Separating the effects of organic matter-mineral interactions and organic matter chemistry on the sorption of diuron and phenanthrene

Even though it is well established that soil C content is the primary determinant of the sorption affinity of soils for non-ionic compounds, it is also clear that organic carbon-normalized sorption coefficients (K(OC)) vary considerably between soils. Two factors that may contribute to K(OC) variability are variations in organic matter chemistry between soils and interactions between organic matter and soil minerals. Here, we quantify these effects for two non-ionic sorbates-diuron and phenanthrene. The effect of organic matter-mineral interactions were evaluated by comparing K(OC) for demineralized (HF-treated) soils, with K(OC) for the corresponding whole soils. For diuron and phenanthrene, average ratios of K(OC) of the HF-treated soils to K(OC) of the whole soils were 2.5 and 2.3, respectively, indicating a substantial depression of K(OC) due to the presence of minerals in the whole soils. The effect of organic matter chemistry was determined by correlating K(OC) against distributions of C types determined using solid-state (13)C NMR spectroscopy. For diuron, K(OC) was positively correlated with aryl C and negatively correlated with O-alkyl C, for both whole and HF-treated soils, whereas for phenanthrene, these correlations were only present for the HF-treated soils. We suggest that the lack of a clear effect of organic matter chemistry on whole soil K(OC) for phenanthrene is due to an over-riding influence of organic matter-mineral interactions in this case. This hypothesis is supported by a correlation between the increase in K(OC) on HF-treatment and the soil clay content for phenanthrene, but not for diuron.     

Semipermeable membrane device (SPMD) for monitoring PCDD and PCDF levels from a paper mill effluent in the Androscoggin River, Maine, USA

Paper mill effluents may contain polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) that are normally generated due to chlorinated bleaching of pulp and paper. We used the semipermeable membrane device (SPMD) to monitor PCDD/F levels upstream and downstream of a paper mill on the Androscoggin River, in Jay (ME). Following the 36 day deployment, SPMD dialysis and cleanup, the samples were analyzed by HRGC/HRMS. Total concentrations of PCDD/Fs in SPMDs (sum of all tetra-through octachlorinated congeners) ranged from 4.71 pg g(-1) to 26.26 pg g(-1). Five out of the targeted 17 toxic congeners were detected, including: 2,3,7,8-TCDF; 1,2,3,7,8-PeCDF; 2,3,4,7,8-PeCDF; 1,2,3,4,6,7,8-HpCDD and OCDD. Permeability reference compounds (PRCs) were used for in situ calibration of the SPMD sampling rate (Rs). In all sites, water concentrations were the highest for OCDD (0.081-0.103 pg l(-1)), and the lowest for 1,2,3,7,8-PeCDF (0.005-0.009 pg l(-1)). There was not a consistent pattern of upstream-downstream gradient in the PCDD/F levels. This suggested that processes other than the mill in Jay (multiple sources, river dynamics) governed the flux of PCDD/Fs in the sampling locations. The SPMD results were validated by comparison to other studies on the Androscoggin River and elsewhere, confirming the potential of the device as a useful monitoring technique for PCDD/Fs in large river systems.     

Photocatalytic and combined anaerobic-photocatalytic treatment of textile dyes

A photocatalytic process based on immobilized titanium dioxide was used to treat crude solutions of azo, anthraquinone and phthalocyanine textile dyes. In addition, the process was applied to the treat autoxidized chemically reduced azo dyes, i.e. representatives of recalcitrant dye residues after biological sequential anaerobic-aerobic treatment. Photocatalysis was able to remove more than 90% color from crude as well as autoxidized chemically reduced dye solutions. UV-absorbance and COD were also removed but to a lower extent (50% in average). The end products of photocatalytic treatment were not toxic toward methanogenic bacteria. The results demonstrate that photocatalysis can be used as a pre- or post-treatment method to biological anaerobic treatment of dye-containing textile wastewater.     

Biochemical effects of clomazone herbicide on piava (Leporinus obtusidens)

This study aims to verify the effects of the clomazone concentration used in rice fields on acetylcholinesterase (AChE), thiobarbituric acid reactive substances (TBARS), protein carbonyl and catalase activity in tissues of piava (Leporinus obtusidens). LC(50)-96h was 5.0 mg L(-1) and the fish were exposed to 1/10 of LC(50)-96 h: 0.5 mg L(-1) of clomazone for 96 and 192h. The same parameters were also assayed after a recovery period of 192 h in clean water. AChE activity was reduced only in the brain and heart of fish exposed for 96 h. AChE activity was decreased in the brain, muscle and heart tissues after 192 h of exposure. After 192 h of recovery period, AChE activity remained diminished in brain and muscle and showed a decrease in eye. However, after 192 h of recovery, AChE activity in heart was recovered. Fish showed increased TBARS levels in brain at all experimental periods. TBARS levels decreased in liver and muscle tissues after 192 h of exposure. The increase in muscle TBARS persisted in fish transferred to clean water. Protein carbonyl in the liver was increased in all periods studied including the recovery period. Catalase activity was reduced during all periods. The present study demonstrates the occurrence of disorders in AChE, TBARS, protein carbonyl and catalase activity in piava. The results also show changes in fish after exposure to an environmentally relevant concentration of clomazone. Most effects observed persisted after the recovery period. Thus, these parameters may be used to monitor clomazone toxicity in fish.     

