厌氧-好氧生物反应器填埋工艺特性研究

基于生物反应器填埋技术,研究1种填埋场地循环操作的厌氧-好氧生物反应器填埋工艺,设计了该工艺模拟装置并研究了其运行工艺特性.厌氧阶段主要通过渗滤液回灌控制反应器工艺条件,主要试验结果为,pH值,R1在 6周后可上升至6.7～7.8,R2在17周内一直低于6.8;渗滤液COD浓度,R1在13周时下降至10?617 mg/L,R2在5周后上升至60?000 mg/L后长期趋于稳定;填埋气累计产量,R1在8周达到44%,R2几乎不产气.衡量稳定化可以分别采用渗滤液pH、COD浓度及BOD₅/COD的减少率、填埋气的累计产率等指标来判断,并据此转换为好氧填埋运行.好氧阶段主要是通过强制通风来减少恶臭和水分,主要试验结果为,通风19d氨气浓度降为1.16 mg/m³,通风23d后恶臭浓度降为19;通风14d后含水率降为26%.完成此阶段的工艺指标值可依据矿化垃圾开采的最终用途确定.对主要试验数据进行了数值模拟.厌氧-好氧填埋过程的微生物演替经RISA分析,有4个优势菌群,一些兼性菌群在厌氧-好氧阶段起着重要的承前启后作用.     

硫酸铵气溶胶对甲苯-NOx-空气体系光化学反应的影响

利用大气模拟烟雾箱,研究了硫酸铵气溶胶对甲苯-NOx-空气体系光化学反应的影响.结果表明,硫酸铵作为气溶胶种子,其存在可以加快反应过程中颗粒物(particle matter,PM)的生成速度,并提高甲苯的气溶胶产率.在高浓度的硫酸铵气溶胶种子条件下,其初始浓度对反应过程中NOx、NO和O3的浓度变化没有明显的影响,但对二次有机气溶胶(secondary organic aemsol,SOA)的生成有显著影响.在硫酸铵气溶胶种子浓度小于160 μg·m-3时,SOA的产率随初始气溶胶种子浓度的增大而增大,从最小7.2%到最大11.7%,其增幅超过60%.     

非点源污染河流的水环境容量估算和分配

通过河流相应集水区内氮磷的各污染源分析(包括农地、畜禽养殖和生活排污等),利用输出系数模型估算各非点源的氮磷投(排)放量和入河量;采用河段氮磷输入-输出平衡关系分析方法,估算河流对氮磷的每月自净量.以此为基础,参照水功能区划所要求的水质目标,提出了水质未超标河段相应集水区的氮磷剩余水环境容量按月估算模型,和水质超标河段相应集水区内氮磷投放削减量的按月估算模型,及其在各污染源之间的分配方案.结果表明,长乐江的总氮和总磷自净量分别达到775.9 t·a^-1和30.9 t·a^-1,自净率分别为28.8%和51.2%.河流对氮磷的自净量不仅受水文生态条件的影响而表现出较大的季节性变化,而且随着污染负荷量本身的增加而提高.按照水功能区划中Ⅲ类水的水质要求,长乐江总氮含量全年超标;各非点源的总氮投(排)放量均须不同程度的削减,削减总量应达到1 581.0　t;氮源削减量分配结果表明,化肥是应削减的最大氮源,要求在河流相应集水区内的化肥氮投放削减量为1 047.4 t·a^-1;而与各种氮源的投排放现状相比,要求削减比例最高的是畜禽养殖的氮排放量,达32.4%.长乐江流域尚有一定的总磷剩余水环境容量(2 335.7 t·a^-1).根据目标水质要求,平水期是各污染源总氮投放需要削减的量最大的时期,丰水期则是总磷剩余水环境容量最小的时期.     

上海市PM2.5的物理化学特征及其生物活性研究

采集了上海市区和郊区春季和夏季的大气PM2.5样品,分析了市区和郊区春夏2季PM2.5质量浓度变化的规律,使用PIXE(Proton Induced X-ray Emission)分析技术获得S、K、Ca、Ti、Cr、Mn、Fe、Ni、Cu、Zn、As、Se、Br、Sr、Pb等15种元素的质量浓度.结果表明,上海PM2.5中化学元素的质量浓度在春季(5038.6ng·m-3)比在夏季(3810.6ng·m-3)高,春季郊区(2528.9ng·m-3)和市区(2509.7ng·m-3)PM2.5中化学元素的质量浓度相当,夏季市区样品(1674.2ng·m-3)中化学元素质量浓度的总量比郊区(2136.3 ng·m-3)的低,但来自人为污染的化学元素(Cr、Mn、Ti、Ni、Cu、Zn、As、Br、Sr、Pb)在市区PM2.5中的含量较高;场发射扫描电镜(FESEM)分析显示,上海PM2.5主要由烟尘集合体、燃煤飞灰、矿物颗粒、生物质颗粒和不明物质组成,质粒DNA评价揭示上海市区PM2.5比郊区的具有更强的生物活性,主要原因可能在于市区样品中含有较高的重金属元素和较多的烟尘集合体.     

