Sensitivity of two dispersion models (AERMOD and ISCST3) to input parameters for a rural ground-level area source

As of December 2006, the American Meteorological Society/U.S. Environmental Protection Agency (EPA) Regulatory Model with Plume Rise Model Enhancements (AERMOD-PRIME; hereafter AERMOD) replaced the Industrial Source Complex Short Term Version 3 (ISCST3) as the EPA-preferred regulatory model. The change from ISCST3 to AERMOD will affect Prevention of Significant Deterioration (PSD) increment consumption as well as permit compliance in states where regulatory agencies limit property line concentrations using modeling analysis. Because of differences in model formulation and the treatment of terrain features, one cannot predict a priori whether ISCST3 or AERMOD will predict higher or lower pollutant concentrations downwind of a source. The objectives of this paper were to determine the sensitivity of AERMOD to various inputs and compare the highest downwind concentrations from a ground-level area source (GLAS) predicted by AERMOD to those predicted by ISCST3. Concentrations predicted using ISCST3 were sensitive to changes in wind speed, temperature, solar radiation (as it affects stability class), and mixing heights below 160 m. Surface roughness also affected downwind concentrations predicted by ISCST3. AERMOD was sensitive to changes in albedo, surface roughness, wind speed, temperature, and cloud cover. Bowen ratio did not affect the results from AERMOD. These results demonstrate AERMOD's sensitivity to small changes in wind speed and surface roughness. When AERMOD is used to determine property line concentrations, small changes in these variables may affect the distance within which concentration limits are exceeded by several hundred meters.     

Anaerobic degradation of nonylphenol in soil

This study investigated the effects of various factors on the anaerobic degradation of nonylphenol (NP) in soil. The results show that the optimal pH for NP degradation was 7.0 and that the degradation rate was enhanced when the temperature was increased. The addition of compost enhanced NP degradation. The individual addition of the electron donors lactate, acetate, and pyruvate inhibited NP degradation. The high-to-low order of NP degradation rates under three anaerobic conditions was sulfate-reducing conditions > methanogenic conditions > nitrate-reducing conditions. The results show that sulfate-reducing bacteria, methanogen, and eubacteria are involved in the anaerobic degradation of NP, with sulfate-reducing bacteria being a major component of the soil. Of the anaerobic strains isolated from the soil samples, strain AT3 expressed the best ability to biodegrade NP.     

Phosphorus Load Reduction Goals for Feitsui Reservoir Watershed, Taiwan

The present paper describes an effort for developing the total maximum daily load (TMDL) for phosphorus and a load reduction strategy for the Feitsui Reservoir in Northern Taiwan. BASINS model was employed to estimate watershed pollutant loads from nonpoint sources (NPS) in the Feitsui Reservoir watershed. The BASINS model was calibrated using field data collected during a 2-year sampling period and then used to compute watershed pollutant loadings into the Feitsui Reservoir. The simulated results indicate that the average annual total phosphorus (TP) loading into the reservoir is 18,910 kg/year, which consists of non-point source loading of 16,003 kg/year, and point source loading of 2,907 kg/year. The Vollenweider mass balance model was used next to determine the degree of eutrophication under current pollutant loading and the load reduction needed to keep the reservoir from being eutrophic. It was estimated that Feitsui Reservoir can becoming of the oligotrophic state if the average annual TP loading is reduced by 37% or more. The results provide the basis on which an integrated control action plan for both point and nonpoint sources of pollution in the watershed can be developed.     

Emerging Tools for Continuous Nutrient Monitoring Networks: Sensors Advancing Science and Water Resources Protection

Sensors and enabling technologies are becoming increasingly important tools for water quality monitoring and associated water resource management decisions. In particular, nutrient sensors are of interest because of the well‐known adverse effects of nutrient enrichment on coastal hypoxia, harmful algal blooms, and impacts to human health. Accurate and timely information on nutrient concentrations and loads is integral to strategies designed to minimize risk to humans and manage the underlying drivers of water quality impairment. Using nitrate sensors as the primary example, we highlight the types of applications in freshwater and coastal environments that are likely to benefit from continuous, real‐time nutrient data. The concurrent emergence of new tools to integrate, manage, and share large datasets is critical to the successful use of nutrient sensors and has made it possible for the field of continuous monitoring to rapidly move forward. We highlight several near‐term opportunities for federal agencies, as well as the broader scientific and management community, that will help accelerate sensor development, build and leverage sites within a national network, and develop open data standards and data management protocols that are key to realizing the benefits of a large‐scale, integrated monitoring network. Investing in these opportunities will provide new information to guide management and policies designed to protect and restore our nation's water resources.     

A storm event-based approach to TMDL development

It is vitally important to define the critical condition for a receiving water body in the total maximum daily load (TMDL) development process. One of the major disadvantages of using a continuous simulation approach is that there is no guarantee that the most critical condition will be covered within the subjectively selected representative hydrologic period, which is usually several years depending on the availability of data. Another limitation of the continuous simulation approach, compared to a design storm approach, is the lack of an estimate of the risk involved. Because of the above limitations, a storm event-based critical flow-storm (CFS) approach was previously developed to explicitly address the critical condition as a combination of a prescribed stream flow and a storm event of certain magnitude, both having a certain frequency of occurrence and when combined, would create a critical condition. The CFS approach was tested successfully in a TMDL study for Muddy Creek in Virginia. The present paper reports results of a comparative study on the applicability of the CFS approach in Taiwan. The Dy-yu creek watershed in northern Taiwan differs significantly from Muddy Creek in terms of climate, hydrology, terrain, and other characteristics. Results show that the critical condition for different watersheds might be also different, and that the CFS approach could clearly define that critical condition and should be considered as an alternative method for TMDL development to a continuous simulation approach.     

