A comparison of the low frequency electrical signatures of iron oxide versus calcite precipitation in granular zero valent iron columns

Geophysical methods have been proposed as technologies for non-invasively monitoring geochemical alteration in permeable reactive barriers (PRBs). We conducted column experiments to investigate the effect of mineralogy on the electrical signatures resulting from iron corrosion and mineral precipitation in Fe0 columns using (a) Na2SO4, and (b) NaHCO3 plus CaCl2 mixture, solutions. At the influent interface where the reactions were most severe, a contrasting time-lapse electrical response was observed between the two columns. Solid phase analysis confirmed the formation of corrosion halos and increased mineralogical complexity in the corroded sections of the columns compared to the minimal/non-corroded sections. We attribute the contrasting time-lapse signatures to the differences in the electrical properties of the mineral phases formed within the two columns. While newly precipitated/transformed polarizable and semi-conductive iron oxides (mostly magnetite and green rust) increase the polarization and conductivity of the sulfate column, the decrease of both parameters in the bicarbonate column is attributed to the precipitation of non-polarizable and non-conductive calcite. Our results show that precipitate mineralogy is an important factor influencing the electrical properties of the corroded iron cores and must be considered if electrical geophysical methods are to be developed to monitor PRB barrier corrosion processes in situ.     

A novel approach to rapid detection of acute water toxicity and its policy implications for grassroots sustainable environmental monitoring

Unknown chemicals, emerging contaminants, and the resulting reactions among them make early detection and warning of acute water toxicity extremely challenging. The conventional approach using small fish for toxicity monitoring normally requires a designated species of fish and over a week's time to complete, including dilution of the wastewater, a pre-test, and a full test. It often increases chances for error and delays emergency management. This paper reports a novel approach, based on grassroots knowledge and field and lab experience in Jilin, China. This approach uses a combination of different species of aquarium fish to achieve fast and reliable monitoring. It tests the original source water directly without going through the dilution procedure, while paying attention to the time factor. The approach does not require a pre-test and may shorten the time needed for detecting acute toxicity to a few minutes, using a new classification of aquatic toxicity levels. It is inexpensive to use and may be easily adopted by grassroots organizations. The approach is "greener" and more financially and socially sustainable than traditional approaches. The wide use of the approach has the potential to encourage policy innovations for making toxicity monitoring grassroots based and more effective in reducing acute contamination emergencies.     

A Mathematical Model for the Effects of Fertilization on Nitrogen Concentrations in Unsaturated Soil on Blueberry Farms in Southern New Jersey

Nitrogen is commonly known as a food source for crops. However, the nitrogen compounds used in crop fertilizers, most commonly nitrate (NO₃) and ammonium (NH₄), are not widely understood. Blueberry plants do not take up these compounds as efficiently as organic nitrogen so varying amounts of leaching into the soil and groundwater will occur. A biogeochemical model consisting of ordinary and partial differential equations is implemented to computationally predict the concentrations of nitrate and ammonium in unsaturated soil of blueberry plants, specifically in the southern region of New Jersey. The model takes into account the type of soil of the region, the nitrate uptake of the plant, the water content in the roots region, the pressure heads in the soil pores, and the application rates of fertilizers containing nitrate, ammonium, and organic nitrogen. Computational simulations demonstrate that the model accounts for natural processes and, in addition, show that commonly used fertilizer application rates cause unnecessarily high concentrations of both nitrate and ammonium in the unsaturated soil level. Further, simulations show that decreasing nitrate fertilizer applications by 85.7% in annual and 91.8% in bi-annual schedules provides an optimal system for safe reapplication.     

The personal,social and environmental sustainability of Jainism in light of Maharishi Vedic Science

The Jain tradition of ecological awareness and sustainability has been well documented over the last 25 years, although its roots lie deep in Indian history, specifically in texts such as the Tattvārtha Sūtra and ācārā?ga Sūtra. This traditional body of knowledge includes a long-standing theory and practice of personal, social and environmental sustainability, addressing such views as the interconnectedness of humans and the laws of nature, the interdependence of everything in the universe, the responsibility of humans to conserve and preserve natural resources, the avoidance of wanton and unnecessary waste generation, and a general aversion to mistreating or abusing the environment. These views encapsulate the lifestyles of some ten million people, including both mendicants and laity. Similarly, Maharishi Vedic Science, the systematic exploration and practical application of the Veda and Vedic Literature as taught by Maharishi Mahesh Yogi, makes a compelling case for establishing the unity of human life with nature and for promoting actions which guarantee both the protection of nature and protection by it. The purpose of this paper is to examine the relationship between the principles of sustainability in Jainism and the corresponding viewpoint of Maharishi Vedic Science, including supporting scientific evidence of its application, and to posit their contribution to a sustainable world future.     

Aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in peninsular Malaysia

An aquatic biomonitoring of Giardia cysts and Cryptosporidium oocysts in river water corresponding to five villages situated in three states in peninsular Malaysia was determined. There were 51.3 % (20/39) and 23.1 % (9/39) samples positive for Giardia and Cryptosporidium (oo)cysts, respectively. Overall mean concentration between villages for Giardia cysts ranged from 0.10 to 25.80 cysts/l whilst Cryptosporidium oocysts ranged from 0.10 to 0.90 oocysts/l. Detailed results of the river samples from five villages indicated that Kuala Pangsun 100 % (9/9), Kemensah 77.8 % (7/9), Pos Piah 33.3 % (3/9) and Paya Lebar 33.3 % (1/3) were contaminated with Giardia cysts whilst Cryptosporidium (oo)cysts were only detected in Kemensah (100 %; 9/9) and Kuala Pangsun (66.6 %; 6/9). However, the water samples from Bentong were all negative for these waterborne parasites. Samples were collected from lower point, midpoint and upper point. Midpoint refers to the section of the river where the studied communities are highly populated. Meanwhile, the position of the lower point is at least 2 km southward of the midpoint and upper point is at least 2 km northward of the midpoint. The highest mean concentration for (oo)cysts was found at the lower points [3.15?±?6.09 (oo)cysts/l], followed by midpoints [0.66?±?1.10 (oo)cysts/l] and upper points [0.66?±?0.92 (oo)cysts/l]. The mean concentration of Giardia cysts was highest at Kuala Pangsun (i.e. 5.97?±?7.0 cysts/l), followed by Kemensah (0.83?±?0.81 cysts/l), Pos Piah (0.20?±?0.35 cysts/l) and Paya Lebar (0.10?±?0.19 cysts/l). On the other hand, the mean concentration of Cryptosporidium oocysts was higher at Kemensah (0.31?±?0.19 cysts/l) compared to Kuala Pangsun (0.03?±?0.03cysts/l). All the physical and chemical parameters did not show significant correlation with both protozoa. In future, viability status and molecular characterisation of Giardia and Cryptosporidium should be applied to identify species and genotypes/subgenotypes for better understanding of the epidemiology of these waterborne parasites.     

A Collaborative Effort to Model Plant Response to Acidic Rain

Radish plants were exposed three times per week to simulated acidic rain at pH values of 2.6 to 5.4 over the course of four weeks in trials performed at Argonne, Illinois; Ithaca and Upton, New York; Corvallis, Oregon; Oak Ridge, Tennessee; and Toronto, Canada. Uniform genotype, soil media and planting techniques, treatment procedures, biological measurements, and experimental design were employed. Growth of plants differed among trials as a result of variation in greenhouse environmental conditions according to location and facilities. Larger plants underwent greater absolute but lower relative reductions in biomass after exposure to the higher levels of acidity. A generalized Mitscherlich function was used to model the effects of acidity of simulated rain or dry mass of hypocotyls using data from three laboratories that performed duplicate trials. The remaining data, from three other laboratories that performed only one trial each, were used to test the model. When the laboratory by trial effect was removed (influence of different growth. conditions), lack of fit to the Mitscherlich function was insignificant. Thus, a single mathematical model satisfactorily characterized the relationship between acidity and mean plant response. The pH value associated with a 10 percent reduction in mass was 3.3 ± 0.3 for hypocotyls. No value was estimated for shoots because effects oh shoots were not significant. The results of this study demonstrate that a generalized exposure-response model can be developed in the presence of large variations in environmental conditions when plant culture and exposure to simulated rain are standardized among laboratories.     

