各种影响因子对电解法预处理医药废水的影响研究

探讨了电解法预处理医药废水时停留时间、电解电压、废水初始浓度、温度和废水pH值等影响因子对去除色度、COD和提高废水可生化性等处理效果的影响，并考察了其应用于工业实际废水处理的可行性。实验结果表明：电解法更适合高浓度医药废水的处理，色度的去除率可达到90％以上；电解时间宜控制在40-60min；电解电压越高，废水COD和色度去除效果越好；在实验温度范围内，温度对色度和COD去除率的影响不大；废水pH值为7．5时电解效果最佳，工程运用宜控制在6—9之间。     

Optimizing electron spin resonance detection of hydroxyl radical in water

The parameters affecting the electron spin resonance (ESR) detection of hydroxyl free radical in water are studied and optimized. The hydroxyl radical is generated by the Fenton reaction with iron (II) ammonium sulfate and hydrogen peroxide reacting in a phosphate buffer using N-tert-butyl-alpha-phenylnitron as the spin trap. The concentrations of Fe²⁺, H₂O₂, and phosphate buffer are the parameters studied. The Taguchi method and the orthogonal experiment design were used to evaluate the effects of these parameters on the ESR signal intensity. By the analysis of the signal-to-noise ratio and the analysis of variance, the order of importance of the various parameters on the hydroxyl radical formation is determined for optimal ESR detection of hydroxyl radical. The results will help the development of water purification technologies using hydroxyl free radical as a green oxidant.     

Status of trace elements in paddy soil and sediment in Taihu Lake region

Thirteen paddy soil profiles and river sediments which are sources of irrigation water were collected around the Taihu Lake, and the trace elements were estimated. The content of La and Ce in paddy soil and sediment were 39.3 and 68.6 mg/kg soil and 36.9 and 65.1 mg/kg soil, being within the range of background values. The values for Pb, Cu, Ni, Cr, Co, Mn, Zn, Se in paddy soil were 23.3, 27.8, 25.5, 63.5, 10.2, 386, 68.7 and 0.25 mg/kg soil respectively, all below the national permission level. There was a decline of Zn in paddy soil. Some of the river sediments were seriously polluted. The river in Yangjin site was most contaminated with 5.47 g Cu/kg and 7.4 g Zn/kg. The high concentration of Pb and Ni also was observed in this sediment. River in Weitang, Huashi, Xinzhuang and Meiyan were contaminated with Pb, Cu and Ni to some extent. Zn, Cu and Pb were the main pollutants in present experiment sites. The fast development of village/township industries have caused severe environmental pollution in the Taihu Lake region, especially irrigation river sediments. Se content in plant and seed was 0.04 and 0.03 mg/kg respectively, showed Se-deficiency in paddy soil in the Taihu Lake region.     

含有机物铁泥的超临界水氧化法资源化

氨基染料生产过程中产生大量含有机物的铁泥,对环境造成严重污染并造成资源的极大浪费.利用超临界水氧化法对含有机物铁泥进行资源化处理研究,并对产物进行了X射线衍射分析(XRD)、色差实验与电子探针分析.研究结果显示,用超临界水氧化法处理铁泥可以将铁泥中所含的有机物完全氧化,真正实现环境友好;超临界水首先将铁泥氧化成α-Fe2O3与γ-Fe2O3,再经过800℃煅烧后可以作为氧化铁红颜料使用;超临界反应压力对样品的晶型与颜色影响不大.     

Pesticide residue removal in classic domestic processing of tomato and its effects on product quality

This study was undertaken to evaluate the effectiveness of several household practices (washing with water or acidic, alkaline, and oxidizing solutions, and peeling) in minimizing pesticide residue contamination of tomatoes, as well as the impact on the quality of the treated fruit. Tests were performed using two systemic fungicides (azoxystrobin and difenoconazole) and one contact fungicide (chlorothalonil). Solid-liquid extraction with low temperature partition (SLE/LTP) and liquid-liquid extraction with low temperature partition (LLE/LTP) were used to prepare the samples for pesticides determination by gas chromatography. Washing the tomatoes with water removed approximately 44% of chlorothalonil, 26% of difenoconazole, and 17% of azoxystrobin. Sodium bicarbonate (5%) and acetic acid (5%) solutions were more efficient, removing between 32 and 83% of the residues, while peeling removed from 68 to 88% of the pesticides. The washing solutions altered some fruit quality parameters, including acidity and chroma, and also caused weight loss. Acetic acid (0.15 and 5%) and hypochlorite (1%) solutions had the greatest effect on these parameters.     

