Fenton试剂降解PAM催化剂的研究

采用Fenton试剂氧化降解含油废水中的聚丙烯酰胺,研究了H2O2用量、催化剂种类及用量对降解聚丙烯酰胺效果的影响。结果表明,H2O2用量为聚丙烯酰胺的20%为宜;CuCl2具有和FeSO4、Fe(NO3)3、FeCl3相近的催化效果,并且可以作为一种在较高pH值条件下应用的催化剂;在优选条件下该氧化体系可以使聚丙烯酰胺黏度大大降低。     

上海市青浦区PM10污染状况及其与气象要素的关系

利用2006-2010年上海市青浦区PM10和同期地面气象要素的监测资料,定量分析PM10的季节变化规律以及PM10与降雨量、大气湿度和风速之间的关系。分析结果表明:PM10浓度在夏季处于低值,冬季处于高值;5mm/d以上的降雨对PM10有显著的清除作用,且春夏季降雨的清除作用大于秋冬季节。PM10浓度与大气湿度基本呈负相关关系。风速在一定范围内有利于PM10的扩散但不至造成扬尘,春夏季节的适宜风速是1.5～3.5m/s,冬季的适宜风速是1.5～2.5m/s。     

SO3烟气调质+电除尘在大型燃煤机组上的应用

大型燃煤机组由于耗煤量巨大,在设计时均考虑了多煤种的情况,但电除尘器对不同煤种燃烧后产生的煤灰的收尘性能差异很大。针对多煤种设计工况,以广东平海电厂为例,SO3烟气调质+电除尘器组合技术既能满足燃烧多煤种时的低排放要求,又具备了较低的一次性投资和较低的运行费,是一种最佳的除尘方案,该项目对同类工程除尘方案的选型推广具有积极的示范及借鉴意义。     

基于BP神经网络的儿童卧室内灰尘PAEs浓度预测

在实测数据的基础上,以邻苯二甲酸酯(PAEs)的各类影响因素为自变量,PAEs浓度为因变量,采用Back-propagation(BP)神经网络建立儿童卧室内PAEs浓度预测模型.结果表明,该模型的预测效果较理想,其中,STD比值均＞0.5,NMB均接近0,EMR均＜19％.以室内环境与儿童健康(CCHH)课题组天津地...     

原子吸收法测定土壤中铅的方法

通过湿法消解土壤样品,利用石墨炉原子吸收分光光度法(GAAS)和火焰原子吸收分光光度法(FAAS)测定不同土壤样品中铅的含量,以验证2种方法的有效性并加以对比。实验结果表明:2种方法均满足土壤中铅含量的测定要求,测定的标准土样含量均在标准值的不确定度范围内,GAAS方法测定结果更接近保证值。二者的相对标准偏差(RSD)值均低于1.5%,FAAS方法的精密度更高,且具有快速简单等优势。     

A comparative study of vocational education and occupational safety and health training in China and the UK

In order to enhance Chinese workers’ occupational safety awareness, it is essential to learn from developed countries’ experiences. This article investigates thoroughly occupational safety and health (OSH) in China and the UK; moreover, the article performs a comparison of Chinese and British OSH training-related laws, regulations and education system. The following conclusions are drawn: China’s work safety continues to improve, but there is still a large gap compared with the UK. In China a relatively complete vocational education and training (VET) system has been established. However, there exist some defects in OSH. In the UK, the employer will not only pay attention to employees’ physiological health, but also to their mental health. The UK’s VET is characterized by classification and grading management, which helps integrate OSH into the whole education system. China can learn from the UK in the development of policies, VET and OSH training.     

Evaluation of geometrically personalized THUMS pedestrian model response against sedan–pedestrian PMHS impact test data

Objective: Evaluating the biofidelity of pedestrian finite element models (PFEM) using postmortem human subjects (PMHS) is a challenge because differences in anthropometry between PMHS and PFEM could limit a model's capability to accurately capture cadaveric responses. Geometrical personalization via morphing can modify the PFEM geometry to match the specific PMHS anthropometry, which could alleviate this issue. In this study, the Total Human Model for Safety (THUMS) PFEM (Ver 4.01) was compared to the cadaveric response in vehicle–pedestrian impacts using geometrically personalized models.

Methods: The AM50 THUMS PFEM was used as the baseline model, and 2 morphed PFEM were created to the anthropometric specifications of 2 obese PMHS used in a previous pedestrian impact study with a mid-size sedan. The same measurements as those obtained during the PMHS tests were calculated from the simulations (kinematics, accelerations, strains), and biofidelity metrics based on signals correlation (correlation and analysis, CORA) were established to compare the response of the models to the experiments. Injury outcomes were predicted deterministically (through strain-based threshold) and probabilistically (with injury risk functions) and compared with the injuries reported in the necropsy.

Results: The baseline model could not accurately capture all aspects of the PMHS kinematics, strain, and injury risks, whereas the morphed models reproduced biofidelic response in terms of trajectory (CORA score = 0.927 ± 0.092), velocities (0.975 ± 0.027), accelerations (0.862 ± 0.072), and strains (0.707 ± 0.143). The personalized THUMS models also generally predicted injuries consistent with those identified during posttest autopsy.

Conclusions: The study highlights the need to control for pedestrian anthropometry when validating pedestrian human body models against PMHS data. The information provided in the current study could be useful for improving model biofidelity for vehicle–pedestrian impact scenarios.     

共代谢条件下丁基黄药的生物降解实验研究

微生物共代谢是降解废水中难降解有机物的重要方式。通过实验研究,比较了以丁基黄药作为唯一碳源和能源以及有共代谢基质存在下丁基黄药的降解过程。结果表明,共代谢显著提高了丁基黄药的降解率。在25℃条件下,以丁基黄药为唯一碳源和能源时,其降解率仅为43.1%;而利用葡萄糖作为共代谢基质,当葡萄糖质量浓度为0.20g/L时,振荡培养72h后丁基黄药的降解率可达65.2%;再加入微量的蛋白胨作为氮源后,丁基黄药的降解率可提高到73.5%;加入共代谢基质后微生物的适应期由原来的36h缩短至24h。共代谢是提高丁基黄药生物降解性能的一条有效途径。     

维生素和酮苷生产废水中难降解污染物的溯源研究

研究了维生素和酮苷生产过程中各生产工段排水的生物降解特性,评价了各生产工段对生产废水中难降解有机物的贡献率,追溯了可能的难降解特征污染物。结果表明,维生素生产废水中的难降解物质主要来自W1-1、W1-3、W1-5和W1-6生产工段,甲醛、丁烯酮、醛酮聚合物和吡啶可能是导致生产废水难降解的重要原因;酮苷生产废水中的难降解物质主要来自W2-1、W2-3和W2-7生产工段,氯代有机溶剂和苯环类物质可能是导致生产废水难降解的重要原因。建议根据具体生产工段排水的水质特征,有针对性地进行物化处理,提高废水可生化性。