Adsorption performance of CMK-3 and C-FDU-15 in NO removal at low temperature

CMK-3 and C-FDU-15 samples were synthesized using hard-templating and evaporationinduced self-assembly(EISA) methods,respectively.The pore structures of CMK-3 and CFDU-15 as well as commercial activated carbon were characterized by means of X-ray diffraction,field emission scanning electron microscopy,transmission electron microscopy,and N_2 adsorption–desorption.Adsorption of NO was investigated by means of thermogravimetric analysis,temperature-programmed desorption of NO + O_2,and in situ diffuse reflectance Fourier transform infrared spectroscopy.The results show that the CMK-3 and C-FDU-15 materials possessed ordered and uniform structures.The coadsorption capacity of NO and O_2 decreased in the sequence CMK-3(88.6 mg/g) C-FDU-15(71.7 mg/g) AC(25.3 mg/g).There were two main adsorption species on CMK-3 and CFDU-15:nitrite and nitrate.Nitrite is converted to nitrate easily.However,the adsorption species were more complex on AC,with nitrite being the main species.Moreover,CMK-3 and C-FDU-15 exhibit excellent regeneration efficiency compared with AC.The excellent NO adsorption performance of CMK-3 and C-FDU-15 was associated with their ordered mesoporous structures and high surface areas.The research provides more options for NO adsorption in the future.     

Effects of metal cations on sorption-desorption of p-nitrophenol onto wheat ash

The mutual e ects of metal cations (Cu2+, Pb2+, Zn2+, and Cd2+) and p-nitrophenol (NP) on their adsorption desorption behavior onto wheat ash were studied. Results suggested that Cu2+, Pb2+, and Zn2+ diminished the adsorption and increased the desorption of NP remarkably, while Cd2+ had no such e ect. In contrast, NP diminished the adsorption of Cu2+, Pb2+, and Zn2+ onto ash, however, this suppression e ect depended on the initial concentrations of metal cations. NP had no e ect on Cd2+ adsorption on ash. Fourier transform infrared (FT-IR) and X-ray absorption spectroscopic (XAS) studies suggested the following mechanisms responsible for the metal suppression e ect on NP adsorption: (1) large hydrated Cu2+, Pb2+, and Zn2+ shells occupied the surface of ash and prevent nonspecific adsorption of NP onto ash surface; (2) Cu2+, Pb2+, and Zn2+ may block the micropores of ash, resulting in decreased adsorption of NP; (3) complexation of Cu2+, Pb2+, and Zn2+ was likely via carboxyl, hydroxylic and phenolic groups of wheat ash and these same groups may also react with NP during adsorption. As a “soft acid”, Cd2+ is less e cient in the complexation of oxygencontaining acid groups than Cu2+, Pb2+, and Zn2+. Thus, Cd2+ had no e ect on the adsorption of NP on wheat ash.     

加热和亚铁离子活化过硫酸钠氧化降解4-CP的研究

通过加热和亚铁离子2种方法活化过硫酸钠产生强氧化性的硫酸根自由基,利用硫酸根自由基氧化难降解有机污染物.以对氯苯酚(4-CP)为目标污染物,研究了温度、pH值、亚铁离子浓度、过硫酸钠浓度、柠檬酸浓度对4-CP降解率的影响.结果表明,升高温度可以显著地提高4-CP降解率.反应4h后,在30℃,4-CP降解率只有2.5%;在50℃,4-CP降解率能够达到43.5%;而在60℃,4-CP降解率为100%.pH值对4-CP降解率的影响较大,依次为pH4.0pH7.0pH10.0.在室温下,亚铁离子是促使4-CP降解的必要条件,并且对反应条件进行了优化,分子探针实验证实了硫酸根自由基的存在.在过硫酸钠/亚铁离子体系加入适量的柠檬酸能够有效利用溶液中的亚铁离子,在等量的过硫酸钠存在条件下,常温下过硫酸钠/亚铁离子/柠檬酸体系对4-CP降解率为50.9%,优于50℃下过硫酸钠体系对4-CP降解率43.5%.     

