炼油厂污水处理负荷的削减措施

总结和分析了某厂削减污水处理负荷的主要措施及效益，预测该厂在达到16000kt/a以上加工规模时的污水处理负荷。     

沉积方向对珊瑚砂动剪切模量及阻尼比的影响∗

复杂地质赋存环境下珊瑚砂具有显著的各向异性特征,颗粒的沉积方向显著影响其动力特性。对南沙岛礁珊瑚砂开展均等固结的共振柱试验,探究了珊瑚砂颗粒的沉积方向角 φ（沉积面与水平面的夹角）和初始有效固结围压对其动剪切模量 G 和阻尼比 λ 的影响。在给定 φ 下,G 随剪应变幅值 γ_a增大而减小的速率随 的增大而增加;给定 下,G 随 γ_a增大而减小的速率随 φ 增大呈现先减后增的趋势,φ = 60°时 G—γ_a曲线位于最下方。最大动剪切模量 G₀随 φ 的增大表现出先减后增的现象,且 φ 对 G₀的影响随 的增大而降低。建立了考虑 φ 和 影响的修正 Hardin 模型,预测和量测的 G₀值偏差小于 10%。动剪切模量比 G/G₀—γ_a曲线对 φ 不敏感,结合修正 Hardin 模型和 Davidenkov 骨架曲线预测和量测的 G 值偏差小于 15%。在陈国兴等（2006）提出的阻尼比经验模型中引入 φ 影响的修正项,预测和量测的 λ 值偏差小于 20%。     

悬浮载体生物膜工艺挂膜试验研究

悬浮载体挂膜需经历微生物在载体表面可逆吸附-不可逆吸附-固着态生长的过程.试验研究发现,悬浮载体挂膜效果受载体性质、环境因素、接种污泥活性及悬浮微生物浓度等多种因素影响,而控制较低的悬浮态微生物浓度,保证固着态微生物的优势生长,是挂膜能否成功的关键.在适宜的温度和操作条件下,经历20 d左右时间可完成悬浮载体挂膜.     

高烈度地震区隧道软硬围岩交接段刚柔并济抗减震技术研究

为提高高烈度地震区隧道抗震性能,以某铁路隧道为研究背景,分析3种抗减震措施下隧道不同监测点隧道拱顶沉降、边墙收敛、衬砌结构PGA及最小安全系数,通过对比分析得到最优抗减震措施.结果表明:相比于工况1,工况2隧道拱顶沉降减小10.54％ ～81.10％,边墙收敛减小13.92％ ～78.77％,衬砌结构PGA减小31.4...     

基于光纤分布式测温的污水管道入流识别方法研究

针对排水管网物探检测需断水操作和无法对管道内部实时探查的问题,建立了一种基于光纤分布式测温的污水管道入流诊断方法,实现了无干扰条件下污水管道污水和雨水入流实时监控.采用感温光缆对选择的试验管段开展了时空高精度观测(空间精度1m、时间精度1min),获得了超过118万个管道水温数据.基于解析出的管道水温时空图像,提出了基于水温温差背景噪声值的入流定位方法;确定出无外部入流影响时管道水温空间和时间温差的背景噪声值分别约为±0.2℃和±0.5℃.采用水温图像降噪处理方法,自动识别出污水管道的旱天污水接入和雨天雨水接入事件,与现场调查结果一致.因此,该方法对污水管道入流的动态识别定位具有可靠性.     

Removal of polycyclic aromatic hydrocarbons from different soil fractions by persulfate oxidation

Removal of polycyclic aromatic hydrocarbons (PAHs) from different soil fractions of contaminated soil was investigated by using activated persulfate oxidation remediation in our research. The results showed that the light fraction, which accounted for only 10% of the soil, contained 30% of the PAHs at a concentration of 4352?mg/kg. The heavy fraction contained more high-molecular-weight PAHs, and the total PAH concentration was 625?mg/kg. After being oxidized, the removal rate of PAHs was 39% in the light fraction and nearly 90% in the heavy fraction. Among the different fractions of the heavy fraction, humic acid contained the highest concentration of PAHs, and consequently, the highest removal efficiency of PAHs was also in humic acid. Compared with the light fraction, the heavy fraction has more aromatic compounds and those compounds were broken down during the oxidation process, which may be the removal mechanism involved in the oxidation of high-ring PAHs. Similarly, the enhancement of C = C bonds after oxidation can also explain the poor removal of high-ring PAHs in the light fraction. These results imply that different fractions of soil vary in composition and structure, leading to differences in the distribution and oxidation efficiencies of PAHs.     

Degradation kinetics and mechanism of aniline by heat-assisted persulfate oxidation

Oxidation of aniline by persulfate in aqueous solutions was investigated and the reaction kinetic rates under different temperature, persulfate concentration and pH conditions were examined in batch experiments. The results showed that, the aniline degradation followed pseudo first-order reaction model. Aniline degradation rate increased with increasing temperature or persulfate concentration. In the pH range of 3 to 11, a low aniline degradation rate was obtained at strong acid system (pH 3), while a high degradation rate was achieved at strong alkalinity (pH 11). Maximum aniline degradation occurred at pH 7 when the solution was in a weak level of acid and alkalinity (pH 5, 7 and 9). Produced intermediates during the oxidation process were identified using liquid chromatography-mass spectrometry technology. And nitrobenzene, 4-4’-diaminodiphenyl and 1-hydroxy-1,2-diphenylhydrazine have been identified as the major intermediates of aniline oxidation by persulfate and the degradation mechanism of aniline was also tentatively proposed.     

纤维改性硫酸亚铁还原铬渣水泥固化体研究

以浸出毒性、表面浸出率、抗日晒能力和抗压强度为指标考察了纤维改性硫酸亚铁还原铬渣水泥固化体的性能。实验结果表明：纤维改性硫酸亚铁还原铬渣水泥固化体养护7d和28d后的浸出毒性均低于国家标准、抗压强度均大于10MPa,可以做最终处置或进行综合利用;与普通铬渣水泥固化体相比,纤维改性硫酸亚铁还原铬渣水泥固化体在加入植物纤维为0．8g时的处理效果最好,浸出毒性、表面浸出率分别降低了76．I％和76．8％;抗日晒能力、抗压强度分别提高了36．4％和52．1％。     

高分子量高纯度阳离子聚丙烯酰胺的合成

以丙烯酰胺与丙烯酰氧乙基三甲基氯化铵为单体,在复合引发剂的作用下,选择水溶液共聚法合成高分子量与高纯度阳离子型聚丙烯酰胺(CPAM)。实验表明,有机偶氮引发剂A用量0.5‰、氧化还原引发剂用量0.45‰、还原剂与氧化剂摩尔比2∶1、反应体系pH为4与反应时间5 h条件下,CPAM分子量为1 042万,且溶解性好。通过对聚合物残单含量影响因素添加剂用量、反应时间的研究,结果表明,添加剂EDTA和增溶剂D对残留AM含量影响小,而苯甲酸钠对聚合物残留AM的含量影响显著;延长反应时间至7 h,残单含量可降低至0.27%,CPAM的纯度高。通过与国内外3种同类型产品进行对比,结果表明,自制产品的分子量明显高于其他产品,且残单含量比国内产品降低了50%～75%。