The study of distribution and fate of nitrobenzene in a water/sediment microcosm

In November 2005, an explosion occurred at a petrochemical plant of the Jilin Petrochemical Corporation in Jilin Province, China. A nearby water body was seriously polluted with a large spill of toxic substances made up of a mixture of benzene, aniline, and nitrobenzene (NB). To understand the long term impact of NB on public health and ecosystem around the Songhua River, it was necessary to investigate its fate in the environment. In this study, a microcosm was used to mimic the polluted water system and to study the transport and fate of NB in the river water body. The volatility and biodegradation of NB was investigated and a Markov model was applied to predict the fate of NB in the environment. The simulated results matched very well with the results obtained from the microcosm experiment. The model indicated that at room temperature and after around 500 h, there was only residual NB in the water and sediment. Most of the NB (around 82%) evaporated into the air and 18% was degraded by microorganisms.     

Non-aromatic hydrocarbons in surface sediments near the Pearl River estuary in the South China Sea

Surface sediment samples at 4 sites along an offshore transect from outer continental shelf off the Pearl River estuary to the shelf slope region of the northern South China Sea, have been analyzed for total organic carbon (TOC), total nitrogen (TN), solvent extractable organic matter (EOM) and non-aromatic hydrocarbons. TOC, TN and EOM show distinct spatial variations. Their highest values are all recorded at the shelf slope region. EOM varies from 18.70-38.58 microgg(-1) dry sediment and accounts for 0.20-0.72% of the TOC contents. The non-aromatic hydrocarbons are an important fraction of EOM. Their contents range from 3.43-7.06 microgg(-1) dry sediment. n-Alkanes with carbon number ranging from 15-38 are identified. They derive from both biogenic and petrogenic sources in different proportions. Results of isoprenoid hydrocarbons, hopanes and steranes also suggest possible petroleum contamination.     

污泥龄对LSP & PNR污泥减量新工艺运行效能的影响

通过研究分析污泥龄(SRT)对富磷污水除磷的LSP&PNR污泥减量新工艺运行效果的影响,结果发现,延长污泥龄有利于提高系统的厌氧释磷能力,但不影响其总的除磷率,同时磷的回收比例增大,当SRT=50 d时,磷回收率取得最大值70.4%;LSP&PNR系统污泥龄增加,还有利于污泥产率的降低.试验还发现,排富磷污水除磷的长污泥龄LSP&PNR系统的除磷效率与污泥产率之间不存在制约关系,即系统可以同时获得优异的污泥减量与生物除磷效果,当SRT=50 d时,每降解1 kg COD仅产生0.143 kg污泥,而除磷率达最高值92.8%;LSP&PNR系统中SRT、DO与SVI之间存在一定的相关性,在供氧充足(DO=0.8～1.5 mg/L)条件下,SRT增加,SVI越高,但对于SRT为50 d的LSP&PNR系统,稳定运行时没有污泥膨胀之虞.     

Histopathological changes in zebrafish embryos exposed to DLPCBs extract from Zhanjiang coastal sediment

Dioxin-like polychlorinated biphenyls (DLPCBs) are ubiquitous persistent pollutants that cause adverse effects in many environmental organisms. DLPCBs in marine sediments can be absorbed by benthic organisms, bioaccumulate, and biomagnify through the food chain and threaten animal and human health. There are no reports of DLPCBs concentrations in the Zhanjiang Gulf seabed. This study was designed to investigate the concentration of DLPCBs in the Zhanjiang coastal sediment and histopathological changes in zebrafish (Diano rerio) embryos exposed to environmentally relevant concentrations of DLPCBs. Of the five sites selected, two sites TS and JSW contained DLPCBs at concentrations of 0.08 and 22.54 ng/g dry sediment, respectively. Two groups of zebrafish embryos were used. One group was exposed to 3.75, 7.5, 15, 30, and 60 mg/ml of DLPCBs extracted from the sediments sampled from the TS site and the second group to 4.375, 8.75, 17.5, 35, and 70 mg/ml of DLPCBs from JSW site from 0.75 h post-fertilization (hpf) to 96 hpf. The zebrafish exposed to 60 and 70 mg/ml of DLPCBs at 96 hpf displayed gross histopathological changes with cardiac lesions including pericardial edema being the most deleterious. Other changes observed were hydropic degeneration of gill filaments and hepatocytes, loss of intestinal folds, and uninflated swim bladder. It appears that only a few sites of the Zhanjiang gulf are contaminated with DLPCBs. This is the first report of histopathological changes in the gills, hepatocytes, intestines, heart, and the swim bladder in zebrafish embryos exposed to DLPCBs from a coastal sediment. Further studies with sampling at different stages of development are required to identify which organ/tissue is most sensitive to DLPCBs.     

