Transportation and fate of cationic surfactant in river water

The degradation, sorption, transportation and material balance of cationic surfactants discharged from domestic waste into river water was studied. Ion-pair solid-phase extraction behavior showed that the sorption of cationic surfactants as an ion-pair with anionic surfactant onto river sediment was so strong that little cationic surfactant was found in the bulk water. Cationic surfactant was found in river sediment at more than 500 times higher concentration than that in the bulk water. The degradation of the cationic surfactant was very slow in river water and much slower in the sediment. A material balance of cationic surfactant was estimated for a river running through Toyama City by measuring the flow rate and the concentration of cationic surfactant in the water at several points. It was found that more than 30% of cationic surfactant introduced to the river was lost during the river running through ca. 3 km in 3 h. This reduction probably comes from a quick transfer of the cationic surfactant from river water to sediment and water weed by means of adsorption or precipitation with suspending solids.     

Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

A new device for measuring fluctuations in plant stem diameter: Implications for monitoring plant responses

An electrical device capable of continuously measuring micronsized changes in stem diameter of woody and herbaceous plants is described. Fumigation of sunflowers with automotive exhaust was used to test the ability of the device to detect short-term plant responses.     

The eolian sand problems arising from desertification

Eolian (wind blown) sand constitutes a very serious problem to development in sandy desert lands and causes equally serious problems in lands that are undergoing desertification. In this paper, eolian sand movement due to bulk movement such as sand dune and ripple movement, sand drift by saltation, and sand storms by strong winds are discussed. Associated problems such as eolian sand encroachment on highways, farms, communities and industrial complexes are also discussed and workable solutions are offered. Solutions include chemical stabilization of the surface grains, fences to trap the blown sand and vegetation to prevent soil deflation. Vegetation is emphasized and recommended as the ultimate viable solution to combat desertification and eolian sand problems.     

Indoor concentrations of carbon monoxide in selected urban microenvironments

CO concentrations were measured in five kindergartens, one children's hospital and two homes for aged, practically without indoor sources, all situated in the city centre, for ten random days in winter and ten in summer. The indoor CO concentrations were the result of the distance from and the traffic density in the nearest street, of general pollution level, seasonal differences, day-to-day variations and daily cycle of air pollution, the vicinity of traffic having a dominant influence. Therefore location of institutions for sensitive population groups in old city centres within a block of houses seems to be a suitable solution as far as exposure to CO is concerned.Revised version of a paper presented as poster at the VIth World Congress on Air Quality, Paris 1983.     

Distribution of heavy metals in water and sediments of selected sites of Yamuna river (India)

The concentration of Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, and Zn metals in water and sediments of Yamuna river were determined by atomic absorption spectrophotometry in the year 1981. The data showed that there was considerable variation in the concentration of elements from one sampling station to the other which may be due to the variation in the quality of industrial and sewage wasters being added to the river at different sampling stations. The sediment samples collected from different sampling stations were also analysed for calcium carbonate, organic matter, potassium, and phosphorus.     

Efficient search procedures for extreme pollutant values

Extreme pollutant values are of great interest in water quality monitoring because of their frequent toxicological significance. The principal barrier to the detection of these values, however, is the cost of extensive and comprehensive monitoring. This paper demonstrates an efficient method to determine the maximum sample measurement from a finite set of sequential samples without explicitly testing them all. It is assumed that the process of sample measurement is distinct from collection and has higher costs. It is further assumed that the measurements have high positive autocorrelation.A methodology is presented based on a common industrial testing procedure referred to as composite sampling—the physical pooling or compositing of a set of sequential samples before measurement. A method known as primary first order compositing (PFOC) was found to be superior to the traditional technique of random sampling, particularly if small composite sizes are utilized.The authors are, respectively, operations research analyst, Vancouver, B. C.; Associate Professor and Chairman, Policy Analysis Division, Faculty of Commerce and Business Administration, University of British Columbia; and Associate Professor, Management Science Division, Faculty of Commerce, U.B.C.     

Integration of modeling,monitoring and laboratory observation to determine reasons for air quality violations

An attempt was made to explain ambient air quality violations in the vicinity of industrial plants. Micrometeorology, diffusion calculaations, ambient readings, and plant engineering data are all taken into consideration to ascertain whether the plant is or is not the principal offender.Scrutiny of hi-vol filters using scanning electron microscopy for particle size analysis and particle chemical make-up as an assessment technique is also described.Case histories using the above analytical techniques are discussed.Presented at the 16th National Conference on Energy and the Environment, May 23, 1979