Lethal and sublethal effects of the pyrethroid, bifenthrin, on grass shrimp (Palaemonetes pugio) and sheepshead minnow (Cyprinodon variegatus)

This study investigated the lethal and sublethal effects of the pyrethroid insecticide bifenthrin on adult and larval grass shrimp, Palaemonetes pugio, and adult sheepshead minnows, Cyprinodon variegatus. The effects were determined by conducting 96-h aqueous static renewal tests and 24-h static tests with sediment. Oxidative stress biomarkers, lipid peroxidation, glutathione, and catalase were also assessed. The 96-h aqueous LC50 value for adult shrimp was 0.020 microg/L (95% CI: 0.015-0.025 microg/L) and for larval shrimp was 0.013 microg/L (95% CI: 0.011-0.016 microg/L). The 96-h aqueous LC50 for adult sheepshead minnow was 19.806 microg/L (95% CI: 11.886-47.250 microg/L). The 24-h sediment LC50 for adult shrimp was 0.339 microg/L (95% CI: 0.291-0.381 microg/L) and for larval shrimp was 0.210 microg/L (95% CI: 0.096-0.393 microg/L). The oxidative stress assays showed some increasing trends toward physiological stress with increased bifenthrin concentrations but they were largely inconclusive. Given the sensitivity of grass shrimp to this compound in laboratory bioassays, additional work will be needed to determine if these exposure levels are environmentally relevant.     

Comparison of surface emissions and subsurface distribution of cis- and trans-1,3-dichloropropene and chloropicrin in sandy field beds covered with four different plastic films

The purpose of this study was to conduct a field study at a Florida field site on surface emissions and subsurface distribution of cis-and trans-1,3-dichloropropene (1,3-D) and chloropicrin (CP) in raised beds injected with Telone C35 with four replications. A total of 16 beds were applied with Telone C35 by chisel injection and covered with four different plastic films, 4 beds for each film. Each bed was installed with five 20-cm long soil pore air probes and a surface air collection pan at arbitrarily locations along the length of each bed for sampling soil pore air and surface air, respectively, for analysis of the three biologically active compounds, cis- and trans-1,3-D and CP. We found that average concentrations of the three compounds at 20-cm depth among the beds covered with four different plastic films generally were not statistically different. Among the four beds covered with the same plastic film, average concentrations of the three compounds were statistically different only in the four metallic PE covered beds at 5 and 24 hours after injection. Volatilization rates of the three compounds among the beds covered with four different plastic films, with the exception of CP at 48 hours after injection, were not statistically different. It appeared that initial upward diffusion and volatilization flux were influenced by solar radiation. Initial subsurface concentrations of the three compounds and volatilization flux, especially cis-1,3-D, were greater in the beds on the east side of the field than that in the beds on the west side of the field. Whether or not difference in initial subsurface concentrations of the compounds between east side beds and west side beds may influence fumigant efficacy remains to be determined.     

Adsorption of chloridazon from aqueous solution on modified kerolite-rich materials

The adsorption of chloridazon (5-amine-4-chloro-2-phenylpyridazin-3(2H)-one) on kerolite samples heated at 110 degrees C (K-110), 200 degrees C (K-200), 400 degrees C (K-400), 600 degrees C (K-600) and acid-treated with H(2)SO(4) solutions of two different concentrations (0.25 and 0.5 M) (K-0.25 and K-0.5, respectively) from pure water at 25 degrees C has been studied by using batch and column experiments. The adsorption experimental data points were fitted to the Freundlich equation in order to calculate the adsorption capacities (K(f)) of the samples; K(f) values ranged from 184.7 mg kg(-1) (K-0.5) up to 2253 mg kg(-1) (K-600). This indicated that the heat treatment given to the kerolite greatly increases its adsorption capacity for the herbicide whereas the acid treatment produces a clear decrease in the amount of chloridazon adsorbed. The removal efficiency (R) was also calculated; R values ranging from 52.8% (K-0.5) up to 88.3% (K-600). Thus, the results showed that the 600 degrees C heat-treated kerolite was more effective in relation to adsorption of chloridazon and it might be reasonably used in removing this herbicide from water.     

