A comparison of fine particle and aerosol strong acidity at the interface zone (1540 m) and within (452 m) the planetary boundary layer of the Great Gulf and Presidential-Dry River Class I Wildernesses on the Presidential Range,New Hampshire USA

Mount Washington, NH in the White Mountain National Forest, is flanked to the north-northeast and south by two Class I Wilderness areas, the Great Gulf and Presidential Range-Dry River Wildernesses, respectively. The Clean Air Act protects Class I Area natural resource values from air pollution. Aerosol sulfate, a fine particulate component that is often transported long distances, is a known contributor to visibility degradation and acidic deposition. We examined summertime fine particulate aerosol mass and sulfate, strong acidity and ammonium concentrations from 1988 to 2007 on Mount Washington at two elevations, 452 and 1540 m (msl). The former site is often within, and the latter at the interface of, the planetary boundary layer. Comparisons of sampling interval durations (10 and 24 h) and site vs. site are made. We also examine the extent to which aerosol sulfate is neutralized.Ten hour (daytime) compared to 24 h samples have higher mass and aerosol sulfate concentrations, however paired samples are well correlated. Fine mass concentrations compared between the 452 m and 1540 m sites (standard temperature and pressure corrected) show a weak positive linear relationship with the later being approximately 32% lower. We attribute the lack of a strong correlation to the facts that the 1540 m site is commonly at the interface of and even above the regional planetary boundary layer in summer and that it can intercept different air masses relative to the 452 m site. Sulfate is ～18% lower at the higher elevation site, but comprises a greater percentage of total fine mass; 42% compared to 37% for the high and low elevation site, respectively. Aerosol strong acidity was found to increase with increasing sulfate concentrations at both sites. Further the ratio of hydrogen to sulfate ion was greater in 24 h than 10 h samples at the higher elevation site likely due to overnight transport of fresh acidic aerosols.     

Characterization of carbonaceous combustion residues. I. Morphological,elemental and spectroscopic features

Scanning electron microscopy, surface area determination, elemental analysis, organic matter extraction and solid-state cross polarization/magic angle spinning and Bloch decay/magic angle spinning 13C nuclear magnetic resonance (NMR) spectroscopy were used to investigate distinctive features among carbonaceous combustion residues. Black carbon (BC) samples included diesel soot, urban dust, carbon black, chimney soot, vegetation fire residues, wood and straw charcoals. Particles varied from small spheres (<50 nm) in fossil BC (>100 m(2)/g), to large layered structures in plant-derived BC (generally <8 m(2)/g). Chimney soot also included large (>1 micrometer) liquid-like structures, while spherules >100 nm were unique to urban dust. The ratios of amorphous to soot carbon (SC) (isolated by thermal degradation) were not necessarily correlated with the degree of aromaticity estimated from H/C ratios. In particular, values of SC in diesel soot were clearly overestimated. Solvent-extractable organic matter (SEOM) was <2% for charcoals and carbon black, but >13% for urban dust, chimney and diesel soot. SEOM is thought to clog pores or to form large waxy globules, hence reducing surface areas. The ratio of polar/nonpolar SEOM was generally <7 for fossil BC, but >30 for plant-derived BC. NMR analysis revealed essentially one chemical shift in the aromatic C region of charcoals, while diesel soot also showed important aliphatic contributions. Aliphatic and oxygenated C predominated over aryl C in urban dust and chimney soot. These morphological and chemical characteristics of the BC samples are discussed in terms of their environmental implications.     

The interplay between incremental,transitional, and transformational adaptation: a case study of Canadian agriculture

Regional Environmental Change - We develop and apply a synthetic framework for understanding potential adaptations to climate change in the Canadian agriculture sector through a case study of...     

