was found to be adequate for treating polluted stream water with stable removal e ciency even during the winter. The integrated modeling system (modified-BASINS) was applied to the Seokmoon estuarine reservoir watershed and calibrated with monitoring data from constructed wetland, stream, and reservoir. The calibrated integrated modeling system estimated that constructing wetlands on 0.5% (about 114 ha) of the watershed area at the mouth of reservoir could reduce 11.61% and 13.49% of total external nitrogen and phosphorus loads, respectively. It also might improve the nitrogen and phosphorus concentration of the reservoir by 9.69% and 16.48%, respectively. The study suggested that about 0.1%–1.0% of the watershed area should be allocated for constructed wetland to meet specified water-quality standards for the estuarine reservoir at the polder area where land use planning is relatively less complicated.     

柴油/CNG公交车排放颗粒物粒径分布特征隧道实测研究

对澳洲某公路隧道中段和名义入口段进行连续4d的超细颗粒物实测,通过数据分析发现隧道内柴油公交车和CNG公交车混合排放的颗粒物日平均粒径呈双峰模态分布.采用多元回归法分别计算柴油公交车和CNG公交车颗粒物数浓度粒径谱排放因子,发现柴油车/CNG颗粒物排放分别呈积聚态单峰分布和核模态单峰分布.对隧道内机动车颗粒物排放每30min平均粒径分布进行核模态和积聚模态的对数正态分布曲线拟合分解,90组粒径分布叠加拟合曲线与实测结果的拟合度为0.972～0.998.采用髭须图对柴油车和CNG车颗粒物排放特征做统计分析发现,柴油公交车颗粒物排放呈积聚模态下的对数正态分布,其峰值粒径74.5～86.5nm,该对数正态分布的几何标准差1.88～2.05.CNG公交车呈核模态的对数正态分布,峰值粒径19.9～22.9nm,几何标准差为1.27～1.3.     

城郊小河流沉积物吸附Pb2+的动力学过程

采用分批试验法,对城郊小河流沉积物吸附Pb2+过程进行了研究,探讨了Pb2+吸附的动力学过程和机制.结果表明,随着溶液中沉积物质量增大,达到吸附平衡所需时间变短,单位沉积物吸附量和达到吸附平衡后溶液中Pb²⁺浓度变低;沉积物含量>0.6 g·L^-1时对溶液中Pb²⁺的去除率超过95%;Pb²⁺在沉积物上吸附的动力学过程符合假二级动力学模型,该模型拟合的平衡吸附量也更接近真实值;Pb²⁺初始吸附速率与初始溶液中沉积物质量无明显的相关性;随溶液中沉积物浓度的增加,吸附速率常数逐渐增大,化学吸附所起的作用也越显著;较高浓度沉积物吸附Pb²⁺的动力学机制能较好符合Elovich方程,但较低浓度沉积物时则相对较差;从吸附速率来看,溶液中沉积物质量较高时,内扩散是整个吸附过程速率的控制步骤,沉积物含量较低时,吸附速率存在多级线性过程,初始阶段非均相扩散是主要控制步骤,但随着时间的延长,其吸附过程转变为沉积物内部的扩散过程.     

信息量模型在地质灾害调查与区划中的应用研究

以浙江省仙居县地质灾害调查与区划项目为例,在分析当地实际地质情况的基础上结合信息论原理,对仙居县进行了基于多因素分析的地质灾害预测区划。经分析计算．得出的区划结果基本符合仙居县的实际情况。故用信息量模型进行地质灾害区划是可行的。     

分子印迹硅纳米改性氧化石墨烯复合材料的制备及其对双酚A的吸附研究

制备了分子印迹硅纳米-氧化石墨烯复合吸附材料,并研究了复合材料对双酚A(Bisphenol A,BPA)的吸附性能.实验结果表明:复合吸附材料对BPA的吸附在35min内达到吸附平衡,Langmuir等温线模型得出最大吸附容量约为338.3mg/g;相对于BPA的结构类似物,对BPA具有良好的选择吸附性能;在溶液pH接...     

如何实施工业企业厂界噪声的规范性监测

"工业企业厂界噪声"监测目的、测量条件、时段选择,规范的监测程序及注意的问题,完整的监测报告。     

Factors affecting the implementation of green specifications in construction

Green specifications constitute one of the important elements in green construction. New sustainability requirements and changing priorities in construction management have spurred the emerging green specifications to a faster pace of development. A cross-sectional survey has been conducted in Hong Kong in 2007 to identify principal factors leading to the success of preparing green specifications. Based on extensive construction management literature, 20 variables concerning sustainable construction were summarized. Using the Mann–Whitney U-test, the subtle differences between stakeholders in specifying construction work have been detected even with the high consistency of the responses among the groups. Moreover, five independent factors for successful specification of green construction have been categorized by factor analysis. They are related to (1) green technology and techniques, (2) reliability and quality of specification, (3) leadership and responsibility, (4) stakeholder involvement, and (5) guide and benchmarking systems. Whilst the first and fourth factors are generally more important, different stakeholder groups have different emphases. The results of the survey have been validated against established principles.