电网应急预案知识图谱构建方法与应用*

为提高电网应急预案知识的检索效率以及电网事故的处置效率,提出电网应急预案知识图谱的构建方法。首先,以电网自然灾害和大面积停电事件应急预案为数据源,分析电网应急预案知识内容体系框架;其次,采用基于规则与基于深度学习的知识抽取方式对应急预案进行知识抽取,并基于Neo4j图数据库对电网应急预案知识进行存储和可视化展示;最后,以某市大面积停电事件应急响应为例,分析电网应急预案知识图谱在实际案例中的有效性。研究结果表明:所构建电网应急预案知识图谱可对电网突发事故进行辅助决策,从而缩短应急决策时间,提高电网事故的应急处置效率。     

Adsorptive removal of hydrophobic organic compounds by carbonaceous adsorbents: A comparative study of waste-polymer-based, coal-based activated carbon, and carbon nanotubes

Adsorption of the hydrophobic organic compounds (HOCs) trichloroethylene (TCE), 1,3-dichlorobenzene (DCB), 1,3-dinitrobenzene (DNB) and γ-hexachlorocyclohexane (HCH) on five different carbonaceous materials was compared. The adsorbents included three polymer-based activated carbons, one coal-based activated carbon (F400) and multiwalled carbon nanotubes (MWNT). The polymerbased activated carbons were prepared using KOH activation from waste polymers: polyvinyl chloride (PVC), polyethyleneterephthalate (PET) and tire rubber (TR). Compared with F400 and MWNT, activated carbons derived from PVC and PET exhibited fast adsorption kinetics and high adsorption capacity toward the HOCs, attributed to their extremely large hydrophobic surface area (2700 m²/g) and highly mesoporous structures. Adsorption of small-sized TCE was stronger on the tire-rubber-based carbon and F400 resulting from the pore-filling effect. In contrast, due to the molecular sieving effect, their adsorption on HCH was lower. MWNT exhibited the lowest adsorption capacity toward HOCs because of its low surface area and characteristic of aggregating in aqueous solution.     

铁炭微电解组合工艺处理大蒜切片废水研究

采用铁炭微电解技术为核心工艺的混凝-铁炭微电解-强化电解组合工艺对大蒜切片废水进行处理,主要研究了铁炭微电解的运行参数,包括曝气与否、废水pH值、反应时间、铁炭质量比、铁水质量比对COD去除效果的影响。结果表明:经过组合工艺处理后,废水刺鼻的气味完全消除,浊度去除率达100%,ρ(COD)值由13050mg/L降至878mg/L,去除率达93.3%,BOD5/COD(B/C)值由0.10提高到0.46,废水的可生化性显著提高。     

河北测震台网地震交互处理系统定位结果的比较研究

利用"十五"系统对所选取的地震事件进行了重新定位,将震中位置与"九五"系统输出的地震目录进行对比分析,得到两套系统在定位结果方面的一致性。同时,对HYP02000和HYPOSAT两种定位方法的适用性进行了比较。     

The disappearing sustainability triangle: community level considerations

This article challenges the application of the sustainability triangle to conceptualise sustainable development by looking at how weak sustainability can be obtained via the reinforcing increase in social capital and natural capital. Sustainable development is often visualised as a triangle consisting of social, environmental, and economic aspects. Would it be possible to conceive a flattened system, with diminishing economic resources or without refilling financial resources? The possibility involves mutual reinforcement between social capital and natural capital. The consideration of the diminishing economic dimension relates to the concept of development without economic growth, such as degrowth, zero-growth, and sustainable growth, that has been revived in the face of the recent economic crisis. Several countries have imposed extreme budget cuts in development collaboration and in other government expenditures. When the economic resource is not at a satisfactory level, can we rely on the reinforcement between social and environmental aspects for sustainability? Although it is not new to acknowledge the contribution of social capital to environmental conservation, research has long ignored the reinforcing relationship between environmental and social dimensions. This article provides a prototype model to demonstrate how social capital and natural capital can reinforce each other. The prototype is studied and verified at the community level using a comparative method. This article concludes with principles and practices that may encourage sustainability with merely the reinforcement between social capital and natural capital.     

