2D brine sewage after impinging on a shallow sea free surface

We consider the problem of the vertically upwards disposal of heavy brine sewage from a two-dimensional diffuser in a lighter, homogeneous, motionless and shallow ambient sea. The rejected high salinity water of seawater desalination plants for urban and agricultural uses is such a case of a two dimensional fountain. The disposal of brine sewage produces a negative buoyant jet due to its initial momentum, which impinges on the free surface, spreads laterally on it and then sinks downwards, because of the negative buoyancy. Laboratory experiments and dimensional considerations are used in this paper in order to investigate the spreading behavior (width) of the vertical fountain which impinges on the free surface of the shallow ambient fluid. The experimental results have been used to derive an equation relating the width at the free surface with the initial parameters of the flow. In addition, the experimentally measured dilution of the heavier brine sewage on the recipient’s surface is compared with the dilution which was calculated by a numerical simulation of a well-known commercial software package, CORJET (a CORMIX sub model).     

Simulation of dam/levee-break hydrodynamics with a three-dimensional implicit unstructured-mesh finite element model

Dam failures usually cause huge economic and life losses , especially in urban areas where there is a high concentration of inhabitants and economic actors. In order to understand the physical mechanisms of the formation and development of dam-break flooding, lots of efforts have been put into different types of modelling techniques. However, most of existing models are 1D (one-dimensional) or 2D models based on the shallow water equations. In this paper, we present a 3D numerical modelling investigation of dam-break flow hydrodynamics in an open L-shape channel. A newly developed 3D unstructured mesh finite element model is used here. An absorption-like term is introduced to the Navier–Stokes equations in order to control the conditioning of the matrix equation in the numerical solution process and thus improve the stability. A wetting and drying algorithm is used here to allow the free surface height to be treated with a high level of implicitness and stability. The 3D model has been validated by comparing the results with the published experimental data. Good agreement has been achieved at six selected locations. This study shows that the 3D unstructured mesh model is capable of capturing the 3D hydraulic aspects and complicated local flows around structures in simulation of dam-break flows.     

PBDEs and PCBs in sediments of the Thi Nai Lagoon (Central Vietnam) and soils from its mainland

Concentration and distribution of PCBs, PCB 11, and PBDEs in both surficial sediment and soil samples, taken from a zone subject to recent accelerated development, were investigated to assess the environmental quality and understand both natural and anthropogenic processes that influence contaminant behaviors. Values of PCB and PBDE are in the lower range of those reported in literature, typical of low impacted coastal zones. This could be due to efficient processes of resuspension and removal. Contaminants in the lagoon showed higher concentrations in sediments from sites close to the city and the outfalls of the industrial area, while soils showed maximum values in the northern samples. In addition, congener patterns and statistical analyses suggest the presence of effective degradation processes, especially for PBDEs, with the exception of the most concentrated samples that may indicate a direct input. PCB 11 is a significant component (up to 18%) in most lagoon sediments. Its presence is strongly associated with fine particles, thus the distribution seems to be driven mainly by the system hydrodynamic and does not trace the sources. Due to evaporation, only flooded agricultural soils show a similar relative abundance of this congener.     

Effect of inoculation methods on the composting efficiency of municipal solid wastes

Four types of inoculation methods were studied during the composting of municipal solid wastes and dry grass (MSWG). The methods included a control group as well as initial-stage, two-stage, and multi-stage inoculations. Fulvic acids were extracted from the composting materials and characterized by spectroscopic techniques. The results showed that inoculation of microbes in MSWG enhanced the biodegradation of aliphatics, proteins, and polysaccharides. The inoculation also increased the molecular weight, humic- and fulvic-like compound content, as well as humification degree of the composting products. The inoculation of microbes in MSWG significantly improved composting process and efficiency. The improvement efficiency was in the order of initial-stage < two-stage < multi-stage inoculations. Inoculation of microbes based on composting organic matter composition and temperature enhanced composting efficiency.     

