Diminution of migration of phthalic acid esters in tequila beverage by the year of production

Abstract

The presence of diethyl-phthalate (DEP), dibutyl-phthalate (DBP), butylbenzyl-phthalate (BBP), diethylhexyl-phthalate (DEHP) and diisononyl-phthalate (DINP) was determined in 295 tequila samples. They were grouped by age of maturation (white, aged, extra aged or ultra aged) and year of production (between 2013 and 2018). Gas Chromatography coupled with Mass Spectrometry was used for identification and quantification. The results showed that 65 samples (22% of the total) were phthalate free. DEP (0.13-0.27?mg/kg), BBP (0.05–2.91?mg/kg) and DINP (1.64–3.43?mg/kg) were detected in 11 (3.73%), 37 (12.54%) and 5 (1.69%) samples, respectively. But, these concentrations did not exceed the maximum permitted limits (MPL) of phthalates for alcoholic beverages. DBP (0.01–2.20?mg/kg) and DEHP (0.03–4.64?mg/kg) were detected in 96 (32.54%) and 224 (75.93%) samples, from them only 10 (3.39%) and 15 (5.08%) samples, respectively, exceeded the MPL for alcoholic beverages and they were few tequilas produced in the year 2014 or before. DEHP was the most frequent phthalate found in tequila and observed DEHP concentrations were 2-times higher in ultra aged tequilas compared to those in white tequilas. We concluded that all tequilas produced in 2015 and after, satisfied the international standards for these compounds.     

The use of nanovermiculite catalyst in the study of removal of the organic load and degradation of atrazine via ozone process in RPB reactor

Abstract

The main objective of this study is the degradation of a synthetic solution of atrazine by a modified vermiculite catalyzed ozonation, in a rotating packed bed (RPB) reactor. A 0.5?L RPB reactor was used to perform the experiments, using a Central Composite Design (CCD) response surface to construct the quadratic model based on the factors: pH, catalyst concentration and reactor rotation frequency. The response variable was the removal of the organic load measured in terms of Chemical Oxygen Demand (COD). After the complete quadratic model was constructed through the response surface, the COD degradation process had an optimal removal of 41% under the following conditions: pH 8.0, rotation of 1150?rpm and catalyst concentration 0.66?g L^?1.     

Biodegradation of anthracene and different PAHs by a yellow laccase from Leucoagaricus gongylophorus

Environmental Science and Pollution Research - Laccases produced by Leucoagaricus gongylophorus act in lignocellulose degradation and detoxification processes. Therefore, the use of L....     

Activated carbon produced from waste coffee grounds for an effective removal of bisphenol-A in aqueous medium

Environmental Science and Pollution Research - Bisphenol-A is widely used chemical in industry and unfortunately often detected in natural waters. Considered as an emerging pollutant, bisphenol-A...     

The use of XAD-resins for the detection of mutagenic activity in water: I. Studies with surface water

A study of the effects of different XAD-resins, bed volume, flow rate, pH and type of eluent on the extraction of organic mutagens from surface water is presented. XAD-4/8 is as effective as XAD-2 in concentrating organic mutagens from surface water and dimethylsulfoxide (DMSO) is as efficient as acetone in eluting the adsorbed organic mutagens. The latter allows direct testing up to 0.5 ml of DMSO concentrate in the Ames test. Variation of the pH of the water after passing the XAD-4/8, followed by readsorption, shows that the majority of the mutagenic activity due to dissolved organics is adsorbed at neutral pH. Only a minor fraction is readsorbed at pH 3. Further a XAD-4/8 concentrate and a similar concentrate prepared by freeze drying gives similar mutagenic activity. This indicates that many of the organic mutagens are recovered in the XAD-4/8 concentrate.It is concluded that adsorption on XAD-4/8, followed by direct testing of the DMSO eluates in the Ames test, presents a rapid and relatively simple way to detect low concentrations of organic mutagens in surface water. The general suitability of the method is shown for different types of surface water.     

