Application of QuEChERS method and gas chromatography-mass spectrometry for the analysis of cypermethrin residue in milk

Analytical methods for the isolation and determination of cypermethrin in milk, based on the solid-phase microextraction (SPME) and QuEChERS methods (Quick, Easy, Cheap, Effective, Rugged, and Safe) are presented. The SPME technique was not appropriate to analyse cypermethrin in milk, even establishing the best extraction conditions, polydimethylsiloxane fiber, 60 min time extraction, 60 °C temperature extraction, addition of salt (NaCl) and stirring rate. The extraction efficiency was low probably because of the matrix constituents. The QuEChERS method involves the extraction of the analyte with acetonitrile and simultaneous liquid-liquid partitioning formed by adding anhydrous MgSO(4) plus NaCl, followed by the removal of residual water and cleanup using a procedure called dispersive solid-phase extraction, in which anhydrous MgSO(4) plus PSA and C18 are mixed with 1 mL of acetonitrile extract. The detection and quantification limits were 0.01 and 0.04 mg kg(-1), respectively, and the percentage recovery obtained ranged from 92 to 105% with relative standard deviations below 7%.     

Carry-over of dietary organochlorine pesticides, PCDD/Fs, PCBs, and brominated flame retardants to Atlantic salmon (Salmo salar L.) fillets

Information on carry-over of contaminants from feed to animal food products is essential for appropriate human risk assessment of feed contaminants. The carry-over of potentially hazardous persistent organic pollutants (POPs) from feed to fillet was assessed in consumption sized Atlantic salmon (Salmo salar). Relative carry-over (defined as the fraction of a certain dietary POP retained in the fillet) was assessed in a controlled feeding trial, which provided fillet retention of dietary organochlorine pesticides (OCPs), dioxins (PCDD/Fs), polychlorinated biphenyls (PCBs), and brominated flame retardants (BFRs). Highest retention was found for OCPs, BFRs and PCBs (31-58%), and the lowest retentions were observed for PCDD/Fs congeners (10-34%). National monitoring data on commercial fish feed and farmed Atlantic salmon on the Norwegian market were used to provide commercially relevant feed-to-fillet transfer factors (calculated as fillet POP level divided by feed POP level), which ranged from 0.4 to 0.5, which is a factor 5-10 times higher than reported for terrestrial meat products. For the OCP with one of the highest relative carry-over, toxaphene, uptake and elimination kinetics were established. Model simulations that are based on the uptake and elimination kinetics gave predicted levels that were in agreement with the measured values. Application of the model to the current EU upper limit for toxaphene in feed (50 μg kg⁻¹) gave maximum fillet levels of 22 μg kg⁻¹, which exceeds the estimated permissible level (21 μg kg⁻¹) for toxaphene in fish food samples in Norway.     

Polychlorinated dibenzo-p-dioxin and dibenzofuran in urban air of an Andean city

Particle-bound polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) in ambient air were monitored together with particulate matter less than 10 μm (PM₁₀) at three sampling sites of the Andean city of Manizales, Colombia; during September 2009 and July 2010. PCDD/Fs ambient air emissions ranged from 1 fg WHO-TEQ m⁻³ to 52 fg WHO-TEQ m⁻³ in particulate fraction. The PM₁₀ concentrations ranged from 23 μg m⁻³ to 54 μg m⁻³. Concentrations of PM₁₀ and PCDD/Fs in ambient air observed for Manizales - a medium sized city with a population of 380 000 - were comparable to concentrations in larger cities. The highest concentrations of PCDD/Fs and PM₁₀ found in this study were determined at the central zone of the city, characterized by public transportation density, where diesel as principal fuel is used. In addition, hypothetical gas fractions of PCDD/Fs were calculated from theoretical K_p data. Congener profiles of PCDD/Fs exhibited ratios associated with different combustion sources at the different sampling locations, ranging from steel recycling to gasoline and diesel engines. Taking into account particle and gas hypothetical fraction of PCDD/Fs, Manizales exhibited values of PCDD/Fs equivalent to rural and urban-industrial sites in the southeast and center of the city respectively. Poor correlation of PCDDs with PM₁₀ (r = −0.55 and r = 0.52) suggests ambient air PCDDs were derived from various combustion sources. Stronger correlation was observed of PCDFs with PM₁₀. Poor correlation between precipitation and reduced PM₁₀ concentration in ambient air (r = −0.45) suggested low PM₁₀ removal by rainfall.     

Structural isomers of polyfluorinated di- and tri-alkylated phosphate ester surfactants present in industrial blends and in microwave popcorn bags

Introduction  

In this study, we provide strategies for detecting and quantifying the structural isomers of polyfluorinated di- and tri-alkyl surfactants (PFAS) by mass spectrometry (MS). We specifically investigate polyfluorinated dialkylated phosphate ester surfactants (x:2/y:2 diPAPS, (F(CF₂) _x CH₂CH₂O-P(O)(O)⁻-OCH₂CH₂(CF₂) _y F)) and their thioether analogues (x:2/y:2 S-diPAPS, F(CF₂) _x CH₂CH₂SCH₂-C[CH₂O)₂P(O)(O)⁻]-CH₂SCH₂CH₂(CF₂) _y F), which are used for industrial applications, such as oil- and water-repellent coatings on paper and board. DiPAPS have been found in human blood and are metabolised to the persistent perfluoroalkyl carboxylic acids (PFCA) in rats.     

