Electrostatic charges during liquid leakage

Leakage accidents of pressurized flammable liquids often occur in chemical plants. To investigate electrostatic hazards due to liquid leakage, the amounts of electrostatic charge during the leakage were observed. The electric field of the clouds generated by liquid leakage was also examined. Various types of pipeline have been designed in consideration of potential leakage that might lead to accidents during industrial processes. Leakage pressure in the range of 0.1–0.3 MPa was used. With regard to the materials, water and kerosene were used. The results obtained from the experiments show that electrostatic charges depend on leakage parameters, such as the type of liquid, the gasket material between flanges, and the pipeline pressure. In all tests, the amount of the electrostatic charges of water, 0.12–0.83 μC/kg, was larger than that of kerosene, ?0.04 to 0.16 μC/kg. The maximum value of the electric field, generated from the leakage liquid in this study, 40.9 v/cm, is a safe level. No incendiary electrostatic sparks, such as brush and/or spark discharges, were detected in our tests.     

Experimental study on electrostatic charging of polymer powders in mixing processes

Powder mixing is often carried out in the chemical and pharmaceutical industries. Electrostatic charges generated on polymer powders during mixing may lead to electrostatic problems due to the poor conductivity of those powders. In this study, we investigated the electrostatic charges, surface potential, and apparent volume resistivity of sample powders using a simple mixing device utilizing the Faraday cup method. To neutralize the charged powders, we also applied an AC-type ionizer in the mixing study. A commercial polyethylene powder with a mean particle size of 585 μm was tested in this experiment. The charge-to-mass ratios at the end of 600 s of mixing were ?0.075 nC/g at 295 rpm agitation speed, ?0.21 nC/g at 495 rpm, and ?0.31 nC/g at 660 rpm, high enough to cause electrostatic agglomeration and adhesion. The electric fields based on the surface potential on the powders were several hundreds of V/cm, too small to give rise to brush discharge. The apparent volume resistivity of powders estimated by a simple measurement system is 1.0 × 10¹⁶ Ωm, in reasonable agreement with that acquired by the conventional test cell method (5.9 × 10¹⁵ Ωm). The charging level on the polymer powders was reduced with an AC-ionizer.     

Development of freshwater sediment management standards for organic matters, nutrients, and metals in Korea

Korean water quality managers are required to promptly develop national assessment standards for freshwater sediment quality due to the Four Major River Restoration Project in Korea in 2009. We conducted this study to develop sediment management standards (SMSs), determining obviously and severely polluted sediment, which could have adverse impacts on water quality and aquatic ecosystem. The SMSs values were derived from the 95th percentile of concentration distribution for organic matter and nutrients in sediment quality database. For the SMSs of metals, foreign sediment quality guidelines (SQGs) were adopted. As a result, 13 % for loss on ignition (LOI), 1,600 mg/kg for total phosphorus (TP), and 5,600 mg/kg for total nitrogen (TN) were set as the SMSs for freshwater sediment in Korea. These values were higher than the range of heavily polluted sediment from USEPA Region 5 guideline derived by the similar approaches for the Great Lakes harbor sediments, and similar or lower than the severe effect level (SEL) from provincial sediment quality guideline (PSQG) of Ontario, Canada by screening level concentration (SLC) approach. However, SMSs in the present study are appropriate considering the concentration ranges and the Korean SMSs’ definition for freshwater sediments in Korea. The Puget Sound marine sediment cleanup screening level (CSL) in Washington State, USA were adopted as the Korean SMSs for As (93 mg/kg), Cd (6.7 mg/kg), Cr (270 mg/kg), Cu (390 mg/kg), Pb (530 mg/kg), and Zn (960 mg/kg) in freshwater sediments. Hg concentration (0.59 mg/kg) of CSL was too low to determine the polluted freshwater sediments in Korea, and the SEL of Ontario, Canada for mercury concentration (2 mg/kg) was selected as the SMS for Hg. These values were found reasonable through the assessment of applicability with the datasets from locations directly affected by obvious point sources. These results indicate that SMSs for organic matter, nutrient, and metals derived within the present study can successfully determine obviously and severely polluted sediment in Korea. However, the SMSs have limits to specifically determine the effects of polluted sediment on water quality and aquatic ecosystem in Korea. Thus, we will revise and specify SMSs considering those effects and further sediment quality assessment framework in the near future.     