Dissipation of DDT in a heavily contaminated soil in Mato Grosso, Brazil

After the prohibition of organochlorine-pesticide use in Brazil for controlling insect vector diseases, Mato Grosso State gathered the exceeding DDT and stored it irregularly in an open air area that belongs to the National Health Foundation, causing soil contamination. This study aimed to evaluate the contamination level and dissipation of p,p'-DDT and p,p'-DDE in this area. For that, surface soil samples were collected on 19 September 2000, 15 December 2000, 4 April 2001 and soil samples 30-40 cm; 60-70 cm and 90-100 cm deep were taken from five points in the studied area on 17 July 2001. The contaminants were determined by a small scale method which consists on extraction and clean-up steps combined into one step by transferring soil samples mixed with neutral alumina to a chromatographic column prepacked with neutral alumina and elution with hexane:dichloromethane (7:3 v:v). The eluate was concentrated and the analytes were quantified by gas chromatography with an electron-capture detector. p,p'-DDT at surface soil ranged from 3,800 to 7,300 mg kg(-1). 30-40 cm deep soil sample concentrations varied from 0.036 to 440 mg kg(-1) while 90-100 cm deep samples varied from 0.069 to 180 mg kg(-1). Volatilization is probably the main dissipation process. The p,p'-DDT is moving slowly downward in the soil profile, however, the levels of this contaminant are high enough to present risk to underground waters.     

Modeling lead bioavailability and bioaccumulation by Lumbriculus variegatus using artificial particles. Potential use in chemical remediation processes

Artificial particles, specifically a diverse selection of chromatographical resins, have been recommended and used as a useful experimental model to predict the bioavailability and bioaccumulation of sediment-bound organic chemicals. In this work the same experimental model was adopted to investigate the bioavailability and bioaccumulation of lead by the freshwater oligochaete Lumbriculus variegatus. Particle-water partition coefficients were also determined. Sand particles and the anionic exchange resin promoted a similar uptake and bioaccumulation of lead. Instead, in the presence of the cationic exchanger the metal was not detected in the animals. For neutral particles, the uptake and accumulation depended on the chemistry of the functional groups at the active sites. In addition, a significant negative correlation was found between bioaccumulation and the particle-water partition coefficients. These studies may help to develop alternative methods for chemical remediation of lead-contaminated aquatic systems.     

Effect of chromium on the fatty acid composition of two strains of Euglena gracilis

The effect of hexavalent chromium on fatty acid composition was studied in two strains of Euglena gracilis; UTEX 753 (from the Culture Collection of Algae of Texas University, USA) and MAT (isolated from a highly polluted River). Both were grown in photoauxotrophic and photoheterotrophic conditions and exposed to two metal concentrations, one below and one above IC50. The high malondialdehyde (MDA) levels (3 to 7-fold) obtained with chromium concentration above IC50, suggested the existence of metal-induced lipid peroxidation. Total lipid content increased only with concentration below IC50, whereas it was inhibited by higher metal concentration. Photoheterotrophic control strains exhibited a significantly higher proportion of saturated and polyunsaturated fatty acids. Polyunsaturated acids were most affected by chromium, especially those related to chloroplast structures. Ultra-structure studies showed clear thylakoid disorganization in all treated cells. The results indicate that hexavalent chromium affects levels of fatty acids, especially those related to photosynthetic activity.     

Solventless sample preparation for pesticides analysis in environmental water samples using solid-phase microextraction-high resolution gas chromatography/mass spectrometry (SPME-HRGC/MS)

Solid-phase micro-extraction (SPME) coupled on line with high resolution gas chromatography and mass spectrometric detection is described for the analysis of pesticides in environmental water samples. Experiments were performed in order to optimize the SPME extraction conditions for selected pesticides including tiomethon, trichorfon, dimethoate, diazinon, malathion, dicofol, methidathion, ethion, bromopropylate and pyrazophos from spiked water solutions. To enhance the SPME efficiency, experimental conditions including the fiber composition, stirring rate, temperature, adsorption time, desorption time and salt concentration were optimized. After validation, the SPME-GC/MS methodology was applied to real-world environmental water samples.     

Sustainable watershed management: an international multi-watershed case study

Global freshwater resources are being increasingly polluted and depleted, threatening sustainable development and human and ecosystem health. Utilizing case studies from 4 different watersheds in the United States, Japan, Switzerland, and Brazil, this paper identifies the most relevant sustainability deficits and derives general vectors for more sustainable water management. As a consequence of the demographic and economic developments experienced in the last few decades, each watershed has suffered declines in water quality, streamflow and biotic resources. However, the extent and the cultural perception of these water-related problems vary substantially in the different watersheds, leading to specific water-management strategies. In industrialized countries, exemplified by the US, Switzerland, and Japan, these strategies have primarily consisted of finance- and energy-intensive technologies, allowing these countries to meet water requirements while minimizing human health risks. But, from a sustainability point of view, such strategies, relying on limited natural resources, are not long-term solutions. For newly industrialized countries such as Brazil, expensive technologies for water management are often not economically feasible, thus limiting the extent to which newly industrialized and developing countries can utilize the expertise offered by the industrialized world. Sustainable water management has to be achieved by a common learning process involving industrialized, newly industrialized, and developing countries, following general sustainability guidelines as exemplified in this paper.