Electrocatalytic reduction of nitrate ions from water using polyaniline nanofibers modified gold electrode

Polyaniline (PANI) nanofibers were electrochemically synthesized on gold electrode using ethanol as soft template by the cyclic voltammetry technique. The PANI nanofibers were characterized by Fourier transform infrared spectroscopy, UV-visible spectroscopy, and scanning electron microscopy. Linear sweep voltammetry was used to investigate electrocatalytic activity of the PANI nanofibers modified electrode toward the reduction of nitrate ions. Results showed that the electroreduction process strongly depends on the applied potential. At the potential value of about -0.8 V vs Ag/AgCl, the electroreduction of nitrate anions to nitrite anions was identified as the rate-determining step of the electroreduction process. In the potential range of -0.8 to -1.0 V, reduction of nitrite to hydroxylamine occurs, followed by the reduction to ammonia. At potentials more negative than -1.0 V, nitrite is directly reduced to ammonia. This study demonstrates the effectiveness of PANI nanofibers modified electrode in the electroreduction of nitrate ions compared to traditional reduction methods.     

Occurrence of alternative flame retardants in indoor dust from New Zealand: indoor sources and human exposure assessment

Due to worldwide restrictions on polybrominated diphenyl ethers (PBDEs), the demand for alternative flame retardants (AFRs), such as organophosphate flame retardants (OPFRs), novel brominated FRs (NBFRs) and hexabromocyclododecanes (HBCDs), has recently increased. Little is known about human exposure to NBFRs and OPFRs and that their levels in dust have been scarcely evaluated worldwide. To increase the knowledge regarding these chemicals, we measured concentrations of five major NBFRs, ten OPFRs and three HBCD isomers in indoor dust from New Zealand homes. Dust samples were taken from living room floors (n=34) and from mattresses of the same houses (n=16). Concentrations (ngg(-1)) of NBFRs were: 1,2-bis(2,4,6-tribromophenoxy)ethane (BTBPE) (<2-175), decabromodiphenyl ethane (DBDPE) (<5-1430), 2-ethylhexyl-2,3,4,5-tetrabromobenzoate (TBB) (<2-2285) and bis(2-ethylhexyl)-3,4,5,6-tetrabromophthalate (TBPH) (<2-640). For OPFRs, concentrations (ngg(-1)) ranged between: tri-ethyl-phosphate (TEP) (<10-235), tri-n-butyl-phosphate (TnBP) (<20-7545), tris-(2-chloroethyl)-phosphate (TCEP) (<20-7605), tris-(1-chloro-2-propyl) phosphate (TCPP) (20-7615), tri-(2-butoxyethyl)-phosphate (TBEP) (50-27325), tris-(2,3-dichloropropyl)-phosphate (TDCPP) (20-16560), tri-phenyl-phosphate (TPhP) (20-35190), and tri-cresyl-phosphate (TCP) (<50-3760). HBCD concentrations fell in the range <2-4100ngg(-1). BTBPE, DBDPE, TBPH, TBEP, and TnBP showed significant positive correlation (p<0.05) between their concentrations in mattresses and the corresponding floor dust (n=16). These data were used to derive a range of plausible exposure scenarios. Although the estimated exposure is well below the corresponding reference doses (RfDs), caution is needed given the likely future increase in use of these FRs and the currently unknown contribution to human exposure by other pathways such as inhalation and diet.     

Heterogeneous reductive dehalogenation of PCB contaminated transformer oil and brominated diphenyl ethers with zero valent iron

Reductive dechlorination and debromination of halogenated biphenyls (PCBs) and diphenyl ethers (PBDEs) occurs efficiently at moderately elevated temperatures (350-600 °C) with zero valent iron (iron powder) in a nitrogen atmosphere. The proton donors tested were waste transformer oil, iso-octane, and n-decane. Observation of production of biphenyl and diphenyl ether and their condensation products indicates that the reaction is not simple pyrolysis, but a reduction. No halogenated organic products are observed.     

Growth responses of crop and weed species to heavy metals in pot and field experiments

Greenhouse and field studies were performed to examine the growth responses and possible phytoremediation capacity towards heavy metals of several Brassicaceae (Brassica alba, Brassica carinata, Brassica napus and Brassica nigra) and Poaceae (durum wheat and barley). Soils used featured total concentrations of Cr, Cu, Pb and Zn largely exceeding the maximum levels permitted by the Italian laws. Different organic amendments were tested such as a compost and the plant growth-promoting rhizobacterium Bacillus licheniformis. In the greenhouse experiment, plant length, leaf area index and shoots dry matter were evaluated periodically for the Brassicaceae examined. Whereas plant length, grains production, weight of 1,000 seeds, ear fertility and tiller density were determined under field conditions at the end of the crop cycle for wheat and barley. In general, the species tested appeared to be tolerant to high heavy metal concentrations in soil, and slightly significant differences were found for all parameters considered. A marked growth increase was shown to occur for Brassicaceae cultivated on compost- and bacillus-amended contaminated soils, with respect to non-amended contaminated soils. With some exception, higher growth parameters were measured for wheat and barley plants cropped from contaminated soils in comparison to non-contaminated soils. Further, bacillus amendment enhanced the length of wheat and barley plants in both non-contaminated and contaminated soils, while different effects were observed for the other parameters evaluated.     

