Community Odours in the Vicinity of a Petrochemical Industrial Complex

Community odours in the vicinity of an oil refinery and petrochemical industrial area were studied by an observer network throughout an entire year. Odour episodes occurred during 0.86 percent of the time of the study. Odour reports increased closer to the refinery. Within a range of 12.5 km, more than 50 percent of the odours were estimated to originate from the refinery. The most typical odour was that of reduced sulphur compounds (35.2 percent of all observations). Odour episodes occurred during low wind velocities and high humidity. Odours were most frequent during January-April, and were usually reported early in the morning. The odours were evidently due to the general operation of the plants, as no single activity or in-plant factor could be identified as the source of the odours.     

Macrofaunal recolonisation following the intertidal placement of fine-grained dredged material

Dredged material is increasingly being regarded as a potential resource, and one of its many uses is to create and/or improve intertidal habitats (i.e. beneficial use). However, uncertainties over the longer-term environmental consequences of such schemes have, to date, limited the practice to small-scale applications in UK waters. This paper studies the macrofaunal recolonisation of fine-grained dredged material recharged concurrently at four adjacent recharge areas along the south-east coast of the UK in order to facilitate predictions regarding the recolonisation of comparable schemes and, thereby, to promote effective environmental management. During the 2-year study period, the four recharge areas were distinctly different in terms of their environmental characteristics, primarily wave exposure and bed level. These conditions resulted in different macrofaunal recolonisation rates and community structures. While the low-level, wave-sheltered area experienced rapid recolonisation, the process was delayed until 12 months post-recharge at the relatively wave-exposed areas. Bed level differences resulted in distinctly different communities in wave-sheltered areas but not under wave-exposed conditions. While we are unable to separate the effects of individual environmental variables on recolonisation, these results provide general conclusions as to the importance of environmental conditions on resulting macrofaunal communities.     

Multi tracer test for the implementation of enhanced in-situ bioremediation at a BTEX-contaminated megasite

At the Centre for Environmental Research Leipzig-Halle (UFZ) research site in Zeitz, Germany, benzene contaminates the lower of two aquifers with concentrations of up to 20 mg/l. Since the benzene plume has a minimum length of approximately 1 km, enhanced natural attenuation measures are being considered as a remediation strategy. This study describes the performance and evaluation of a multi-species reactive tracer test using the tracers fluorescein and bromide as conservative tracers and toluene as reactive tracer. Sampling was performed over a period of six months using a detailed network of multilevel sampling wells. Toluene was only slightly retarded in comparison to bromide, whereas fluorescein was retarded considerably stronger. Therefore, it was not possible to use fluorescein as an in situ tracer for the determination of groundwater velocities. The ionic nature of fluorescein is assumed to be the major reason for its retardation. The results show that the infiltration conditions were suitable to produce a wide spreading of the tracer front along the full thickness of the aquifer. Thus, a large aquifer volume can be treated in future enhanced bioremediation measures. The total quantity of infiltrated toluene (24 l) was degraded under sulfate-reducing conditions over a flow path of 50 m. Benzylsuccinate was identified as a metabolite of toluene degradation under sulfate-reducing conditions at this site. The modelling results show that toluene degradation was described more accurately using Monod kinetics than first-order kinetics. Since toluene was only slightly retarded in comparison to bromide, sorption and desorption processes were considered to be negligible.     

MIXING INDUCED BY AN INTERNAL HYDRAULIC JUMP1

ABSTRACT The efficiency of an inverted internal hydraulic jump as a mixing and dispersion mechanism in an aquatic environment was examined. The flow considered was a two-dimensional buoyant flow from a shallow channel over a sloping bottom into a deep reservoir. It could be seen that a rapidly varied flow associated with violent turbulent mixing occurred near the point of discharge if specific discharge conditions and downstream controls were met. Downstream from the mixing zone the flow was stably stratified. The main object of the study was to find the conditions under which a turbulent mixing zone occurred and the rate of turbulent entrainment. Energy loss and length of the mixing zone were also investigated. The independent variables were the outlet densimetric Froude number, the density differential between outfall water and receiving water, the relative depths of the upper and lower layers in the stratified flow portion, the total depth, and the slope of the transition. Theoretical calculations had to be confined to a step increase in depth, but experiments in a laboratory flume showed that results obtained with slopes of 23° and 90° were quite similar. Both theory and experiments showed, for example, that dilution (entrainment rates) up to 2:1 (2 parts heated water to one part cold water) can be achieved at very little energy expense and with downstream depths approximately 8 times the outlet depth. Theoretically, any amount of dilution can be obtained, but large depths may be required. Experimental results also indicate that the length of the mixing zone was frequently ten times the value of the outlet densimetric Froude number.     

Importance of public relations in recycling strategies: principles and case studies

The separate collection of waste, and especially of recyclables with specific collection systems, would not be possible without the involvement of the users. Apart from the physical installations such as collection containers, collection points, etc., the motivation of the users is an essential component. Motivation can be reinforced through public relations work. In addition to the underlying technical considerations, this paper describes the difference between communication in general and public relations and specifically examines public involvement in recycling. Through the use of examples, we look at the targeted users and typical media employed. Furthermore, we analyzes the development of public involvement. The examples show that public relations for recycling strategies relies to a great extent on attitudes, habits, and access to the target group. Thus, standardized procedures cannot be developed. For these reasons, public relation activities must be planned carefully and professionally and include an analysis of the target group, choice of media, and verification of success.     

Monitoring ammonia in urban, inner alpine and pre-alpine ambient air

Passive samplers were used to monitor ammonia concentrations at rural inner alpine and pre-alpine, as well as urban, sites in Austria and Bavaria. Elevated concentrations were measured both at farms (up to 36 microg NH3 m(-3)) and at urban locations (up to 28 microg NH3 m(-3)). At urban locations a linear relationship between the traffic density and the NH3 concentration was found, but there was no marked seasonal trend. The highest ammonia concentrations were measured in a traffic tunnel (up to 78 microg NH3 m(-3)). The presence of livestock breeding or small scale alpine pastures resulted in elevated concentrations at the rural sites (8.1-12 and 2.5-4.6 microg NH3 m(-3), respectively), compared to the surrounding areas (3.1 and 0.9 microg NH3 m(-3)). Agriculture related sources are usually limited either spatially or seasonally. As the emissions were moderate in our case, a rapid removal and dilution of ammonia was possible and therefore the NH3 burden was only local. Sources related to traffic are more evenly distributed both geographically and seasonally. The WHO guideline, annual average concentration of 8 microg m(-3) for the protection of vegetation, was only exceeded at farms, at the urban station with the heaviest traffic and in the Tauerntunnel.     

The European Water Framework Directive: Water Quality Classification and Implications to Engineering Planning

The European Water framework directive (WFD) is probably the most important environmental management directive that has been enacted over the last decade in the European Union. The directive aims at achieving an overall good ecological status in all European water bodies. In this article, we discuss the implementation steps of the WFD and their implications for environmental engineering practice while focusing on rivers as the main receiving waters. Arising challenges for engineers and scientists are seen in the quantitative assessment of water quality, where standardized systems are needed to estimate the biological status. This is equally of concern in engineering planning, where the prediction of ecological impacts is required. Studies dealing with both classification and prediction of the ecological water quality are reviewed. Further, the combined emission–water quality approach is discussed. Common understanding of this combined approach is to apply the most stringent of either water quality or emission standard to a certain case. In contrast, for example, the Austrian water act enables the application of only the water quality based approach - at least on a temporary basis.