Marine litter in coral reef areas along the Jordan Gulf of Aqaba, Red Sea

Composition and abundance of submerged marine litter at six selected sites within a coral reef area along the Jordanian coast of the Gulf of Aqaba have been estimated. The litter was collected in clean up voluntary campaigns that took place in the period between 25 August 2003 and 29 February 2004. A total of 10,506 items weighing 1159 kg were collected during the survey. Mean litter density in the individual sampling sites varied between 1 and 6 items/m(2) with an overall mean density of 2.8 items/m(2). The mean weight of the collected items per sampling site varied between 0.06 and 1.06 kg/m(2) with an overall mean of 0.31 kg/m(2). Plastic accounted for 42% of the collected items, fishing gear was the second most abundant (31%) while metal was the third most abundant item (17%). By comparison, cardboard constituted 1%, and rubber and other items accounted for less than 1% of the total items collected during the campaigns. Approximately 61% of the plastics consisted of bags followed by bottles (24%), plastic containers and sheets accounted for 13 and 2%, respectively. Statistical analysis indicates no significant differences between the sites in terms of litter count and weight. Potential sources are pointed out and recommendations and actions to address the problem are suggested.     

Simulation of boundary layer trajectory dispersion sensitivity to soil moisture conditions: MM5 and Noah-based investigation

In this study, the sensitivity of trajectory paths to anomalous soil moisture was analyzed during three different synoptic episodes in June 2006. The MM5 and Noah land surface models were used to simulate the response of the planetary boundary layer. The HYSPLIT model was used for trajectory analysis. It was found that the response in horizontal lower-level wind field was larger at regions where vertical wind velocity changes were also large. In addition, the sensitivity to soil moisture changes was significant and localized where convective activity was well developed and synoptic effects did not dominate. A non-local effect was felt over the rest of the domain where convection was not present since the model atmosphere reacted as a whole to compensate for induced changes in vertical velocity. This finding was supported by the fact that domain averaged vertical velocities changes were of the order of 0.2 cm s^?1 or less at about 650 hPa and about 200 times smaller than modeled local vertical velocity changes. The largest change in horizontal wind field near the surface was found for weak synoptic events on June 11–12 and June 22–23 while the stronger synoptic event of June 17–18 showed smaller differences. These changes in wind field conditions impacted the transport and dispersion of pollutants. To quantify the sensitivity of air quality estimates to soil moisture uncertainty, we have used three well known measures of trajectory differences: the absolute horizontal transport deviation (AHTD), the relative horizontal transport deviation (RHTD) and the absolute vertical transport deviation (AVTD) for an ensemble of 98 trajectories departing from a region well within the computational domain. For the June 11–12 event it was found that for wet and dry soil moisture experiments, AHTD, RHTD, and AVGTD can reach values in the range 60–100 km, 10–20% and 500–900 m at 24 h run time, respectively. For the June 17–18 and June 22–23 events these values of trajectory differences were reduced more than half. These differences in behavior between time periods are largely attributed to the combined effects of synoptic forcing and the sensitivity of planetary boundary layer to soil moisture changes during well developed convection. The implication for air quality studies is that the soil moisture anomaly and related uncertainty in planetary boundary layer response needs to be incorporated in order to construct an ensemble of the most probable scenarios in which pollutants are released and transported throughout a given target region.     

Effect of oxygenated liquid additives on the urea based SNCR process

An experimental investigation was performed to study the effect of oxygenated liquid additives, H₂O₂, C₂H₅OH, C₂H₄(OH)₂ and C₃H₅(OH)₃ on NO_x removal from flue gases by the selective non-catalytic reduction (SNCR) process using urea as a reducing agent. Experiments were performed with a 150 kW pilot scale reactor in which a simulated flue gas was generated by the combustion of methane operating with 6% excess oxygen in flue gases. The desired levels of initial NO_x (500 ppm) were achieved by doping the fuel gas with ammonia. Experiments were performed throughout the temperature range of interest, i.e. from 800 to 1200 °C for the investigation of the effects of the process additives on the performance of aqueous urea DeNO_x. With H₂O₂ addition a downward shift of 150 °C in the peak reduction temperature from 1130 to 980 °C was observed during the experimentation, however, the peak reduction efficiency was reduced from 81 to 63% when no additive was used. The gradual addition of C₂H₅OH up to a molar ratio of 2.0 further impairs the peak NO_x reduction efficiency by reducing it to 50% but this is accompanied by a downward shift of 180 °C in the peak reduction temperature. Further exploration using C₂H₄(OH)₂ suggested that a 50% reduction could be attained for all the temperatures higher than 940 °C. The use of C₃H₅(OH)₃ as a secondary additive has a significant effect on the peak reduction efficiency that decreased to 40% the reductions were achievable at a much lower temperature of 800 °C showing a downward shift of 330 °C.     