Mechanical Property Characterization of Plasticized Sugar Beet Pulp and Poly(Lactic Acid) Green Composites Using Acoustic Emission and Confocal Microscopy

Sorbitol and glycerol were used to plasticize sugar beet pulp-poly(lactic acid) green composites. The plasticizer was incorporated into sugar beet pulp (SBP) at 0%, 10%, 20%, 30% and 40% w/w at low temperature and shear and then compounded with poly(lactic acid) (PLA) using twin-screw extrusion and injection molding. The SBP:PLA ratio was maintained at 30:70. As expected, tensile strength decreased by 25% and the elongation increased. Acoustic emission (AE) showed correlated debonding and fracture mechanisms for up to 20% w/w plasticizer and uncorrelated debonding and fracture for 30–40% sorbitol and 30% glycerol content in SBP–PLA composites. All samples had a well dispersed SBP phase with some aggregation in the PLA matrix. However, at 40% glycerol plasticized SBP–PLA composites exhibited unique AE behavior and confocal microscopy revealed the plasticized SBP and PLA formed a co-continuous two phase system.

Assessment of sediment contamination in Casco Bay, Maine, USA

The current status of contaminant concentrations in Casco Bay, decadal trends of these contaminants and changes in their geographical distribution are assessed using sediment samples collected approximately 10 years apart. In general, regulated contaminants appeared to be decreasing in concentration. Total PAH and dioxins/furans concentrations did not significantly change over this period. Total organochlorine pesticides, 4,4-DDE, 4,4-DDD, total DDT, PCB, tributyltin and total butyltin decreased in concentration. Trace element concentrations in sediments decreased at the majority of the sampling sites for chromium, nickel, and selenium while arsenic, cadmium, copper, lead, mercury, silver, and zinc remained relatively constant. None of the contaminants measured has increased by more than a factor of 2. Selected sites located in the Inner Bay, where concentrations are higher and new inputs were more likely, showed increased concentrations of contaminants. Most contaminants were not found at concentrations expected to adversely affect sediment biota based on ERL/ERM guidelines.     

Use of principal component analysis to profile temporal and spatial variations of chlorinated solvent concentration in groundwater

This work aims at evaluating spatial distribution patterns of concentration variations for chlorinated solvents in groundwater, based on principal component analysis and geographic information system (GIS) tools. The study investigates long-time series of chlorinated solvent concentrations in groundwater measured for 18 contaminated industrial sites. The characterization of contaminant plumes and delineation of pollutant sources are essential for choosing appropriate monitoring and remediation strategies, as contaminated groundwaters are characterized by complex patterns of spatial and temporal concentration variability, with wide unpredictable fluctuations over time. The present work describes the results of a new exploratory statistical method called the Variability Index Method (VIM) applied to environmental data to assess the performance of using concentration variations as molecular tracers to reveal aquifer dynamics, industrial impacts, and point sources for contamination plumes. The application of this method provides a useful assessment of controls over contaminant concentration variations as well as support for remediation techniques.     

Particle fluxes above forests: observations, methodological considerations and method comparisons

This paper reports a study designed to test, evaluate and compare micro-meteorological methods for determining the particle number flux above forest canopies. Half-hour average particle number fluxes above a representative broad-leaved forest in Denmark derived using eddy covariance range from -7x10(7) m(-2) s(-1) (1st percentile) to 5x10(7) m(-2) s(-1) (99th percentile), and have a median value of -1.6x10(6) m(-2) s(-1). The statistical uncertainties associated with the particle number flux estimates are larger than those for momentum fluxes and imply that in this data set approximately half of the particle number fluxes are not statistically different to zero. Particle number fluxes from relaxed eddy accumulation (REA) and eddy covariance are highly correlated and of almost identical magnitude. Flux estimates from the co-spectral and dissipation methods are also correlated with those from eddy covariance but exhibit higher absolute magnitude of fluxes.     

Substance Flow Analyses of Organic Pollutants in Stockholm

This paper summarizes substance flow analyses for four organic substances in the City of Stockholm, Sweden: diethylhexyl phthalate (DEHP), alkylphenolethoxylates (APEO), polybrominated diphenylethers (PBDE) and chlorinated paraffins (CP). The results indicate that the stocks of APEO, PBDE and CP all are approximately 200–250 tonnes, whereas the DEHP stock is two orders of magnitude larger. Emissions can be linked to imported consumer goods such as electronics (PBDE) and textiles (APEO), and to construction materials (DEHP, CP). For several of the substances considerable amounts remain in the technosphere for a long time, even after use of the substance in new products has been eliminated. For example, the use of DEHP as plasticizer for PVC plastics in cables and floorings has more or less been phased-out, but still these applications make up a stock of some 20,000 tonnes (85% of the total DEHP stock in Stockholm) and emit 28 tonnes of DEHP annually (93% of overall emissions). Likewise, the use of chlorinated paraffins in sealants has been radically reduced, but there are 170 tonnes of CP in sealants in Stockholm making up 75% of the stock, and causing half of the emissions to water and air. These emissions are likely to continue for decades, and the stocks therefore have to be considered when analysing and managing the impact of urban substance flows on the environment.