活性污泥对甲醛废水的净化性能

采用微生物法处理低浓度甲醛废水达标排放是比较经济的方法之一.在研究中采用序批式活性污泥法(SBR)工艺,考察了曝气时间、进水甲醛浓度、进水 pH 和水温对微生物净化低浓度甲醛废水的影响.结果表明,随着曝气时间的延长,活性污泥对甲醛的去除率增大.进水甲醛浓度在 40～120 mg/L 范围内,随着浓度升高甲醛污泥负荷增加,微生物对甲醛的降解速率增加,但对甲醛的去除率降低.活性污泥在 pH 为 5～7 的中性和弱酸性环境中对甲醛的降解速率较高.在15～35℃范围内,污泥对废水中甲醛的去除率随温度升高而上升,微生物对甲醛的降解速率随温度升高呈指数递增趋势.     

区域水战略方案选优的动态组合评价模型研究

水安全危机是人类进入新世纪以来在生存及发展方面所面临的最严重挑战之一。研究科学合理的水安全战略成为区域可持续发展的重大课题。针对区域水战略问题涉及众多因素且各因素之间动态关联的特点,提出了基于水战略方案优选的兼容度极大化动态组合评价模型（CMM—DCEM）,并将其成功地应用于我国广东省北江下游及其三角洲地区水安全战略方案优选评价。评价结果及模型基于不确定性的敏感性分析结果证明：CMM—DCEM实现了主、客观赋权方法以及单一评价模型的融合,使用实码加速遗传算法求解目标函数,克服了传统的组合评价方法计算繁琐的不足,评价过程更加科学合理。     

废旧电池资源化、无害化

对当前国内外在废旧电池的处理处置方面进行了综合性论述,对废旧电池的危害及当前应采取的对策进行分析。     

间歇-阶段性酸雨入侵对填埋稳定化飞灰中重金属浸出行为影响

以间歇-分阶段进水方式进行了模拟酸雨柱式动态淋溶实验.结果表明,间歇-阶段性酸雨入侵会影响填埋飞灰中Pb、Zn、Cu、Cr和Ni的浸出行为;尤其间歇停滞期后的初期酸雨入侵会增加多数重金属的再浸出水平,且该部分重金属的释放主要源于前阶段酸雨侵蚀过程中所形成的非稳定性(弱酸态)重金属.各酸雨侵蚀阶段,部分重金属(如Pb-Zn)的浸出行为具有相关性,这与各重金属在飞灰基质内的赋存形态、矿物相稳定性及酸性侵蚀程度等有关.各阶段酸雨入侵会相继溶出飞灰中的可溶性(NaCl、KCl等)、难溶性氯盐(CaClOH)以及微溶性钙盐(CaSO₄),并增加CaCO₃和Ca-Al-Si-O等矿物的峰强.各阶段酸雨入侵会使初始飞灰表面的团簇状结构逐渐被酸性(H⁺)侵蚀作用破坏,并暴露出大量棒状或条形状CaCO₃晶体,且随着酸雨入侵次数的增加,CaCO₃也将逐渐被侵蚀破坏.本研究为非连续酸性降雨条件下填埋稳定化飞灰的重金属浸出行为评价及风险管控提供了科学依据.     

北方泥炭地泥炭土矿化速率、温度敏感性及其影响因素研究

北方泥炭地是全球重要的碳汇,也是全球变暖最为敏感的区域之一.然而,由于泥炭地表层和亚表层泥炭土碳排放过程对全球变暖的响应过程及机制仍存在一定争议,目前对全球变暖背景下泥炭地碳排放的认识仍存在一定不足.本研究于2019年8月在大兴安岭满归泥炭地采集表层(0～10 cm)和亚表层(15～30 cm)泥炭土进行室内增温模拟有氧培养,测定其矿化速率、有机质性质和水解酶活性.结果表明,表层泥炭土矿化速率在5、15、25℃下培养时((142.8±66.9)～(545.3±30.6)、(575.0±62.1)～(1843.0±547.4)、(888.4±123.9)～(3646.7±167.9)μg·g^-1·d^-1)均高于亚表层((113.0±41.5)～(367.1±64.1)、(357.4±52.3)～(1122.1±218.8)、(697.1±38.1)～(2336.4±150.6)μg·g^-1·d^-1),但表层和亚表层矿化作用的温度敏感性不具有显著差异;培养过程中,表层与亚表层泥炭土β-1,4-N-乙酰葡...     

