嗜酸硫杆菌和黑曲霉对电镀污泥重金属浸出效果

电镀污泥重金属浸出对电镀污泥资源化利用具有重要意义。为了降低处置成本,采用嗜酸硫杆菌与黑曲霉对电镀污泥重金属浸出效果进行了研究。结果表明,采用嗜酸性氧化硫硫杆菌和氧化亚铁硫杆菌混合菌种对含固率为3%的电镀污泥进行为期15 d(培养驯化后)的处理后,污泥中Ni、Cr与Cu的浸出率虽分别高达92.8%、85.0%和96.8%,但耗时久,无法大规模地实际应用。利用黑曲霉对电镀污泥进行为期6 d的处理,Ni、Cr和Cu的浸出率分别达到92.0%、74.4%和55.3%。若采用黑曲霉培养15 d后产生的生物有机酸和同pH的柠檬酸处理电镀污泥4 h后,两者对Ni、Cr和Cu的浸出率分别为:85.0%与94.2%、63.8%与73.7%、57.9%与99.6%。可见,利用黑曲霉发酵菌液浸出电镀污泥中重金属有一定的实际应用价值。     

CuO/γ-Al_2O_3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH（4~5）条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为：pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为：pH〉反应时间〉H2O2用量〉催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

Particulates and Metallic Elements Monitoring at Two Sampling Sites (Harbor,Airport) in Taiwan

This study characterized the dry deposition flux and dry deposition velocity (Vd) of metallic elements attached on particulate matter. Specifically, large particles (>10 μm), coarse particles (10 μm～2.5 μm), and fine particles (<2.5 μm) were studied at the Gong Ming Junior High School (Taichung Airport) and Taichung Harbor sampling sites in central Taiwan. Ambient air samples were collected to determine total suspended particulate matter (TSP), dry deposition plate (DDP), Vd, coarse particulate matter (PM_2.5–10) and fine particulate matter (PM_2.5), and metallic elements concentrations at the Airport and Taichung Harbor sites between June 17, 2013, and November 14, 2013. The results revealed that the average TSP, DDP, Vd, PM_2.5–10, and PM_2.5 particulate at the Airport were 54.55 (μg/m³), 902.25 (μg/m²-min), 17.11 (m/sec), 0.003 (μg/m³), and 0.010 (μg/m³), respectively; while these values at Taichung Harbor were 63.66 (μg/m³), 539.69 (μg/m²-min), 9.94 (m/sec), 0.003 (μg/m³), and 0.014 (μg/m³), respectively. In addition, the results showed that the average Cu and Pb concentrations were higher than Cr, Ni, and Cd for both the airport and harbor sampling sites. Furthermore, Cr, N, Cu, Cd, and Pb had the highest average concentrations versus those reported for other study areas, with one exception: The results obtained in Kacanik, Kosovo, during 2005. The average metallic elements concentrations order was Cu > Pb > Cr > Ni > Cd.     

Certainty and uncertainty in understanding global warming

Global warming has greatly concerned the whole world.Owing to the limitation we currently have,it is still difficult to completely understand the mechanism and physical science of climate change.Now both certainty and uncertainty coexist in the understanding of climate warming.This paper aims to summarize certainties and uncertainties in climate-warming studies,which focus on seven key problems related to human activities,namely,global warming,atmospheric concentrations of greenhouse gases,relationship between greenhouse gas emissions and climate warming,climate models,future climate change,2?warming threshold and tipping point in the Earth's system.We should comprehensively take into account the level of certainty and uncertainty in our understanding of climate change while adapting to and mitigating global warming and adjusting our industrial structures accordingly.This would allow us to respond to change with certainty,while avoiding the risks associated with uncertainty.     

运用分子轨道理论考察甲酚的生物降解特性

运用分子轨道理论考察了甲酚同分异构体的生物降解特性。计算出最高占据轨道（HOMO）能量的大小,反映了甲酚同分异构体生物降解反应的难易程度,且结论与事实相符合。     

固定化生物活性炭处理低浓度甲醇废水

将分离筛选得到的甲醇降解菌固定在颗粒活性炭上,组成固定化生物活性炭反应系统,研究该反应系统处理轻度污染含甲醇废水的最佳运行条件和运行效果,结果表明,固定化生物活性炭处理轻度污染含甲醇放心水的方法明显好于3种树脂和单纯活性炭吸附处理,反应系统的最佳运行条件是水力负荷0．84－0．77m^3(m^2.h）,停留时间57－62min,pH7－8,温度20℃－30℃,溶解氧是去除甲醇的主要限制因子,甲醇含量为11．3－23．1mg／L时,去除率大90％,出水CODcr小于12mg／L。此外还研究了生物活性炭生物膜的一些特点,并分析了运行中活性炭吸附性能的变化。     