Biosorption potential and kinetic studies of vegetable waste mixture for the removal of Nickel(II)

Biosorption potential of new low cost biosorbent prepared from vegetable waste, composed of 1:1 mixture of potato and carrot peels for the removal of Ni(II) from aqueous solution was determined. The residual metallic ion concentrations were determined using an atomic absorption spectrophotometric technique (AAS). Batch experiments were conducted to optimize parameters such as initial pH, temperature, contact time, initial metal ion concentration and biosorbent dose and the results showed that maximum adsorption of Nickel (79.32 %) occurs when the contents were stirred for 75 min with 3.0 g of biosorbent at 35 °C and pH 4. Kinetic studies of the reaction revealed that it follows a pseudo-second order reaction. The experimental results were analyzed in terms of Langmuir and Freundlich isotherms. The Langmuir isotherm model fits well to data of Ni(II) biosorption by the prepared biomass as compared to the model of Freundlich. Both neat and Ni loaded biosorbent samples were analyzed by AAS using a dry ashing process in a furnace and also by use of a FT-IR spectrophotometer and an X-Ray florescence spectrometer in order to confirm the biosorption of Ni(II) and the results have revealed that a significant amount of Ni is present in the spent biosorbent.     

Chemical characterization and source apportionment of fine and coarse particulate matter in Lahore,Pakistan

Lahore, Pakistan is an emerging megacity that is heavily polluted with high levels of particle air pollution. In this study, respirable particulate matter (PM_2.5 and PM₁₀) were collected every sixth day in Lahore from 12 January 2007 to 19 January 2008. Ambient aerosol was characterized using well-established chemical methods for mass, organic carbon (OC), elemental carbon (EC), ionic species (sulfate, nitrate, chloride, ammonium, sodium, calcium, and potassium), and organic species. The annual average concentration (±one standard deviation) of PM_2.5 was 194 ± 94 μg m^?3 and PM₁₀ was 336 ± 135 μg m^?3. Coarse aerosol (PM_10?2.5) was dominated by crustal sources like dust (74 ± 16%, annual average ± one standard deviation), whereas fine particles were dominated by carbonaceous aerosol (organic matter and elemental carbon, 61 ± 17%). Organic tracer species were used to identify sources of PM_2.5 OC and chemical mass balance (CMB) modeling was used to estimate relative source contributions. On an annual basis, non-catalyzed motor vehicles accounted for more than half of primary OC (53 ± 19%). Lesser sources included biomass burning (10 ± 5%) and the combined source of diesel engines and residual fuel oil combustion (6 ± 2%). Secondary organic aerosol (SOA) was an important contributor to ambient OC, particularly during the winter when secondary processing of aerosol species during fog episodes was expected. Coal combustion alone contributed a small percentage of organic aerosol (1.9 ± 0.3%), but showed strong linear correlation with unidentified sources of OC that contributed more significantly (27 ± 16%). Brick kilns, where coal and other low quality fuels are burned together, are suggested as the most probable origins of unapportioned OC. The chemical profiling of emissions from brick kilns and other sources unique to Lahore would contribute to a better understanding of OC sources in this megacity.     

The role of bacteria in the heavy metals removal and growth of Sedum alfredii Hance in an aqueous medium

This study was the first attempt to examine the possible role of the naturally occurring rhizospheric bacteria in heavy metal removal by Sedum alfredii Hance, a terrestrial Zn/Cd hyperaccumuluator, from Zn, Cd, Cu and Pb contaminated water using antibiotic ampicillin. Moreover, the toxicity symptom in plants under heavy metal stress expressed as total chlorophyll, chlorophyll a and b content, growth inhibition, root length, and N, P contents were studied, and the possible relationship among them were also discussed. These results indicate that rhizospheric bacteria may play an important role in the uptake of N and P by S. alfredii, and consequently result in the increase of Chlorophyll content in the leaves and plant biomass due to improved photosynthesis. At the same time, root length significantly decreased under the treatment with ampicillin, which suggested that rhizospheric bacteria appeared to protect the roots against heavy metal toxicity. The Pb, Zn, Cu and Cd concentrations in the roots, stems and leaves of S. alfredii were much higher than those exposed to ampicillin. Accordingly, metal concentrations in the contaminated water without ampicillin treatment were lower than those treated with ampicillin. These results suggest that the rhizospheric bacteria may be useful in plant tolerance to heavy metal toxicity, and also accelerate the metal removal from contaminated water.     

