秸秆焚烧对北京市空气质量的影响

用火焰原子吸收光谱法测试了北京市两个采样点 1 #站 (十三陵站 ,清洁对照点 )和 5#站 (天坛站 ,居民生活区 )1 1 0个大气颗粒物样品中的水溶性钾 ,以表征秸秆焚烧颗粒物。 1 #站水溶性钾的质量浓度年均值为 1 .2 1 μg/m3,其中以1 998年 6月份浓度 (3 .0 7μg/m3)最高 ,是 5月份 (1 .0 2μg/m3)的 3倍 ;5#站水溶性钾的质量浓度年均值为 1 .94μg/m3,6月份 (4 .2 2 μg/m3)最高 ,是 5月份 (1 .97μg/m3)的 2 .1倍。数据分析结果表明 1 998年 6月份麦收季节存在以秸秆焚烧为主的生物质燃烧现象 ,使大气颗粒物中有机碳浓度水平升高 ,并对北京市的空气质量带来负面影响     

青岛市降水中的铅及其变化规律

对青岛市四个站位 1 997年 1 1月～ 1 998年 1 0月 33次降水中铅浓度进行了监测 ,降水中铅浓度在 <0 .5～2 7.7μg/ L之间 ,均值为 4 .2μg/ L,降雪高于降雨。讨论了 p H、交通和季节对铅浓度变化的影响 ,并与其它城市地区降水中铅进行了比较     

环境空气中VOC s 的监测技术新进展

大气中的挥发性有机物(VOCs)严重威胁着人类的健康,目前对它的监测技术的研究越来越多.文章综述了近年来国内外在VOCs的采样及测试技术上的进展,重点介绍了固相微萃取、罐取样、吸附法等采样技术以及以气相色谱法为主的分析方法,并对一些非色谱法的分析技术进行了简单介绍.     

南京市城市典型道路交通噪声控制措施效果初探

针对南京市典型道路的交通噪声控制措施,分别选取低噪声路面、声屏障、隔声窗3种噪声控制措施进行监测,监测显示低噪声路面对整体声级降噪有限,声屏障对于1kHz倍频带以上的中高频隔声相对较好,真空玻璃隔声窗能对低频噪声有显著改善。     

广州市居民家庭室内灰尘中传统和新型阻燃剂与塑化剂的污染特征及健康风险评估

近年来,随着阻燃剂多溴联苯醚(PBDEs)和以邻苯二甲酸酯(PAEs)为代表的传统型塑化剂(LPs)的逐步禁用或限用,有机磷系阻燃剂(PFRs)等新型阻燃剂及替代型塑化剂(APs)的生产和使用呈逐年增长的趋势,其环境污染特征和人体暴露健康风险值得引起广泛关注.目前,灰尘已广泛用于室内环境中PBDEs、PFRs和LPs等半挥发性有机污染物(SVOCs)的污染特征评估,而关于室内灰尘中APs的污染特征则鲜有报道.本研究以广州市42户普通居民家庭为研究对象,采集家庭室内灰尘并分析了PFRs、PBDEs、LPs和APs的含量及组成特征.结果表明,PFRs、PBDEs、LPs和APs在室内灰尘中均有广泛检出,其含量分别为593.28～11531.56、13.45～27029.13、40494.83～1154497.16和15365.19～1013352.51 ng·g^-1.大多数家庭中,PFRs和部分APs在灰尘中的含量呈现高于PBDEs和LPs的特征,PFRs和APs等新型污染物的人体暴露健康风险需引起高度关注.采用暴露模型评估人体经灰尘摄入和皮肤接触对目标污染物的日均暴...     

磷酸三(1,3-二氯-2-丙基)酯导致小鼠神经毒性结局的潜在靶点研究

磷酸三(1,3-二氯-2-丙基)酯(TDCPP)在环境介质及生物样本中被广泛检出,为探究TDCPP的潜在神经毒性以及作用机制,以C57BL/6小鼠为动物模型,考察经300 mg·kg-1·d-1的TDCPP持续染毒35 d后,小鼠大脑皮层神经功能相关因子及血清代谢组学的变化.结果显示,小鼠在TDCPP染毒35 d后,大...     

某卷烟厂除尘系统管道撕裂原因分析及解决措施

对除尘系统管道撕裂的原因进行分析,认为除尘器出口处的涡流和二次流造成的管道振动是导致管道撕裂的主要原因。结合实际情况提出了解决措施,预期取得较好的效果。     

矿区环境污染现状及防控对策——以煤矿为视角

随着城市化进程的加快,能源资源的需求呈逐年递增态势,由此引发的环境问题日趋突出.生态破坏、环境污染已成为制约经济社会发展的一个重要因素.煤炭的开采和加工所产生的大量废矸石、废气、废水给周边生态环境产生严重影响,及时掌握矿区环境污染现状,采取行之有效的防治措施,具有极其重要的现实意义.     

Mercury pollution in a mining area of Guizhou,China: Fluxes over contaminated surfaces and concentrations in air,biological and geological samples

A dynamic flux chamber has been used to estimate fluxes of mercury over different types of surfaces in an abandoned open‐cut mine of Tongren prefecture, Guizhou province, China during spring and summer of 1996. The highest fluxes were obtained over cinnabar slag and contaminated soils, whereas the emissions above cinnabar ore were substantially lower. These fluxes was scaled up to estimate the contribution of mercury emissions to air from mercury wastes, compared to anthropogenic activities in the province of Guizhou, China. Atmospheric mercury concentrations measured were enhanced in the mining area (<1.3 μg m^‐3) compared to regional background sites (1.8–5.1 ng m^‐3). The spreading of mercury was estimated by using biological and geological samples. Moss bags have been employed to estimate long‐time dry‐ and wet‐deposition to this area.     

Optimization of hydrogen distribution systems with pressure constraints

Hydrogenation units are often operated at high pressure, requiring the use of compressors which are one of the most expensive chemical processing equipment. Optimizing a hydrogen network should therefore take into consideration not only purity and flowrate constraints but also pressure requirements. In this paper, based on the hydrogen surplus diagram approach, the average pressure profiles of hydrogen sources and sinks are proposed through the introduction of a system’s minimum pressure drop Δp. Combined with the traditional purity profiles, whether a source can meet a sink either for hydrogen concentration or for pressure requirements can be determined intuitively. In cases where the pressure of a source is not sufficient for a sink, installing a hydrogen compressor or using another source with higher purity and pressure could be potential solutions. A cost equation is established to determine which of the two solutions is economically more viable. For different matching situations between sources and sinks, strategies for optimum placement of compression equipment within a given hydrogen network are proposed. A case study is used to illustrate the application and effectiveness of the proposed method.