Dilution-based emissions sampling from stationary sources: Part 2--Gas-fired combustors compared with other fuel-fired systems

With the recent focus on fine particle matter (PM2.5), new, self-consistent data are needed to characterize emissions from combustion sources. Such data are necessary for health assessment and air quality modeling. To address this need, emissions data for gas-fired combustors are presented here, using dilution sampling as the reference. The dilution method allows for collection of emitted particles under conditions simulating cooling and dilution during entry from the stack into the air. The sampling and analysis of the collected particles in the presence of precursor gases, SO2 nitrogen oxide, volatile organic compound, and NH3 is discussed; the results include data from eight gas fired units, including a dual-fuel institutional boiler and a diesel engine powered electricity generator. These data are compared with results in the literature for heavy-duty diesel vehicles and stationary sources using coal or wood as fuels. The results show that the gas-fired combustors have very low PM2.5 mass emission rates in the range of approximately 10(-4) lb/million Btu (MMBTU) compared with the diesel backup generator with particle filter, with approximately 5 x 10(-3) lb/MMBTU. Even higher mass emission rates are found in coal-fired systems, with rates of approximately 0.07 lb/MMBTU for a bag-filter-controlled pilot unit burning eastern bituminous coal. The characterization of PM2.5 chemical composition from the gas-fired units indicates that much of the measured primary particle mass in PM2.5 samples is organic or elemental carbon and, to a much less extent, sulfate. Metal emissions are quite low compared with the diesel engines and the coal- or wood-fueled combustors. The metals found in the gas-fired combustor particles are low in concentration, similar in concentration to ambient particles. The interpretation of the particulate carbon emissions is complicated by the fact that an approximately equal amount of particulate carbon (mainly organic carbon) is found on the particle collector and a backup filter. It is likely that measurement artifacts, mostly adsorption of volatile organic compounds on quartz filters, are positively biasing "true" particulate carbon emission results.     

The redox state and activity of superoxide dismutase classes in Arabidopsis thaliana under cadmium or copper stress

The redox state of glutathione and ascorbate as well as the activity of superoxide dismutase classes were determined in leaves of Arabidopsis thaliana grown for seven days in the nutrient solution containing 0, 5 and 50 microM Cd or Cu excess. A decrease in GSH/GSSG ratio was found in plants under Cd and Cu stress. In the plants exposed to Cu stress the activity of all SOD classes increased. However, in the plants treated with Cd the activity of FeSOD and MnSOD was elevated, but CuZnSOD activity was diminished in comparison with control. In these plants the activity of SOD classes was dependent on both the GSH/GSSG and AA/DHA ratios, while in those exposed to Cu excess - on the GSH/GSSG ratio. Differences were shown in the changes both in redox state and activity of SOD classes caused by the metals differing in physiochemical properties. Moreover, relationships between changes in SOD class activities and ROS levels were discussed.     

Quantification of biotransformation of chlorinated hydrocarbons in a biostimulation study: added value via stable carbon isotope analysis

Stable carbon isotope analysis of chlorinated aliphatic compounds was performed at an in situ biostimulation pilot test area (PTA) at a site where 1,2-dichloroethane (1,2-DCA) and trichloroethene (TCE) were present in groundwater. Chlorinated products of TCE reductive dechlorination (cis-dichloroethene (cDCE) and vinyl chloride (VC)) were present at concentrations of 17.5 to 126.4 micromol/L. Ethene, a potential degradation product of both 1,2-DCA dihaloelimination and TCE reductive dechlorination was also present in the PTA. Emulsified soybean oil and lactate were added as electron donors to stimulate anaerobic dechlorination in the PTA. Stable carbon isotope analysis provided evidence that dechlorination was occurring in the PTA during biostimulation, and a means of monitoring changes in dechlorination efficiency over the 183 day monitoring period. Stable carbon isotope analysis was also used to determine if ethene production in the PTA was due to dechlorination of TCE, 1,2-DCA, or both. Fractionation factors (alpha) were determined in the laboratory during anaerobic biotransformation of 1,2-DCA via a dihaloelimination reaction in four separate enrichment cultures. These alpha values (as well as the previously published ranges of alpha for the dechlorination of TCE, cDCE and 1,2-DCA) were used, along with isotopic values measured during the pilot test, to derive quantitative estimates of biotransformation during the pilot test. Dechlorination was found to account for 10.7 to 35.9%, 21.9 to 74.9%, and 54.4 to 67.8% of 1,2-DCA, TCE and cDCE concentration loss respectively in the PTA. Stable carbon isotope analysis indicates that dechlorination of 1,2-DCA, TCE and cDCE were all significant processes during the pilot test, while ethene production during the pilot test was dominated by 1,2-DCA dihaloelimination. This study demonstrates how stable carbon isotope analysis can provide more conservative estimates of the extent of biotransformation than do conventional protocols. In addition, in a complex mixed plume such as this, compound specific isotope analysis is shown to be one of the few methods available for clarifying dominant biotransformation pathways where breakdown products are non-exclusive (i.e. ethene).     