Source apportionment of particulate matter (PM2.5) in an urban area using dispersion,receptor and inverse modelling

Air pollution emission inventories are the basis for air quality assessment and management strategies. The quality of the inventories is of great importance since these data are essential for air pollution impact assessments using dispersion models. In this study, the quality of the emission inventory for fine particulates (PM_2.5) is assessed: first, using the calculated source contributions from a receptor model; second, using source apportionment from a dispersion model; and third, by applying a simple inverse modelling technique which utilises multiple linear regression of the dispersion model source contributions together with the observed PM_2.5 concentrations. For the receptor modelling the chemical composition of PM_2.5 filter samples from a measurement campaign performed between January 2004 and April 2005 are analysed. Positive matrix factorisation is applied as the receptor model to detect and quantify the various source contributions. For the same observational period and site, dispersion model calculations using the Air Quality Management system, AirQUIS, are performed. The results identify significant differences between the dispersion and receptor model source apportionment, particularly for wood burning and traffic induced suspension. For wood burning the receptor model calculations are lower, by a factor of 0.54, but for the traffic induced suspension they are higher, by a factor of 7.1. Inverse modelling, based on regression of the dispersion model source contributions and the PM_2.5 concentrations, indicates similar discrepancies in the emissions inventory. In order to assess if the differences found at the one site are generally applicable throughout Oslo, the individual source category emissions are rescaled according to the receptor modelling results. These adjusted PM_2.5 concentrations are compared with measurements at four independent stations to evaluate the updated inventory. Statistical analysis shows improvement in the estimated concentrations for PM_2.5 at all sites. Similarly, inverse modelling is applied at these independent sites and this confirms the validity of the receptor model results.     

The network imaginary: coherence and creativity within a multiscalar collaborative effort to reform US fire management

In response to the ongoing crisis in fire management, the US Fire Learning Network (FLN) engages partners in collaborative, landscape-scale ecological fire restoration. The paper contends that the FLN employs technologies, planning guidelines and media to articulate an FLN imaginary that co-ordinates independent efforts to engage in ecological fire restoration work without need of either hierarchal authority or collective social capital. This imaginary may allow the FLN to draw on the creativity and adaptive innovation of collaboration to reform fire management institutions and fire-adapted ecosystems.     

Investigation into the use of satellite data in aiding characterization of particulate air quality in the Atlanta, Georgia metropolitan area

Poor air quality episodes occur often in metropolitan Atlanta, GA. The primary focus of this research is to assess the capability of satellites as a tool in characterizing air quality in Atlanta. Results indicate that intracity PM2.5 (particulate matter < or = 2.5 microm in aerodynamic diameter) concentrations show similar patterns as other U.S. urban areas, with the highest concentrations occurring within the city. PM2.5 and MODIS (Moderate Resolution Imaging Spectroradiometer) aerosol optical depth (AOD) have higher values in the summer than spring, yet MODIS AOD doubles in the summer unlike PM2.5. Most (80%) of the Ozone Monitoring Instrument aerosol index (AI) is below 0.5 with little differences between spring and summer. Using this value as a constraint of the carbonaceous aerosol signal in the urban area, aerosol transport events such as wildfire smoke associated with higher positive AI values can be identified. The results indicate that MODIS AOD is well correlated with PM2.5 on a yearly and seasonal basis with correlation coefficients as high as 0.8 for Terra and 0.7 for Aqua. A possible alternative view of the PM2.5 and AOD relationship is seen through the use of AOD thresholds. These probabilistic thresholds provide a means to describe the air quality index (AQI) through the use of multiyear AOD records for a specific area. The National Ambient Air Quality Standards (NAAQS) are used to classify the AOD into different AQI codes and probabilistically determine thresholds of AOD that represent most of a specific AQI category. For example, 80% of cases of moderate AQI days have AOD values between 0.5 and 0.6. The development of AOD thresholds provides a useful tool for evaluating air quality from the use of satellites in regions where there are sparse ground-based measurements of PM2.5.     

