Modelling of Materials Policies

This paper discusses the REAP1 model and its application for the analysis of CO₂ reduction and waste management policies for Japanese petrochemicals. The pros and cons of this modelling approach in comparison to other tools is elaborated. This is followed by a discussion of the model code and the modelling results. The results show that CO₂ policies can have significant impacts on waste flows and waste policies can have significant CO₂ benefits. As a consequence both effects must be considered in policy assessment. Pricing instruments are recommended instead of regulations because of the complex physical relations in the materials life cycle that extend beyond sector boundaries. A taxation approach is superior to a subsidy approach because rebound effects can be avoided.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Seasonal characteristics of haze observed by continuous visibility monitoring in the urban atmosphere of Kwangju, Korea

Continuous visibility monitoring has been carried out inKwangju, Korea since May 1999. The total light extinctioncoefficient b _ext measured by a transmissometer andreveals seasonal trends in urban visual air quality,especially under hazy conditions with a visual range of lessthan 15 km. Seasonal atmospheric visibility under lowrelative humidity during the winter was observed to be betterthan during any other seasons. Summertime visibility wasseverely degraded due to highly increased light scattering byhygroscopic particles under high humidity atmosphericconditions. Visibility during spring and fall was alsomoderate. However, yellow sand in spring caused the lowestvisibility conditions over the measurement area for a fewdays. With continuous monitoring using the transmissometer,the daily average seasonal visual range was measured to be13.1, 9.2, 11.0, and 13.9 km in spring, summer, falland winter, respectively. Under the atmospheric humiditycondition less than 60%, visual range was observed tobe 16.1, 13.9, 15.1, and 16.6 km in spring, summer,fall, and winter, respectively. The mean light extinctionbudget by sulfate and nitrate aerosols was determined to bethe highest value of 63.71% during the summer and thelowest value of 27.08% during spring. During the `yellow sand dust' period, a mean light extinction budget by soil particles was estimated to be at an unusually high value of 44.22%.     

Soil Lead and Other Metal Levels in Industrial, Residential and Nature Reserve Areas in Singapore

The use of pressure feedback microwave digestion technique has permitted rapid and efficient digestion of soil and sediment samples. The evaluation of different acid mixtures to digest soil samples were studied by mixed-level orthogonal array design. The selected acid mixture of HCl-HNO3-HF was employed in the survey of Pb, Zn, Cu, Cr and Mn in soil samples. Surface soil samples were collected from industrial, residential and nature reserve areas in Singapore. The five metal concentrations were determined by flame atomic absorption spectrometry and graphite furnace atomic absorption spectrometry. The lead and other metal contents in NBS SRM 1645, NIES CRM No. 2 and NRCC BCSS-1 sediment standard references were determined concurrently with the survey samples. Five measured metal loading on the surface soils was in the order: industrial area > residential area > nature reserve area. The trace metal concentrations in surface soil from areas of heavy traffic are higher than those from residential areas. The main sources of trace metal pollution are vehicular exhaust and industrial activities.     

Modeling photocatalytic destruction of the organic contaminants in continuous stir flow reactor

Thin-film technique is becoming an industry standard for the preparation of TiO₂-based photocatalyst for organic destruction. The catalyst provides several advantages over the conventional powder TiO₂ in the treatment of wastewater and groundwater. In this study, a continuous stir flow reactor model is developed capable of describing the photocatalytic process. The model incorporates the following fundamental mechanisms: adsorption, diffusion, liquid-film transfer, UV attenuation, and photocatalytic reaction. All of the simulation results indicate that there exists a highly nonlinear relation between each of these parameters and the destruction rate. Various incident light intensities also are incorporated to simulate the energy efficiency. The simulations illustrate that the photocatalytic model can be used to elucidate the effect of process variables. It is also possible to “custom-design” a catalyst for the treatment of a particular waste stream.     