Long-term study of environmental levels of dioxins and furans in the vicinity of a municipal solid waste incinerator

From 1975 to 2004, a municipal solid waste incinerator (MSWI) was operating in Montcada (Barcelona, Catalonia, Spain). Because of the potential health risks derived from emission of pollutants by the facility, especially polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs), a long-term monitoring program focused on measuring the environmental levels of PCDD/Fs near the facility, and to assess the health risks for the population living in the neighborhood, was established between 1996 and 2002. A total number of 111 soil and 121 herbage samples were analyzed for PCDD/Fs during this period. Human health risks for the individuals living near the MSWI (500 and 1,000 m) were also assessed before (1998) and after modernization (2000) of the facility. It included PCDD/F inhalation, dermal contact, soil and dust ingestion, and food intake. All these data are here summarized. The environmental levels of PCDD/Fs showed that the MSWI was not the main responsible of the atmospheric pollution by these compounds. In turn, human health risks for the population living in the vicinity of the facility after introduction of a modern technology were negligible in comparison with the dietary PCDD/F exposure.     

Retention of estrogenic steroid hormones by selected New Zealand soils

We performed batch sorption experiments for 17beta-estradiol (E2) and 17alpha-ethynylestradiol (EE2) on selected soils collected from dairy farming regions of New Zealand. Isotherms were constructed by measuring the liquid phase concentration and extracting the solid phase with dichloromethane, followed by an exchange step, and analysis by HPLC and UV detection. The corresponding metabolite estrone, (E1) formed during equilibration of E2 with soil was taken into account to estimate the total percentage recoveries for the compounds, which ranged from 47-105% (E2 and E1) and 83-102% (EE2). Measured isotherms were linear, although some deviation from linearity was observed in a few soils, which was attributed to the finer textured particles and/or the allophanic nature of the soils having high surface area. There was a marked difference in K(d)(eff) (effective distribution coefficient) values for E2 and EE2 among the soils, consistent with the soils organic carbon content and ranged from 14-170 L kg(-1) (E2), and 12-40 L kg(-1) (EE2) in the soils common for both compounds. The sorption affinity of hormones in the soils followed an order: EE2相似文献   

Footprints for Sustainability: The Next Steps

The concept of an ecological footprint is based on the understanding that every individual human appropriates a share of the productive and assimilative capacity of the biosphere. An ecological footprint corresponds to this exclusive biologically productive area that a defined population uses for all its resource requirements and wastes, and is expressed in terms of bioproductive space, with world-average productivity. Humanity's footprint or its aggregate ecological demand can only temporarily exceed the productive and assimilative capacity of the biosphere without liquidating and weakening the natural capital on which humanity depends fundamentally. Therefore, accounting tools for quantifying humanity's use of nature are essential for overall assessments of human impact as well as for planning specific steps towards a sustainable future.This paper discusses the strengths and weaknesses of the ecological footprint as an ecological accounting method, points out research needs for improvement of the analysis, and suggests potential new applications. The paper identifies ten new applications of the tool to make it applicable at various geographic scales and for a number of analytical and didactic purposes. Then nine methodological improvements are suggested that could refine the currently applied method, making assessments more sensitive to a larger number of ecological impacts. It concludes that many crucial questions pertinent to building a sustainable society can be addressed by current ecological footprint research. By making the method more complete, this tool could evolve from being largely of pedagogical use to become a strategic tool for policy analysis.     

Thallium: a review of public health and environmental concerns

Thallium (Tl) is a rare but widely dispersed element. All forms of thallium are soluble enough to be toxic to living organisms. Thallium is more toxic to humans than mercury, cadmium, lead, copper or zinc and has been responsible for many accidental, occupational, deliberate, and therapeutic poisonings since its discovery in 1861. Its chemical behavior resembles the heavy metals (lead, gold and silver) on the one hand and the alkali metals (K, Rb, Cs) on the other. It occurs almost exclusively in natural waters as monovalent thallous cation. The solubility of thallous compounds is relatively high so that monovalent thallium is readily transported through aqueous routes into the environment. Tl can be transferred from soils to crops readily and accrues in food crops. The fascinating chemistry and high toxicity potential make thallium and its compounds of particular scientific interest and environmental concern. Thallium was detected in base-metal mining effluents. The conventional removal of heavy metals from wastewater has little effect on thallium. In this review, various treatment options and removal technologies are enumerated in order to protect the environment from thallium toxicity.