Estimation of land surface temperature using different retrieval methods for studying the spatiotemporal variations of surface urban heat and cold islands in Indian Punjab

Spatial patterns of land surface temperature (LST), surface urban heat island (SUHI), surface urban cold island (SUCI), and their seasonal variations during January (winter) and September (summer) were analyzed over the three cities of Indian Punjab (Balachaur, Ludhiana and Bathinda) using Landsat 5, 7 and 8 satellite data of the years 1991, 2001, 2011, and 2018. Urban hot spots and Urban Thermal Field Variance Index (UTFVI) were used to measure the ecological environment of these cities. Land surface temperature was retrieved from Landsat satellite data using Plank equation, mono-window algorithm (MWA), single-channel algorithm (SCA), and radiative transfer equation. The LST derived using these algorithms was validated with MODIS-LST product. The relationship between LST derived from Landsat 5, 7 and 8 using the four methods and MODIS-LST product was higher with the SCA algorithm (R²?>?0.75). Land surface temperature was significantly positively correlated with built-up but significantly negatively correlated with vegetation. The surface urban heat intensity was higher during September than January, and it was higher in Ludhiana followed by Bathinda and Balachaur, irrespective of the season. Besides built-up area and population density, soil moisture availability in surrounding rural areas has significant impact on increasing surface urban heat intensity during September than January. The SUCIs were formed in the center of Bathinda city during January 1991, but these were in Ludhiana and Balachaur cities during January 2011. The most critical areas for ecological environment based on UTFVI were identified and the critical UTFVI values (>?0.020) were highest in Bathinda city followed by Balachaur and Ludhiana cities. These results suggest that SUHIs and SUCIs are influenced by seasons and the mitigating plans to counteract the overheating of urban areas should be formulated taking into account soil moisture availability in surrounding rural areas, landscape pattern, seasonal variations, local climatic conditions, urban growth, and development plan etc.

     

Effect of compression ratio,nozzle opening pressure,engine load,and butanol addition on nanoparticle emissions from a non-road diesel engine

Currently, diesel engines are more preferred over gasoline engines due to their higher torque output and fuel economy. However, diesel engines confront major challenge of meeting the future stringent emission norms (especially soot particle emissions) while maintaining the same fuel economy. In this study, nanosize range soot particle emission characteristics of a stationary (non-road) diesel engine have been experimentally investigated. Experiments are conducted at a constant speed of 1500 rpm for three compression ratios and nozzle opening pressures at different engine loads. In-cylinder pressure history for 2000 consecutive engine cycles is recorded and averaged data is used for analysis of combustion characteristics. An electrical mobility-based fast particle sizer is used for analyzing particle size and mass distributions of engine exhaust particles at different test conditions. Soot particle distribution from 5 to 1000 nm was recorded. Results show that total particle concentration decreases with an increase in engine operating loads. Moreover, the addition of butanol in the diesel fuel leads to the reduction in soot particle concentration. Regression analysis was also conducted to derive a correlation between combustion parameters and particle number emissions for different compression ratios. Regression analysis shows a strong correlation between cylinder pressure-based combustion parameters and particle number emission.

     

Selection of suitable lichen bioindicator species for monitoring climatic variability in the Himalaya

Interspecific comparison in metals and PAHs profile in three lichen species, Flavoparmelia caperata, Phaeophyscia hispidula and Pyxine sorediata, were studied in different altitudinal gradients of the Western Himalayas. The species collected from 14 sites, enroute from Dehradun to Morinda (243 Km) including the trekking route 42 Km from Taluka to Morinda having an altitudinal gradient between 850–3,750 m, were analysed for their metals and PAHs. The species showed similar metal as well as PAHs profile under similar altitudinal gradients in the sequence of F. caperata > P. hispidula > P. sorediata. The difference in pollutant concentrations within each lichen species may be related to intrinsic attributes of the species, such as thallus morphology and the presence of lichen substances which are responsible for the sensitivity and accumulation potential of a particular species. Novelty of the present study lies on the fact that all the species show a similar efficiency of reflecting the environmental condition of the area, albeit the coefficient values of individual species for individual pollutant obtained by three-factor ANOVA revealed that the bioaccumulation affinity of F. caperata is significantly higher than P. hispidula and P. sorediata. For individual metals, F. caperata has a higher affinity for Al, Cr, Fe, Pb and Zn while P. hispidula has a significant positive affinity for Fe and Pb. PCA analysis of sites with respect to pollutant revealed the segregation of sites based on source and distance. Combining the bioaccumulation potential parameters along with geostatistical (GIS) techniques establishes that F. caperata species is a better accumulator of metals and PAHs in comparison to P. hispidula and P. sorediata in the temperate regions of the Himalaya.     