Adsorption characteristics of a phenoxy acetic acid herbicide on activated carbon

The adsorption of 2,4-dichlorophenoxyacetic acid (2,4-D) by two powdered coal activated carbons was studied in aqueous solution. The modelling of the adsorption equilibrium showed that the adsorption of 2,4-D fitted a Langmuir isotherm. Adsorption was influenced by the activated carbon type, adsorbent concentration and solution characteristics. The adsorption was found to decrease with an increase in pH over the range 1.5-9. Maximum adsorption occurred at pH approximately 2.5, which corresponds to the 2,4-D pKa value. The amount of 2,4-D adsorbed was also found to depend on the NaCl concentration.     

Performance evaluation of a sorbent tube sampling method using short path thermal desorption for volatile organic compounds

Air sampling, using sorbents, thermal desorption and gas chromatography, is a versatile method for identifying and quantifying trace levels of volatile organic compounds (VOCs). Thermal desorption can provide high sensitivity, appropropriate choices of sorbents and method parameters can accommodate a wide range of compounds and high humidity, and automated short-path systems can minimize artifacts, losses and carry-over effects. This study evaluates the performance of a short-path thermal desorption method for 77 VOCs using laboratory and field tests and a dual sorbent system (Tenax GR, Carbosieve SIII). Laboratory tests showed that the method requirements for ambient air sampling were easily achieved for most compounds, e.g., using the average and standard deviation across target compounds, blank emissions were < or = 0.3 ng per sorbent tube for all target compounds except benzene, toluene and phenol; the method detection limit was 0.05 +/- 0.08 ppb, reproducibility was 12 +/- 6%, linearity, as the relative standard deviation of relative response factors, was 16 +/- 9%, desorption efficiency was 99 +/- 28%, samples stored for 1-6 weeks had recoveries of 87 +/- 9%, and high humidity samples had recoveries of 102 +/- 12%. Due to sorbent, column and detector characteristics, performance was somewhat poorer for phenol groups, ketones, and nitrogen containing compounds. The laboratory results were confirmed in an analysis of replicate samples collected in two field studies that sampled ambient air along roadways and indoor air in a large office building. Replicates collected under field conditions demonstrated good agreement except for very low concentrations or large (> 41 volume) samples of high humidity air. Overall, the method provides excellent performance and satisfactory throughput for many applications.     

铁路运输业污水治理系统分析

研究了乌鲁木剂铁路局系统污水治理污染控制方法及途径，提出了主要污染物为石油类，其最佳治理对策是：确定重点污染单位、污染源、用最低的治理投入，选择斜板隔油气浮工艺治理重点污染和次重点污染部门，得到较好的治理效果，否定盲目追求“零排放”的高投入方案。     

Application of PCR and probe hybridization techniques in detection of airborne fungal spores in environmental samples

Specific PCR amplification and probe hybridization techniques were applied to examine the compositions of airborne fungi in samples from three different environments. The results from microscopic and CFU counting were compared to those of the molecular-based detections. The detection sensitivity for PCR amplifications was 9 to 73 spores and 1.3 to 19.3 CFUs per PCR reaction. The hybridization detection limit was 2 to 4 spores and 0.2 to 1.2 CFU. The hybridization method was more sensitive than PCR amplification and showed less variation among samples. Using specific PCR primers and probes we identified the presence of several fungal groups and species in the air samples. Specific detections through probe hybridization to PCR products amplified with universal or group-specific fungal primers have promising applications in the examination of air samples for environmental monitoring.     

Assessing land use impacts on flood processes in complex terrain by using GIS and modeling approach

A distributed hydrologic modeling and GIS approach is applied for the assessment of land use impact in the Steinsel sub-basin, Alzette, Grand-Duchy of Luxembourg. The assessment focuses on the runoff contributions from different land use classes and the potential impact of land use changes on runoff generation. The results show that the direct runoff from urban areas is dominant for a flood event compared with runoff from other land use areas in this catchment, and tends to increase for small floods and for the dry season floods, whereas the interflow from forested, pasture and agricultural field areas contributes to the recession flow. Significant variations in flood volume, peak discharge, time to the peak, etc., are found from the model simulation based on the three hypothetical land use change scenarios.