In-field variation in 2,4-D mineralization in relation to sorption and soil microbial communities

This study was undertaken to assess 2,4-D mineralization in an undulating cultivated field, along a sloping transect (458 m to 442 m above sea level), as a function of soil type, soil microbial communities and the sorption of 2,4-D to soil. The 2,4-D soil sorption coefficient (Kd) ranged from 1.81 to 4.28 L kg(-1), the 2,4-D first-order mineralization rate constant (k) ranged from 0.04 to 0.13 day(-1) and the total amount of 2,4-D mineralized at 130 days (M(130)) ranged from 24 to 39%. Both k and M(130) were significantly negatively associated (or correlated) with soil organic carbon content (SOC) and Kd. Both k and M(130) were significantly associated with two fatty-acid methyl esters (FAME), i17:1 and a18, but not with twenty-two other individual FAME. Imperfectly drained soils (Gleyed Dark Grey Chernozems) in lower-slopes showed significantly lesser 2,4-D mineralization relative to well-drained soils (Orthic Dark Grey Chernozems) in mid- and upper-slopes. Well-drained soils had a greater potential for 2,4-D mineralization because of greater abundance and diversity of the microbial community in these soils. However, the reduced 2,4-D mineralization in imperfectly drained soils was predominantly because of their greater SOC and increased 2,4-D sorption, limiting the bioavailability of 2,4-D for degradation. The wide range of 2,4-D sorption and mineralization in this undulating cultivated field is comparable in magnitude and extent to the variability of 2,4-D sorption and mineralization observed at a regional scale in Manitoba. As such, in-field variations in SOC and the abundance and diversity of microbial communities are determining factors that require greater attention in assessing the risk of movement of 2,4-D by runoff, eroded soil and leaching.     

Characterizing ammonia emissions from swine farms in eastern North Carolina: part 1--conventional lagoon and spray technology for waste treatment

Ammonia (NH3) fluxes from waste treatment lagoons and barns at two conventional swine farms in eastern North Carolina were measured. The waste treatment lagoon data were analyzed to elucidate the temporal (seasonal and diurnal) variability and to derive regression relationships between NH3 flux and lagoon temperature, pH and ammonium content of the lagoon, and the most relevant meteorological parameters. NH3 fluxes were measured at various sampling locations on the lagoons by a flowthrough dynamic chamber system interfaced to an environmentally controlled mobile laboratory. Two sets of open-path Fourier transform infrared (FTIR) spectrometers were also used to measure NH3 concentrations for estimating NH3 emissions from the animal housing units (barns) at the lagoon and spray technology (LST) sites. Two different types of ventilation systems were used at the two farms. Moore farm used fan ventilation, and Stokes farm used natural ventilation. The early fall and winter season intensive measurement campaigns were conducted during September 9 to October 11, 2002 (lagoon temperature ranged from 21.2 to 33.6 degrees C) and January 6 to February 2, 2003 (lagoon temperature ranged from 1.7 to 12 degrees C), respectively. Significant differences in seasonal NH3 fluxes from the waste treatment lagoons were found at both farms. Typical diurnal variation of NH3 flux with its maximum value in the afternoon was observed during both experimental periods. Exponentially increasing flux with increasing surface lagoon temperature was observed, and a linear regression relationship between logarithm of NH3 flux and lagoon surface temperature (T1) was obtained. Correlations between lagoon NH3 flux and chemical parameters, such as pH, total Kjeldahl nitrogen (TKN), and total ammoniacal nitrogen (TAN) were found to be statistically insignificant or weak. In addition to lagoon surface temperature, the difference (D) between air temperature and the lagoon surface temperature was also found to influence the NH3 flux, especially when D > 0 (i.e., air hotter than lagoon). This hot-air effect is included in the statistical-observational model obtained in this study, which was used further in the companion study (Part II), to compare the emissions from potential environmental superior technologies to evaluate the effectiveness of each technology.     

Single-source impact analysis using three-dimensional air quality models

Isolating the effects of an individual emissions source on secondary air pollutants such as ozone and some components of particulate matter must incorporate complex nonlinear processes, be sensitive to small emissions perturbations, and account for impacts that may occur hundreds of kilometers away. The ability to evaluate these impacts is becoming increasingly important for efficient air quality management. Here, as part of a recent compliance enforcement action for a violation of the Clean Air Act and as an evaluation of ozone response to single-source emissions plumes, two three-dimensional regional photochemical air quality models are used to assess the impact on ozone from approximately 2000 to 3000 excess t/month of nitrogen oxides emitted from a single power plant in Ohio. Periods in May, July, and August are evaluated. Two sensitivity methods are applied: the "brute-force" (B-F) method and the decoupled direct method (DDM). Using DDM, maximum 1-hr averaged ozone concentrations are found to increase by up to 1.8, 1.3, and 2.2 ppbv during May, July, and August episodes, respectively, and concentration increases greater than 0.5 ppbv occur in Ohio, Pennsylvania, Maryland, New York, West Virginia, Virginia, and North and South Carolina. B-F results for the August episode show a maximum 1-hr averaged ozone concentration increase of 2.3 ppbv. Significant localized decreases are also simulated, with a maximum of 3.6 ppbv in Ohio during the August episode and decreases of 0.50 ppbv and greater in Ohio, Pennsylvania, Maryland, West Virginia, and Virginia. Maximum increases are compared with maximum decreases for the August period using second-order DDM and are found, in aggregate, to be greater in magnitude by 42%. When evaluated during hours when ozone concentrations exceed 0.060 ppm, the maximum increases in ozone are higher than decreases by 82%. The spatial extent of ozone increase in both cases is about triple that of reduction.     