Resolving the interactions between population density and air pollution emissions controls in the San Joaquin Valley, USA

The effectiveness of emissions control programs designed to reduce concentrations of airborne particulate matter with an aerodynamic diameter < 2.5 microm (PM2.5) in California's San Joaquin Valley was studied in the year 2030 under three growth scenarios: low, medium, and high population density. Base-case inventories for each choice of population density were created using a coupled emissions modeling system that simultaneously considered interactions between land use and transportation, area source, and point source emissions. The ambient PM2.5 response to each combination of population density and emissions control was evaluated using a regional chemical transport model over a 3-week winter stagnation episode. Comparisons between scenarios were based on regional average and population-weighted PM2.5 concentrations. In the absence of any emissions control program, population-weighted concentrations of PM2.5 in the future San Joaquin Valley are lowest undergrowth scenarios that emphasize low population density. A complete ban on wood burning and a 90% reduction in emissions from food cooking operations and diesel engines must occur before medium- to high-density growth scenarios result in lower population-weighted concentrations of PM2.5. These trends partly reflect the fact that existing downtown urban cores that naturally act as anchor points for new high-density growth in the San Joaquin Valley are located close to major transportation corridors for goods movement. Adding growth buffers around transportation corridors had little impact in the current analysis, since the 8-km resolution of the chemical transport model already provided an artificial buffer around major emissions sources. Assuming that future emissions controls will greatly reduce or eliminate emissions from residential wood burning, food cooking, and diesel engines, the 2030 growth scenario using "as-planned" (medium) population density achieves the lowest population-weighted average PM2.5 concentration in the future San Joaquin Valley during a severe winter stagnation event. Implications: The San Joaquin Valley is one of the most heavily polluted air basins in the United States that are projected to experience strong population growth in the coming decades. The best plan to improve air quality in the region combines medium- or high-density population growth with rigorous emissions controls. In the absences of controls, high-density growth leads to increased population exposure to PM2.5 compared with low-density growth scenarios (urban sprawl).     

Levels and seasonal variations of organochlorine pesticides in urban and rural background air of southern Ghana

Urban, suburban and rural background air samples were collected in southern Ghana in 2008 employing polyurethane foam disc passive air samplers (PAS). PAS were analysed for organochlorine pesticides (OCPs), namely hexachlorocyclohexanes (α-, β-, γ- and δ-hexachlorocyclohexane), dichlorodiphenyltrichloroethane including metabolites (o,p'- and p,p'-DDT, DDE and DDD), hexachlorobenzene, pentachlorobenzene, aldrin, dieldrin, endrins (endrin, endrin aldehyde and endrin ketone), isodrin, heptachlors (heptachlor, heptachlor epoxide A and heptachlor epoxide B), chlordanes (α-, β-chlordane, oxychlordane and trans-nonachlor), endosulfans (α- and β-endosulfan and endosulfan sulphate), methoxychlor and mirex using a gas chromatograph coupled to a mass spectrometer. The levels of OCPs ranged for the individual pesticides from below limit of quantification to 750 pg m(-3) (for α-endosulfan), and current agricultural application seemed to be the main primary source of most abundant pesticides. Re-volatilization of previously used pesticides from contaminated soils could not be ruled out either as potential secondary source of contamination, especially in warm and dry seasons and periods of intensive agricultural activities. Higher atmospheric concentrations were observed in November and December during the dry season compared to lower concentrations observed in June, July and August when the country experiences heavy rains. The highest seasonal variation was observed for currently used pesticides as α-endosulfan. A p,p'-DDT/p,p'-DDE ratio suggested recent inputs of fresh technical DDT.     

