偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附

以腈纶纤维为原料络合Fe3+制得偕胺肟合铁(Ⅲ)纤维,用其处理α-萘酚溶液,研究了偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附工艺条件和吸附动力学参数。实验结果表明,偕胺肟合铁(Ⅲ)纤维对α-萘酚的最佳吸附工艺条件为pH=3.0、吸附温度313.15K和吸附时间45min。在最佳工艺条件下,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附在所研究的α-萘酚浓度范围内符合Freundlich等温吸附方程。未达到饱和吸附前,偕胺肟合铁(Ⅲ)纤维对α-萘酚的吸附符合一级反应动力学特征。     

化学还原法回收含银电镀废液中的银

以Na2S2O4为还原剂,采用化学还原法回收某电镀厂含银电镀废液中的银。实验结果表明,在n(Na2S2O4)∶n(Ag+)=2.5、反应温度35℃、废水pH7.5、搅拌速率300r/min的条件下,Ag+回收率达到99.92%。对回收的银粉进行X射线衍射和扫描电子显微镜分析,分析结果表明回收的银粉纯度较高,成球形。     

废纸苯酚液化物合成热固型酚醛树脂

为了提高废纸的附加值,利用废纸苯酚液化物与甲醛在碱性环境中反应,进行热固型酚醛树脂合成实验。通过正交实验确定最优化的树脂化合成工艺为:n(甲醛)∶n(废纸液化物)=2.1,n(氢氧化钠)∶n(废纸液化物)=0.5,合成温度74℃,合成时间3.0h。在此工艺条件下制备的酚醛树脂压制的胶合板达到GB/T9846—2004《人造板及饰面人造板理化性能试验方法》中Ⅰ类胶合板的强度要求。     

Global sensitivity analysis of a process-based model for ammonia emissions from manure storage and treatment structures

The development of process-based models to estimate ammonia emissions from animal feeding operations (AFOSs) is sought to replace costly and time-consuming direct measurements. Critical to process-based model development is conducting sensitivity analysis to determine the input parameters and their interactions that contribute most to the variance of the model output. Global and relative sensitivity analyses were applied to a process-based model for predicting ammonia emissions from the surface of anaerobic lagoons for treating and storing manure. The objectives were to compare global sensitivity analysis (GSA) to relative (local) sensitivity analysis (RSA) on a process-based model for ammonia emissions. Based on the first-order coefficient, both GSA and RSA showed the model input parameters in order of importance in process model for ammonia emissions from lagoon surfaces were: (i) pH, (ii) lagoon liquid temperature, (iii) wind speed above the lagoon surface, and (iv) the concentration of ammoniacal nitrogen in the lagoon. The GSA revealed that interactions between model parameters accounted for over two-thirds of the model variance, a result that cannot be achieved using traditional RSA. Also, the GSA showed that parameter interactions involving liquid pH had more impact on the model output variance than the single parameters: (i) temperature, (ii) wind speed, or (iii) total ammoniacal nitrogen. This study demonstrates that GSA provides a more complete analysis of model input parameters and their interactions on the model output compared to RSA. A comprehensive tutorial regarding the application of GSA to a process model is presented.     

疏水改性阳离子聚丙烯酰胺絮凝剂的制备及其絮凝性能

通过水溶液共聚合法,以丙烯酰胺(AM)、丙烯酰氧乙基三甲基氯化铵(DAC)和2-乙烯基吡啶(2-VP)为共聚单体合成了疏水改性阳离子聚丙烯酰胺P(AM-DAC-2VP),并用红外光谱仪和核磁共振光谱仪对其结构进行了表征。实验结果表明:当w(2-VP)为1.0%、w(DAC)为30%、活性污泥pH为5、P(AM-DAC-2VP)加入量为25mg/L时,P(AM-DAC-2VP)对本实验的活性污泥絮凝能力最强,上清液透光率为92.1%;P(AM-DAC-2VP)比同条件下制备的阳离子聚丙烯酰胺P(AM-DAC)具有更好的絮凝效果。     

溶剂热法合成SnWO4及其可见光催化活性

采用溶剂热法合成了新型的可见光催化剂SnWO4,以甲基橙为目标污染物,考察了合成温度、合成时间和煅烧工艺对催化剂可见光催化活性的影响。实验结果表明:煅烧工艺会明显降低催化剂的光催化活性;在合成温度为180℃、合成时间为8h、未煅烧的条件下,合成的催化剂的光催化效果最好,光照90min后,对甲基橙的降解率可达99.93%。     

隔震:保证建筑物地震安全的最佳选择

<正>几十年地震预报实践说明,地震预报尚未成熟,远未达到实用化,目前仍属于摸索探索阶段。有些地震虽然说可能作预测预报,但即使预报了,对一个大城市而言也不会轻易疏散、停工停产,而且地震发生了城市的物质文明建设照样会遭到严重破坏。换个方式去思维去实践,即把城乡建筑的抗震性能提高了,尤其是住宅建筑和重     

壳聚糖三元接枝共聚物的合成及其阻垢性能

以壳聚糖(CTS)、衣康酸(IA)和马来酸酐(MA)为原料,以醋酸为溶剂、(NH_4)_2S_2O_8为引发剂,合成了CTS-IA-MA三元接枝共聚物。聚合反应的最佳条件为:反应温度90℃,n(CTS):n(IA):n(MA)=1:1.5:1.0,引发剂质量分数0.35%,反应时间5 h。通过傅立叶变换红外光谱(FTIR)表征,所得产物为CTS-IA-MA接枝共聚物。三元接枝共聚物质量浓度为50 mg/L、水样pH为中性或弱酸性时三元接枝共聚物对CaCO_3的阻垢效果较好。     

液相色谱-质谱法测定水中氨基甲酸酯类农药及其代谢物

建立了直接测定水中10种氨基甲酸酯类农药及其代谢物的超高效液相色谱-质谱分析方法。该方法对水样无需进行富集处理,水样过滤后就可以直接测定。实验结果表明:测定液中各氨基甲酸酯类农药及其代谢物的质量浓度与离子对峰面积在质量浓度0.5～1 000.0μg/L内具有良好的线性关系;方法检出限为0.1～5.0μg/L;加标回收率91%～103%;相对标准偏差为2%～5%。该方法具有简便快捷、灵敏度高的特点。