Assessment of sediment contamination in Casco Bay, Maine, USA

The current status of contaminant concentrations in Casco Bay, decadal trends of these contaminants and changes in their geographical distribution are assessed using sediment samples collected approximately 10 years apart. In general, regulated contaminants appeared to be decreasing in concentration. Total PAH and dioxins/furans concentrations did not significantly change over this period. Total organochlorine pesticides, 4,4-DDE, 4,4-DDD, total DDT, PCB, tributyltin and total butyltin decreased in concentration. Trace element concentrations in sediments decreased at the majority of the sampling sites for chromium, nickel, and selenium while arsenic, cadmium, copper, lead, mercury, silver, and zinc remained relatively constant. None of the contaminants measured has increased by more than a factor of 2. Selected sites located in the Inner Bay, where concentrations are higher and new inputs were more likely, showed increased concentrations of contaminants. Most contaminants were not found at concentrations expected to adversely affect sediment biota based on ERL/ERM guidelines.     

Field and laboratory simulations of storm water pulses: behavioural avoidance by marine epifauna

Epifaunal communities associated with macroalgae were exposed to storm water pulses using a custom made irrigation system. Treatments included Millipore freshwater, freshwater spiked with trace metals and seawater controls to allow for the relative importance of freshwater inundation, trace metals and increased flow to be determined. Experimental pulses created conditions similar to those that occur following real storm water events. Brief storm water pulses reduced the abundance of amphipods and gastropods. Freshwater was the causative agent as there were no additional effects of trace metals on the assemblages. Laboratory assays indicated that neither direct nor latent mortality was likely following experimental pulses and that epifauna readily avoid storm water. Indirect effects upon epifauna through salinity-induced changes to algal habitats were not found in field recolonisation experiments. Results demonstrate the importance of examining the effects of pulsed contaminants under realistic exposure conditions and the need to consider ecologically relevant endpoints.     

Use of principal component analysis to profile temporal and spatial variations of chlorinated solvent concentration in groundwater

This work aims at evaluating spatial distribution patterns of concentration variations for chlorinated solvents in groundwater, based on principal component analysis and geographic information system (GIS) tools. The study investigates long-time series of chlorinated solvent concentrations in groundwater measured for 18 contaminated industrial sites. The characterization of contaminant plumes and delineation of pollutant sources are essential for choosing appropriate monitoring and remediation strategies, as contaminated groundwaters are characterized by complex patterns of spatial and temporal concentration variability, with wide unpredictable fluctuations over time. The present work describes the results of a new exploratory statistical method called the Variability Index Method (VIM) applied to environmental data to assess the performance of using concentration variations as molecular tracers to reveal aquifer dynamics, industrial impacts, and point sources for contamination plumes. The application of this method provides a useful assessment of controls over contaminant concentration variations as well as support for remediation techniques.     

Particle fluxes above forests: observations, methodological considerations and method comparisons

This paper reports a study designed to test, evaluate and compare micro-meteorological methods for determining the particle number flux above forest canopies. Half-hour average particle number fluxes above a representative broad-leaved forest in Denmark derived using eddy covariance range from -7x10(7) m(-2) s(-1) (1st percentile) to 5x10(7) m(-2) s(-1) (99th percentile), and have a median value of -1.6x10(6) m(-2) s(-1). The statistical uncertainties associated with the particle number flux estimates are larger than those for momentum fluxes and imply that in this data set approximately half of the particle number fluxes are not statistically different to zero. Particle number fluxes from relaxed eddy accumulation (REA) and eddy covariance are highly correlated and of almost identical magnitude. Flux estimates from the co-spectral and dissipation methods are also correlated with those from eddy covariance but exhibit higher absolute magnitude of fluxes.