基于测试数据的室内超宽带信道建模研究

基于室内超宽带信道测量研究建立了基于簇的时延抽头模型以及与距离和载频有关的新颖的路径损耗模型,建立了路径损耗同时与距离和频率的依赖关系.同时,研究发现视距和非视距接收信号幅度分别满足莱斯和瑞利分布.该模型对超宽带无线系统仿真和设计有重要的指导意义.     

An analysis of flaring and venting activity in the Alberta upstream oil and gas industry

Alberta, Canada, is an important global producer of petroleum resources. In association with this production, large amounts of gas (1.14 billion m3 in 2008) are flared or vented. Although the amount of flaring and venting has been measurably reduced since 2002, data from 2005 reveal sharp increases in venting, which have important implications in terms of resource conservation and greenhouse gas emissions (which exceeded 8 million tonnes of carbon dioxide equivalent in 2008). With use of extensive monthly production data for 18,203 active batteries spanning the years 2002-2008 obtained in close cooperation with the Alberta Energy Resources Conservation Board, a detailed analysis has been completed to examine activity patterns of flaring and venting and reasons behind these trends in the Alberta upstream oil and gas industry. In any given year, approximately 6000 batteries reported flaring and/or venting, but the distribution of volumes flared and vented at individual sites was highly skewed, such that small numbers of sites handled large fractions of the total gas flaring and venting in the Province. Examination of month-to-month volume variability at individual sites, cast in terms of a nominal turndown ratio that would be required for a compressor to capture that gas and direct it into a pipeline, further revealed that volumes at a majority of sites were reasonably stable and there was no evidence that larger or more stable sites had been preferentially reduced, leaving potential barriers to future mitigation. Through linking of geospatial data with production data coupled with additional statistical analysis, the 31.2% increase in venting volumes since 2005 was revealed to be predominantly associated with increased production of heavier oils and bitumen in the Lloydminster region of the Province. Overall, the data suggest that quite significant reductions in flaring and venting could be realized by seeking mitigation solutions for only the largest batteries in the Province.     

Deriving a bioavailability-based zinc environmental quality standard for France

Environmental Science and Pollution Research - National Environmental Quality Standards (EQS) for zinc used for the assessment of ecological status in freshwaters have been shown to vary by over...     

Replacing monocultures with mixed-species stands: Ecosystem service implications of two production forest alternatives in Sweden

Whereas there is evidence that mixed-species approaches to production forestry in general can provide positive outcomes relative to monocultures, it is less clear to what extent multiple benefits can be derived from specific mixed-species alternatives. To provide such insights requires evaluations of an encompassing suite of ecosystem services, biodiversity, and forest management considerations provided by specific mixtures and monocultures within a region. Here, we conduct such an assessment in Sweden by contrasting even-aged Norway spruce (Picea abies)-dominated stands, with mixed-species stands of spruce and birch (Betula pendula or B. pubescens), or spruce and Scots pine (Pinus sylvestris). By synthesizing the available evidence, we identify positive outcomes from mixtures including increased biodiversity, water quality, esthetic and recreational values, as well as reduced stand vulnerability to pest and pathogen damage. However, some uncertainties and risks were projected to increase, highlighting the importance of conducting comprehensive interdisciplinary evaluations when assessing the pros and cons of mixtures.     

Study on the determination of PCDDs/Fs and HCB in exhaust gas

The subject of this study was to develop a method of simultaneous determination of PCDDs/PCDFs and HCB in exhaust gases from industrial installations. Sampling to determine PCDDs/PCDFs was conducted using the method described in PN-EN 1948-1: 2006, where the sorption material is polyurethane foam (PUF). In order to simultaneously collect PCDDs/PCDFs and HCB and to avoid sorbent bed breakthrough, it was necessary to apply an additional polyurethane sorption layer. Twenty-seven samples of exhaust gases from various cement plants and 40 samples of exhaust gases from hospital and industrial waste incineration plants collected in 2009/2010 in the entire territory of Poland were examined. The average content of PCDDs/Fs in samples from cement plants amounted to 0.076 ng I-TEQ N m(-3) (range of 0.002-0.62 ng I-TEQ N m(-3)), while the average content of HCB amounted to 10 ng N m(-3) (range of 0.98-60.5 ng N m(-3)). In the case of samples collected from waste incineration plants, the average concentration of PCDDs/Fs was 0.39 ng I-TEQN m(-3) (range of 0.002-5.68 ng I-TEQ N m(-3)). In the case of HCB, the average concentration was 238 ng N m(-3) (range of 3.21-2500 ng N m(-3)). Also, the interdependence of the concentration of PCDDs/PCDFs and HCB was determined in the analysed samples, with the ranges of low and high content of PCDDs/PCDFs being examined separately. In all cases, the determined values of the r correlation coefficient were within the range of 0.7-1.0, which indicates a good correlation between the concentrations of PCDDs/PCDFs and HCB.     