Characterization of controlled-release KMnO4 (CRP) barrier system for groundwater remediation: a pilot-scale flow-tank study

Release and spreading of permanganate (MnO(4)(-)) in the well-based controlled-release potassium permanganate (KMnO(4)) barrier system (CRP system) was investigated by conducting column release tests, model simulations, soil oxidant demand (SOD) analyses, and pilot-scale flow-tank experiments. A large flow tank (L x W x D=8m x 4m x 3m) was constructed. Pilot-scale CRP pellets (OD x L=0.05 m x1.5m; n=110) were manufactured by mixing approximately 198 kg of KMnO(4) powders with paraffin wax and silica sands in cylindrical moulds. The CRP system (L x W x D=3m x 4m x 1.5m) comprising 110 delivery wells in three discrete barriers was constructed in the flow tank. Natural sands (organic carbon content=0.18%; SOD=3.7-11 g MnO(4)(-)kg(-1)) were used as porous media. Column release tests and model simulations indicated that the CRP system could continuously release MnO(4)(-) over several years, with slowly decreasing release rates of 2.5 kg d(-1) (day one), 109 g d(-1) (day 100), 58 g d(-1) (year one), 22 g d(-1) (year five), and 12 g d(-1) (year 10). Mean MnO(4)(-) concentrations within the CRP system ranged from 0.5 to 6 mg l(-1) during the 42 days of testing period. The continuously releasing MnO(4)(-) was gradually removed by SOD limiting the length of MnO(4)(-) zone in the porous media. These data suggested that the CRP system could create persistent and confined oxidation zone in the subsurface. Through development of advanced tools for describing agent transport and facilitating lateral agent spreading, the CRP system could provide new approach for long-term in situ treatment of contaminant plumes in groundwater.     

Nontarget screening using passive air and water sampling with a level Ⅱ fugacity model to identify unregulated environmental contaminants

It is thought that there are many unregulated anthropogenic chemicals in the environment.For risk assessment of chemicals, it is essential to estimate the predicted environmental concentrations. As an effort of identifying residual organic contaminants in air and water in Korea, nontarget screening using two-dimensional gas chromatography time-of-flight mass spectrometry(GC × GC-TOFMS) was conducted at 10 sites using polyurethane foam passive air sampler and at 6 sites using polydimethyl siloxane(PDMS) passive water sampler in three different seasons in 2014. More than 600 chemical peaks were identified satisfying the identification criteria in air and water samples, respectively, providing a list for further investigation. Chemical substances with reported national emission rates in2014(n = 149) were also screened for potential existence in the environment using a level Ⅱ fugacity model. Most of chemical substances classified as not detectable were not identified with detection frequency greater than 20% by nontarget screening, indicating that a simple equilibrium model has a strong potential to be used to exclude chemicals that are not likely to remain in the environment after emissions from targeted monitoring.     

Re-emergence of a GII.4 Norovirus Sydney 2012 Variant Equipped with GII.P16 RdRp and Its Predominance over Novel Variants of GII.17 in South Korea in 2016

Noroviruses are major causative pathogen of nonbacterial acute gastroenteritis worldwide. Of the seven genogroups of noroviruses suggested recently, genogroup II genotype 4 (GII.4) had been the most common genotype identified in hospitalized patients in the last few decades. However, since the latter half of 2014, new variants of GII.17 have been reported as the main causes of outbreaks over GII.4 in East Asia and have also occurred in America and Europe. In this study, we monitored norovirus GII in coastal streams at South Gyeongsang province and South Jeolla province of South Korea from March 2015 to May 2016. Norovirus GII.17 capsid sequences were predominantly detected until September 2015 in water samples. However, we found that the number of positive cases of the norovirus GII.4 Sydney 2012 capsid sequence has been increasing since December 2015, overtaking that of GII.17 in 2016. The RdRp genotype of this predominant GII.4 variant in 2016 was identified as GII.P16. The emergence and predominance of the GII.4 pandemic capsid sequence harboring a different RdRp genotype suggested the potential for a future pandemic.     