城市地表水环境质量排名方法研究

基于现行的国家水环境质量评价标准和方法,研究建立了综合反映城市地表水环境质量的城市水质指数CWQI。方法具有普适性、可操作性和可比性,可用于城市地表水环境质量排名。应用于长三角经济圈、珠三角经济圈和京津冀经济圈的相关城市进行排名测算,3个经济圈的城市水质指数呈现不同的分布规律,总体来说长三角经济圈的城市地表水环境质量优于珠三角经济圈和京津冀经济圈。     

大气污染排放窗口机制研究

以2种典型的污染排放源(点污染源和线污染源)为基础,提出排污窗口的概念,通过参数转换分解源强对污染扩散进行研究。首先在高斯污染扩散模型的基础上,对非持续性污染源强建模,然后以某烟囱的周期性排污分析,检验排污窗口设置的合理性。对于单双号限行的窗口性质的污染排放研究中,首先对交通流建立线污染扩散模型,然后融合元胞自动机(9元胞互影响)模拟区域多角度污染的扩散平衡,最后对"单双号限行"下北京市不同区域空气质量指标进行分析与仿真。分析结果表明,合理的排污窗口能够减轻污染程度及对人们日常生活的影响。     

Effects of pig manure containing copper and zinc on microbial community assessed via phospholipids in soils

Pig manure (PM) is widely used as an organic fertilizer to increase yields of crops. Excessive application of compost containing relatively great concentrations of copper (Cu) and zinc (Zn) can change soil quality. To clarify the effects of different rates of application and to determine the optimal rate of fertilization, PM containing 1,115 mg Cu kg^?1, dry mass (dm) and 1,497 mg Zn kg^?1, dm was applied to alkaline soil at rates of 0, 11, 22, 44, 88, and 222 g PM kg^?1, dm. Phospholipid fatty acids (PLFAs) were used to assess soil microbial community composition. Application of PM resulted in greater concentrations of total nitrogen (TN), NH₄ ⁺-N, NO₃ ^?-N, total carbon (TC), soil organic matter (SOM) but lesser pH values. Soils with application rates of 88–222 g PM kg^?1, dm had concentrations of total and EDTA-extractable Cu and Zn significantly greater than those in soil without PM, and concentrations of T-Cu and T-Zn in these amended soils exceeded maximum limits set by standards in china. Except in the soil with a rate of 11 g PM kg^?1, dm, total bacterial and fungal PLFAs were directly proportional to rate of application of PM. Biomasses of bacteria and fungi were significantly greater in soils with application rates of 44–222 g PM kg^?1, dm than in the soil without PM. SOM, TC and EDTA-Zn had the most direct influence on soil microbial communities. To improve fertility of soils and maintain quality of soil, rate of application should be 22–44 g PM kg^?1 dm, soil containing Cu and Zn.     

石化行业给排水系统设计图纸环境监理审查要点

石化行业废水种类多样、毒性较大,给排水系统的设计会直接影响石化项目建成后周边地表及地下水环境质量。设计文件的环保审查是环境监理的重要依据之一,其中,相关的设计图纸对下一步建设工作具有指导作用,是所有施工单位的施工依据。以某石化行业为例,对给排水系统设计文件的收集进行了分析,并根据设计图纸环保审查中存在的问题,对环境监理如何提高在设计会审中的作用,设计阶段如何对设计图纸进行审查以及审查的重点内容等进行了阐述。     

Technological innovation paths toward green industry in China

With the environmental carrying capacity reaching its limits and the decreasing margin benefits of traditional production factors, the green transformation and green development through technological innovations has been a major direction for the future development of Chinese industries. However, the characteristics and heterogeneities of various types of industries call for different approaches regarding technological innovations. How to choose the most effective mode of technological innovation according to the characteristics of a certain industry has been a key issue. This paper measures the green total factor productivity of 32 industrial trades using the Slacks Based Measure(SBM)-DDF method. The effects of three innovation modes in the green transformation of industrial industry, including the independent innovation(Ⅱ), the technology introduction(TI), and the government support(GS), are empirically analyzed based on industry heterogeneity. Results indicate that the green total factor productivities of different industries show significant differences if taking into account the energy input and the undesirable output of pollutant emissions. The green total factor productivities of traditional high input,high pollution, and high energy consumption industrial trades were significantly lower than those with obvious green features. The year of 2009 is a leap year for the industrial green transformation in China. For resource-intensive industries, the II and the GS are the important ways to achieve green transformation. For labor-intensive industries, the TI is the best path to achieve green transformation, while for technology-intensive industries, the II is the primary driving force for the promotion of green developments. In addition, the innovation-compensating effect of the current Chinese environmental regulations to the resource-intensive industries has been revealed. Improving the overall scale and the industrial concentration of the industries is also beneficial for the green transformation of the industries.