FIA-coupled spectrophotometric method for determination of Cr (VI) traces in natural waters: application of in-line dissolution of 1,5-diphenylcarbazide after heat treatment and activated alumina as adsorbent for preconcentration

This work proposes the quantification of Cr (VI) ions in natural waters in trace level, using activated alumina (Al₂O₃) as preconcentration support, controlled in-line dissolution of the solidified chromophore diphenylcarbazide after heat treatment and spectrophotometric detection. The manifold ensures high sensitivity of analytical response, good repeatability, and stability. In this work, optimization of experimental conditions of a flow injection system was chosen as the parameters for greater sensitivity and better selectivity. The selected optimized conditions were 0.30 mol L^?1 for H₂SO₄ concentration, system flow rate as 0.40 mL min^?1, sample injection volume of 192.50 μL, 2 min for preconcentration time, and 0.10 mol L^?1 for eluent concentration. The analytical curves obtained for real sample analysis show linear range from 0.192 to 0.961 μM, linear correlation coefficient R?=?0.9997 and LOD?=?0.024 μM. The preconcentration factor of about four times was obtained through the passage of 800 μL of a standard solution containing 0.961 μM of Cr (VI) through mini-column of preconcentration followed by elution at 192.5 μL of NH₄OH 0.1 mol L^?1 solution. The solid chromogenic reagent presented high durability (weeks in daily use with mass of 0.0993 g) and good reproducibility in analytical signal. The reactivation of the mini-column of alumina should be executed after ten injections of eluent, using 800 μL of HCl 0.02 mol L^?1 solution in flow through the same. Each cycle of injection and elution of the sample takes about 5 min on the proposed terms. Despite the length of each cycle still be high, low concentrations can be detected using a technique of relatively low cost. This is due in part, the association dissolution of the chromogenic reagent directly in the line and the preconcentration step. Another important factor is the economy of reagent chromogenic, low generation of reject contributing to better quality of the environment, and the high potential for applications to work in field.     

Environmental copper: Behaviour when involved in physical adsorption at several interfaces

From a literature-based assessment of the current knowledge about both the toxic or salutary properties of copper, this study focused on the determination, at 25 °C, of the interfacial properties of CuCl_2, either alone or in mixture with carbofuran used, here, as a model of organics and/or pesticide. The interfaces under study were: i) the air/solution interface and ii) the silica/solution interface. The former is considered as a path for volatilization, whereas the latter permits a modelling of physical adsorption upon solids, which is the first and unavoidable step in any adsorption process. One should note that it can also mimic adsorption on some sandy soils. Coadsorption was clearly identified as implicated in an enhancement of the surface content of both solutes at both interfaces. However, at the two interfaces under study, the way the surface became structured led to opposite adsorption mechanisms for the organic compounds and the salt. A rough theory about ionic adsorption is also proposed.     

Biomonitoring perfluorinated compounds in Catalonia,Spain: concentrations and trends in human liver and milk samples

Background, aim and scope  

Perfluorinated compounds (PFCs) are global environmental pollutants that bioaccumulate in wildlife and humans. Laboratory experiments have revealed toxic effects such as delayed development, humoral suppression, and hepatotoxicity. Although numerous human blood levels have been reported, little is known about distribution in the human body. Knowledge about PFC distribution and accumulation in the human body is crucial to understanding uptake and subsequent effects as well as to conduct risk assessments. The present study reports PFC levels in human liver and breast milk from a general population living in Catalonia, Spain. Liver and milk levels are compared to previously reported levels in blood from the same geographic area as well as to other existing reports on human liver and milk levels in other countries.     