The velocity of DNAPL fingering in water-saturated porous media: laboratory experiments and a mobile-immobile-zone model.

Dense nonaqueous phase liquids (DNAPLs) are immiscible with water and can give rise to highly fingered fluid distributions when infiltrating through water-saturated porous media. In this paper, a conceptual mobile-immobile-zone (MIZ) model is presented to describe the structure of a DNAPL finger in water-saturated porous media and the velocity of finger propagation. A finger is composed of a finger body and a tip. The finger body has a mobile core and an immobile sheath. All the DNAPL within the tip of a finger is mobile. Lab experiments utilizing image analyses of a DNAPL (PCE) penetrating into water-saturated homogeneous glass beads were carried out in a two-dimensional transparent chamber. The results show that the fingers elongated almost linearly with time. The fingers did not grow laterally after the tip of the finger had passed. The average finger diameters were between 3.9 and 5.4 mm for PCE propagation in water-saturated glass bead porous media with mean particle diameters from 0.32 to 1.36 mm. The estimated mobile core diameters were 51-60% of the average finger diameters.     

Precipitation chemistry in the coast of the Metropolitan Region of Rio de Janeiro, Brazil

Precipitation chemistry was studied in the Metropolitan Region of Rio de Janeiro (MRRJ). This study reveals that rainwater in the MRRJ is affected by emissions of air pollutants and provides essential data for future estimates of regional biogeochemical cycles and the impacts of acid deposition on tropical ecosystems. The volume-weighted mean (VWM) pH was 4.77, varying from 3.50 to 6.85. Sea-salt aerosols were the dominant sources of the Na+, Cl- and Mg2+. Excess SO4(2-), Ca2+ and K+ comprised 82, 91, and 87% of their total VWM concentrations, respectively. There were very strong correlations (r > 0.75, P > 0.01) for NO3- and H+, NO3- and excess(exc-)SO4(2-), NH4+ and exc-K+, and exc-SO4(2-) and exc-Ca2+, suggesting causal relationships between these ion pairs. The VWM concentrations of all major ions, except H+, were higher in the dry season, with dry to wet VWM concentration ratios varying from 1.1 (NH4+) to 4.7 (for total K+).     

Attempt to adsorb N-nitrosamines in solution by use of zeolites

The strong adsorption of zeolite for N-nitrosamines in solution was first revealed by use of adsorption, and temperature programmed surface reaction (TPSR) techniques. N-nitrosodimethylamine (NDMA) and N-nitrosopyrrolidine (NPYR) as well as N-nitrosohexamethyleneimine (NHMI) can be adsorbed on zeolite Y, ZSM-5 and A in the solution of methylene chloride or water, which will be helpful for removal of the N-nitrosamines pollution in environmental protection. The equilibrium data were fitted to Freundlich-type isotherms, but the adsorption capacity of zeolites mainly depended on their pore size, surface area and acid-basic properties. Molecular size of adsorbate and solute-solvent interaction also strongly affected the adsorption of N-nitrosamines on zeolite in solution. The extraordinary adsorption properties of NaA zeolite for N-nitrosamines in aqueous solution is first reported and discussed.     

Preparations of organobentonite using nonionic surfactants

Due to hydrophilic environment at its surface, natural bentonite is an ineffective sorbent for nonpolar nonionic organic compounds in water even though it has high surface area. The surface properties of natural bentonite can be greatly modified by simple ion-exchange reactions with large organic cations (cationic surfactants) and this organobentonite is highly effective in removing nonionic organic compounds from water. Cationic surfactant derived organobentonites have been investigated extensively for a wide variety of environmental applications. In this study, the preparation of organobentonite using nonionic surfactants has been investigated for the first time. Results indicate that nonionic surfactants intercalates into the interlamellar space of bentonite and may demonstrate higher sorption capacity than cationic surfactant. It is possible to create large interlayer spacing and high organic carbon content organobentonite by use of nonionic surfactants with suitable balance between the hydrocarbon and ethylene oxide chain lengths. In addition, nonionic surfactant derived organobentonites are more chemically stable than cationic surfactant derived organobentonites.     

Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).