First assessment of the PM<Subscript>10</Subscript> and PM<Subscript>2.5</Subscript> particulate level in the ambient air of belgrade city

INTENTION, GOAL, SCOPE, BACKGROUND: As the strong negative health effect of exposure to the inhalable particulate matter PM10 in the urban environment has been confirmed, the study of the mass concentrations, physico-chemical characteristics, sources, as well as spatial and temporal variation of atmospheric aerosol particles becomes very important. OBJECTIVE: This work is a pilot study to assess the concentration level of ambient suspended particulate matter, with an aerodynamic diameter of less than 10 microm, in the Belgrade central urban area. Average daily concentrations of PM10 and PM2.5 have been measured at three representative points in the city between June 2002 and December 2002. The influence of meteorological parameters on PM10 and PM2.5 concentrations was analyzed, and possible pollution sources were identified. METHODS: Suspended particles were collected on Pure Teflon filters by using a Mini-Vol low-volume air sampler (Airmetrics Co., Inc.; 5 l min(-1) flow rate). Particle mass was determined gravimetrically after 48 h of conditioning in a desiccator, in a Class 100 clean room at the temperature T = 20 degrees C and at about 50% constant relative humidity (RH). RESULTS AND DISCUSSION: Analysis of the PM10 data indicated a marked difference between season without heating--(summer; mean value 56 microg m(-3)) and heating season--(winter; mean value 96 microg m3); 62% of samples exceeded the level of 50 microg m(-3). The impact of meteorological factors on PM concentrations was not immediately apparent, but there was a significant negative correlation with the wind speed. CONCLUSIONS: The PM10 and PM2.5 mass concentrations in the Belgrade urban area had high average values (77 microg m(-3) and 61 microg m(-3)) in comparison with other European cities. The main sources of particulate matter were traffic emission, road dust resuspension, and individual heating emissions. When the air masses are coming from the SW direction, the contribution from the Obrenovac power plants is evident. During days of exceptionally severe pollution, in both summer and winter periods, high production of secondary aerosols occurred, as can be seen from an increase in PM2.5 in respect to PM10 mass concentration. RECOMMENDATION AND OUTLOOK: The results obtained gave us the first impression of the concentration level of particulate matter, with an aerodynamic diameter of less than 10 microm, in the Belgrade ambient air. Due to measured high PM mass concentrations, it is obvious that it would be very difficult to meet the EU standards (EEC 1999) by 2010. It is necessary to continue with PM10 and PM2.5 sampling; and after comprehensive analysis which includes the results of chemical and physical characterization of particles, we will be able to recommend effective control measures in order to improve air quality in Belgrade.     

Performance analysis and optimization of solar-powered E-rickshaw for environmental sustainability in rural transportation

Environmental Science and Pollution Research - The last mile connectivity through public transport is a challenging task in India. However, according to the Society of Indian Automotive...     

Recycling/reuse of plastic waste as construction material for sustainable development: a review

Environmental Science and Pollution Research - The exponential rise in the production of plastic and the consequential surge in plastic waste have led the scientists and researchers look out for...     

Effect of metallic pollutants on the physiology of lichen, Pyxine subcinerea Stirton in Garhwal Himalayas

Chl. a, Chl. b, total Chl., Carotenoid, Protein and OD 435/OD 415 ratio were measured to estimate the possible damage caused by the metallic pollutants in the lichen, Pyxine subcinerea Stirton collected from four different sites of Srinagar Garhwal, Uttaranchal, India. Multiple correlation analysis revealed significant correlation (P < 0.001) among the Fe, Ni, Cu, Cr, Zn and Pb metals analysed. Cd did not correlate with any other metals except Fe (P < 0.05). Cu, Pb and Zn, are the main constituents of the vehicular emissions had significant positive correlation (P < 0.001) with protein content while, the OD 435/OD 415 ratio values decreased statistically (P < 0.001) with increase in amount of Cu, Pb and Zn.     

Fungicidal elements accumulated in Cryptothecia punctulata (Ascomycetes lichen) of an arecanut orchard in South India

Different nutrient elements were analyzed in the lichen Cryptothecia punctulata collected from the arecanut trees which were exposed to several sprays of a fungicide Bordeaux mixture. The study revealed the accumulation of fungicidal elements such as Cu, Ca and S in higher concentration of 575.4, 10,000 and 21,000 microg g(-1), respectively.     

Electrocatalytic reduction of ortho nitrobenzaldehyde using modified aluminum electrode and its determination

A simple, cost effective and rapid electrochemical method has been developed for the determination of micro level ortho nitrobenzaldehyde（ONB） based on outstanding properties of modified aluminum electrode tin nanorods/anodic aluminum oxide/aluminum（SnNR/AAO/Al） for the first time. The SnNR/AAO/Al electrode was fabricated by a second step anodization, followed by electrodeposition and its electrochemical behavior was investigated in detail. The cyclic voltammetry results indicated that the SnNR/AAO/Al electrode exhibited efficient electrocatalytic activity toward reduction of ONB in the acidic solution. It provides an appreciable improvement of reduction peak for ONB at-0.721 V.Furthermore, various kinetic parameters such as transfer electron number, transfer proton number and standard heterogeneous rate constant were calculated from the scan rates.The electrocatalytic behavior was further exploited as a sensitive detection scheme for the ONB determination by differential pulse voltammetry. Under the optimized conditions, the concentration range and detection limit are 0.1-100 μmol/L and 0.05 μmol/L, respectively,for ONB. The analytical performance of this modified sensor has been evaluated for detection of real sample such as river water and recovery of ONB was achieved all-out up to102.3% under standard addition method.