Characteristics of the PAH emissions from the incineration of livestock wastes with/without APCD

This study was conducted on two batch-type livestock waste incinerators, including the one with an air-pollution control device (APCD)-one wet scrubber (WSB) and the other without APCD for the disposal of livestock wastes. The concentration and composition of 21 individual polycyclic aromatic hydrocarbons (PAHs) in the stack flue gas (gas and particle phases), bottom ash, and effluent of WSB were determined. Stack flue gas samples were collected by a PAH stack-sampling system. Twenty-one individual PAHs were analyzed by a gas chromatography/mass spectrometer (GC/MS). Due to the low combustion temperature, a remarkable and significant increase in the total-PAH concentration of emission from the stack with APCD was observed when compared with the case without APCD. Measured total-PAH emission factors were 285 and 2.86 mg/kg waste for the incineration with and without APCD, respectively, while BaP (the most carcinogenic PAH) emission factors were 0.79 and 0.12 mg/kg waste for the incineration with and without APCD. The total-PAH output/input mass ratios averaged 0.011 and 0.004 with and without APCD, respectively. The result reveals that the PAH content in the auxiliary fuel during the incinerating process could affect the emission of PAH.     

Odor measurements for manure spreading using a subsurface deposition applicator

Odor emissions during manure spreading events have become a source of concern, particularly where farms are located nearby urban areas. The objective of the present study was to compare odor concentrations and odor emission rates due to pig manure application using two different types of applicators, a sub-surface deposition system and a conventional splash-plate applicator. Air samples were collected using a Surface Isolation Flux Chamber and the "bag-in-vacuum chamber" techniques, at 0.5, 1.5 and 2.5 hours after manure application. A three-station forced-choice dynamic dilution olfactometer was used by an odor panel for determining odor concentration. Preliminary results indicated that with the sub-surface deposition system applicator odor emission rate was reduced by 8% to 38% compared to that of the conventional splash-plate applicator. The highest reduction in odor strength and odor emission rate was observed in the most offensive period after manure application. The sub-surface deposition system may be a solution for hog producers who wish to reduce odor complaints from applying manure without the cost and problems associated with deep injection systems.     

INTERDISCIPLINARY MODELING IN THE ANALYSIS OF THE SALINITY PROBLEMS OF THE SAFFORD VALLEY1

ABSTRACT: A groundwater quality change of +0.13 millimhos electrical conductivity was documented between 1940 and 1 972 in the Safford Valley. The change is attributable to four principal mechanisms: pumping-encouraged saline artesian aquifer leakage, natural recharge of the water table aquifer by saline waters, leaching of agricultural waters into the aquifer and the lateral flow of groundwater through saline lacustrine beds. A hydrologic study of the area has shown the first of these mechanisms to be predominant. Salinity modeling has shown three regions of salinity change, and salinity increase projections for each are determined. An economic analysis and an economic model are then combined with the physical model, yielding information as to when certain economic conditions are reached with respect to the salinity increase. This combined model shows that, based on projected salinity trends, cotton, the principal agricultural crop of the valley, will remain economical to cultivate for a significant time beyond the model's limit of prediction. Alfalfa, on the other hand, should go out of production in large areas of the valley by 1990, and not be under economical cultivation by 2040. A sociologic model, based on the cluster analysis of questionnaire data, shows an awareness of the salinity problems of the area but little concern over them. Interdisciplinary model based salinity control regulations are made.     

Fuzzy AHP-based study of cleaner production implementation in Taiwan PWB manufacturer