Characterisation of particulate exposure during fireworks displays

Little is known about the level and content of exposure to fine particles (PM_2.5) among persons who attend fireworks displays and those who live nearby. An evaluation of the levels of PM_2.5 and their elemental content was carried out during the nine launches of the 2007 Montréal International Fireworks Competition. For each event, a prediction of the location of the firework plume was obtained from the Canadian Meteorological Centre (CMC) of the Meteorological Service of Canada. PM_2.5 was measured continuously with a photometer (Sidepak?, TSI) within the predicted plume location (“predicted sites”), and integrated samples were collected using portable personal samplers. An additional sampler was located on a nearby roof (“fixed site”). The elemental composition of the collected PM_2.5 samples from the “predicted sites” was determined using both a non-destructive energy dispersive ED-XRF method and an ICP-MS method with a near-total microwave-assisted acid digestion. The elemental composition of the “fixed site” samples was determined by the ICP-MS with the near-total digestion method. The highest PM_2.5 levels reached nearly 10 000 μg m^?3, roughly 1000 times background levels. Elements such as K, Cl, Al, Mg and Ti were markedly higher in plume-exposed filters. This study shows that 1) persons in the plume and in close proximity to the launch site may be exposed to extremely high levels of PM_2.5 for the duration of the display and, 2) that the plume contains specific elements for which little is known of their acute cardio-respiratory toxicity.     

Relation between management's behavioural intentions toward the environment and environmental actions

Drawing on Ajzen's Theory of Planned Behaviour, this paper analyses whether there is a relation between management's behavioural intentions toward an environmental problem and the company's specific actions in this area, and also considers the impact of the company size on these actions. For the data, a questionnaire was sent to 184 managers employed in industrial companies located in Spain which belonged to the automobile industry. The empirical analysis produces positive and significant regression coefficients and provides support for the hypotheses proposed. Specifically, the results show that the environmental actions carried out in the company respond at least in part to management's behavioural intentions toward these issues and the size of the firm.     

High efficiencies in the electrochemical oxidation of an anthraquinonic dye with conductive-diamond anodes

Oxidation of anthraquinonic dye Acid Blue 62 by electrolysis with conductive-diamond electrodes is studied in this work. COD, TOC, and color have been selected to monitor the degradation of the molecule as a function of several operating inputs (current density, pH, temperature, and NaCl concentration). Results show that the electrochemical oxidation of this model of large molecules follows a first order kinetics in all the conditions assessed, and it does not depend on the pH and temperature. The occurrence of chloride ions in wastewaters increases the rate of color and COD removal as a consequence of the mediated oxidation promoted by the chlorinated oxidizing species. However, chloride occurrence does not have an influence on the mineralization rate. First-order kinetic-constants for color depletion (attack to chromophores groups), oxidation (COD removal), and mineralization (TOC removal) were found to depend on the current density and to increase significantly with its value. A single model was proposed to explain these changes in terms of the mediated oxidation processes. Rate of mineralization remained very close to that expected for a purely mass transfer-controlled process. This was explained assuming that mediated oxidation does not have a significant influence on the mineralization in spite it has some effect on intermediate oxidation stages. The efficiency of the oxidation was found to depend mainly on the concentration of COD being negligible the effect of the other inputs assessed except for the occurrence of chloride ions. Opposite, the efficiency of mineralization depends on concentration of TOC and current density and it did not depend on the chloride occurrence. This observation was found to have an important influence on the power required to remove a given percentage of the initial TOC or COD. To decrease COD efficiently, the occurrence of chloride in the solution is very important, while to remove TOC efficiently, it is more important to work at low current densities and chloride effect is negligible. Energy consumption could be decreased by folds using the proper conditions.     

Valorization of solid waste products from olive oil industry as potential adsorbents for water pollution control—a review

The global olive oil production for 2010 is estimated to be 2,881,500 metric tons. The European Union countries produce 78.5 % of the total olive oil, which stands for an average production of 2,136,000 tons. The worldwide consumption of olive oil increased of 78 % between 1990 and 2010. The increase in olive oil production implies a proportional increase in olive mill wastes. As a consequence of such increasing trend, olive mills are facing severe environmental problems due to lack of feasible and/or cost-effective solutions to olive-mill waste management. Therefore, immediate attention is required to find a proper way of management to deal with olive mill waste materials in order to minimize environmental pollution and associated health risks. One of the interesting uses of solid wastes generated from olive mills is to convert them as inexpensive adsorbents for water pollution control. In this review paper, an extensive list of adsorbents (prepared by utilizing different types of olive mill solid waste materials) from vast literature has been compiled, and their adsorption capacities for various aquatic pollutants removal are presented. Different physicochemical methods that have been used to convert olive mill solid wastes into efficient adsorbents have also been discussed. Characterization of olive-based adsorbents and adsorption mechanisms of various aquatic pollutants on these developed olive-based adsorbents have also been discussed in detail. Conclusions have been drawn from the literature reviewed, and suggestions for future research are proposed.     

