Visible light responsive N-F-codoped TiO2 photocatalysts for the degradation of 4-chlorophenol

Visible light responsive N-F-codoped TiO₂ photocatalysts exhibit a higher catalytic activity than N-doped TiO₂ for the degradation of 4-chlorophenol due to the synergistic effect of nonmetal elements.     

Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

Decolorization of dye solutions with Ruditapes philippinarum conglutination mud and the isolated bacteria

Application of Ruditapes Philippinarum conglutination mud (RPM) for decolorizing synthetic dye solutions was studied. RPM showed good activity for decolorization of Methylene Blue, Crystal Violet, Malachite Green, and Ink Blue. The amount of the RPM had great effect on the decoloration rate of the dye solutions. However, the decoloration rate did not continue to increase when the amount of mud exceeded the optimum dose. The temperature of the dye solution had a remarkable effect on the decolorization rate of Ink Blue solution, but had little effect on the other three dye solutions. The initial pH of the dye solutions evidently affected the decolorization rate of Malachite Green solution, but had less effect on the other three. The decolorization rate of the dye solutions increased significantly with treatment time within 8 hr, but tended to be steady after 8 hr for Methylene Blue, Crystal Violet and Malachite Green solutions, and after 12 hr for Ink Blue solution. The decolorization efficiencies for the four dye solutions under the optimum conditions were all above 90%. Seventeen strains screened from RPM showed flocculation ability for kaolin clay suspension. Out of them, the flocculation rate of strain ZHT3-9 and strain ZHT4-13 were up to 88.14% and 86.01%, respectively. ZHT3-9 was studied, and its decolorization rate for Methylene Blue, Crystal Violet, and Malachite Green reached 90.02%, 89.21%, and 80.29%, respectively. By morphological, physiological and biochemical characteristics analysis and 16S rRNA sequencing, the strain ZHT3-9 was identified as Arthrobacter sp.     

Cadmium removal from wastewater by sponge iron sphere prepared by hydrogen reduction

A new type of sponge iron sphere (NSIS) with 1-5 mm diameter, made of concentrated iron powder and possessed high activity and intension, was prepared by mini-pellet sintering integrated with H₂ direct reduction. Static state experiment has been carried on to investigate the Cd²⁺ removal efficiency from wastewater by the NSIS and to explore the Cd²⁺ removal reaction kinetics. It was suggested that initial pH value and Cd²⁺ original concentration had significant influence on Cd²⁺ removal percentage. Cd²⁺ removal percentage decreased significantly with the increasing of Cd²⁺original concentration whether the original pH value be adjusted to 3.0 or without adjustment. The results showed that the Cd²⁺ removal process followed the first order reaction because the reaction order was from 0.803 to 0.996. The apparent reaction rate constant between Cd²⁺ and NSIS was from 0.0025 to 0.1000 (mg·L^?1)^1-n·min^?1. Compared with SIS reduced by charcoal reduction, NSIS deoxided by hydrogen possessed higher activity, and could remove the same quantity of Cd²⁺ within a shorter period of time.     

小型燃煤工业锅炉NO_x形成与释放规律模拟研究

NOx是我国十二五期间重点控制的污染物,燃煤工业锅炉是其重要来源。为了研究燃煤工业锅炉NOx的形成与释放规律,在实验室模拟了不同煤种的燃烧过程。采用原煤/焦炭燃烧法分别研究挥发分氮和焦炭氮生成NOx的反应,探讨燃料型NOx的形成与释放规律,并解释试验模拟条件下燃煤NOx产污系数和现场实测值的差异。结果表明,试验中烟煤、无烟煤、煤焦的NO转化率平均值分别为25.77%,22.17%和11.98%,产污系数平均值分别为4.31,5.08和2.00kg/t,高于现场实测结果核算值。燃煤工业锅炉NOx以燃料型为主,燃料型NOx的形成和释放是一个复杂的多相反应过程,由挥发分氮的氧化还原反应和焦炭氮的氧化还原反应组成,煤种、温度、空气流量、粒径、氧含量等因素对4种反应各自影响及影响程度并不相同。     

化学品测试合格实验室体系建设与发展

根据《新化学物质环境管理办法》要求,为新化学物质申报目的提供测试数据的境内测试机构,应当为环境保护部公告的化学物质测试机构,并接受环境保护部的监督和检查。拟通过借鉴国际合格实验室规范(GLP)基本原则和国内其他GLP认证工作经验做法,结合环境保护部已开展的检查考核工作和化学品测试实验室实际情况,探讨化学品测试合格实验室的管理现状和存在的问题,旨在为推动我国化学品测试合格实验室体系建设提供新的管理思路。     

无砾石微孔管地下渗滤系统试验研究

针对传统无砾石管式地下渗滤系统存在的处理性能差,渗滤通量低两个问题,通过去掉包裹织物,提高渗滤管开孔率、改变开孔方式,设计了无砾石微孔管地下渗滤系统。通过实验研究表明,无砾石微孔管地下渗滤系统对COD、氨氮的去除率比传统管式系统分别提高了10.8%、12.7%,总磷去除率并无显著差异,ORP值提高约85 mV,渗滤通量提高26.8%。在3.3 cm/d的水力负荷下,无砾石微孔管地下渗滤系统出水COD、氨氮、总磷平均浓度分别为19 mg/L,0.62 mg/L,0.048 mg/L。渗滤管下10 cm的土壤层去除了约70%的COD,80%的氨氮和91%的总磷,向下随着土壤深度的增加,单位厚度的土壤层去除的污染物量呈显著下降趋势。     

交通拥堵对TSP排放的影响分析

在上海市杨浦区军工路部分路段采集TSP浓度、气压、温度、分车型车流量、区段车速、信号配时等数据,通过多元回归方法分析小型车交通量,大型车交通量,拖挂车交通量及区段车速对TSP浓度的影响,建立起TSP浓度与上述交通变量的函数关系,并通过AIMSUN交通仿真软件以及基础采集数据,建立军工路路网,模拟四种交通拥堵状况(重度拥堵,中度拥堵,轻度拥堵,基本畅通)的产生和消散过程。综合分析路段交通拥堵对道路TSP排放和分布的影响。分析整理得出道路TSP小时排放总量和拥堵程度成正比关系,且TSP污染主要集中在车辆拥挤怠速的部分,车辆拥挤排队的队尾部分是TSP排放源强最高、源强增长最快的区域,增长率达到240%～290%。     

提高煤层气采收率的CO2埋存技术

作为常规油气重要接替补充的非常规天然气,煤层气越来越受到世人的关注.如何提高煤层气采收率是摆在煤层气开发工程师面前迫切需要解决的技术难题.通过向煤层中注入CO2,既可以提高煤层气采收率又能间接地实现CO2减排,即提高煤层气采收率的CO2埋存技术(CO2-ECBM).该项技术已在世界各地迅速发展,并取得一些实质性进展.文...