Catalytic destruction of 1,2-dichlorobenzene on V2O5-WO3/Al2O3-TiO2 catalyst

Studies on the catalytic destruction of 1,2-dichlorobenzene were carried out on a specially constructed semi-technical equipment whose most important element was a catalytic reactor with a monolithic catalyst in the form of 150 x 150 x 100 mm cubes. A catalyst made from cordierite with an active layer composed of Al2O3 - 64 wt%, TiO2 - 26 wt%, V2O5 - 6.6 wt% and WO3 - 3.4 wt% was used. The reactor made it possible to carry out the process in the temperature range 150-350 degrees C, at variable catalyst loading and different velocities of gas flow through the reactor. The content of 1,2-dichlorobenzene in the air was analysed by a chromatographic method. A significant effect of catalyst loading and temperature on 1,2-dichlorobenzene destruction efficiency was observed and no effect of the linear flow velocity through the catalyst on o-dichlorobenzene destruction efficiency was reported. The applied vanadium-tungsten catalyst on a monolithic carrier made from TiO2/gamma-Al2O3 revealed very good activity that resulted in an over 80% efficiency of 1,2-dichlorobenzene destruction at the temperature around 250 degrees C at a very high catalyst loading reaching ca. 8200 h(-1). Additionally, in this study the kinetics of 1,2-dichlorobenzene decomposition was determined, specifying the order of reaction and dependence of the decomposition rate constant on temperature, using a simple power-rate law model.     

Likelihood Ratio Analysis of Skin Cancer Prevalence Associated with Arsenic in Drinking Water in the USA

Several published studies have examined skin-cancer prevalence in regions of the USA that have concentrations of arsenic above the USA drinking-water standard. Those studies with adequate exposure and health outcome data did not report any skin cancer cases. Because the USA's arsenic concentrations are relatively low compared to some other countries and the study populations are small, the absence of reported skin-cancer cases could be due to an absence of risk in USA populations or random variability from a predicted risk. We used the current EPA arsenic cancer slope factor (CSF) model, which is derived from Taiwanese populations exposed to high levels of arsenic, to predict the expected number of skin cancers. We then conducted a likelihood ratio analysis, which showed that a null hypothesis (no additional skin cancer risk from arsenic) was approximately 2.2 times more likely than the hypothesis that ingested arsenic causes the predicted rate of skin cancers. Although based on small numbers, our analysis of USA populations indicates that the CSF derived from arsenic exposure in Taiwanese populations may be an overestimate when applied to USA populations.     

PARAMETER UNCERTAINTY IN RAINFALL-RUNOFF MODELING FOR POLDER SYSTEM DESIGN1

ABSTRACT: An approach is developed for incorporating the uncertainty of parameters for estimating runoff in the design of polder systems in ungaged watersheds. Monte Carlo Simulation is used to derive a set of realizations of streamflow hydrographs for a given design rainstorm using the U. S. Soil Conservation Service (SCS) unit hydrograph model. The inverse of the SCS curve number, which is a function of the antecedent runoff condition in the SCS model, is the random input in the Monte Carlo Simulation. Monte Carlo realizations of streamfiow hydrographs are used to simulate the performance of a polder flood protection system. From this simulation the probability of occurrence of flood levels for a particular hydraulic design may be used to evaluate its effectiveness. This approach is demonstrated for the Pluit Polder flood protection system for the City of Jakarta, Indonesia. While the results of the application indicate that uncertainty in the antecedent runoff condition is important, the effects of uncertainty in rainfall data, in additional runoff parameters, such as time to peak, in the hydraulic design, and in the rainfall-runoff model selected should also be considered. Although, the SCS model is limited to agricultural conditions, the approach presented herein may be applied to other flood control systems if appropriate storm runoff models are selected.     

Does trait affect promote job attitude stability?

Trait affect has been studied as a factor which may help explain why job attitudes tend to be rather enduring over time. In this study, test-retest correlations of various job attitudes measured 7 years apart were relatively unaffected by controlling for five measures of affective disposition.     

Seasonal changes in radon concentrations in buildings in the region of northeastern Poland

In this study, seasonal observations of radon concentration changes inside buildings carried out in the northeastern region of Poland is presented. One-year measurements of radon concentrations were performed in chosen buildings. The integral method of Cr-39 trace detectors in diffusive chambers was used. Mean values of radon concentrations were determined in monthly, 2-, 3-, 6-month, and annual observations. The fraction of a mean annual concentration of the value obtained in a shorter observation was calculated. Monthly concentration values were from about 0.2 to 14.9 of the annual mean. All buildings revealed seasonal fluctuation of radon concentration. Negative correlation of indoor radon concentration in the buildings and the mean temperature outside was observed in most examined buildings. The lowest coefficient range, determining which part of the annual mean value would be obtained in the 6-month observation, was gained for exposure begun in April or October.     

Remediation of soils on municipal rendering plant territories using Miscanthus × giganteus

Environmental Science and Pollution Research - Phytoremediation, as a cost-effective, highly efficient, environmentally friendly, and green approach, gained attention to the removal of metals,...