Decomposition of SF6 in an RF Plasma Environment

Abstract

Sulfur hexafluoride (SF₆)-contained gas is a common pollutant emitted during the etching process used in the semiconductor industry. This study demonstrated the application of radio-frequency (RF) plasma in the decomposition of SF₆. The decomposition fraction of SF₆ [η_SF6 (C_in–C_out)/C_in x 100%] and the mole fraction profile of the products were investigated as functions of input power and feed O₂/SF₆ ratio in an SiO₂ reactor. The species detected in both SF₆/Ar and SF₆/O₂/Ar RF plasmas were SiF₄, SO₂, F₂, SO₂F₂, SOF₂, SOF₄, S₂F₁₀, S₂OF₁₀, S₂O₂F₁₀, and SF₄. The results revealed that at 40 W, η_SF6 exceeded 99%, and the reaction products were almost all converted into stable compounds such as SiF₄, SO₂, and F₂ with or without the addition of oxygen. Sulfur oxyfluorides such as SO₂F₂, SOF₂, SOF₄, S₂OF₁₀, and S₂O₂F₁₀ were produced only below 40 W. The results of this work can be used to design a plasma/chemical system for online use in a series of a manufacturing process to treat SF₆-containing exhaust gases.     

Characterizing Driving Patterns for Zhuhai for Traffic Emissions Estimation

Abstract

Zhuhai, a relatively less developed city on the western coast of the Pearl River Delta (PRD) of China, is planning to undergo major development in coming years. A Hong Kong-Zhuhai-Macao Bridge project has been approved by the Central Government of China. The project will have great impact on the driving pattern and vehicular emissions to the city. This baseline study collected speed-time data of two instrumented private cars in morning and evening periods, as well as a daytime nonpeak period of >10 consecutive days in the spring and winter of 2003. The authors used the microwave speed sensor and global positioning system installed in the instrumented cars and used car-chasing technique to perform the data collection. They used the statistical package SPSS to assess the consistency, as well as to evaluate the variability of the data. Nine parameters, namely, average speed, average running speed, average acceleration rate, average deceleration rate, mean length of a driving period, time proportions of driving modes, average number of acceleration-deceleration changes, root mean square acceleration, and positive acceleration kinetic energy are calculated to represent the driving characteristics. A driving cycle for private cars was developed. If emission tests were conducted using the Zhuhai driving cycle, the level of vehicle emissions measured is likely to be in between that of the Federal Test Procedure (FTP) cycle and the Melbourne Peak cycle.     

Microwave-induced nanoscale zero-valent iron degradation of perchloroethylene and pentachlorophenol

Microwave (MW) is applied to enhance perchloroethylene (PCE) or pentachlorophenol (PCP) removal using zero-valent iron (ZVI; Fe⁰) as the dielectric medium. ZVI has a much higher dielectric loss factor (39.5) than other media; it is capable of absorbing MW radiation rapidly to speed up the release of electrons, leading to rises of the ZVI particle surface temperature. If the MW power is continued, excessive electricity will accumulated inside ZVI particles, resulting in sparks. The results show that during the initial 5 sec (700 W), the linear aliphatic PCE has a faster decomposing rate than the ringed PCP (82.0% vs. 4.8%) because less energy is required for decomposing the linear-chlorine bond (90 kcal mol^?1) than ring-chlorine bonds (95 kcal mol^?1). Later, the removal rate for either PCE or PCP remains the same when the exposure time is between 5 and 60 sec. Without MW irradiation, linear PCE molecules have larger surface area to contact ZVI, and hence they have better removal efficiencies than PCP molecules. Using Fe⁰ as a microwave dielectric medium to treat PCE or PCP is a new and worthwhile treatment technology; it is environmentally friendly, and its use will eliminate the secondary pollution.

Implications Nanoscale iron particles are characterized by high surface-area-to-volume ratios, high specific surface area, and high surface reactivity. With a much higher dielectric loss factor, it is capable of absorbing MW radiation rapidly to speed up the release of electrons, leading to rise in temperature. The time needed to achieve a satisfactory treatment is also reduced, leading to significant saving of energy consumption to make this method cost-effective and also environmentally friendly for the industry to pursuit sustainable development.