Sulfur Control In Coal Fired Power Plants: A Probabilistic Approach to Policy Analysis

The optimum level of sulfur pollution control for a coal fired power plant is the point where the sum of societal costs, due to pollution, and control costs is minimized. This basic microeconomic concept has been of limited practical value due to considerable uncertainty in estimating both costs. A probabilistic approach is used to characterize these uncertainties quantitatively for a hypothetical 1000 Mw_e plant located near Pittsburgh, Pennsylvania. Only mortality effects within a distance of 80 km of the plant have been included. The results allow explicit consideration of attitude toward risk and appropriate level of investment to prevent deaths. Limitations of the findings are discussed. Implications are described for policy based on alternative sets of values and assumptions.     

Formation and Removal Reactions of Hazardous Air Pollutants

Current regulatory policies for hazardous air pollutants (HAPs) target the sources of direct emissions. In addition to direct emissions, some of the aromatic, nitrogenated, and oxygenated HAPs can be formed in the atmosphere. Formaldehyde and acetaldehyde, in particular, are produced by almost every hydrocarbon photooxidation reaction. Estimates have been made that, in some urban areas, in situ formation contributes as much as 85 percent of the ambient levels of formaldehyde and 95 percent for acetaldehyde. Over 40 percent of the HAPs being regulated under Title III of the 1990 Clean Air Act Amendments have atmospheric lifetimes of less than one day. The transformation products of these HAPs with low atmospheric persistence are important for assessing risks to human health, especially for cases where the transformation products are more toxic than the HAP itself.     

Temperature and air velocity effects on ethanol emission from corn silage with the characteristics of an exposed silo face

Volatile organic compounds (VOCs) from agricultural sources are believed to be an important contributor to tropospheric ozone in some locations. Recent research suggests that silage is a major source of VOCs emitted from agriculture, but only limited data exist on silage emissions. Ethanol is the most abundant VOC emitted from corn silage; therefore, ethanol was used as a representative compound to characterize the pattern of emission over time and to quantify the effect of air velocity and temperature on emission rate. Ethanol emission was measured from corn silage samples removed intact from a bunker silo. Emission rate was monitored over 12 h for a range in air velocity (0.05, 0.5, and 5 m s^?1) and temperature (5, 20, and 35 °C) using a wind tunnel system. Ethanol flux ranged from 0.47 to 210 g m^?2 h^?1 and 12 h cumulative emission ranged from 8.5 to 260 g m^?2. Ethanol flux was highly dependent on exposure time, declining rapidly over the first hour and then continuing to decline more slowly over the duration of the 12 h trials. The 12 h cumulative emission increased by a factor of three with a 30 °C increase in temperature and by a factor of nine with a 100-fold increase in air velocity. Effects of air velocity, temperature, and air-filled porosity were generally consistent with a conceptual model of VOC emission from silage. Exposure duration, temperature, and air velocity should be taken into consideration when measuring emission rates of VOCs from silage, so emission rate data obtained from studies that utilize low air flow methods are not likely representative of field conditions.     

Participant-based monitoring of indoor and outdoor nitrogen dioxide,volatile organic compounds,and polycyclic aromatic hydrocarbons among MICA-Air households

The Mechanistic Indicators of Childhood Asthma (MICA) study in Detroit, Michigan introduced a participant-based approach to reduce the resource burden associated with collection of indoor and outdoor residential air sampling data. A subset of participants designated as MICA-Air conducted indoor and outdoor residential sampling of nitrogen dioxide (NO₂), volatile organic compounds (VOCs), and polycyclic aromatic hydrocarbons (PAHs). This participant-based methodology was subsequently adapted for use in the Vanguard phase of the U.S. National Children’s Study. The current paper examines residential indoor and outdoor concentrations of these pollutant species among health study participants in Detroit, Michigan.Pollutants measured under MICA-Air agreed well with other studies and continuous monitoring data collected in Detroit. For example, NO₂ and BTEX concentrations reported for other Detroit area monitoring were generally within 10–15% of indoor and outdoor concentrations measured in MICA-Air households. Outdoor NO₂ concentrations were typically higher than indoor NO₂ concentration among MICA-Air homes, with a median indoor/outdoor (I/O) ratio of 0.6 in homes that were not impacted by environmental tobacco smoke (ETS) during air sampling. Indoor concentrations generally exceeded outdoor concentrations for VOC and PAH species measured among non-ETS homes in the study. I/O ratios for BTEX species (benzene, toluene, ethylbenzene, and m/p- and o-xylene) ranged from 1.2 for benzene to 3.1 for toluene. Outdoor NO₂ concentrations were approximately 4.5 ppb higher on weekdays versus weekends. As expected, I/O ratios pollutants were generally higher for homes impacted by ETS.These findings suggest that participant-based air sampling can provide a cost-effective alternative to technician-based approaches for assessing indoor and outdoor residential air pollution in community health studies. We also introduced a technique for estimating daily concentrations at each home by weighting 2- and 7-day integrated concentrations using continuous measurements from regulatory monitoring sites. This approach may be applied to estimate short-term daily or hourly pollutant concentrations in future health studies.     

