不同条件下高炉渣吸附水中无机磷的研究

高炉渣(BFS)是在冶炼生铁过程中产生的固体废弃物,开展高炉渣的资源化研究具有重要意义.为了对水淬高炉渣净化含磷污水的应用提供理论依据,采取等温吸附的实验方法,比较了不同水淬炉渣的吸附磷效果,研究了不同pH和不同温度下水淬炉渣吸附磷的特点,结果如下:利用Langmuir等温吸附方程炉渣吸附磷的过程进行拟合,其相关系数均能达到显著水平.炉渣的碱度越高,吸附磷的效果越好;炉渣对磷的吸附能力随溶液pH的增加而降低,且初始为酸性(pH=2、4)的溶液在吸附达到平衡后pH有所上升,而初始为碱性的溶液(pH=10、12)在吸附达到平衡后pH有所下降;炉渣对磷的吸附是一个自发放热过程.     

苯胺降解菌的分离和降解特性研究

通过驯化富集培养,从白洋淀底泥中分离筛选出数株能够有效降解苯胺的菌株,经过反复筛选,得到一株能够以苯胺为唯一碳源、高效降解苯胺的菌株BA-1-3.其利用苯胺的最适pH值为7.0,最适温度为30℃,在苯胺浓度为1000 mg/L,180 r/min条件下振荡培养60 h,降解率达到80%以上.经鉴定,菌株BA-1-3属苍白杆菌属(Ochrobactrumsp.).     

Evaluation of municipal sewage treatment systems for pollutant removal efficiency by measuring levels of micropollutants

In order to evaluate the municipal sewage treatment systems used at Harbin municipal sewage treatment plant for their pollutant removal efficiency, raw sewage and effluent samples at different treatment stages from the sewage treatment systems were taken, priority pollutants (PPs) were identified and quantified using gas chromatography-mass spectrometry (GC-MS) and inductively coupled plasma-atomic emission spectrograph (ICP-AES). The test results indicated that there were one hundred and fifty species of organic pollutants identified in the raw sewage sample, and only ten species of PPs in all the sewage samples. The levels of dimethyl phthalate (DMP), diethyl phthalate (DEP), dibutyl phthalate (DBP), di-n-octyl phthalate (DnOP) in the sewage samples were 0.779-0.111 microg l(-1), 1.977-0.022 microg l(-1), 6.411-2.194 microg l(-1) and 7.152-2.953microg l(-1), respectively, and most of these phthalate esters (PAEs) were removed through anaerobic/aerobic (A/O) process; The levels of alachlor, acetochlor, atrazine were 0.074-0.021 microg l(-1), 0.160-0.096 microg l(-1) and 0.238-0.184 microg l(-1), respectively, and the total removal efficiency of atrazine was poorest through the sewage treatment systems. The levels of Cu, Cr, Se, Hg, Ni and Zn were 0.0030-0.2327 mg l(-1). It is therefore concluded from these results that the sewage treatment systems were efficient in removing most of the organic and inorganic compounds in this study, and so, the discharged effluent could cause little of the secondary pollution of the aquatic environment.     

Characteristics of the stabilized/solidified municipal solid wastes incineration fly ash and the leaching behavior of Cr and Pb

Fly ash is a hazardous byproduct of municipal solid wastes incineration (MSWI). An alkali activated blast furnace slag-based cementitious material was used to stabilize/solidify the fly ash at experimental level. The characteristics of the stabilized/solidified fly ash, including metal leachability, mineralogical characteristics and the distributions of metals in matrices, were tested by toxic characteristic leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectrometer (SEM-EDS) respectively. Continuous acid extraction was utilized to extract metal ions and characterize their leaching behavior. The stabilization/solidification procedure for MSWI fly ash demonstrates a strong fixing capacity for the metals by the formation of C-S-H phase, hydrated calcium aluminosilicate and ettringite. The stabilized/solidified fly ash shows a dense and homogeneous microstructure. Cr is mainly solidified in hydrated calcium aluminosilicate, C-S-H and ettringite phase through physical encapsulation, precipitation, adsorption or substitution mechanisms, and Pb is mainly solidified in C-S-H phase and absorbed in the Si-O structure.     

Chemical characteristics of fine particulate matter emitted from commercial cooking

The chemical characteristics of fine particulate matter (PM_2.5) emitted from commercial cooking were explored in this study. Three typical commercial restaurants in Shanghai, i.e., a Shanghai-style one (SHS), a Sichuan-style one (SCS) and an Italian-style one (ITS), were selected to conduct PM_2.5 sampling. Particulate organic matter (POM) was found to be the predominant contributor to cooking-related PM_2.5 mass in all the tested restaurants, with a proportion of 69.1% to 77.1%. Specifically, 80 trace organic compounds were identified and quantified by gas chromatography/mass spectrometry (GC/MS), which accounted for 3.8%–6.5% of the total PM_2.5 mass. Among the quantified organic compounds, unsaturated fatty acids had the highest concentration, followed by saturated fatty acids. Comparatively, the impacts of other kinds of organic compounds were much smaller. Oleic acid was the most abundant single species in both SCS and ITS. However, in the case of SHS, linoleic acid was the richest one. ITS produced a much larger mass fraction of most organic species in POM than the two Chinese cooking styles except for monosaccharide anhydrides and sterols. The results of this study could be utilized to explore the contribution of cooking emissions to PM_2.5 pollution and to develop the emission inventory of PM_2.5 from cooking, which could then help the policymakers design efficient treatment measures and control strategies on cooking emissions in the future.     

