75t/h燃煤锅炉汞迁移转化规律研究

通过对2台75 t/h循环流化床锅炉烟气中汞排放浓度、燃煤和其他固体副产物中的汞含量进行测试,分析了燃煤大气汞的排放因子,并建立了燃煤汞的质量平衡。结果表明:燃煤锅炉中,大部分汞主要存在于烟气和脱硫副产物中,燃烧后进入炉渣、飞灰中的汞含量较少,低于5%。燃煤汞排放去向与脱硫除尘控制技术有关,不同控制技术协同除汞的效果差异较大,而单质汞是燃煤锅炉汞污染防治的重点和难点。     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.     

复合生物阴极型微生物燃料电池处理废水及同步产电性能

为研究生物阴极在MFC（微生物燃料电池）中的应用,分别以粒径为2~4 mm的颗粒活性炭和粒径为2~4、4~8、8~12 mm的颗粒石墨为阴极基质材料,构建升流复合生物阴极型单室MFC,研究阴极基质材料的种类和粒径对MFC的产电性能和净水效能的影响.结果表明:当阳极基质材料为2~4 mm粒径的颗粒活性炭时,燃料电池中利用玻璃纤维取代离子交换膜,阴极基质材料为选用4~8 mm粒径颗粒石墨的反应柱产电量最大,为534 mV（外电阻为1 000 Ω）,最大功率密度达到631.6 mW/m3,库伦效率为3.82%;阴极的pH越低越有利于阴极的产电反应;不同阴极基质材料的MFC对COD_Cr去除率均在80%左右,TN、NH₄+-N及TP的去除率最高可分别达到79%、93%和34%.研究显示,阴极基质材料的种类和粒径对MFC的产电性影响较大,但对其净水效能的影响不大.      

Ambient volatile organic compounds pollution in China

Owing to rapid economic and industrial development, China has been suffering from degraded air quality and visibility. Volatile organic compounds (VOCs) are important precursors to the formation of ground-level ozone and hence photochemical smog. Some VOCs adversely affect human health. Therefore, VOCs have recently elicited public concern and given new impetus to scientific interest. China is now implementing a series of polices to control VOCs pollution. The key to formulating policy is understanding the ambient VOCs pollution status. This paper mainly analyzes the species, levels, sources, and spatial distributions of VOCs in ambient air. The results show that the concentrations of ambient VOCs in China are much higher than those of developed countries such as the United States and Japan, especial benzene, which exceeds available standards. At the same time, the ozone formation potential (OFP) and secondary organic aerosol formation potential (SOAFP) of various VOCs are calculated. Aromatics and alkenes have much higher OFPs, while aromatics have higher SOAFP. The OFPs of ambient VOCs in the cities of Beijing, Guangzhou and Changchun are very high, and the SOAFP of ambient VOCs in the cities of Hangzhou, Guangzhou and Changchun are higher.     

海洋功能区划保留区管控要求解析及政策建议

本文基于保留区选划的原因和分类,结合新一轮全国和省级海洋功能区划编制,汇总和比较全国、省级保留区管控规定,分析了目前各省保留区个数、面积、岸线长度、离岸距离等设置情况。据此,依据保留区内涵将保留区划分为五类,即功能待定区、发展预留区、整治修复预留区、保护缓冲区以及特殊功能预留区,分别提出五类保留区的使用管理要求和环境保护要求。最后,文章从保留区用海现状处理方式、开发利用条件、用海活动管理等方面提出政策建议。总体来说,保留区不允许随意利用但并不完全禁止利用,在不改变海域自然属性的前提下,当用海活动符合保留区用途及环境保护要求,不影响周边海域功能正常发挥的情况下允许进行开发利用。     

Impacts of climate variability and changes on domestic water use in the Yellow River Basin of China