区域易损性分析、评估及易损度区划：—以重庆市为例

根据重庆市建国50年来的灾害统计资料,选取灾害密度、灾害频数、经济（GDP）损失模数、生命易损模数等易损性评价指标,在详尽分析了重庆市各区县市易性的基础上,对重庆市各区县市的脆弱性和易损强度进行了综合评估,并且计算出了各区县市的易损度,结合GIS方法对重庆进行了易损度区划。并借此提出域易损性分析、评估的模式、为区域防灾、减灾规划提供科学依据。     

Atmosphic pollutants study of particles ionic species during high wind speed (>7 m s-1) near Taiwan strait in central Taiwan from 2004 to 2005

This study monitored atmospheric pollutants during high wind speed (> 7 m s⁻¹) at two sampling sites: Taichung Harbor (TH) and Wuci traffic (WT) during March 2004 to January 2005 in central Taiwan. The correlation coefficient (R ²) between TSP, PM_2.5, PM_2.5−10 particle concentration vs. wind speed at the TH and WT sampling site during high wind speed (< 7 m s⁻¹) were also displayed in this study. In addition, the correlation coefficients between TSP, PM_2.5 and PM_2.5−10 of ionic species vs. high wind speed were also observed. The results indicated that the correlation coefficient order was TSP > PM_2.5−10 > PM_2.5 for particle at both sampling sites near Taiwan strait. In addition, the concentration of Cl⁻, NO₃ ⁻, SO₄ ²⁻, NH₄ ⁺, Mg²⁺, Ca²⁺ and Na⁺ were also analyzed in this study.     

Influence of Meteorological Parameters on Particulates and Atmospheric Pollutants at Taichung Harbor Sampling Site

Atmospheric aerosol particles and metallic concentrations, ionic species were monitored at the Experimental harbor of Taichung sampling site in this study. This work attempted to characterize metallic elements and ionic species associated with meteorological conditions variation on atmospheric particulate matter in TSP, PM_2.5, PM_2.5–10. The concentration distribution trend between TSP, PM_2.5, PM_2.5–10 particle concentration at the TH (Taichung harbor) sampling site were also displayed in this study. Besides, the meteorological conditions variation of metallic elements (Fe, Mg, Cr, Cu, Zn, Mn and Pb) and ions species (Cl⁻, NO₃ ⁻, SO₄ ²⁻, NH₄ ⁺, Mg²⁺, Ca²⁺ and Na⁺) concentrations attached with those particulate were also analyzed in this study. On non-parametric (Spearman) correlation analysis, the results indicated that the meteorological conditions have high correlation at largest particulate concentrations for TSP at TH sampling site in this study. In addition, the temperature and relative humidity of meteorological conditions that played a key role to affect particulate matter (PM) and have higher correlations then other meteorological conditions such as wind speed and atmospheric pressure. The parameter temperature and relative humidity also have high correlations with atmospheric pollutants compared with those of the other meteorological variables (wind speed, atmospheric pressure and prevalent wind direction). In addition, relative statistical equations between pollutants and meteorological variables were also characterized in this study.     

Is an adjusted rhizosphere-based method valid for field assessment of metal phytoavailability? Application to non-contaminated soils

Previously recommended rhizosphere-based method (RHIZO) applied to moist rhizosphere soils was integrated with moist bulk soils, and termed adjusted-RHIZO method (A-RHIZO). The A-RHIZO and RHIZO methods were systematically compared with EDTA, DTPA, CaCl2 and the first step of the Community Bureau of Reference (BCR1) methods for assessing metal phytoavailability under field conditions. Results suggested that moist bulk soils are equally suited or even better than rhizosphere soils to estimate metal phytoavailability. The A-RHIZO method was preferred to other methods for predicting the phytoavailability of Ni, Cu, Zn, Cd, Pb and Mn to wheat roots with correlation coefficients of 0.730 (P<0.001), 0.854 (P<0.001), 0.887 (P<0.001), 0.739 (P<0.001), 0.725 (P<0.001) and 0.469 (P<0.05), respectively. When including soil properties, other extraction methods were also able to predict phytoavailability reasonably well for some metals. Soil pH, organic matter and Fe-Mn oxide contents, and cation-exchange capacity mostly influenced the extraction and phytoavailability of metals.