Influence of combustion conditions on yields of solvent-extractable anhydrosugars and lignin phenols in chars: Implications for characterizations of biomass combustion residues

Anhydrosugars, such as levoglucosan and its isomers (mannosan, galactosan), as well as the solvent-extractable lignin phenols (methoxylated phenols) are thermal degradation products of cellulose/hemicellulose and lignin, respectively. These two groups of biomarkers are often used as unique tracers of combusted biomass inputs in diverse environmental media. However, detailed characterization of the relative proportion and signatures of these compounds in highly heterogeneous plant-derived chars are still scarce. Here we conducted a systematic study to investigate the yields of solvent-extractable anhydrosugars and lignin phenols in 25 lab-made chars produced from different plant materials under different combustion conditions. Solvent-extractable anhydrosugars and lignin phenols were only observed in chars formed below 350 °C and yields were variable across different combustion temperatures. The yields of mannosan (M) and galactosan (G) decreased more rapidly than those of levoglucosan (L) under increasing combustion severity (temperature and duration), resulting in variable L/M and L/(M + G) ratios, two diagnostic ratios often used for identification of combustion sources (e.g. hardwoods vs. softwoods vs. grasses). Our observations thus may provide an explanation for the wide ranges of values reported in the literature for these two ratios. On the other hand, the results of this study suggest that the ratios of the major solvent-extractable lignin phenols (vanillyls (V), syringyls (S), cinnamyls (C)) provide additional source reconstruction potential despite observed variations with combustion temperature. We thus propose using a property-property plot (L/M vs. S/V) as an improved means for source characterization of biomass combustion residues. The L/M-S/V plot has shown to be effective in environmental samples (soil organic matter, atmospheric aerosols) receiving substantial inputs of biomass combustion residues.     

Methylmercury in a predatory fish (Cichla spp.) inhabiting the Brazilian Amazon

This research tested whether limnological conditions, biological characteristics of fish and anthropogenic impacts influenced the assimilation of methylmercury into the muscle of a sedentary piscivorous fish, Cichla spp., from three rivers (Negro, Madeira, Tapajós) and two hydroelectric reservoirs (Balbina, Tucuruí) within the Brazilian Amazon. Methylmercury in this fish ranged from 0.04 to 1.43microgg(-1) w.w. across sites. No significant differences were observed in the methylmercury concentrations between males and females, or for different morphotypes of this species. Positive correlations were found between methylmercury and fish body weight. No differences were found between the weight normalized methylmercury (MeHg) concentrations or its percent of total mercury in fish from the three rivers; weight normalized MeHg was highest in one of the two reservoirs. In Rio Tapajós, where gold mining and deforestation cause high water turbidity, fish showed the highest MeHg and concentrations were different across the four sites examined. In all sampling areas, the %MeHg was found to be higher than 70.     

Migration of aluminum from food contact materials to food—a health risk for consumers? Part II of III: migration of aluminum from drinking bottles and moka pots made of aluminum to beverages

Background

Drinking bottles and stove-top moka pots made of aluminum have become very popular. Storing drinks in bottles and preparing coffee in a moka pot may result in the migration of aluminum to the beverage.

Results/Conclusions

In a systematic study of aluminum drinking bottles, it has been shown that drinking a mixture of apple juice and mineral water in an aluminum bottle may reach 86.6% of the total weekly intake (TWI) for adults, and drinking tea from an aluminum bottle may exceed the TWI (145%) for a child weighing 15 kg. In contrast, preparing coffee in an aluminum moka pot results in a maximum of 4% to TWI, if an average of 3.17 L coffee is consumed per week, even if the pots are washed in the dishwasher, against the explicit instructions of the manufacturer.

     

Migration of aluminum from food contact materials to food—a health risk for consumers? Part I of III: exposure to aluminum,release of aluminum,tolerable weekly intake (TWI), toxicological effects of aluminum,study design,and methods

Background

In spite of the prevalence of aluminum in nature, no organism has been found to date which requires this element for its biological functions. The possible health risks to human beings resulting from uptake of aluminum include detrimental effects to the hemopoietic system, the nervous system and bones. Aluminum is used in many fields and occurs in numerous foodstuffs. Food contact materials containing aluminum represent an anthropogenic source of dietary aluminum.

Results

As a result of their frequent use in private households a study was undertaken to detect migration of this metal to foodstuffs from drink containers, coffee pots, grill pans, and camping cookware made of aluminum.

Conclusions

An estimate of the health risk to consumers is calculated, based on the tolerable weekly intake (TWI) specified by the European Food Safety Authority of 1 mg/kg body weight for all groups of people. In some instances the TWI is significantly exceeded, dependent upon the food contact material and the food itself.