Effects of pig manure containing copper and zinc on microbial community assessed via phospholipids in soils

Pig manure (PM) is widely used as an organic fertilizer to increase yields of crops. Excessive application of compost containing relatively great concentrations of copper (Cu) and zinc (Zn) can change soil quality. To clarify the effects of different rates of application and to determine the optimal rate of fertilization, PM containing 1,115 mg Cu kg^?1, dry mass (dm) and 1,497 mg Zn kg^?1, dm was applied to alkaline soil at rates of 0, 11, 22, 44, 88, and 222 g PM kg^?1, dm. Phospholipid fatty acids (PLFAs) were used to assess soil microbial community composition. Application of PM resulted in greater concentrations of total nitrogen (TN), NH₄ ⁺-N, NO₃ ^?-N, total carbon (TC), soil organic matter (SOM) but lesser pH values. Soils with application rates of 88–222 g PM kg^?1, dm had concentrations of total and EDTA-extractable Cu and Zn significantly greater than those in soil without PM, and concentrations of T-Cu and T-Zn in these amended soils exceeded maximum limits set by standards in china. Except in the soil with a rate of 11 g PM kg^?1, dm, total bacterial and fungal PLFAs were directly proportional to rate of application of PM. Biomasses of bacteria and fungi were significantly greater in soils with application rates of 44–222 g PM kg^?1, dm than in the soil without PM. SOM, TC and EDTA-Zn had the most direct influence on soil microbial communities. To improve fertility of soils and maintain quality of soil, rate of application should be 22–44 g PM kg^?1 dm, soil containing Cu and Zn.     

Characteristics and assessment of phthalate esters in urban dusts in Guangzhou city, China

Phthalate esters (PAEs) were examined in indoor and outdoor dust samples from the subtropical city of Guangzhou, China. The ∑(16)PAEs concentrations ranged from 121 to 3,223 μg g(-1) dust, with the median concentration of 840 μg g(-1) dust. Significantly higher concentrations of PAEs in dust samples were found in offices where electrical and electronic devices, carpet pads, and office furniture were widely used. Of the 16 PAEs, diisobutyl phthalate (DiBP), di-n-butyl phthalate (DnBP), and di(2-ethylhexyl) phthalate (DEHP) dominated the PAEs in indoor and outdoor dust samples, and accounted for >96.8% and >93.1% of the ∑(16)PAEs concentrations, respectively. The median daily inhalation exposure of ∑(16)PAEs were 3.53 and 0.247 μg kg(-1) body weight day(-1), and at the 95(th) percentile were 7.62 and 0.530 μg kg(-1) body weight day(-1), up on the measured concentrations and estimated dust ingestion rates, respectively, for toddles and adults. The ubiquitous distribution of PAEs as noted in this study suggests the need for detailed assessment of PAEs concentrations using more sites and to further investigate the factors influencing PAEs exposure in China.     

Differences in the Spatial Distribution and Chemical Composition of PM10 Between the UK and Poland

The Fine Resolution Atmospheric Multi-pollutant Exchange Model was used to calculate the spatial distribution and chemical composition of PM₁₀ concentrations for two geographically remote countries in Europe—the UK and Poland—for the year 2007. These countries are diverse in terms of pollutant emissions as well as climate conditions. Information on the contribution of natural and anthropogenic as well as national and imported particles in total PM₁₀ concentrations in both countries is presented. The paper shows that the modelled national annual average PM₁₀ concentrations, calculated for the entire country area, are similar for the UK and Poland and close to 12 μg m^?3. Secondary inorganic aerosols dominate the total PM₁₀ concentrations in Poland. Primary particulate matter has the greatest contribution to total PM₁₀ in the UK, with large contribution of base cations. Anthropogenic sources predominate (81 %) in total PM₁₀ concentrations in Poland, whereas natural prevail in the UK—hence, the future reduction of PM₁₀ air concentrations by emissions reduction could be more difficult in the UK than in Poland.     

