Orientation ofRhizophagus grandis (Coleoptera: Rhizophagidae) to oxygenated monoterpenes in a species-specific predator-prey relationship

Summary The predator,Rhizophagus grandis, is linked to its specific prey,Dendroctonus micans, by semiochemical signals regulating oviposition and long range orientation. A mixture of simple oxygenated monoterpenes [(–)—fenchone, (–)—pinocamphone, rac. camphor, terpinene-4-ol, borneol, fenchol and verbenone], identified from the frass ofD. micans has been found to be extremely active in a flight windtunnel as a long—range attractant for the predator. The mixture elicited 84 % of the response to larval frass of the prey. Excluding pinocamphone from the mixture did not influence its activity. Also, changing the absolute configurations of some of the components (fenchol, terpinene-4-ol and borneol) did not influence the predators' response. However, the addition of (–)—-terpineol increased the attractivity of the synthetic blend to almost that of larval frass of the prey. Ecological implications of the identified semiochemicals and their use in pest management are discussed.     

Impact of atrazine-bearing agricultural tile drainage discharge on planktonic drift of a natural stream

Preliminary results are reported from a co-operative study between Agriculture Canada and Environment Canada on environmental impacts of atrazine measured in a field stream receiving agricultural drainage. Systematically, tile drained plots of known crop rotation, area, flow and pesticides use were used in the study. A maximum tile drainage concentration of 13.9 microg liter(-1) atrazine was measured while the maximum measured stream concentration was 1.89 microg liter(-1). Phytoplankton and zooplankton samples were collected on a bi-monthly basis during the growing season. The study indicated possible negative impacts of low concentrations of atrazine on planktonic drift populations, when natural stream flow was reduced, resulting in a lower dilution capacity. A 20 m section of the stream was affected by the tile drainage waters as measured by the resident biological community. Both atrazine and ambient environmental conditions were felt to be contributing to the measured results. No negative impacts on planktonic drift populations were evident beyond 50 m downstream of the tile drainage and stream confluence.     

Identifying the land use and land cover change drivers: methods and case studies of two forest reserves in Northern Benin

Environment, Development and Sustainability - Land use and land cover change (LULCC) is one of the problems that the world has been facing for the last few decades despite political attention....     

Utilization of a fumigated sediment by two benthic deposit-feeders:Abra alba (Mollusca: Bivalvia) andEupolymnia nebulosa (Annelida: Polychaeta)

The present study tested the utilization of dead microbial biomass by two benthic deposit-feeders:Abra alba (Wood) (Mollusca: Bivalvia) andEupolymnia nebulosa (Montagu) (Annelida: Polychaeta). Clams were collected in the Canet lagoon during spring 1989. Worms were collected in the Port-Vendres harbour during spring 1989. The¹⁴C-labelled (glutamic acid, 24 h) sediment used during the study was sterilized with 1% chloroform, washed with sterile seawater, and dried (60°C; 48 h). This sterilisation procedure, called fumigation is the least harmful to the sediment (Novitsky 1986). Both clams and worms were incubated in the presence of the fumigated sediment for 5, 10, 20, and 50 h. At the end of each experiment we recorded the radioactivity in four compartments: (1) sediment, (2) dissolved organic matter (DOM), (3) CO₂, and (4) animals. The radioactivity of the sediment was subdivided into five fractions: (i) soluble in 2N HCl, (ii) soluble in hot 5% trichloroacetic acid (TCA), (iii) soluble in 1N NaOH, (iv) soluble in hot 6N HCl, (v) residual (after combustion in a Leco carbon analyser). In the first set of experiments, after 20 h of incubation, 5.4 and 4.7% of the total radioactivity was taken up by clams and worms, respectively. However, a model revealed that this uptake could have been correlated with the release of radiolabelled DOM (33% of total radioactivity during the first 5 h). In order to test this assumption, we used the same protocol with three additional washes of the fumigated sediment. This resulted in a significantly lower uptake by the clams (1.9% of the total radioactivity byt = 50 h), whereas the worms exhibited an uptake similar to that in the initial experiment (5.1% of total radioactivity byt = 50 h). These results underline the importance of considering interactions with DOM when applying radiotracer techniques to the study of benthic food chains. The average ingestion rates of fumigated sediment byA. alba andE. nebulosa were 5.2 10^–2 mg sediment dry wt mg^–1 clam h^–1 and 3.5 10^–2 mg sediment dry wt mg^–1 worm h^–1, respectively, which is comparable to previous data reported for other deposit-feeding bivalves and polychaetes feeding on natural sediment or detritus. The low radioactivity recorded for CO₂ together with the similarity of the changes in the partitioning of the radioactivity within the sediment between control experiments and experiments carried out in the presence of clams or worms suggest low assimilation efficiencies. Therefore, the present study supports the fact that dead microbial biomass does not constitute an important food source for benthic deposit-feeders.     

