Atmospheric emissions and attenuation of non-methane organic compounds in cover soils at a French landfill

In addition to methane (CH(4)) and carbon dioxide (CO(2)), landfill gas may contain more than 200 non-methane organic compounds (NMOCs) including C(2+)-alkanes, aromatics, and halogenated hydrocarbons. Although the trace components make up less than 1% v/v of typical landfill gas, they may exert a disproportionate environmental burden. The objective of this work was to study the dynamics of CH(4) and NMOCs in the landfill cover soils overlying two types of gas collection systems: a conventional gas collection system with vertical wells and an innovative horizontal gas collection layer consisting of permeable gravel with a geomembrane above it. The 47 NMOCs quantified in the landfill gas samples included primarily alkanes (C(2)-C(10)), alkenes (C(2)-C(4)), halogenated hydrocarbons (including (hydro)chlorofluorocarbons ((H)CFCs)), and aromatic hydrocarbons (BTEXs). In general, both CH(4) and NMOC fluxes were all very small with positive and negative fluxes. The highest percentages of positive fluxes in this study (considering all quantified species) were observed at the hotspots, located mainly along cell perimeters of the conventional cell. The capacity of the cover soil for NMOC oxidation was investigated in microcosms incubated with CH(4) and oxygen (O(2)). The cover soil showed a relatively high capacity for CH(4) oxidation and simultaneous co-oxidation of the halogenated aliphatic compounds, especially at the conventional cell. Fully substituted carbons (TeCM, PCE, CFC-11, CFC-12, CFC-113, HFC-134a, and HCFC-141b) were not degraded in the presence of CH(4) and O(2). Benzene and toluene were also degraded with relative high rates. This study demonstrates that landfill soil covers show a significant potential for CH(4) oxidation and co-oxidation of NMOCs.     

Soils, climate change and the OECD

Some concepts of sustainability applied to soils are given in relation to the Organisation for Economic Co-operation and Development (OECD) Co-operative Research Programme 'Biological Resource Management for Sustainable Agricultural Systems'. The application of these concepts to climate change will be discussed in relation to seven high-profile papers published over the past 12 months. It is argued that multi-disciplinary (including social science) approaches are needed to address the issues. There is also a brief discussion on biomass energy in terms of soil sustainability and climate change.     

Coupling a 3D patch model and a rockfall module to assess rockfall protection in mountain forests

Many forests in the Alps are acknowledged for protecting objects, such as (rail) roads, against rockfall. However, there is a lack of knowledge on efficient silvicultural strategies and interventions to maintain these forests at optimal protection level. Therefore, assessment tools are required that quantify the rockfall protection effect of forest stands over time, and thereby provide the ability to evaluate the necessity and effect of management interventions. This paper introduces such a tool that consists of a 3D rockfall module embedded in the patch based forest simulator PICUS. The latter is extended for this study with a new regeneration module. In a series of experiments the new combined simulation tool is evaluated with regard to parameter sensitivity, model intercomparison experiments with recently proposed algorithms from the literature, and the ability to respond realistically to different management regimes in rockfall protection forests. Results confirm the potential of the new tool for realistic simulation of rockfall activity in heterogeneous mountain forests, but point at the urgent need to improve the knowledge base on the interaction of understory and rockfall activity. Further work will focus on model validation against empirical rockfall data, and include reduced tree vitality due to damage from boulder collisions as well as the explicit consideration of downed dead wood.     

Baseline assessment for environmental services payments from satellite imagery: a case study from Costa Rica and Mexico

In this study we evaluate the accuracy of four global and regional forest cover assessments (MODIS, IGBP, GLC2000, PROARCA) as tools for baseline estimation. We conduct this research at the national scale for Costa Rica and for two tropical dry forest study sites in Costa Rica (Santa Rosa) and Mexico (Chamela-Cuixmala). We found that at the national level, the total forest cover accuracy of the four land cover maps was inflated due to an overestimation of forest in areas with an evergreen canopy. However, the four maps greatly underestimated the extent of the deciduous forest (dry forest); an ecosystem that faces high deforestation pressure and poses complications to the mapping of its extent from remotely sensed data. For the tropical dry forest sites, all maps have low forest cover accuracies (mean for Santa Rosa: 27%; mean for Chamela-Cuixmala: 56%). This has implications for policy implementation.     