Dynamics of the lakes in the middle and lower reaches of the Yangtze River basin, China, since late nineteenth century

The middle and lower reaches of the Yangtze River basin have the most representative and largest concentration of freshwater lakes in China. However, the size and number of these lakes have changed considerably over the past century due to the natural and anthropogenic impact. The lakes, larger than 10 km² in size, were chosen from relief maps and remotely sensed images in 1875, 1950, 1970, 1990, 2000, and 2008 to study the dynamics of lakes in the middle and lower reaches of the Yangtze River basin and to examine the causes and consequences of these changes. Results indicated that there was a dramatic reduction in lake areas, which decreased by 7,841.2 km² (42.64 %) during the study period (1875–2008), and the number of lakes in this region changed moderately. Meanwhile, a large number of lakes in the middle and lower reaches of the Yangtze River basin were directly converted into paddy fields, ponds, building lands, or other land-use types over the study period. Therefore, all kinds of lake reclamation should be identified as the major driving factors for the loss of lake in this region. Furthermore, flooding, soil erosion, and sedimentation were also the main factors which triggered lake changes in different periods. Some wetland conservation and restoration projects have been implemented since the 1970s, but they have not reversed the lake degradation. These findings were of great importance to managers involved in making policy for the conservation of lake ecosystems and the utilization of lake resources.     

Honeybees (<Emphasis Type="Italic">Apis mellifera</Emphasis>) as a biological barrier for contamination of honey by environmental toxic metals

The aim of the study was to investigate the transfer of toxic metals from honeybee workers (Apis mellifera L.) to bee honey in relation to the ecological state of the environment. The materials of the study consisted of samples of honeybee bodies and varietal honeys taken from the same apiary located in three areas: R1—urbanized (16), R2—ecologically clean (16) and R3—industrialized (15) of south-eastern Poland. The contents of 14 elements in all tested samples, including toxic metals (Cd, Pb, Hg, Al, Ni, Tl) as well as bioelements (K, Mg, Ca, Mn, Fe, Zn, Cu, Se), were analysed by the ICP-OES method with prior microwave mineralization. The concentrations of the majority of the studied elements, excluding aluminum and lead, were significantly higher in bee bodies than in honey samples (P?<?0.05). The pollution of bee bodies by toxic metals was dependent on the environmental cleanliness, and the most pollution was observed in the industrialized area. The bee body was the most effective barrier for Cd and Tl transfer to the honey, while the level of Ni was similar in both tested materials. The Al concentration was significantly higher in honey than bee bodies (14.81?±?24.69 and 6.51?±?5.83 mg kg^?1, respectively), which suggests the possibility of secondary contamination of honey. The greatest sensitivity to heavy metal pollution was observed in honeydew honey compared to nectar honeys (P?<?0.05). It was proved for the first time that bees work as biofilters for toxic metals and prevent honey contamination.     

Sb release characteristics of the solid waste produced in antimony mining smelting process

Sb release characteristics of blast furnace slag, mining waste rock and tailing sand were investigated in static immersion and dynamic leaching test. These three kinds of waste samples were collected from the antimony mine in Lengshuijiang, China, produced in mining smelting process. Effects of solid/liquid ratio, sample size and pH of leaching solution on Sb release characteristics were inspected based on the analysis of scanning electron microscope, pH and EC of leachate. The optimal parameters for Sb leaching of each sample were analyzed. For blast furnace slag and mining waste rock, Sb release contents increased along with the decline of solid/liquid ratio. The maximum accumulative release contents were 42.13, 34.26 mg/kg at the solid/liquid ratio of 1:20. While Sb release content for tailing sand decreased first and then increased with the reduction of solid/liquid ratio. When the solid/liquid ratio was 1:5, the accumulative Sb release content reached the most (24.30 mg/kg). Sb release content of mining waste rock increased with the drop of leaching solution pH, with the highest accumulative release content of 26.01 mg/kg at pH 2.0. Sb release contents of blast furnace slag and tailing sand showed positive correlation with the variation of leaching solution pH. The maximum accumulative release contents of these two samples were 215.91 and 147.83 mg/kg, respectively, when leaching solution pH was 7.0. In summary, Sb release capacity of the three samples in descending order was tailing sand, blast furnace slag and mining waste rock. pH and EC of the leachate in dynamic test varied independently with the initial pH of leaching solution while showing close relationship with mineral hydrolysis in the waste.