In recent years, many electronic manufacturing firms have looked upon Cleaner Production (CP) as the means by which they could maintain environmental practice and competitive advantages. CP has been adopted by companies as an important factor in enhancing industrial productivity. Sustainable projects that deal appropriately with environmental and social factors are also more likely to be the most profitable.This paper investigated the criteria and attributes that determine a successful adoption and implementation of CP in reference to PWB manufacture in Taiwan. Fuzzy Analytic Hierarchy Process (FAHP) methodology is used to discuss the different decision criteria that include Organizing, Systems and Technologies, Measurement and Feedback, Working environment and Worker's Culture which are all vital factors in an effective CP implementation. AHP is an efficient tool in controlling the fuzziness of the data involved in choosing the most preferred decision variables. The linguistic level of comparisons produced by the manufacturers and experts are tapped and constructed in a form of triangular fuzzy numbers in order to construct fuzzy pairwise comparison matrices. The implementation of the system is demonstrated by a problem involving three stages of hierarchy which contains different criteria and attributes at a wider perspective within an environmental uncertainty. The findings advocate that these enterprises would need to setup the priorities of the CP implementation. The results suggest a generic hierarchical model of organizations of which the highest level is to be prioritized among the CP implementation factors.     

Implications of geometric plasticity for maximizing photosynthesis in branching corals

Reef-building corals are an example of plastic photosynthetic organisms that occupy environments of high spatiotemporal variations in incident irradiance. Many phototrophs use a range of photoacclimatory mechanisms to optimize light levels reaching the photosynthetic units within the cells. In this study, we set out to determine whether phenotypic plasticity in branching corals across light habitats optimizes potential light utilization and photosynthesis. In order to do this, we mapped incident light levels across coral surfaces in branching corals and measured the photosynthetic capacity across various within-colony surfaces. Based on the field data and modelled frequency distribution of within-colony surface light levels, our results show that branching corals are substantially self-shaded at both 5 and 18 m, and the modal light level for the within-colony surface is 50 μmol photons m^?2 s^?1. Light profiles across different locations showed that the lowest attenuation at both depths was found on the inner surface of the outermost branches, while the most self-shading surface was on the bottom side of these branches. In contrast, vertically extended branches in the central part of the colony showed no differences between the sides of branches. The photosynthetic activity at these coral surfaces confirmed that the outermost branches had the greatest change in sun- and shade-adapted surfaces; the inner surfaces had a 50 % greater relative maximum electron transport rate compared to the outer side of the outermost branches. This was further confirmed by sensitivity analysis, showing that branch position was the most influential parameter in estimating whole-colony relative electron transport rate (rETR). As a whole, shallow colonies have double the photosynthetic capacity compared to deep colonies. In terms of phenotypic plasticity potentially optimizing photosynthetic capacity, we found that at 18 m, the present coral colony morphology increased the whole-colony rETR, while at 5 m, the colony morphology decreased potential light utilization and photosynthetic output. This result of potential energy acquisition being underutilized in shallow, highly lit waters due to the shallow type morphology present may represent a trade-off between optimizing light capture and reducing light damage, as this type morphology can perhaps decrease long-term costs of and effect of photoinhibition. This may be an important strategy as opposed to adopting a type morphology, which results in an overall higher energetic acquisition. Conversely, it could also be that maximizing light utilization and potential photosynthetic output is more important in low-light habitats for Acropora humilis.     

Sedimentary Pigments and Organic Matter in Relation to Benthic Fauna in the Tan-Shui Estuary, Taiwan

The benthic ecological structure of the Tan-Shui estuary, Taiwan is changed due to long term effects of dumping of urban wastewater and of engineering actions. to monitor these changes, we sampled and analyzed benthos and sediment from 12 stations on the estuary.

The composition of the dominant species of benthos varied seasonally, with molluscan and crustacean species having greater numbers and higher frequencies of occurrence than other species. the dominant taxa during winter were Nassarius sp. and Maldanidae at two stations. Analysis using Simpson's index and Shannon's index showed the benthic community varied more in coastal areas than in offshore areas.

Physicochemical analysis showed that most of the Tan-Shui estuary consisted of sandy sediment. the variations in concentrations of organic carbon and total nitrogen at each station were small. Although the concentrations of chlorophyll-a and carotenoid at all stations were generally low, the two stations had the highest concentrations, and we concluded that the concentration of pigments in these sediments was related to the abundance of benthos. the community structure of the benthos reflected the characteristics of the sediments, and benthic species exhibited selection of and adaptation to specific sedimentary environments.