Yield and grain quality of spring wheat (Triticum aestivum L., cv. Drabant) exposed to different concentrations of ozone in open-top chambers

Spring wheat (Triticum aestivum L., cv. Drabant) was exposed to different concentrations of ozone in open-top chambers for two growing seasons, 1987 and 1988, at a site located in south-west Sweden. The chambers were placed in a field of commercially grown spring wheat. The treatments were charcoal-filtered air (CF), non-filtered air (NF) and non-filtered air plus extra ozone (NF(+)). In 1988, one additional ozone concentration (NF(++)) was used. Grain yield was affected by the ozone concentration of the air. Air filtration resulted in an increase in grain yield of about 7% in both years, compared to NF. The addition of ozone (NF(+), NF(++)) reduced grain yield and increased the content of crude protein of the grain in both years. Filtration of the air had no significant effect on the content of crude protein, compared to NF. The results showed a strong positive chamber effect on grain yield in the cold and wet summer of 1987. In 1988, there was no net chamber effect on grain yield. The relative differences between the CF, NF and NF(+) treatments with respect to grain yield were of the same magnitude in the two years, despite the very different weather conditions.     

Reversibility of stemflow-induced soil acidification in Swedish beech forest

Stemwater running down the trunks of beech (Fagus sylvatica L.) has an acidifying effect on soil near the stem. The deposition of acidifying substances may be two to four times higher close to the stem compared to in the stand in general. To study reversibility of soil acidification, 72 stumps of beech trees were chosen from five different year classes of felling (3, 6, 9, 14-15, 25-30), representing the years when stemflow ceased to affect the soil. The H(+) concentration (pH KCl) in the topsoil (0-5 cm) differed between the distances 10-30 cm and 230-250 cm from the stumps, the soil close to the stem being more acid. The longer the time since felling the smaller the differences in H(+) concentration became. This reduction in soil acidity amounted to ca. 50% after 15 years, and only small further changes occurred over the next ten years. This indicates that soil may not recover fully from acidification, or does so at a rather slow rate after the initial 15 years of recovery.     

Antagonism and synergism between lead and zinc in amphibian larvae

Lead and zinc effects on Bufo arenarum larval survival were studied in single and combined treatments. On a weight basis, lead is about twice as toxic as zinc. The antagonism or synergism between these heavy metals is dose-dependent.     

Reduction and avoidance of lubricant mist demands an integrated assessment approach

A case study to identify major factors for lubricant mist exposure covered 15 metal machining sites. The investigation included milling, turning, drilling and grinding applications. Systematic analysis considered all relevant data concerning the machine tool, the lubricant and the suction plant. The efficiency of the implemented maintenance program at the installed filter systems was checked by concentration measurements immediately before and after service. All performed measurements of lubricant aerosol and vapor loads upstream and downstream of the installed filter systems were carried out according to VDI 2066 and BIA 3110, respectively. The selection criteria for the sites to be investigated, the systematic nature of the data acquisition and the procedure of the analysis are demonstrated in detail by performing comparisons between selected applications using emulsions and those employing straight oil for lubrication. The results of the study identify recirculation of ventilated air as the major source of workplace exposure to airborne lubricant emissions. More than 60% of the demisters investigated emit air at total lubricant loads (aerosols and vapor) above the limit of 20 mg m-3 at any time of operation; which also means immediately after service. A common reason for exceeded aerosol loads in recirculated air is e.g. the fact that the type of filter system applied is often not suitable for the separation problem. Loads of lubricant vapor are usually higher at the processes which use water emulsions as lubricant. In a quarter of the cases the limits were exceeded solely due to high vapor loads even immediately after service. The exposure can be reduced by replacing the lubricant, installation of a vapor separation plant or avoiding air recirculation. Maintenance time of the demisting system and aerosol separation efficiency of state-of-the-art demisting systems can be expanded by implementation of enhanced preliminary filter stages. This study confirms that appropriate service measures lower both aerosol emissions and lubricant vapor concentrations due to the reduction of exposed oil-wetted surfaces. The performed measurements show no significant relationship between loads of airborne lubricants and the type of machining process. Therefore, investigations at a much more detailed level have to be performed. However, the individual assessment of any workplace due to the complex situation remains essential.