Environmental monitoring of alcohol sulfates and alcohol ethoxysulfates in marine sediments

The study describes the environmental monitoring of anionic surfactants―alcohol sulfates (AS) and alcohol ethoxysulfates (AES)—in marine sediments. Concentration values were obtained after pressurised liquid extraction (PLE) and liquid chromatography–tandem mass spectrometry analysis (LC–MS/MS). Samples were collected from a range of wastewater discharge points along the coast of the provinces of Huelva, Málaga, Granada and Almería. Urban, agricultural and industrial wastewaters are discharged at the selected 38 sampling sites. Principal component analysis was carried out in order to evaluate the distribution and behaviour of these compounds in these coastal environments. Evaluation of the data revealed that the behaviour and sources of AS and AES in marine sediments are different, and that the distribution of AES depends on the length of the alkyl chain, while the number of ethoxylated units is not relevant. Additionally, the 38 sampling sites can be grouped into only two types of outfalls according to their AS distribution. The concentration of compounds in sediment samples ranged from 7.52 to 13.50 mg kg^?1 for AS, from 3.04 to 10.68 mg kg^?1 for AES–C₁₂E_x and from 3.83 to 11.56 mg kg^?1 for AES–C₁₄E_x.     

Spatial variability of precipitation in Spain

The spatial variability of annual and seasonal precipitation in the conterminous land of Spain has been evaluated by using correlation decay distance analysis (CDD). The CDD analysis essentially explores how the correlation between neighbouring stations varies according to distance. We analysed CDD independently for the decades 1956–1965, 1966–1975, 1976–1985, 1986–1995, and 1996–2005 using only those stations with no missing values for each decade. To this end, 972, 1,174, 1,242, 773 and 695 complete series were used for each decade, respectively. In particular, for each station and decade, we calculated the threshold distance at which the common variance between target (i) and neighbour series is higher than 50 % (r ²  = 0.5) to evaluate whether current density of the climate data set captures the spatial variability of precipitation within the study area. Results indicate that, at an annual scale, neighbouring stations with 50 % of common variance are restricted on average to about 105 km, but this distance can vary from 28 to 251 km within the study area. The lowest variability is located to the SW and in winter, while the higher spatial variability is found to the north, in the Cantabrian area, and to the east, in the Mediterranean and Pyrenees, during summer. Our results suggest that current density of climate stations (those operating in 2005) is good enough to study precipitation variability at an annual scale for winter, spring and autumn, but not enough for summer.     

Climate change and economic consequences for inland waterway transport in Europe

Future climate conditions are likely to affect inland waterway transport in Europe. According to some climate scenarios, in summer, in the river Rhine, periods with low water levels are likely to occur more often and become more serious. Then inland waterway transport carriers will experience more severe restrictions on the load factor of their inland ships, which implies a stronger reduction in transport capacity in the market. Transport prices will rise under such conditions. Some studies reviewed in this paper find that at extremely low water levels, the price per tonne for inland waterway transport in the river Rhine area will almost double. These increased transport prices result in welfare losses. For the dry summer in 2003, the losses for North West Europe are estimated to sum up to around €480 million. Increased transport prices trigger adaptation. Inland waterway carriers may use smaller vessels, and shippers have the opportunity to shift from inland waterway transport to alternative transport modes in periods with low water levels. This effect is probably rather modest, however, with a modal shift to road and rail smaller than 10 %. Also, changes in transport costs may lead to relocation of certain economic activities in the long run.