Polyfluorinated surfactants (PFS) in paper and board coatings for food packaging

Introduction  

In this study, we explore the identity of a range of polyfluorinated surfactants (PFS) used for food contact materials, primarily to impart oil and water repellency on paper and board. PFS are of interest, as they can be precursors of poly- and perfluorinated alkyl substances (PFAS), of which several are persistent and are found worldwide in human blood and in the environment.     

Viable skin efficiently absorbs and metabolizes bisphenol A

Skin contact has been hypothesized to contribute to human exposure to bisphenol A (BPA). We examined the diffusion and metabolism of BPA using viable skin models: human skin explants and short-term cultures of pig ear skin, an alternative model for the study of the fate of xenobiotics following contact exposure. ¹⁴C-BPA [50-800 nmol] was applied on the surface of skin models. Radioactivity distribution was measured in all skin compartments and in the diffusion cells of static cells diffusion systems. BPA and metabolites were further quantified by radio-HPLC. BPA was efficiently absorbed in short-term cultures, with no major difference between the models used in the study [viable pig ear skin: 65%; viable human explants: 46%; non-viable (previously frozen) pig skin: 58%]. BPA was extensively metabolized in viable systems only. Major BPA metabolites produced by the skin were BPA mono-glucuronide and BPA mono-sulfate, accounting together for 73% and 27% of the dose, in pig and human, respectively. In conclusion, experiments with viable skin models unequivocally demonstrate that BPA is readily absorbed and metabolized by the skin. The trans-dermal route is expected to contribute substantially to BPA exposure in human, when direct contact with BPA (free monomer) occurs.     

Chemical composition of burnt smell caused by accidental fires: environmental contaminants

The chemical composition of the odors typical of fires has recently been deciphered. Basically the constituents are mixtures of acetophenone, benzyl alcohol, hydroxylated derivatives of benzaldehyde, methoxylated and/or alkylated phenols and naphthalene. This finding makes it possible to develop objective, practical analytic measurement methods for the burnt smell as a contribution to improving fire damage assessment and remediation monitoring. With the aid of an artificially produced burnt smell and a panel of testers the odor detection threshold of a test mixture was determined olfactometrically to 2 μg m⁻³. Using a defined burnt-smell atmosphere in a test chamber, analytical methods with active sampling, the adsorbents XAD 7 and TENAX TA, and GC/MS measurement were then optimized and tested with a view to being able to carry out sensitive quantitative measurement of burnt smells. A further practical method with particular application to the qualitative characterization of this odor is based on the use of a new SPME (solid-phase microextraction) field sampler with DVB/CAR/PDMS (divinylbenzene/Carboxen™/polydimethylsiloxane) fibers.     

Magnetic ion exchange treatment of stabilized landfill leachate

Stabilized landfill leachate is characterized by a high concentration of non-biodegradable organic matter, which is similar in chemistry to dissolved organic matter (DOM) in the natural aquatic environment. Magnetic ion exchange (MIEX) resin treatment is well-studied in drinking water for removal of DOM from natural waters. There are fewer studies evaluating MIEX treatment of waste waters, and there is no previous work evaluating MIEX treatment of landfill leachate. This work systematically evaluated MIEX treatment of stabilized landfill leachate and evaluated the results in the context of previous studies of MIEX treatment of natural and waste waters. Five leachates from four landfills were evaluated as a function of MIEX resin dose, mixing time, and regeneration efficiency. MIEX resin removed DOM from landfill leachate, even in the presence of a reported high background concentration of inorganic ions. MIEX resin that was exhausted with leachate DOM was effectively regenerated with a concentrated NaCl solution, and regenerated MIEX resin performed similarly to virgin resin. For a majority of the leachates, the removal trend for MIEX resin was color > UV-absorbing substances > dissolved organic carbon ≈ COD > total nitrogen. Finally, MIEX resin removed a wider range of DOM from leachate than coagulation. The most important contribution of this work is that MIEX treatment of leachate followed very similar trends as MIEX treatment of natural waters, which will allow previous MIEX data to be used to estimate the treatment efficiency of other waste waters.     

Comparison between UVA- and zero-valent iron-activated persulfate processes for degrading propylparaben

Conventional wastewater treatments are not efficient in removing parabens, which may thus end up in surface waters, posing a threat to aquatic biota and hu     

Occurrence of PPCPs in the marine environment: a review

Little research has been conducted on the occurrence of pharmaceuticals and personal care products (PPCPs) in the marine environment despite being increasingly impacted by these contaminants. This article reviews data on the occurrence of PPCPs in seawater, sediment, and organisms in the marine environment. Data pertaining to 196 pharmaceuticals and 37 personal care products reported from more than 50 marine sites are analyzed while taking sampling strategies and analytical methods into account. Particular attention is focused on the most frequently detected substances at highest concentrations. A snapshot of the most impacted marine sites is provided by comparing the highest concentrations reported for quantified substances. The present review reveals that: (i) PPCPs are widespread in seawater, particularly at sites impacted by anthropogenic activities, and (ii) the most frequently investigated and detected molecules in seawater and sediments are antibiotics, such as erythromycin. Moreover, this review points out other PPCPs of concern, such as ultraviolet filters, and underlines the scarcity of data on those substances despite recent evidence on their occurrence in marine organisms. The exposure of marine organisms in regard to these insufficient data is discussed.