无砾石微孔管地下渗滤系统处理生活污水的中试研究

进行了无砾石微孔管地下渗滤系统处理生活污水的中试研究。基于不同土壤、不同管径、不同植物的协同效应,对比研究了不同系统处理污水中有机物、氮、磷和SS的去除效果及其影响因素。结果表明,不同土壤、不同管径及不同植物组成的系统,对生活污水中有机物、氮、磷和SS的去除效果差别较大。中试系统对COD、总磷、氨氮、总氮和SS的最佳去除率分别达到86.13%、90.20%、61.24%、65.49%和97.43%,对应的出水COD、总磷、氨氮、总氮和SS的平均浓度分别为64.29、0.69、22.13、26.19和5.56 mg/L。分析表明,进水SS浓度过高、外界温度下降等共同作用是导致系统对生活污水中NH4+-N和TN的去除率相对较低的主要原因。     

A moving target—incorporating knowledge of the spatial ecology of fish into the assessment and management of freshwater fish populations

Freshwater fish move vertically and horizontally through the aquatic landscape for a variety of reasons, such as to find and exploit patchy resources or to locate essential habitats (e.g., for spawning). Inherent challenges exist with the assessment of fish populations because they are moving targets. We submit that quantifying and describing the spatial ecology of fish and their habitat is an important component of freshwater fishery assessment and management. With a growing number of tools available for studying the spatial ecology of fishes (e.g., telemetry, population genetics, hydroacoustics, otolith microchemistry, stable isotope analysis), new knowledge can now be generated and incorporated into biological assessment and fishery management. For example, knowing when, where, and how to deploy assessment gears is essential to inform, refine, or calibrate assessment protocols. Such information is also useful for quantifying or avoiding bycatch of imperiled species. Knowledge of habitat connectivity and usage can identify critically important migration corridors and habitats and can be used to improve our understanding of variables that influence spatial structuring of fish populations. Similarly, demographic processes are partly driven by the behavior of fish and mediated by environmental drivers. Information on these processes is critical to the development and application of realistic population dynamics models. Collectively, biological assessment, when informed by knowledge of spatial ecology, can provide managers with the ability to understand how and when fish and their habitats may be exposed to different threats. Naturally, this knowledge helps to better evaluate or develop strategies to protect the long-term viability of fishery production. Failure to understand the spatial ecology of fishes and to incorporate spatiotemporal data can bias population assessments and forecasts and potentially lead to ineffective or counterproductive management actions.     

Development and Testing of 2D Finite Difference Model in Open Channels

This study develops a depth-averaged two-dimensional (2D) numerical model using a finite difference method (FDM) on a staggered grid. The governing equations were solved using the Marker and Cell method that was developed at the Los Alamos laboratories by Harlow and Welch in 1965. In the paper, an explicit FDM was used to solve the governing equations. A first-order approximation was used for the temporal derivative. Second-order central difference approximations were used for space discretization. The time step is limited by the Courant–Friedrichs–Lewy (CFL) condition. The time step used in this study depends on the grid spacing and velocity components in the x- and y-directions. The study is divided into two steps: the first step is to develop a depth-averaged 2D numerical model to simulate the flow process. The second constructs a module to calculate the bed load transport and simulate the river morphology in the areas that have steep slopes, torrents, and mountain rivers. Developed model was applied to the artificial channel and a flood event in the Asungjun River section of the mountainous Yangyang Namdae River (South Korea). General simulation results showed that the developed model was in good agreement with the observed data.     

郫县灰潮田有效硅含量和小麦施硅效应初探

通过同田对比试验，本文对郫县水稻土小麦施用硅肥进行了初步研究．结果表明，小麦施硅获得了增产效果；施硅对小麦穗粒数、株高和基部节间体积等具有生长效应；郫县水稻土有效硅含量为１２７±３９ｍｇ·ｋｇ－１（ｎ＝１２），变异较大，与土壤粘粒（＜０．００１ｍｍ）呈极显著正相关（ｒ＝０．７９）；发育于第四系岷江灰色冲积母质的郫县水稻上，粘粘含量普遍较低，因此，郫县小麦施硅具有较大增产潜力．     

山东省生物多样性及其保护与开发利用

山东省自然条件优越，生态环境多样，因而具有极其丰富的生物多样性，本文初步研究了山东省生物多样性现状，保护与经济协调发展对策。     

西藏高山松松脂资源及其开发利用前景

本文在西藏高山松进行的采脂试验和对松脂及其加工产品松香，松节油的成分，含量和质量分析的基础上，论述了西藏高山松松脂资源潜在的质量优势及其潜在的经济效益，据此结合西藏的实际，对开发利用高山松松脂资源的前景作了分析并提出了几点建议。