Enhanced cross-flow filtration with flat-sheet ceramic membranes by titanium-based coagulation for membrane fouling control

• Ceramic membrane filtration showed high performance for surface water treatment. • PTC pre-coagulation could enhance ceramic membrane filtration performance. • Ceramic membrane fouling was investigated by four varied mathematical models. • PTC pre-coagulation was high-effective for ceramic membrane fouling control. Application of ceramic membrane (CM) with outstanding characteristics, such as high flux and chemical-resistance, is inevitably restricted by membrane fouling. Coagulation was an economical and effective technology for membrane fouling control. This study investigated the filtration performance of ceramic membrane enhanced by the emerging titanium-based coagulant (polytitanium chloride, PTC). Particular attention was paid to the simulation of ceramic membrane fouling using four widely used mathematical models. Results show that filtration of the PTC-coagulated effluent using flat-sheet ceramic membrane achieved the removal of organic matter up to 78.0%. Permeate flux of ceramic membrane filtration reached 600 L/(m²·h), which was 10-fold higher than that observed with conventional polyaluminum chloride (PAC) case. For PTC, fouling of the ceramic membrane was attributed to the formation of cake layer, whereas for PAC, standard filtration/intermediate filtration (blocking of membrane pores) was also a key fouling mechanism. To sum up, cross-flow filtration with flat-sheet ceramic membranes could be significantly enhanced by titanium-based coagulation to produce both high-quality filtrate and high-permeation flux.     

Impact of different pretreatments on the anaerobic digestion performance of cucumber vine

Environmental Science and Pollution Research - Copious amounts of cucumber vine (CV) derived from crop growing and harvesting are casually discarded in the field, posing severely negative impacts...     

Structural investigation of catalyst deactivation of Pt/SDB for catalytic oxidation of VOC-containing wastewater

The stability of styrene-divinyl benzene copolymer (SDB)-supported Pt (Pt/SDB) catalysts for destruction of volatile-organic-compound (VOC) in wastewater was examined. The test reaction was wet oxidation of water-containing aliphatic alcohol and formaldehyde at 140 degrees C and 90 psig for 40 h. The catalytic performance tests indicated that activity of the Pt/SDB catalysts could be maintained for VOC concentration of 3 wt.%, whereas the catalysts deactivated rapidly for 10 wt.% VOC containing wastewater. In order to investigate the nature of catalyst deactivation, extended X-ray absorption fine structure (EXAFS) and X-ray absorption near edge (XANES) spectroscopy were used to characterize the fresh and used catalysts. After the reaction, there is no oxidation of Pt clusters observed in EXAFS and XANES spectroscopy suggesting that the oxidation reaction takes places via the adsorbed oxygen. The spectroscopy results further indicated that deactivation of the catalysts were mainly caused by the increase of Pd particle size. After the reaction, the Pt-Pt coordination number has no significant change for the 3 wt.% wastewater whereas increase from 5.6 to 6.2 for 10 wt.% wastewater. Combined with the fact that the catalysts fractured during the reactions, we suggested that Pt agglomeration was mainly caused by thermal migration of the metal clusters.     

Adsorption of acid dye onto activated carbons prepared from agricultural waste bagasse by ZnCl2 activation

A series of activated carbons were prepared from agricultural waste sugarcane bagasse by chemical activation with zinc chloride (ZnCl2) as an activating agent at 500 degrees C and 0.5 h soaking time. The Langmuir surface area and total pore volume were used to estimate the average pore diameter of the carbon products. The values of the surface area and pore volume increased linearly with increase in the impregnation ratio (IR) up to 100 wt%. The adsorption capacities of the derived adsorbents for Acid Orange 10 were measured at 20 degrees C and 40 degrees C to gain further insights into the acidic surface oxides of the adsorbent from the results of Fourier transform infrared (FTIR) spectroscopy analysis and pH measurement. Adsorption isotherms of the acid dye on adsorbents prepared were determined and correlated with common isotherm equations. It was found that the Langmuir model appears to fit the isotherm data better than the Freundlich model. The physical properties of these adsorbents were consistent with the parameters obtained from the isotherm equations.     

圆孔多孔板水力空化杀灭大肠杆菌的实验研究

在以圆形孔口多孔板为空化空蚀发生器的水力空化装置中,对含有大肠杆菌的水样进行灭菌处理.通过检测大肠杆菌的灭菌率,研究了水力空化对水中大肠杆菌的灭活效果.分析了大肠杆菌初始浓度,水流空化数,孔口流速,孔口排布,孔口数量,孔口大小,空化空蚀作用时间等参数对灭菌效果的影响.试验结果表明：提高流速,降低空化数,选取适当的初始浓度,延长空化空蚀作用时间,增加孔口数量,减小孔口大小以及改进孔口排布可以进一步提高大肠杆菌的杀灭率.水力空化的空化空蚀作用能够杀灭水中的大肠杆菌,是一种饮用水消毒的新技术.