高速公路路面沉积物的污染特性

对湖南省长潭西高速公路不同采样点的路面沉积物进行取样分析,并检测了样品的颗粒级配、COD、重金属(Cu、Zn、Pb和Cd)和有机质。结果表明,路面沉积物主要以粒径<0.15 mm的颗粒为主;较小颗粒物中的COD含量高于较大颗粒中的COD含量;粒径在0.15 mm以下的颗粒物所含重金属Cu、Zn、Pb和Cd的浓度普遍高于所选的土壤标准值,降雨一旦形成径流将会产生严重的污染危害;沉积物中的有机质含量对重金属的吸附有一定的影响,有机质含量越高,沉积物中重金属含量相对也高。     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

Effect of inoculation methods on the composting efficiency of municipal solid wastes

Four types of inoculation methods were studied during the composting of municipal solid wastes and dry grass (MSWG). The methods included a control group as well as initial-stage, two-stage, and multi-stage inoculations. Fulvic acids were extracted from the composting materials and characterized by spectroscopic techniques. The results showed that inoculation of microbes in MSWG enhanced the biodegradation of aliphatics, proteins, and polysaccharides. The inoculation also increased the molecular weight, humic- and fulvic-like compound content, as well as humification degree of the composting products. The inoculation of microbes in MSWG significantly improved composting process and efficiency. The improvement efficiency was in the order of initial-stage < two-stage < multi-stage inoculations. Inoculation of microbes based on composting organic matter composition and temperature enhanced composting efficiency.     

Spatial distribution and loading amounts of particle sorbed and dissolved perfluorinated compounds in the basin of Tokyo Bay

In this study, we analyzed over 30 types of PFCs, including precursors in both the dissolved phase and particle solid phase, in 50 samples of river water collected from throughout the Tokyo Bay basin. PFCs were detected in suspended solids (SSs) at levels ranging from <0.003-4.4 ng L(-1) (0.11-2470 ng g(-1) dry weight). The concentrations of PFCs in the SS were one to two order(s) of magnitude lower than those of PFCs in the dissolved phase. Relatively high levels of PFCs (total of 35 PFCs) in SS were observed in urbanized areas. The concentration of PFCAs, including PFOA and PFNA, were significantly correlated with the geographic index as artificial area (R(2) of the linear regression curve in a double logarithmic plot: 0.09-0.55). Conversely, PFOS and FOSA were significantly correlated with the arterial traffic area (R(2) in a double logarithmic plot: 0.29-0.55). Those spatial trends were similar to the trends in dissolved PFCs. We estimated the loading amount of PFCs into Tokyo Bay from six main rivers and found that more than 90% of the total PFCs reached Tokyo Bay in the dissolved phase. However, 40.0-83.5% of the long chain PFCAs (C12-C15), were transported as particle sorbed PFCs. Rain runoff events might increase the loading amount of PFCs in SS. Overall, the results presented herein indicate that greater attention should be given to PFCs, especially for longer chain PFCs in SS in addition to dissolved PFCs.     

垃圾焚烧炉炉膛温度的影响因素

垃圾焚烧过程的不稳定会导致大量有害物质的生成,为确保垃圾的清洁燃烧需要将炉膛温度控制在850℃以上,为此测试了焚烧炉运行的主要可控参数对炉膛温度的影响。结果表明,垃圾堆放位置在垃圾池深3～8 m处,并经过6 d以上发酵脱水后适合焚烧;炉膛温度随给料量、一次风率和一次风温增加而增大,随过量空气系数增加而降低,其中给料量宜控制在95%～110%之间;当过量空气系数为1.6、一次风率为90%、一次风温为260℃、给料量为100%时炉膛温度达901℃。     

高铁酸钾预处理对活性污泥脱水性能的影响

通过投入不同剂量的高铁酸钾于剩余活性污泥中,研究其对污泥絮体性质和脱水性能的影响作用。污泥絮体性质的研究包括絮体粒径的变化以及污泥EPS含量的变化。脱水性能的研究包括过滤脱水性能(以CST表征)以及脱水程度(离心泥饼含固率)。实验结果表明,高铁酸钾的强氧化性可以破坏污泥絮体结构,提高污泥的机械脱水程度;但同时污泥EPS含量增加,对污泥过滤脱水性能有负面影响。高铁酸钾氧化分解生成的Fe(OH)3具有絮凝能力,可以使污泥颗粒重新絮凝;而其混凝作用可以破坏污泥细胞的稳定性,提高污泥的沉降性能。     

树脂法去除并回收富营养化河涌水中的磷

磷作为一种重要的元素而被广泛应用于农业与工业中,然而磷的过量排放已成为许多封闭半封闭水体富营养化和沿海赤潮频繁发生的原因之一.去除水体中的营养盐特别是磷酸盐,是有效控制水体富营养化的关键.广州市某河涌水含总磷2.6 mg/L,采用并选择DS离子交换树脂对水中磷进行动态吸附和去除,可使水中的磷降至排放标准以内,解决河涌水含磷高的富营养化问题.由DS树脂所吸附的磷,通过淋洗可得到含磷富集液,使磷从水体中完全分离出来并获得回收.DS树脂的再生能力强,经6次吸附-解吸-再生后,树脂对河涌水中磷的去除率仍可达到90％以上.     

物化-生物组合工艺处理TNT红水

采用酸析+微电解+混凝沉淀+减压蒸馏+固定化微生物滤池+活性焦吸附组合工艺处理兵器八○五厂(襄樊分部)的TNT红水,出水中的硝基化合物浓度多小于0.8 mg/L,且多次未检出;COD最高值为76 mg/L,平均值为51.6 mg/L;色度为20°;苯胺浓度全部小于1 mg/L,达到了中试方案提出的要求,出水水质指标符合《兵器工业水污染物排放标准火炸药》(GB14470.1-2002)的要求.中试期间设备没有发生堵塞、燃烧等事故,减压蒸馏装置正常稳定运行,证实了减压蒸馏法处理TNT红水的安全可靠性.     

漆酶对活性黑KN-B和直接大红染料的脱色性能

利用白腐真菌漆酶对活性黑KN-B和直接大红2种偶氮染料进行脱色实验。考察反应时间、加酶量、pH值、染料浓度、温度对脱色率的影响,研究了ABTS介体以及金属离子存在下的脱色效果,并分析了漆酶脱色的动力学性能以及其对偶氮染料的降解规律。结果表明,活性黑KN-B和直接大红脱色适宜条件为：反应时间为30 min,加酶量8 U/mL,pH=7,染料浓度分别为50 mg/L和80 mg/L,温度40~45℃。ABTS介体对酶促偶氮染料脱色没有明显促进作用。Fe²⁺对漆酶脱色有较强的抑制作用;Cu²⁺对漆酶催化活性黑KN-B促进作用较大,对直接大红影响较小。漆酶对2种染料的脱色反应符合米氏方程,其催化活性黑KN-B和直接大红染料的K_m值分别为114.81 mg/L,317.5 mg/L,v_max值分别为6.57 mg/（L·min）和26.0 mg/（L·min）。