A study on torrefaction characteristics of waste sawdust in an auger type pyrolyzer

Torrefaction is thermo-chemical process which can improve solid fuel quality as well as grindability. In previous studies, torrefaction has been studied mainly for removal of moisture and for improving grindability. In this experiment, the characteristics of torrefied waste sawdust were studied especially for its energy yield. Hence, torrefaction was performed on varying reaction temperatures (200, 220, 240, 260, 280, 300 °C) and solid residence time (10, 30, 60 min). The results indicated that the yield of torrefaction decreases with increasing temperature and residence time. It was found that above 280 °C, the yield got remarkably decreased. The lowest yield was obtained at the residence time of 60 min. It was also noticed that the HHV of torrefied samples increases with increasing temperature. The highest HHV was found to be 26.09 MJ/kg which was obtained at 60 min and 300 °C. However, the highest energy yield was obtained to be 104.17 % which was noticed at 30 min and 260 °C.     

Study of hydrodynamic characteristics in a circulating fluidized bed gasifier for plastic waste by computational fluid dynamics modeling and simulation

For designing an efficient circulating fluidized bed reactor, understanding the complex hydrodynamic characteristics in the reactor is required. Hence, in the present study, the modeling and simulation of the circulating fluidized bed gasifier using plastic waste were carried out with Eulerian-Granular approach. Several cases were investigated as changing superficial gas velocities or sizes of plastic waste particle. Firstly, cases were examined with four different velocities when the particle diameter is 1 mm. At the gas velocity of 6 or 8 m/s, gas volume fraction is more than 95 % throughout the reactor and particle velocity has positive value overall. Therefore, a circulating fluidized bed seems to be formed in both cases. Comparing those two cases, better solid mixing can be expected considering the mass fraction and solid velocity at the superficial gas velocity of 6 m/s. Thus this case was further studied for the effect of particle size. As the diameters of plastic waste particle are 1 or 3 mm, it is considered that a circulating fluidized bed is formed. And plastic waste and sand particles are well mixed throughout the reactor. However, the particle diameter increases over 3 mm then, it is very hard to maintain circulating fluidization condition.     

Evaluation of SWAT sub-daily runoff estimation at small agricultural watershed in Korea

A study was undertaken for the prediction of runoff flow from 0.8 ha field-sized agricultural watershed in South Korea using Soil and Water Assessment Tool (SWAT) sub-daily. The SWAT model with sub-daily configuration predicted flow from the watershed within the range of acceptable accuracy. The SWAT sub-daily simulations were carried out for a total of 18 rainfall events, 9 each for calibration and validation. Overall trend and extent of matching simulated flow for the rainfall events in 2007-2008 with measured data during the calibration process were coefficient of determination (R²) value of 0.88 and Nash and Sutcliffe Efficiency (E_NS) value of 0.88. For validation, R² and E_NS values were 0.9 and 0.84, respectively. Whereas R² and E_NS values for simulation results using daily rainfall data were 0.79 and -0.01, respectively, that were observed to be out of acceptable limits for the model simulation. The importance of higher time resolution (hourly) precipitation records for flow simulation were evaluated by comparing R² and E_NS with 15 min, 2 h, 6 h and 12 h precipitation data, which resulted in lower statistics with increases in time resolution of precipitation data. The SWAT sub-daily sensitivity analysis was performed with the consideration of hydraulic parameter and was found as in the rank order of CN2 (curve number), ESCO (soil evaporation compensation factor), GW_DELAY (ground water delay time), ALPHA_BF ( base flow alpha factor), GWQMN ( a threshold minimum depth of water in the shallow aquifer required for return flow to occur) , REVAPMN (minimum depth of water in shallow aquifer for re-evaporation to occur) , LAT_TIME (lateral flow travel time) respectively. These sensitive parameters were evaluated at 10% higher and lower values of the parameters, corresponding to 70.5% higher and 23.2% lower in simulated flow out from the SWAT model. From the results obtained in this study, hourly precipitation record for SWAT sub-daily with Green-Ampt infiltration method was proven to be efficient for runoff estimation at field sized watershed with higher accuracies that could be efficiently used to develop site-specific Best Management Practices (BMPs) considering rainfall intensity, rather than simply using daily rainfall data.