Temporal variability in dynamic and colloidal metal fractions determined by high resolution in situ measurements in a UK estuary

In recent environmental legislation, such as the Water Framework Directive in the European Union (WFD, 2000/60/EC), the importance of metal speciation and biological availability is acknowledged, although analytical challenges remain. In this study, the Voltammetric In situ Profiler (VIP) was used for high temporal resolution in situ metal speciation measurements in estuarine waters. This instrument simultaneously determines Cd, Cu and Pb species within a size range (ca. <4 nm) that is highly relevant for uptake by organisms. The colloidal metal fraction can be quantified through a combination of VIP measurements and analyses of total dissolved metal concentrations.VIP systems were deployed over tidal cycles in a seasonal study of metal speciation in the Fal Estuary, southwest England. Total dissolved concentrations were 4.97-315 nM Cu, 0.13-8.53 nM Cd and 0.35-5.75 nM Pb. High proportions of Pb (77 ± 17%) and Cu (60 ± 25%) were present as colloids, which constituted a less important fraction for Cd (37 ± 30%). The study elucidated variations in the potentially toxic metal fraction related to river flow, complexation by organic ligands and exchanges between dissolved and colloidal phases and the sediment. Based on published toxicity data, the bioavailable Cu concentrations (1.7-190 nM) in this estuary are likely to severely compromise the ecosystem structure and functioning with respect to species diversity and recruitment of juveniles. The study illustrates the importance of in situ speciation studies at high resolution in pursuit of a better understanding of metal (bio)geochemistry in dynamic coastal systems.     

Transcriptional profiles induced by the Aryl Hydrocarbon Receptor agonists 2,3,7,8-tetrachlorodibenzo-p-dioxin, 2,3,7,8-tetrachlorodibenzofuran and 2,3,4,7,8-pentachlorodibenzofuran in primary rat hepatocytes

Toxicogenomics was used to examine mRNA expression profiles obtained from primary rat hepatocytes treated for 24 h with 0.01 or 1.0 nM 2,3,7,8-tetrachlorodibenzo-p-dioxin (2,3,7,8-TCDD), 0.02 or 2.0 nM 2,3,4,7,8-pentachlorodibenzofuran (2,3,4,7,8-PeCDF) and 0.1 or 10 nM 2,3,7,8-tetrachlorodibenzofuran (2,3,7,8-TCDF). The concentrations of 2,3,4,7,8-PeCDF and 2,3,7,8-TCDF were chosen to be equivalent to 2,3,7,8-TCDD’s concentration based on the toxic equivalency factor/toxic equivalent (TEF/TEQ) method for estimating biological potency. 2,3,7,8-TCDD at 1.0 nM altered the expression of 533 genes; 2,3,4,7,8-PeCDF at 2.0 nM altered 182 genes, and 2,3,7,8-TCDF at 10 nM altered 154 genes. Of these, 57 genes were affected by all three congeners. Agglomerative hierarchical clustering revealed distinct congener-dependent gene subclusters. Principal components analyses of the microarray data revealed that these congeners cluster independently of one another. Data presented here demonstrate that equivalent TEQ concentrations of 2,3,7,8-TCDD, 2,3,4,7,8-PeCDF and 2,3,7,8-TCDF, while altering the expression of a small battery of genes in common, also produce substantial congener specific alterations in gene expression.     

Preparation and X-ray structural characterization of further stereoisomers of 1,2,5,6,9,10-hexabromocyclododecane

