Inactivation of pathogenic micro-organisms in hospital waste using a microwave

The aim of this study was to investigate the efficiency of dry sterilization by microwave in the inactivation of pathogenic bacteria in blood wastes. Eight bacteria strains were selected for this purpose and these are S. aureus, Salmonella sp., E. faecalis, K. pneumonia, P. aeruginosa, E. coli, Streptococcus Group B and Bacillus sp. Sterilization by microwave was carried out at 385, 450 and 700 watts for 1, 5 and 10 min, respectively. Isolation and enumeration of pathogenic bacteria before and after treatments were carried out using direct plate technique and inactivation was determined in terms of log reduction. Increasing the running time and power to 10 min and 700 watts did not increase log reduction of most of pathogenic bacteria especially of gram negative bacteria. Revival of pathogenic bacteria during the storage period might be aided by the presence of a low moisture content which helps bacterial cells to revive but not to reproduce or over-grow. It can be concluded that dry sterilization of blood wastes by microwave reduces the number and limited re-growth of these pathogenic bacteria during storage time, due to the lower moisture content in the blood wastes.     

Characterization of exhaust particles from military vehicles fueled with diesel,gasoline, and JP-8

Diluted exhaust from selected military aircraft ground-support equipment (AGE) was analyzed for particulate mass, elemental carbon (EC) and organic carbon (OC), SO4(2-), and size distributions. The experiments occurred at idle and load conditions and utilized a chassis dynamometer. The selected AGE vehicles operated on gasoline, diesel, and JP-8. These military vehicles exhibited concentrations, size distributions, and emission factors in the same range as those reported for nonmilitary vehicles. The diesel and JP-8 emission rates for PM ranged from 0.092 to 1.1 g/kg fuel. The EC contributed less and the OC contributed more to the particulate mass than reported in recent studies of vehicle emissions. Overall, the particle size distribution varied significantly with engine condition, with the number of accumulation mode particles and the count median diameter (CMD) increasing as engine load increased. The SO4(2-) analyses showed that the distribution of SO4(2-) mass mirrored the distribution of particle mass.     

Natural radioactivity and dose assessment for phosphate rocks from Wadi El-Mashash and El-Mahamid Mines, Egypt

The activity concentrations of (226)Ra, (232)Th and (40)K have been measured by gamma spectroscopy (sodium iodide NaI(Tl) detector) in phosphate rock samples, collected from the Wadi El-Mashash, a site located in the central eastern desert, and El-Mahamid in the Nile valley, Egypt. The average activity concentrations of (226)Ra, (232)Th and (40)K (Bq kg(-1)) in phosphate rocks were 665.8+/-33.4, 329.4+/-17 and 587.6+/-29.4 for Wadi El-Mashash and 566.8+/-28.6, 217.3+/-11.8 and 560.1+/-28 for El-Mahamid, respectively. The corresponding values for shale rocks were 85.2+/-5.7, 93.3+/-5.6 and 303.1+/-15.2 Bq kg(-1), respectively. As a measure of radiation hazard to the occupational workers and public, the Ra equivalent activities, representative level index and dose rates due to natural radionuclides at 1 m above the ground surface were estimated. The calculated external gamma-radiation dose received by the workers of the phosphate mine are 538 and 418 microSv/y, which is far below the permitted dose of 20 mSv/y recommended by the International Commission of Radiation Protection [ICRP-60, 1990. Radiation Protection: 1990 Recommendation of the International Commission on Radiological Protection, Oxford, Pergamon Preis.] for workers.     

A new practical approach to risk management for underground mining project in Quebec

The mining industry worldwide is currently experiencing an economic boom that is contributing to economic recovery and social progress in many countries. For this to continue, the mining industry must meet several challenges associated with the start-up of new projects. In a highly complex and uncertain environment, rigorous management of risks remains indispensable in order to repel threats to the success of mining.In this article, a new practical approach to risk management in mining projects is presented. This approach is based on a novel concept called “hazard concentration” and on the multi-criteria analysis method known as the Analytic Hierarchy Process (AHP). The aim of the study is to extend the use of this approach to goldmines throughout Quebec. The work is part of a larger research project of which the aim is to propose a method suitable for managing practically all risks inherent in mining projects.This study shows the importance of taking occupational health and safety (OHS) into account in all operational activities of the mine. All project risks identified by the team can be evaluated. An adaptable database cataloguing about 250 potential hazards in an underground goldmine was constructed. In spite of limitations, the results obtained in this study are potentially applicable throughout the Quebec mining sector.     