Social Networks and Community-Based Natural Resource Management

We conducted case studies of three successful examples of collaborative, community-based natural resource conservation and development. Our purpose was to: (1) identify the functions served by interactions within the social networks of involved stakeholders; (2) describe key structural properties of these social networks; and (3) determine how these structural properties varied when the networks were serving different functions. The case studies relied on semi-structured, in-depth interviews of 8 to 11 key stakeholders at each site who had played a significant role in the collaborative projects. Interview questions focused on the roles played by key stakeholders and the functions of interactions between them. Interactions allowed the exchange of ideas, provided access to funding, and enabled some stakeholders to influence others. The exchange of ideas involved the largest number of stakeholders, the highest percentage of local stakeholders, and the highest density of interactions. Our findings demonstrated the value of tailoring strategies for involving stakeholders to meet different needs during a collaborative, community-based natural resource management project. Widespread involvement of local stakeholders may be most appropriate when ideas for a project are being developed. During efforts to exert influence to secure project approvals or funding, however, involving specific individuals with political connections or influence on possible sources of funds may be critical. Our findings are consistent with past work that has postulated that social networks may require specific characteristics to meet different needs in community-based environmental management.     

Risk assessment and prioritisation of contaminated sites on the catchment scale

Contaminated sites pose a significant threat to groundwater resources worldwide. Due to limited available resources a risk-based prioritisation of the remediation efforts is essential. Existing risk assessment tools are unsuitable for this purpose, because they consider each contaminated site separately and on a local scale, which makes it difficult to compare the impact from different sites. Hence a modelling tool for risk assessment of contaminated sites on the catchment scale has been developed. The CatchRisk screening tool evaluates the risk associated with each site in terms of its ability to contaminate abstracted groundwater in the catchment. The tool considers both the local scale and the catchment scale. At the local scale, a flexible, site specific leaching model that can be adjusted to the actual data availability is used to estimate the mass flux over time from identified sites. At the catchment scale, a transport model that utilises the source flux and a groundwater model covering the catchment is used to estimate the transient impact on the supply well. The CatchRisk model was tested on a groundwater catchment for a waterworks north of Copenhagen, Denmark. Even though data scarcity limited the application of the model, the sites that most likely caused the observed contamination at the waterworks were identified. The method was found to be valuable as a basis for prioritising point sources according to their impact on groundwater quality. The tool can also be used as a framework for testing hypotheses on the origin of contamination in the catchment and for identification of unknown contaminant sources.     

Factors affecting river health and its assessment over broad geographic ranges: the Western Australian experience

AusRivAS is an Australia-wide program that measures river condition using predictive models to compare the macroinvertebrate families occurring at a river site with those expected if the site were in natural condition. Results of assessment of 685 sites across all major rivers in Western Australia are presented. Most rivers were in relatively natural condition in the northern half of the state where the human population is low and pastoralism is the major land use. In the south, where the human population is higher and agriculture is more intensive, rivers were mostly more disturbed. AusRivAS assessment produced some erroneous results in rivers of the south-west cropping zone because of the lack of appropriate reference site groups and biased distribution of sampling sites. Collecting low numbers of animals from many forested streams, because of low stream productivity and samples that were difficult to sort, also affected assessments. Overall, however, AusRivAs assessment identified catchment processes that were inimical to river health. These processes included salinisation, high nutrient and organic loads, erosion and loss of riparian vegetation. River regulation, channel modification and fire were also associated with river degradation. As is the case with other assessment methods, one-off sampling at individual sites using AusRivAS may be misleading. Seasonal drought, in particular, may make it difficult to relate conditions at the time of sampling to longer-term river health. AusRivAS has shown river condition in Western Australia is not markedly different from other parts of Australia which, as a whole, lacks the substantial segments of severely degraded river systems reported in England.     