We present a methodology for using a domestic water use time series that were obtained from Yellow River Conservancy Commission, together with the climatic records from the National Climate Center of China to evaluate the effects of climate variability on water use in the Yellow River Basin. A suit of seven Global Circulation Models (GCMs) were adopted to anticipate future climate patterns in the Yellow River. The historical records showed evidences of rises in temperature and subsequent rises in domestic water demand in the basin. For Upstream of Longyangxia region, the impact was the least, with only 0.0021?×?10⁸ m³ for a temperature increase of 1 °C; while for Longyangxia-Lanzhou region, domestic water use was found to increase to 0.18?×?10⁸ m³ when temperature increases 1 °C. Downstream of Huayuankou was the region with the most changes in temperature that gave the highest increase of 1.95?×?10⁸ m³ in domestic water demand for 1 °C of change of temperature. Downstream of Huayuankou was identified as the most vulnerable area, where domestic water demand increases nearly by 42.2 % with 1 °C increase of temperature. Judging from the trends of temperature range, we concluded that future temperature in Yellow River Basin has an increasing tendency. This could worsen the existing issues of domestic water demand and even more to trigger high competition among different water-using sectors.     

罕见冬季降雨中人工增雨微物理过程分析研究

用Micaps实时资料、CPAS卫星反演分析资料、NCEP再分析资料、ECMWF再分析资料,多普勒雷达PUP产品资料,对2015年12月1日夜间至2日凌晨沈阳地区罕见冬季降雨过程,进行了天气学分析、及大气微物理人工增雨作业条件分析,并结合沈阳地区人工增雨作业指标,得出本次降雨过程在厄尔尼诺正在发生的背景下,为常见的高空槽转东北冷涡型,水汽、动力等微物理作业条件也适合于开展人工增雨作业,并给出了相应的作业指导参数,为沈阳地区今后在冬季降雨天气过程中开展人工增雨作业积累了宝贵经验.     

飞行器环境适应性设计方法研究与实践

目的针对飞行器环境适应性设计不足的现状提出对策。方法分析飞行器环境适应性设计的特点和当前存在的不足,以某电气设备为对象开展应用研究。结果提出环境适应性设计工作内容、工作流程、设计原则和技术手段等方面的对策。环境适应性设计应采用环境仿真和验证试验相结合的手段,并逐步形成环境适应性设计准则。结论飞行器环境适应性设计应采用系统工程的思路,覆盖产品层级、环境因素和研制阶段。技术手段方面应大力推进环境仿真研究和应用,建立产品环境适应性设计规范。     

铝合金-丁腈橡胶航空带垫卡箍典型环境损伤研究

目的研究典型环境对丁腈橡胶-铝合金带垫卡箍的损伤效应。方法通过模拟铝合金-丁腈橡胶航空带垫卡箍使用时的装配结构和应力状态,应用GJB 150A—2009中的湿热和太阳辐射两种典型老化环境,采用宏观形貌观察、卡箍保持力测试和橡胶衬垫拉伸性能测试方法,结合扫描电子显微镜和傅里叶红外光谱技术,分析带垫卡箍的性能劣化过程。结果带垫卡箍在湿热和太阳辐射环境中老化50 d后,卡箍橡胶衬垫表面出现大量微孔缺陷,拉伸性能大幅降低,导致卡箍保持力分别下降了35%和51%。结论带垫卡箍在模拟装配状态下进行湿热和太阳辐射环境暴露实验,卡箍橡胶衬垫内部结构由致密逐渐变得疏松,部分碳碳双键发生氧化交联反应,并在一定程度上提高了聚合物的交联密度,材料硬度提高,回弹性能减弱,橡胶衬垫对芯轴的包裹能力降低,导致卡箍保持力性能降低。     

利用HAZOP评估提高工艺操作安全性

介绍了HAZOP在某石化公司双峰聚乙烯装置的评估结果,提出在有效辨识出潜在安全风险后,利用HAZOP评估结果及时修正工艺技术操作规范,包括工艺操作规程、工艺参数控制等,从而提高化工装置工艺操作的安全性。