厌氧-好氧生物反应器填埋工艺特性研究

基于生物反应器填埋技术,研究1种填埋场地循环操作的厌氧-好氧生物反应器填埋工艺,设计了该工艺模拟装置并研究了其运行工艺特性.厌氧阶段主要通过渗滤液回灌控制反应器工艺条件,主要试验结果为,pH值,R1在 6周后可上升至6.7～7.8,R2在17周内一直低于6.8;渗滤液COD浓度,R1在13周时下降至10?617 mg/L,R2在5周后上升至60?000 mg/L后长期趋于稳定;填埋气累计产量,R1在8周达到44%,R2几乎不产气.衡量稳定化可以分别采用渗滤液pH、COD浓度及BOD₅/COD的减少率、填埋气的累计产率等指标来判断,并据此转换为好氧填埋运行.好氧阶段主要是通过强制通风来减少恶臭和水分,主要试验结果为,通风19d氨气浓度降为1.16 mg/m³,通风23d后恶臭浓度降为19;通风14d后含水率降为26%.完成此阶段的工艺指标值可依据矿化垃圾开采的最终用途确定.对主要试验数据进行了数值模拟.厌氧-好氧填埋过程的微生物演替经RISA分析,有4个优势菌群,一些兼性菌群在厌氧-好氧阶段起着重要的承前启后作用.     

以膨润土为辅助添加剂固化/稳定化污泥的试验研究

针对传统以水泥固化污泥,带来的水泥用量大与固化体的浸出液pH过高等问题,提出了以膨润土为添加剂辅助水泥固化/稳定化污泥的思路.通过开展无侧限抗压强度试验、毒性浸出试验,测量掺入膨润土后污泥固化体的强度、重金属浸出率、浸出液COD及pH值,研究该固化/稳定化方法的效果.结果表明,膨润土的掺入极大地提高了固化体的抗压强度,将掺入量为0.4(相对污泥的质量比)的水泥一半用膨润土替代时,固化体的强度提高了6左右.体积安定性也能够满足要求.随膨润土掺入量增加,固化体中锌、铅的浸出率与浸出液的pH值呈现不断减小的趋势,锌与铅的浸出率分别由6.9%下降至0.25%,9.6%下降至5%,pH值由12.3下降至12.1.在强碱条件下及烘干或风干条件下,铜会随着有机物的分解而析出,从而增加铜的浸出率,而膨润土的加入能弥补水泥造成的强碱环境及风干或烘干过程对固化污泥中铜的稳定产生的不利影响.     

硫酸铵气溶胶对甲苯-NOx-空气体系光化学反应的影响

利用大气模拟烟雾箱,研究了硫酸铵气溶胶对甲苯-NOx-空气体系光化学反应的影响.结果表明,硫酸铵作为气溶胶种子,其存在可以加快反应过程中颗粒物(particle matter,PM)的生成速度,并提高甲苯的气溶胶产率.在高浓度的硫酸铵气溶胶种子条件下,其初始浓度对反应过程中NOx、NO和O3的浓度变化没有明显的影响,但对二次有机气溶胶(secondary organic aemsol,SOA)的生成有显著影响.在硫酸铵气溶胶种子浓度小于160 μg·m-3时,SOA的产率随初始气溶胶种子浓度的增大而增大,从最小7.2%到最大11.7%,其增幅超过60%.     

非点源污染河流的水环境容量估算和分配

通过河流相应集水区内氮磷的各污染源分析(包括农地、畜禽养殖和生活排污等),利用输出系数模型估算各非点源的氮磷投(排)放量和入河量;采用河段氮磷输入-输出平衡关系分析方法,估算河流对氮磷的每月自净量.以此为基础,参照水功能区划所要求的水质目标,提出了水质未超标河段相应集水区的氮磷剩余水环境容量按月估算模型,和水质超标河段相应集水区内氮磷投放削减量的按月估算模型,及其在各污染源之间的分配方案.结果表明,长乐江的总氮和总磷自净量分别达到775.9 t·a^-1和30.9 t·a^-1,自净率分别为28.8%和51.2%.河流对氮磷的自净量不仅受水文生态条件的影响而表现出较大的季节性变化,而且随着污染负荷量本身的增加而提高.按照水功能区划中Ⅲ类水的水质要求,长乐江总氮含量全年超标;各非点源的总氮投(排)放量均须不同程度的削减,削减总量应达到1 581.0　t;氮源削减量分配结果表明,化肥是应削减的最大氮源,要求在河流相应集水区内的化肥氮投放削减量为1 047.4 t·a^-1;而与各种氮源的投排放现状相比,要求削减比例最高的是畜禽养殖的氮排放量,达32.4%.长乐江流域尚有一定的总磷剩余水环境容量(2 335.7 t·a^-1).根据目标水质要求,平水期是各污染源总氮投放需要削减的量最大的时期,丰水期则是总磷剩余水环境容量最小的时期.     

Water-soluble matter in PM2.5 in a coastal city over China: Chemical components, optical properties, and source analysis

Although marine and terrestrial emissions simultaneously affect the formation of atmospheric fine particles in coastal areas, knowledge on the optical properties and sources of water-soluble matter in these areas is still scarce. In this work, taking Qingdao, China as a typical coastal location, the chemical composition of PM_2.5 during winter 2019 was analyzed.Excitation-emission matrix fluorescence spectroscopy was combined with parallel factor analysis model to explain the component...     

Production of new concrete with leather tannery waste used as partial replacement of the natural sand

Journal of Material Cycles and Waste Management - Leather production is a technology that boosts the economy because of its versatility and durability. However, the wastes generated throughout the...     

Face mask and medical waste generation in the City of Baguio,Philippines: its current management and GHG footprint

Journal of Material Cycles and Waste Management - The daily use of facemask to prevent virus transmission increases the negative effect on the environment because of improper waste disposal. Due to...     

Capacity assessment to secure COVID-19 waste treatment in Vietnam

Journal of Material Cycles and Waste Management - The accelerated generation of COVID-19 waste under the Delta-fuelled outbreak placed a sudden burden on waste disposal in Vietnam. To secure the...     

Mineralogical characterization of the Tournemire argillite after in situ interaction with concretes

This study aims to investigate, through mineralogical characterization (SEM, XRD) and mass-balance calculations, the effects of contact time, concrete types and presence of free water on the Tournemire argillite under in situ conditions. Three sampling zones from Excavation Disturbed Zone (EDZ) areas have been chosen: (1) dry contacts, collected at the tunnel masonry/argillite interface (contact time - 125 years), (2) wet contacts, taken close to drained areas below the tunnel roadbed in contact with the canal draining the Cernon fault water (contact time - 15 and 7 years) and at the tunnel masonry/argillite interface over 70 m from the Cernon fault (contact time - 125 years). This study shows that: in the absence of water, no significant modification of argillite is observed after 125 years, except for pyrite dissolution and gypsum precipitation; in the presence of water, precipitation of gypsum, recrystallization of mixed-layer clays, neoformation of zeolites and K-feldspars overgrowths are observed. At the concrete/argillite interface near the Cernon fault, important dolomite neoformation and leaching of chlorite and kaolinite occur. These processes are enhanced with contact time, low flow rate and the nature of the concrete (compound cement Portland CEM II 32.5). Evidence for oxidation processes linked to the EDZ (pyrite oxidation, Fe-oxy-hydroxide and gypsum precipitation) is observed.