Technical 1,2,5,6,9,10-hexabromocyclododecane (HBCD) consists largely of three diastereomers (α-, β-, and γ-HBCD) produced by the trans addition of bromine to cis,trans,trans-cyclododeca-1,5,9-triene (CDT). However, another seven diastereomers are theoretically possible and may be produced by trans addition of bromine across the double bonds of the other three isomers of 1,5,9-CDT. There are indications that small amounts of the minor HBCD isomers may be present in commercial HBCD mixtures or in products containing this brominated flame retardant (BFR). Such minor components may indeed derive from traces of other 1,5,9-CDTs in the cis, trans, trans starting material, however their formation may also be possible through isomerizations during the processing of this BFR or by bioisomerization subsequent to its release into the environment. Two of the seven additional diastereomers (δ- and ε-HBCD) were synthesized previously from trans,trans,trans-CDT. We now report the preparation of the remaining five diastereomers, ζ-, η-, and θ-HBCD from cis,cis,trans-CDT and ι- and κ-HBCD from cis,cis,cis-CDT, and their characterization by ¹H NMR spectroscopy and X-ray crystallography. The availability of these further diastereomers of HBCD should aid in determining if the minor isomers are present in commercial samples of this BFR, in products containing HBCDs, or in environmental samples. We have also carried out an X-ray crystal structure determination on ε-HBCD, so that crystal structures are now available for all 10 HBCD diastereomers.     

Outdoor and indoor cadmium distributions near an abandoned smelting works and their relations to human exposure

The relationship of measured or modelled Cd concentrations in soil, house dust and available to plants with human urinary Cd concentrations were assessed in a population living around a Cd/Pb/Zn smelter in the UK. Modelled air concentrations explained 35% of soil Cd variation indicating the smelter contributed to soil Cd loads. Multi-variate analysis confirmed a significant role of biological and life-style factors in determining urinary Cd levels. Significant correlations of urinary Cd with soil, house dust and modelled plant available Cd concentrations were not, however, found. Potential reasons for the absence of clear relationships include limited environmental contact in urban populations; the role of undefined factors in determining exposure; and the limited spatial scope of the survey which did not sample from the full pollution gradient. Further, the absence of any significant relationship indicates that environmental measures provide limited advantage over atmospheric model outputs for first stage human exposure assessment.     

Characterization of spatial impact of particles emitted from a cement material production facility on outdoor particle deposition in the surrounding community

The objective of this study was to estimate the contribution of a facility that processes steel production slag into raw material for cement production to local outdoor particle deposition in Camden, NJ. A dry deposition sampler that can house four 37-mm quartz fiber filters was developed and used for the collection of atmospheric particle deposits. Two rounds of particle collection (3-4 weeks each) were conducted in 8-11 locations 200-800 m downwind of the facility. Background samples were concurrently collected in a remote area located -2 km upwind from the facility. In addition, duplicate surface wipe samples were collected side-by-side from each of the 13 locations within the same sampling area during the first deposition sampling period. One composite source material sample was also collected from a pile stored in the facility. Both the bulk of the source material and the < 38 microm fraction subsample were analyzed to obtain the elemental source profile. The particle deposition flux in the study area was higher (24-83 mg/m2 x day) than at the background sites (13-17 mg/m2day). The concentration of Ca, a major element in the cement source production material, was found to exponentially decrease with increasing downwind distance from the facility (P < 0.05). The ratio of Ca/Al, an indicator of Ca enrichment due to anthropogenic sources in a given sample, showed a similar trend. These observations suggest a significant contribution of the facility to the local particle deposition. The contribution of the facility to outdoor deposited particle mass was further estimated by three independent models using the measurements obtained from this study. The estimated contributions to particle deposition in the study area were 1.8-7.4% from the regression analysis of the Ca concentration in particle deposition samples against the distance from the facility, 0-11% from the U.S. Environmental Protection Agency (EPA) Chemical Mass Balance (CMB) source-receptor model, and 7.6-13% from the EPA Industrial Source Complex Short Term (ISCST3) dispersion model using the particle-size-adjusted permit-based emissions estimates.     

Environmental analysis of groundwater in Mecosta County, Michigan

Groundwater withdrawal has major economic, social, and environmental implications. In Michigan, recent legislative activity has begun to address the issue of groundwater sustainability. However, more hydrologic data are needed to help inform policy and legislation. A study was conducted in Mecosta County, Michigan to: (1) determine if a relationship could be established between land use/land cover and groundwater quality; and (2) develop a conceptual model for the shallow groundwater system of the study region. In general, groundwater quality was good, with below detection levels of E. coli, low total bacterial counts, and relatively low nutrient concentrations. No statistically significant associations were found between the bacterial numbers and either land use or the physical/chemical attributes measured, which may be because the scale of our spatial analysis was too coarse to detect patterns. Finer-scale, localized processes may have a greater influence on microorganism growth and abundance than coarser-scale, regional processes in this area. Our groundwater analysis suggested that shallow groundwater flow paths are generally consistent with regional surface water flow networks, and that shallow groundwater levels in most of the region have fluctuated within 1–2 m over the past 30 years, with no obvious increasing or decreasing trend.