Serial Correlation and Inter-annual Variability in Relation to the Statistical Power of Monitoring Schemes to Detect Trends in Fish Populations

We studied the effects of inter-annual variability and serial correlation on the statistical power of monitoring schemes to detect trends in biomass of bream (Abramis brama) in Lake Veluwemeer (The Netherlands). In order to distinguish between 'true' system variability and sampling variability we simulated the development of the bream population, using estimates for population structure and growth, and compared the resulting inter-annual variabilities and serial correlations with those from field data. In all cases the inter-annual variability in the field data was larger than in simulated data (e.g. for total biomass of all assessed bream sigma = 0.45 in field data, and sigma = 0.03-0.14 in simulated data) indicating that sampling variability decreased statistical power for detecting trends. Moreover, sampling variability obscured the inter-annual dependency (and thus the serial correlation) of biomass, which was expected because in this long-lived population biomass changes are buffered by the many year classes present. We did find the expected serial correlation in our simulation results and concluded that good survey data of long-lived fish populations should show low sampling variability and considerable inter-annual serial correlation. Since serial correlation decreases the power for detecting trends, this means that even when sampling variability would be greatly reduced, the number of sampling years to detect a change of 15%.year(-1) in bream populations (corresponding to a halving or doubling in a six-year period) would in most cases be more than six. This would imply that the six-year reporting periods that are required by the Water Framework Directive of the European Union are too short for the existing fish monitoring schemes.     

Distribution of PAHs in Surface Soils from Petroleum Handling Facilities in Calabar

The level of concentrations of polycyclic aromatic hydrocarbons (PAHs) in surface soils from petroleum handling facilities (kerosene tank, generating plant, petrol stations, mechanic workshops, leaking pipeline and air port fuel dump) from Calabar metropolis southeastern Nigeria was determined by gas chromatography/ mass spectrometry. The results show that total polycyclic aromatic hydrocarbons (PAHs) varied from 1.80 to 334.43 mg/kg with a mean of 50.31 mg/kg. The lowest value of 1.80 mg/kg was obtained from petrol station while the highest value of 334.43 mg/kg was obtained from facility characterised by petrol stations and mechanic workshops. The ratio of phenanthrene/anthracene and fluoranthene/pyrene, varied from 0.43 to 27.72 and from 0.14 to 17.76 respectively. These ratios indicate various sources for the PAH. The two to three ring PAHs are the most abundant. Based on the PAH ratios and content alone it is not possible to distinguish between contribution from motor vehicle exhaust, gasoline spillage, used engine oil or petroleum production. However, considering the area of the study, it is very likely that the major source of soil contamination is originating from petroleum product.     

Fugitive emissions opacity determination using the digital opacity compliance system (DOCS)

Maintenance of Department of Defense (DoD) weapon systems, conducting battlefield training exercises as well as meeting military construction and/or demolition schedules, invariably generate fugitive air emissions, many of which are visible. Although there is no codified federal method for quantifying fugitive emissions opacity, many state and local air regulatory agencies have instituted enforceable fugitive emission opacity standards at DoD facilities. The current study focused on comparing the performance of the digital opacity compliance system (DOCS) with U.S. Environment Protection Agency Method 9 (Method 9) certified human observers in quantifying the visible opacity associated with fugitive emissions produced using a commercial fog generator. By systematically repositioning both DOCS cameras and Method 9-certified observers during field testing, differences in method performance as a function of observational locations were documented. At both the 30- and 300-ft off-set distances, opacity levels reported by the DOCS technology and Method 9-certified smoke readers were found to be statistically different at the 99% confidence level. Alternatively, at the 90- and 150-ft off-set distances, results suggested that there was an insignificant difference at the 99% confidence level between the two methods. Comparing the magnitude of the each method's standard deviation suggested that, at the 30-ft off-set distance, the DOCS technology was consistently more precise than Method 9-certified readers regardless of the observer's downwind distance. However, at the 90, 150, and 300-ft off-set distances, method precision seemed to vary as a function of both off-set and downwind distance. The primary factor affecting the consistency in opacity measurements appeared to be the impact of ground-level air turbulence on fog plume dispersion and transport. Field observations demonstrated that localized wind shear played a critical and decisive role in how and to what extent fugitive emissions opacity could be determined, regardless of the method selected.