Report: Combustion Byproducts and Their Health Effects: Summary of the 10th International Congress

The 10th International Congress on Combustion Byproducts and their Health Effects was held in Ischia, Italy, from June 17-20, 2007. It is sponsored by the US NIEHS, NSF, Coalition for Responsible Waste Incineration (CRWI), and Electric Power Research Institute (EPRI). The congress focused on: the origin, characterization, and health impacts of combustion-generated fine and ultrafine particles; emissions of mercury and dioxins, and the development/application of novel analytical/diagnostic tools. The consensus of the discussion was that particle-associated organics, metals, and persistent free radicals (PFRs) produced by combustion sources are the likely source of the observed health impacts of airborne PM rather than simple physical irritation of the particles. Ultrafine particle-induced oxidative stress is a likely progenitor of the observed health impacts, but important biological and chemical details and possible catalytic cycles remain unresolved. Other key conclusions were: (1) In urban settings, 70% of airborne fine particles are a result of combustion emissions and 50% are due to primary emissions from combustion sources, (2) In addition to soot, combustion produces one, possibly two, classes of nanoparticles with mean diameters of?~10?nm and?~1?nm. (3) The most common metrics used to describe particle toxicity, viz. surface area, sulfate concentration, total carbon, and organic carbon, cannot fully explain observed health impacts, (4) Metals contained in combustion-generated ultrafine and fine particles mediate formation of toxic air pollutants such as PCDD/F and PFRs. (5) The combination of metal-containing nanoparticles, organic carbon compounds, and PFRs can lead to a cycle generating oxidative stress in exposed organisms.     

Optimising of Scenedesmus sp. biomass production in chicken slaughterhouse wastewater using response surface methodology and potential utilisation as fish feeds

Production of Scenedesmus sp. biomass in chicken slaughterhouse wastewater (CSWW) is a promising alternative technique for commercial culture medium due to the high nutritional content of the generated biomass to be used as fish feeds. The current work deals with optimising of biomass production in CSWW using response surface methodology (RSM) as a function of two independent variables, namely temperature (10–30 °C) and photoperiod (6–24 h). The potential application of biomass yield as fish feeds was evaluated based on carbohydrate, protein and lipid contents. The results revealed that the best operating parameters for Scenedesmus sp. biomass production with high contents of carbohydrates, proteins and lipids were determined at 30 °C and after 24 h. The actual and predicted values were 2.47 vs. 3.09 g, 1.44 vs. 1.27 μg/mL, 29.9 vs. 31.60% and 25.75 vs. 28.44%, respectively. Moreover, the produced biomass has a high concentration of fatty acid methyl ester (FAME) as follows: 35.91% of C15:1; 17.58% of C24:1 and 14.11% of C18:1N9T. The biomass yields have 7.98% of eicosapentaenoic acid (EPA, C20:5N3) which is more appropriate as fish feeds. The Fourier transform infrared (FTIR) analysis of biomass revealed that the main functional groups included hydroxyl (OH), aldehyde (=C–H), alkanes and acyl chain groups. Scanning electron micrograph (SEM) and energy-dispersive X-ray spectroscopic analysis (EDS) indicated that the surface morphology and element distribution in biomass produced in BBM and CSWW were varied. The findings have indicated that the biomass produced in CSWW has high potential as fish feeds.

     

Takakura composting method for food wastes from small and medium industries with indigenous compost

Environmental Science and Pollution Research - The current work aimed to study the physical, chemical and biological properties of food wastes generated from small and medium industries by using...     

Biosensors for pathogen surveillance

Biologists, chemists, and physicists are collaborating to develop highly sensitive and specific biosensors for pathogen detection in the food, healthcare, and environmental sectors. Those novel biosensors allow quick detection and are thus expected to solve the issues of the emergence of highly virulent or antibiotic-resistant pathogens. This article reviews different types of biosensors used for pathogen detection, classified based on the type of transducer used. Optical biosensors integrate labeled means, e.g., fluorophores, quantum dots, and carbon dots to overcome photobleaching. Surface plasmon resonance is also used for enhanced sensitivity. Mechanical biosensors with piezoelectric crystals and cantilevers are adapted for the detection of food pathogens without sample preparation or labels. Conventional methods using electrodes for the measurement of electrochemical changes with differential pulse voltammetry or impedance spectroscopy are fast and highly sensitive. Immunosensors are developed for pathogen detection at trace levels using sample enrichment, signal amplification, and new visual detection techniques.     

Effect of using limestone fines on the chemical shrinkage of pastes and mortars

Environmental Science and Pollution Research - The main aim of this study is to examine the effect of incorporating limestone fine (LF) on chemical shrinkage of pastes and mortars. For this...