光/电Fenton牺牲阳极法降解有机污染物

采用Fe片为阳极和石墨为阴极,在可见光(λ450 nm)照射并外加电压条件下,以有机染料橙Ⅱ(orangeⅡ)及有机无色小分子2,4-二氯苯酚(2,4-dichlorophenol,DCP)为目标化合物,探讨了光/电Fenton牺牲阳极法降解有机污染物的最佳反应条件,结果表明,在电压=3 V,pH=3.0,H2O2浓度为5×10-5mol/L时,orangeⅡ的降解效果最好,反应10 h矿化率可达到78%,210 min内2,4-DCP降解率为91.4%。通过对光/电Fenton体系原位循环伏安参数测定及过氧化物酶催化反应吸光光度法和苯甲酸荧光分析法检测光/电Fenton降解orange II过程中H2O2和羟基自由基(.OH)的变化,表明orangeⅡ降解过程涉及.OH历程。     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

昆明市污水排水系统产甲烷规律的模拟实验研究

通过对昆明市餐饮和居民生活污水厌氧模拟实验研究,初步探讨生活污水中CH4的产生规律,实验结果表明,在自然条件下,餐饮和居民生活污水中产生的甲烷浓度最大值分别为1.63 mg/L和3.82 mg/L。并且将COD、硫酸盐、硫化物、TN的浓度变化与甲烷浓度变化进行Pearson简单相关性分析,结果表明,1/COD、COD/硫酸盐和1/TN与甲烷在置信度为0.01时极显著相关,硫化物与甲烷在置信度为0.05时不相关;COD、硫酸盐和TN浓度的变化对生活污水中甲烷的产生起关键性作用。对居民生活污水中甲烷产生规律进行温度和pH控制分析研究,实验结果表明,生活污水在25~30℃时,24 h内甲烷产生量最大值为8.6494 mg/L,明显大于其他温度段的甲烷产生量;在pH为7~8之间时,甲烷的产生量在24 h内达到的最大值为3.0477 mg/L,明显高于其他pH控制段的甲烷产生量。     

Effects of compositional heterogeneity and nanoporosity of raw and treated biomass-generated soot on adsorption and absorption of organic contaminants

A biomass-generated soot was sequentially treated by HCl-HF solution, organic solvent, and oxidative acid to remove ash, extractable native organic matter (EOM), and amorphous carbon. The compositional heterogeneity and nano-structure of the untreated and treated soot samples were characterized by elemental analysis, thermal gravimetric analysis, BET-N₂ surface area, and electron microscopic analysis. Sorption properties of polar and nonpolar organic pollutants onto the soot samples were compared, and individual contributions of adsorption and absorption were quantified. The sorption isotherms for raw sample were practically linear, while were nonlinear for the pretreated-soot. The removal of EOM enhanced adsorption and reduced absorption, indicating that EOM served as a partitioning phase and simultaneously masked the adsorptive sites. By drastic-oxidation, the outer amorphous carbon and the inner disordered core of the soot particles were completely removed, and a fullerene-like nanoporous structure (aromatic shell) was created, which promoted additional π-π interaction between phenanthrene and the soot.     

Determination of 27 pharmaceuticals and personal care products (PPCPs) in water: The benefit of isotope dilution

• Isotope dilution method was developed for the determination of 27 PPCPs in water. • The established method was successfully applied to different types of water samples. • The correction effect of corresponding 27 ILSs over 70 d was investigated. • Benefit of isotopic dilution method was illustrated for three examples. Pharmaceuticals and personal care products (PPCPs) are a unique group of emerging and non-persistent contaminants. In this study, 27 PPCPs in various water samples were extracted by solid phase extraction (SPE), and determined by isotope dilution method using liquid chromatography coupled to tandem triple quadruple mass spectrometer (LC-MS/MS). A total of 27 isotopically labeled standards (ILSs) were applied to correct the concentration of PPCPs in spiked ultrapure water, drinking water, river, effluent and influent sewage. The corrected recoveries were 73%–122% with the relative standard deviation (RSD)<16%, except for acetaminophen. The matrix effect for all kinds of water samples was<22% and the method quantitation limits (MQLs) were 0.45–8.6 ng/L. The developed method was successfully applied on environmental water samples. The SPE extracts of spiked ultrapure water, drinking water, river and wastewater effluent were stored for 70 days, and the ILSs-corrected recoveries of 27 PPCPs were obtained to evaluate the correction ability of ILSs in the presence of variety interferences. The recoveries of 27 PPCPs over 70 days were within the scope of 72%–140% with the recovery variation<37% in all cases. The isotope dilution method seems to be of benefit when the extract has to be stored for long time before the instrument analysis.     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

微污染水源水净化新技术

介绍了近年来出现的纳滤膜,预臭氧化及新型生物反应器（膜生物反应器和电生物反应器）处理微污染水源水的最新技术动态。对相关机理进行了归纳总结。