MCM-41分子筛负载铁铈催化降解甲基橙

采用等体积浸渍法制备了负载型有序介孔Fe-Ce/MCM-41催化剂。研究了该催化剂降解甲基橙的适宜工艺条件,并采用XPS,XRD,TEM技术对该催化剂进行了表征。实验结果表明,该催化剂Fenton氧化降解甲基橙的较适宜工艺条件为:溶液pH 5.0、甲基橙溶液初始质量浓度100 mg/L、催化剂加入量2.0 g/L、H_2O_2浓度20 mmol/L,在此适宜条件下反应120 min时,甲基橙去除率接近100%。表征结果显示:Fe-Ce/MCM-41催化剂主要由铁、铈、氧、碳4种元素组成;铁与铈的摩尔比接近3∶1;铁和铈主要以Fe_3O_4和CeO_2的形态存在于催化剂表面。     

城市污水生物处理系统中微生物酶的活性及其分布

通过水解模式底物进行分光光度测定的方法,研究了城市污水生物处理系统中微生物酶的活性.选取亮氨酸氨基肽酶、β-葡萄糖苷酶、碱性磷酸酶和脂酶等胞外酶进行分析,结果发现4种胞外酶的平均活性在31.O～88.5 μmol/(L·h),其中76.9%～94.8%的酶活性分布在活性污泥中,说明绝大部分胞外酶是与细胞相连或固定在细胞外多聚絮体基质里.混合水样和出水水样中的DOC几乎相等,而各胞外酶与DOC不存在任何显著的相关关系.增加NO3-浓度可提高亮氨酸氨基肽酶和β-葡萄糖苷酶的活性,但对碱性磷酸酶和脂酶却有明显的抑制作用.     

水源水中摇蚊幼虫的孳生与生态控制

摇蚊幼虫(红虫)在城市供水系统中的出现,成为困扰水厂正常生产运行的又一水处理难题.首先对其生理特性与环境因子之间的关系进行了论述,然后从生态学角度出发,利用生态群落中的食物链关系,分析了富营养化水体中摇蚊幼虫大量孳生的原因.在此基础上提出了利用合理的生物操纵技术,通过鱼类与水生生物间的"下行效应",以达到恢复生态平衡并控制摇蚊幼虫孳生为目的的生态治理方案.     

数字城市防震减灾

数字城市减灾战略的提出城市发展战略的各种研讨,总是要讨论安全城市概念中重要的灾害安全的涵义。同样,讨论安全战略的场合中,或者在讨论国家安全战略的著作中,也要讨论自然灾害或地震安全,或防灾减灾战略方面的内容。就是在国家长期科     

The dynamic changes of arsenic biotransformation and bioaccumulation in muscle of freshwater food fish crucian carp during chronic dietborne exposure

Dietary uptake is the major way that inorganic arsenic (iAs) enters into benthic fish; however, the metabolic process of dietborne iAs in fish muscle following chronic exposure remains unclear. This was a 40-day study on chronic dietborne iAs [arsenite (AsIII) and arsenate (AsV)] exposure in the benthic freshwater food fish, the crucian carp (Carassius auratus), which determined the temporal profiles of iAs metabolism and toxicokinetics during exposure. We found that an adaptive response occurred in the fish body after iAs dietary exposure, which was associated with decreased As accumulation and increased As transformation into a non-toxic As form (arsenobetaine). The bioavailability of dietary AsIII was lower than that of AsV, probably because AsIII has a lower ability to pass through fish tissues. Dietary AsV exhibited a high potential for transformation into AsIII species, which then accumulated in fish muscle. The largely produced AsIII considered more toxic at the earlier stage of AsV exposure should attract sufficient attention to human exposure assessment. Therefore, the pristine As species and exposure duration had significant effects on As bioaccumulation and biotransformation in fish. The behavior determined for dietborne arsenic in food fish is crucial for not only arsenic ecotoxicology but also food safety.     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

Concentrations and accumulation rates of polychlorinated biphenyls in soil along an urban–rural gradient in Shanghai

Environmental Science and Pollution Research - This study proposed an in situ soil experimental system to quantify concentration and accumulation rates of polychlorinated biphenyl (PCB) congeners...     

碘量法测定水中溶解氧有关问题的探讨及改进

碘量法测定溶解氧时,采用NH3·H2O—KI代替NaOH(KOH)—KI固定溶解氧,用H2SO4—H3PO(41+1)混合酸代替H2SO4溶解沉淀,使沉淀沉降速度加快,分界线明显,沉淀溶解也更完全。同时做样品空白实验,校正了氧化还原性物质产生的干扰,对废水有明显的抗干扰能力。通过对蒸馏水、自来水、池塘水、废水进行溶解氧测定,结果均非常满意。     

Determination of Steroid Estrogens in Wastewater Treatment Plant of A Controceptives Producing Factory

Steroid estrogens such as estrone (E1), 17β-estradiol (E2), estriol (E3), and 17α-ethynylestradiol (EE2) have been suspected to be the main contaminants, which can affect the endocrine system of animals. Many authors have investigated these chemicals in the domestic wastewater treatment plants (WTP). However, wastewater from industries producing steroid contraceptives has not got ample attention. From the environmental point of view, the four steroids are very significant because even very low concentrations (ng/L) can cause reproductive disturbances in human, livestock and wildlife. The main purpose of the present investigation was to develop an analytical method for the determination of the four steroid estrogens present in WTP of a pharmacy factory, mainly producing contraceptive medicine in Beijing, China. Analysis was performed by solid-phase extraction (SPE) system and liquid chromatography combined with tandem mass spectrometry (LC/MS/MS). The average recoveries from effluent samples ranged from 88% to 103% and the precision of the method ranged from 9% to 4%. Based on 0.5-L wastewater samples, the limit of quantification (LOQ) was determined at 0.7 ng/L for E1, 0.8 for E2, 0.9 ng/L for E3, and 0.5 ng/L for EE2 in influent, and 1.0 ng/L for E2 and EE2, and 2.0 ng/L for E1 and E3 in effluent. In the influent samples, average concentrations of 80, 85, 73 and 155 ng/L were determined for E1, E2, E3 and EE2, respectively, showing that they were removed in this WTP to the extent of 79, 73, 85 and 67%, respectively.