Anoxic biodegradation of dimethyl phthalate （DMP） by activated sludge cultures under nitrate-reducing conditions

Worldwide extensive use of plasticized plastics has resulted in phthalates pollution in different environment. Nitrates from industry and agriculture are also widely disseminated in the soils, natural waters and wastewaters. Dimethyl phthalate (DMP) biodegradation by activated sludge cultures under nitrate-reducing conditions was investigated. Under one optimized condition, DMP was biodegraded from 102.20 mg/L to undetectable level in 56 h under anoxic conditions and its reaction fitted well with the first-order kinetics. Using the high-performance liquid chromatography (HPLC) and liquid chromatography mass spectrometry (LC-MS) analysis, mono-methyl phthalate (MMP) and phthalic acid (PA) were detected as the major intermediates of DMP biodegradation. When combined with the determination of chemical oxygen demand (CODCr) removal capacity and pH, DMP was found to be mineralized completely under anoxic conditions. The biodegradation pathway was proposed as DMP → MMP → PA → … → CO2 H2O.The molar ratio of DMP to nitrate consumed was found to be 9.0:1, which agrees well with the theoretical stoichiometric values of DMP biodegradation by nitrate-reducing bacteria. The results of the non-linear simulation showed that the optimum pH and temperature for the degradation were 7.56 and 31.4℃, respectively.     

Do disinfection byproducts in drinking water have an effect on human cancer risk worldwide? A meta‐analysis

In the present study, a meta‐analysis was carried out to clarify the association between disinfection byproducts (DBPs) in drinking water and human cancer risk worldwide. Kidney, colorectal, esophagus, urinary bladder, brain, breast, leukemia, lung, and rectum cancers were selected to perform this analysis. According to preferred reporting items for systematic review and meta‐analysis protocol (PRISMA) guidelines, the relevant studies were identified and selection criteria (inclusion and exclusion criteria) were applied. Next, effective subgroups in these studies (gender, type of drinking water source, and type of DBPs) were analyzed. The quality of the studies was evaluated using the Newcastle‐Ottawa Scale. In addition, this overall study included analyses of 16 case–control and 3 cohort studies. The overall odds ratio (OR) with 95% confidence intervals (CI) between DBPs and cancer risk was 1.01 (95% CI, 0.94–1.09). The summary ORs of cancer risk were 1.04 (95% CI, 0.89–1.19) for kidney; 0.98 (95% CI, 0.87–1.09) for colorectal; 1.07 (95% CI, 0.84–1.29) for esophagus; 0.93 (95% CI, 0.80–1.06) for pancreatic; 1.00 (95% CI, 0.83–1.18) for brain; 1.13 (95% CI, 0.99–1.26) for breast; 0.93 (95% CI, 0.72–1.13) for leukemia; and 1.18 (95% CI, 1–1.36) for lung cancers. The results of this meta‐analysis suggested that there is not a significant association between DBPs in water and cancer risk. In addition, subgroup analysis shows a positive association with colorectal and kidney cancer risk in men, as well as colon and breast cancers in females. Studies of both genders have shown a significant association between lung and pancreatic cancers. Moreover, this study finds a significant relationship between cancer rate and consumers of city water and bottled water sources. In analyzing different types of DBPs in water, chlorine and trichloromethane show a significant association in increasing cancer risk.     

Effect of chromium on growth attributes in sunflower (Helianthus annuus L.)

Heavy metal soil pollution takes place when the metal concentration of soil exceeds natural background level and causes ecological destruction and deterioration of the environment.In the present study,a pot experiment was conducted to evaluate the effect of chromium-contaminated soil in sunflower(Helianthus annuus L.)growth attributes.Three different levels of chromium(Cr)i.e.,20, 40,and 60 mg/kg were applied to three varieties of sunflower(G-3,G-9,and G-59).The results of morphological,chemical,and yield p...