Formation pathways of polychlorinated dibenzofurans (PCDFs) in sediments contaminated with PCBs during the thermal desorption process

Thermal desorption has attracted considerable interest as a remediation technology for the removal of dioxins and polychlorinated biphenyls (PCBs) from contaminated soils and sediments. Although several research groups have confirmed that polychlorinated dibenzofurans (PCDFs) are formed from PCBs during the thermal desorption of sediments contaminated with PCB, the formation pathways remain poorly understood. Herein, thermal desorption has been used to develop a greater understanding of the formation pathways of PCDFs from sediments contaminated with PCBs. PCB decomposition experiments of sediments contaminated with PCBs were performed over 5 min at 450 °C with a gas composition of 10% O(2)/90% N(2), either in the absence (Run 1) or presence (Run 2-4) of one of three different (13)C(12)-labeled PCB individual standards. The results of Run 1 showed that 99.96% of PCBs and 98.40% of polychlorinated dibenzo-p-dioxins (PCDDs) in the treated sediments had decomposed, whereas the concentration levels of PCDFs had increased by a factor of 31. The addition of different (13)C(12)-labeled PCBs to the sediment sample yielded different (13)C(12)-PCDFs isomer patterns, with formation pathways including loss of ortho-Cl(2), loss of HCl involving a 2,3-chlorine shift, loss of ortho-H(2) and dechlorination.     

Urban transformation of a metropolis and its environmental impacts

Purpose

The aim of this paper is to understand the sustainability of urban spatial transformation in the process of rapid urbanization, and calls for future research on the demographic and economic dimensions of climate change. Shanghai towards its transformation to a metropolis has experienced vast socioeconomic and ecological change and calls for future research on the impacts of demographic and economic dimensions on climate change. We look at the major questions (1) to explore economic and demographic growth, land use and land-cover changes in the context of rapid economic and city growth, and (2) to analyze how the demography and economic growth have been associated with the local air temperature and vegetation.

Method

We examine urban growth, land use and land-cover changes in the context of rapid economic development and urbanization. We assess the impact of urban expansion on local air temperature and vegetation. The analysis is based on time series data of land use, normalized difference vegetation index (NDVI), and meteorological, demographic and economic data.

Results and discussion

The results indicate that urban growth has been driven by mass immigration; as a consequence of economic growth and urban expansion, a large amount of farmland has been converted to paved road and residential buildings. Furthermore, the difference between air temperature in urban and exurban areas has increased rapidly. The decrease of high mean annual NDVI has mainly occurred around the dense urban areas.     

Urbanisation and human health in China: spatial features and a systemic perspective

Background, aims and scope

Current studies have paid little attention to the dynamism in urban spatial expansion and its possible environmental and health effects or to the health effects of rapid urban environmental change at different points along the urbanisation gradient. This study adopts a public health ecology approach to systematically understand the relationship between urbanisation, urban environmental change and human health in China.

Method

Remote sensing image analysis, based on night light data at five different time periods in recent decades, was used to determine changes to the overall urban area. Through a review of the evidence on the relationships between environmental health, urbanisation and health, we advance a pathway framework for explaining urban human health ecology. The Spearman rank correlation coefficient was used to measure the correlation between disease prevalence and urbanisation level, adding a further dimension to a systemic understanding of urban health.

Results and conclusions

Urban areas have been increasing spatially, but unevenly, in recent decades, with medium and small cities also expanding rapidly in the past decade. Urbanisation and urban expansion result in changes to land use/coverage change, the urban environment and the residents?? lifestyle, which result in human health problems. Regions with the highest urbanisation level were more inclined to have a high prevalence of chronic disease in recent decades. An ecological public health approach provides insights into the multiple types of data which need to be routinely collected if human disease is not to become a barrier to social and economic development.     

Enhanced degradation of azo dye alizarin yellow R in a combined process of iron–carbon microelectrolysis and aerobic bio-contact oxidation

Purpose

With the aim of enhanced degradation of azo dye alizarin yellow R (AY) and further removal of the low-strength recalcitrant matter (LsRM) of the secondary effluent as much as possible, our research focused on the combination of aerobic bio-contact oxidation (ABO) with iron/carbon microelectrolysis (ICME) process.

Materials and methods

The combined ABO (with effective volume of 2.4?l) and ICME (with effectively volume of 0.4?l) process were studied with relatively short hydraulic retention time (HRT) of 4 or 6?h.

Results

At the HRT of 6?h with the reflux ratio of 1 and 2, the AY degradation efficiency in the final effluent was >96.5%, and the total organic carbon (TOC) removal efficiency were 69.86% and 79.44%, respectively. At the HRT of 4?h and the reflux ratio of 2, TOC removal efficiency and AY degradation efficiency were 73.94% and 94.89%, respectively. The ICME process obviously enhanced the total AY removal and the generated micromolecule acids and aldehydes then that wastewater backflow to the ABO where they were further biodegraded.

Conclusion

The present research might provide the potential options for the advanced treatment azo dyes wastewater with short HRT and acceptable running costs.