Wastewater-nitrogen removal using polylactic acid/starch as carbon source: Optimization of operating parameters using response surface methodology

The use of PLA/starch blends for nitrogen removal was achieved. The influence of different operating parameters on responses was verified using RSM. The conditions for desired responses were successfully optimized simultaneously. Blends material may have a promising application prospect in the future. Nitrogen removal from ammonium-containing wastewater was conducted using polylactic acid (PLA)/starch blends as carbon source and carrier for functional bacteria. The exclusive and interactive influences of operating parameters (i.e., temperature, pH, stirring rate, and PLA-to-starch ratio (PLA proportion)) on nitrification (Y₁), denitrification (Y₂), and COD release rates (Y₃) were investigated through response surface methodology. Experimental results indicated that nitrogen removal could be successfully achieved in the PLA/starch blends through simultaneous nitrification and denitrification. The carbon release rate of the blends was controllable. The sensitivity of Y₁, Y₂, and Y₃ to different operating parameters also differed. The sequence for each response was as follows: for Y₁, pH>stirring rate>PLA proportion>temperature; for Y₂, pH>PLA proportion>temperature>stirring rate; and for Y₃, stirring rate>pH>PLA proportion>temperature. In this study, the following optimum conditions were observed: temperature, 32.0°C; pH 7.7; stirring rate, 200.0 r·min^-1; and PLA proportion, 0.4. Under these conditions, Y₁, Y₂, and Y₃ were 134.0 μg-N·g-blend^-1·h^-1, 160.9 μg-N·g-blend^-1·h^-1, and 7.6 × 10³ μg-O·g-blend^-1·h^-1, respectively. These results suggested that the PLA/starch blends may be an ideal packing material for nitrogen removal.     

Distribution of thifluzamide,fenoxanil and tebuconazole in rice paddy and dietary risk assessment

Distribution behaviors of thifluzamide, fenoxanil, and tebuconazole applied to rice were investigated in South China. Analysis was by a modified QuEChERS method with gas chromatography (thifluzamide and fenoxanil) and liquid chromatography mass spectrometry (tebuconazole). Thifluzamide and tebuconazole partitioned mainly into the soil, with half-lives in the paddy soil of 12–14 and 5.3–7.8 days, respectively. Fenoxanil partitioned mainly into the rice plants, with half-lives of 3.3–4.4 days. The half-lives of thifluzamide, fenoxanil, and tebuconazole in paddy water were 0.17–0.89, 1.8–3.0, and 1.6–4.0 days, respectively. The residues in rice grains at the pre-harvest interval of 14 days were all below the established maximum limit values. The dietary risks assessed as hazard quotients at the pre-harvest interval were less than 1.     

Using regression models to evaluate the formation of trihalomethanes and haloacetonitriles via chlorination of source water with low SUVA values in the Yangtze River Delta region,China

The purpose of this study was to develop the multiple regression models to evaluate the formation of trihalomethanes (THMs) and haloacetonitriles (HANs) during chlorination of source water with low specific ultraviolet absorbance (SUVA) in Yangtze River Delta, China. The results showed that the regression models of THMs exhibited good accuracy and precision, and 86–97 % of the calculated values fell within ±25 % of the measured values. While the HANs models showed relatively weak evaluation ability, as only 75–83 % of the calculated values were within ±25 % of the measured values. The organic matter [dissolved organic carbon (DOC) or UV absorbance at 254 nm] and bromide exerted the most important influence on the formation of HANs. While for THMs, besides the organic matter and bromide, reaction time was also a key factor. Comparing the models for total THMs (T-THMs) in this study with others revealed that the regression models from the low SUVA waters may have low DOC coefficients, but high bromide coefficients as compared with those from the high SUVA waters.     

基于我国物种毒性数据的多溴联苯醚预测无效应浓度分析

采用多溴联苯醚(PBDEs)对我国广泛分布生物物种的生态毒性数据,根据欧盟现有化学物质风险评价技术指导文件,对不同环境介质中PBDEs预测无效应浓度(PNEC)进行了推导。结果表明:我国淡水环境PBDEs(四溴、五溴、八溴)的PNEC水分别为50μg·L~(-1)、0.53μg·L~(-1)、0.017μg·L~(-1)。沉积物环境PBDEs(四溴、五溴、八溴和十溴)的PNEC沉积物分别为823.35 mg·kg~(-1)wt、1.55 mg·kg~(-1)dw、12.72 mg·kg~(-1)dw、38.41 mg·kg~(-1)dw。土壤环境PBDEs(四溴、五溴、八溴和十溴)的PNEC土壤分别为668.3mg·kg~(-1)wt、0.38 mg·kg~(-1)dw、147 mg·kg~(-1)dw、98 mg·kg~(-1)dw。次生毒性PBDEs(五溴、八溴和十溴)的PNEC经口分别为0.3~0.7 mg·kg~(-1)、0.56 mg·kg~(-1)、2 500 mg·kg~(-1)。该数值期为我国PBDEs的环境风险评价提供科学基础。     

顶空-气相色谱法(氮磷检测器)测定固定污染源废气中三甲胺

建立了顶空-气相色谱法测定固定污染源废气中三甲胺的分析方法。弱酸性吸收液采集固定污染源废气中的三甲胺,碱液中和后顶空进样气相色谱仪氮磷检测器分析。并对平衡温度、平衡时间、盐析效应、氨水和氢氧化钠条件实验进行优化,在最佳实验条件下,三甲胺的方法检出限为0. 46μg/m~3(以采集20 L空气样品计),加标回收率为97%～107%,相对标准偏差在9. 26%以下。利用该方法对垃圾焚烧发电厂厂界空气及鱼粉厂有组织废气中三甲胺进行检测分析,该方法能够满足国家标准及上海地方标准中三甲胺排放限值的要求。