Evaluating carbon emissions of China’s waste management strategies for building refurbishment projects: contributing to a circular economy

This study evaluates carbon emissions of construction and demolition (C&D) waste generated by building refurbishment, using a life cycle assessment approach through a case study project in China. Three waste management scenarios were developed for a building refurbishment project in the city of Suzhou. Scenario 1 is under the business-as-usual C&D waste management practice in China; scenario 2 is based on the open-ended 3R strategy, which focuses on the downstream impact of waste; and scenario 3 considers both the upstream and downstream impact of waste. The results reveal that the composition of the waste generated from building refurbishment projects is different from construction and demolition projects. In the life cycle of C&D waste management of building refurbishment projects, the refurbishment material stage generates the highest carbon emissions compared to the dismantlement, refurbishment construction, and refurbishment material end of life stages. Scenario 1 produces higher carbon emissions than scenario 2, but the difference is not significant in the whole life cycle of the building refurbishment project, whereas carbon emissions for scenario 3 are significantly less than both scenario 1 and scenario 2. The study finds the reason for this difference is that scenario 1 and scenario 2 are based on a linear economy that relies on unsustainable demand for raw materials, whereas scenario 3 is based on a circular economy that uses upcycled materials to substitute for raw materials and considers waste management from a cradle to cradle perspective. This study fills a research gap by evaluating carbon emissions of different waste management strategies for building refurbishment projects, which are expected to be an increasing portion of overall construction activity in China for the foreseeable future.

     

Behaviour and mobility of preemergent herbicides in turfgrass: A field study

Abstract

The quality of many golf courses and other turfgrass areas often requires high levels of cultural management. The fact that this level of maintenance usually includes the use of preemergent herbicides has caused concern about their potential for ground water contamination. Much of this concern is based on extrapolation from agricultural situations rather than data developed from studies conducted in field turfgrass situations. To address this data gap, a two‐year field project evaluating the behaviour and mobility of the commonly used preemergent herbicides, benfluralin, trifluralin, bensulide, oxadiazon. pendimethalin, and DCPA with its two metabolites was conducted at OARDC/The Ohio State University, Wooster, Ohio, in 1988–89. Plots were located on a site with thatch (WT) and one with no thatch (NT)to further clarify the impact of thatch on herbicide behavior. Treatments were applied in April and samples of thatch and four zones of soil (0–2.5, 2.5–5, 7.5–10 and 22.5–25cm) were collected throughout the year and analyzed for residue dissipation. Residues of pendimethalin, benfluralin, and trifluralin in the 22.5–25 cm zone were below the limit of determination. No detectable oxadiazon residues were found in this zone at the WT site in 1988 but on two occasions, residues of 0.01 and 0.02 kg/ha were found in 1989. At the NT site, residues in this zone on one occasion were 0.02 kg/ha in 1988 and none in 1989. Residues of bensulide in the same zone ranged not detectable (ND)‐0.02 kg/ha in both locations. The DCPA residues in the 22.5–25 cm zone ranged ND‐0.10 kg/ha (WT), ND‐0.27 kg/ha (NT) in 1988. and ND‐0.02 kg/ha (WT), ND‐0.04 kg/ha (NT) in 1989. The residues of SDS 1449, the less stable of two dacthal metabolites, were very low but higher in 1988 than in 1989 in both locations. The SDS 954 residues in 22.5–25 cm zone ranged ND‐0.1 kg/ha (WT), and ND‐0.16 kg/ha (NT) in 1988, and ND‐0.26 kg/ha (WT), and ND‐0.27 kg/ha (NT) in 1989.

Some amount of all herbicides applied carried over into the spring of the year following application but oxadiazon and bensulide were the most persistent.