废旧锌锰电池锌锰元素的分析表征

为了解废旧锌锰电池的锌锰元素特征,以废旧碱性(A-A)和酸性(Zn-C)电池为研究对象,采用化学分析、BCR连续萃取技术、SEM-EDS和XRD等手段对拆分的电池正、负电极材料中的锌锰元素进行了分析表征.实验表明:废旧碱性(A-A)电池中Mn、Zn分别占到正极材料质量的49.2%、10.3%,以Zn Mn2O4四方体锌锰矿结构晶体存在;Zn占负极材料的52.5%,以Zn O晶体存在;废旧酸性(Zn-C)电池混合电解质中,Mn、Zn各占41.8%和25.2%,分别以Zn Mn2O4、Mn O2、Zn5(OH)8Cl2·H2O和Zn(NH3)2Cl2等晶体存在.BCR处理结果显示,A-A电池正极和Zn-C电池混合电解质中,Mn主要为残渣态较难酸释,而A-A电池负极中的Zn易于回收.     

鲅鱼乙酰胆碱酯酶对海水甲基对硫磷的响应条件研究

动物体内乙酰胆碱酯酶(ACHE)的活性变化常被用于表征环境中有机磷农药(OPs)的污染状况.以鲅鱼脑组织AChE粗酶液为试验材料,以甲基对硫磷为OPs代表,从不同条件海水中鲅鱼AChE的活性变化人手,优化甲基对硫磷对鲅鱼AChE活性的抑制条件,获得了甲基对硫磷浓度与AChE活性抑制程度之间的关系曲线.结果表明,抑制时间为30min,温度为35℃,海水pH为7.5时,鲅鱼AChE的活性较高,甲基对硫磷对其抑制程度最强;在最佳的抑制条件下,甲基对硫磷在10～500 μg/L时,其质量浓度与AChE活性抑制率之间具有良好的线性关系(R=0.994 4),检测下限低于1.0 μg/L.     

废食用油活性炭脱色工艺的研究

脱色处理是提高废食用油油品质量、利用其生产生物柴油的关键环节之一.研究餐饮废食用油活性炭吸附脱色工艺,考察典型木质活性炭和煤基活性炭对脱色效果的影响,并将活性炭结构、性能指标与其脱色能力进行关联.结果表明,以弱粘性煤和褐煤为原料制备的活性炭对废食用油脱色效果较好;活性炭的总孔容积、总比表面积、微孔比表面积、微孔容积、碘值和亚甲基蓝值等性能指标与脱色效果关联度不大,而活性炭的孔径和中孔容积是决定活性炭脱色效果的主要指标.优化后废食用油活性炭脱色工艺的主要参数是:活性炭用量7%,炭粒度100～300目,脱色温度90～120℃,吸附时间为30 min,搅拌速度为10 r/min,废食用油的脱色率在50%～65%.     

EDTAD-modified cassava stalks loaded with Fe3O4: highly efficient removal of Pb2+ and Zn2+ from aqueous solution

Environmental Science and Pollution Research - In this study, a novel magnetic cassava stalk composite (M-EMCS) was prepared through modification with ethylenediamine tetraacetic anhydride (EDTAD)...     

Macro analysis of spatiotemporal variations in ecosystems from 1996 to 2016 in Xishuangbanna in Southwest China

Environmental Science and Pollution Research - This study used remote sensing images from 1996 to 2016 as the main data source, and selected the average annual ecosystem type net change rate,...     

Effects of emergent and submerged rigid vegetation configurations on gravity current dynamics

Environmental Fluid Mechanics - The propagation and hydrodynamic processes of lock-exchange gravity current through vegetation regions were investigated experimentally. Experimental results show...     

城市高温灾害及其预防

本文通过实例阐述了大城市高温灾害的主要成因是热岛效应；分析了高温对工业生产、人民生活的影响和危害，进而提出了城市高温灾害的预防措施和对策。