N-nitrosodimethylamine and trihalomethane formation and minimisation in Southeast Queensland drinking water

This study assesses the prevalence of disinfection by-product (DBP) precursors in some Southeast Queensland drinking water sources by conducting formation potential experiments for the four regulated trihalomethanes (THMs), and the potent carcinogen, N-nitrosodimethylamine (NDMA). NDMA formation potentials were consistently low (<5-21 ng/L), and total THM (tTHM) formation potentials were consistently below the Australian Drinking Water Guideline (250 μg/L). NDMA concentration of finished drinking waters was also monitored and found to be <5 ng/L in all cases. The effect of coagulation and advanced oxidation on the formation of NDMA and THMs is also reported. UV/H(2)O(2) pre-treatment was effective in producing water with very low THMs concentrations, and UV irradiation was an effective method for NDMA degradation. H(2)O(2) was not required for the observed NDMA degradation to occur. Coagulation using alum, ferric chloride or poly(diallyldimethylammonium chloride) (polyDADMAC) was ineffective in removing DBPs precursors from the source water studied, irrespective of the low dissolved organic carbon (DOC) and dissolved organic nitrogen (DON) attained. Rather, coagulation with polyDADMAC caused an increase in NDMA formation potential upon chloramination, and all coagulants led to an increased tTHM formation potential upon chlorination due to the high bromide concentration of the source water studied.     

Development of a multi-criteria index ranking system for urban runoff best management practices (BMPs) selection

Low impact development best management practices (LID-BMPs) are considered to be cost-effective measures for mitigating the water quantity and quality impact of urban runoff. Currently, there are many types of LID-BMPs, and each type has its own intrinsic technical and/or economical characteristics and limitations for implementation. The selection of the most appropriate BMP type(s) for a specific installation site is therefore a very important planning step. In the present study, a multi-criteria selection index system (MCIS) for LID-BMP planning was developed. The selection indexes include 12 first-level indices and 26 second-level indices which reflect the specific installation site characteristics pertaining to site suitability, runoff control performance, and economics of implementation. A mechanism for ranking the BMPs was devised. First, each individual second-level index was assigned a numeric value that was based on site characteristics and information on LID-BMPs. The quantified indices were normalized and then integrated to obtain the score for each of the first-level index. The final evaluation scores of each LID-BMP were then calculated based on the scores for the first-level indices. Finally, the appropriate BMP types for a specific installation site were determined according to the rank of the final evaluation scores. In order to facilitate the application of the MCIS BMP ranking system, the computational process has been coded into a software program, BMPSELEC. A case study demonstrating the MCIS methodology, using an LID-BMP implementation planning at a college campus in Foshan, Guangdong Province, is presented.     

Pectenotoxins--an issue for public health: a review of their comparative toxicology and metabolism.

Pectenotoxins (PTXs) are a group of toxins associated with diarrhetic shellfish poisoning (DSP) and isolated from DSP toxin-producing dinoflagellate algae. Consumption of shellfish contaminated with PTXs has been associated with incidences of severe diarrhetic illness resulting in hospitalisation. Concern has been raised for public health following the discovery that these toxins are not only hepatotoxic and can cause diarrhetic effects in mammals, but that they are potently cytotoxic to human cancer cell lines and have been found to be tumour promoters in animals. With advances in knowledge and technology, more PTXs are being identified, but little is known of their toxicology and the potential impact these toxins may have on public health in the long term. Without such information, adequate health-risk assessments for the consumption of shellfish contaminated with PTXs cannot be performed. This review gives a brief introduction to diarrhetic shellfish toxins, details the known toxicology and metabolism of PTXs in animals, and discusses known incidences of PTX poisoning in humans.     

Triad case study: Former small arms training range

The U.S. Army Corps of Engineers (US ACE) used the Triad approach to expedite site characterization of contaminated soil at the Former Small Arms Evergreen Infiltration Training Range in Fort Lewis, Washington. The characterization was designed to determine if surface soils contain significant concentrations of metals, with the focus on collecting sufficient data for determining appropriate future actions (i.e., risk analysis or soil remediation). A dynamic sampling and analytical strategy based on rapid field‐based analytical methods was created in order to streamline site activities and save resources while increasing confidence in remediation decisions. Concurrent analysis of soil samples during the demonstration of method applicability (DMA) used both field portable X‐ray fluorescence (FPXRF) and laboratory methodologies to establish a correlation between FPXRF and laboratory data. Immediately following the DMA, contaminated soil from the impact berm was delineated by collecting both FPXRF data and fixed laboratory confirmation samples. The combined data set provided analytical results that allowed for revisions to the conceptual site model for the range and directed additional sample collection activities to more clearly determine the extent and distribution of soil contamination. © 2004 Wiley Periodicals, Inc.