Simultaneous determination of parathion and p-nitrophenol in vegetable tissues by derivative spectrophotometry

A first derivative spectrophotometric method has been developedfor the determination of parathion and p-nitrophenol in vegetabletissues. Ethanol was used as solvent for extracting the compoundsfrom the tissues and subsequently the samples were evaluated against a vegetable tissue blank, directly by derivative spectrophotometry. The simultaneous determination of these compounds can be carried out using the zero-crossing approach for parathion at 253.0 nm and for p-nitrophenol at 273.1 nm. In the samples each analyte was determined in the presence of one another in the ranges between 4.9 to 3883.5 g g^-1 forparathion and 4.9 to 3285.3 g g^-1 for p-nitrophenol.The detection limits (3) were found to be 1.5 and 1.4 g g^-1 for parathion and p-nitrophenol, respectively. The relative standard deviations were in all instances less than1.8%. The proposed method was applied to the determination ofthe analytes in spiked leafs of corn. The results show a goodrecovery and they are in agreement with those obtained bypolarography.     

Formation and Emission of N2O and CH4 from Compost Heaps of Organic Household Waster

Composting can be a source of N₂O andCH₄ production. In this investigation, differentcompost heaps of organic household waste weremonitored with the focus on potential formation ofCH₄ and N₂O in the heaps and emission ofthese gases from the heaps. The studied compost heapshad different compost ages, turning intervals andcompost sizes. The analysed compost gases containedbetween 1–3421 L of N₂O-N L^-1 and 0–470 mL of CH₄ L^-1. The emission rates ofN₂O and CH₄ from the compost heaps werebetween 1–1464 mg N₂O m^-2 day^-1 and0–119 000 mg CH₄ m^-2 day^-1. These verylarge differences in compost gas composition andemission indicate the importance of compostmanagement. The results also give an understanding ofwhere in the composting process an increasing emissionof N₂O and CH₄ can occur.     

Survey of the occurrence of residues of methyl tertiary butyl ether (MTBE) in Dutch drinking water sources and drinking water

An indicative survey has been carried out in The Netherlands investigating the presence of methyl tertiary butyl ether (MTBE) in drinking water and the corresponding sources. In total, 71 different sites used for the preparation of drinking water in The Netherlands were sampled in two successive seasons in 2001 involving the analysis of 156 samples. (ground water (n = 88), surface water (n = 17), bank filtrate water (n = 6) and drinking water (n = 45)). To combine high sample throughput with high selectivity and sensitivity, off-line purge and trap for sampling and gas chromatography mass spectrometry equipped with an automated thermal desorption sampler (TDS-GC-MS) was selected as the preferred analytical methodology. The developed procedure enabled the analysis of at least 40 samples per day and provided a limit of quantification of 2 ng l(-1). In the first period 63 samples of raw water were analyzed. Concentrations ranged between < 10 ng l(-1) and 420 ng l(-1) with a median concentration below 10 ng l(-1). The second period was focused at the re-sampling of positive locations (MTBE > 10 ng l(-1)) and a few additional drinking water utilities of which both the raw and drinking water of the utilities were analyzed. The median concentration of MTBE in the selected set of drinking water samples was 20 ng l(-1) (n = 45). At one location MTBE was found at a level of 2900 ng l(-1) caused by point source contamination of the ground water (11 900 ng l(-1)). Special attention has been paid to the quality of the results by analyzing all samples in duplicate and the analysis of control samples during each series of analyses.     

Application of PCR and probe hybridization techniques in detection of airborne fungal spores in environmental samples

Specific PCR amplification and probe hybridization techniques were applied to examine the compositions of airborne fungi in samples from three different environments. The results from microscopic and CFU counting were compared to those of the molecular-based detections. The detection sensitivity for PCR amplifications was 9 to 73 spores and 1.3 to 19.3 CFUs per PCR reaction. The hybridization detection limit was 2 to 4 spores and 0.2 to 1.2 CFU. The hybridization method was more sensitive than PCR amplification and showed less variation among samples. Using specific PCR primers and probes we identified the presence of several fungal groups and species in the air samples. Specific detections through probe hybridization to PCR products amplified with universal or group-specific fungal primers have promising applications in the examination of air samples for environmental monitoring.     

SI-traceable certification of Cu, Cr, Cd and Pb in sediment and fly ash candidate reference materials

Many fields in environmental analytical chemistry deal with very low limits and thresholds as set by governmental legislations or transnational regulations. The need for the accuracy, comparability and traceability of analytical measurements in environmental analytical chemistry has significantly increased and total uncertainties are even asked for by accreditation bodies of environmental laboratories. This paper addresses achieving these goals to guarantee accuracy, quality control, quality assurance or validation of a method by means of certified reference materials. The assessment of analytical results in certified reference materials must be as accurate as possible and every single step has to be fully evaluated. This paper presents the SI-traceable certification of Cu, Cr, Cd and Pb contents in geological and environmentally relevant matrices (three sediments and one fly ash sample). Certification was achieved using isotope dilution (ID) ICPMS as a primary method of measurement. In order to reduce significantly the number of analytical steps and intermediate samples a multiple spiking approach was developed. The full methodology is documented and total uncertainty budgets are calculated for all certified values. A non-element specific sample digestion process was optimised. All wet chemical digestion methods examined resulted in a more or less pronounced amount of precipitate. It is demonstrated that these precipitates originate mainly from secondary formation of fluorides (essentially CaF2) and that their formation takes place after isotopic equilibration. The contribution to the total uncertainty of the final values resulting from the formation of such precipitates was in general < 0.1% for all investigated elements. Other sources of uncertainty scrutinised included the moisture content determination, procedural blank determination, cross-contamination from the different spike materials, correction for spectral interferences, instrumental background and deadtime effects, as well as the use of either certified values or IUPAC data in the IDMS equation. The average elemental content in the sediment samples was 30-130 micrograms g-1 for Pb, 0.5-3 micrograms g-1 for Cd and 50-70 micrograms g-1 for Cu. Cr was measured in one sample and was about 60 micrograms g-1. The concentrations in the fly ash sample were up to 2 orders of magnitude higher. Expanded uncertainty for the investigated elements was about 3% (coverae factor k = 2) except for Cr, (measured by high resolution ICPMS), for which the expanded uncertainty was about 7% (k = 2).     

Spatial properties of nutrient concentrations in the Baltic Sea

Using existing monitoring data, the present study attempts to characterize spatial patterns of surface water nutrients in the Baltic Sea. The analysis was made for two different spatial scales, differences between and within sub-basins.Non-parametric methods were chosen to reduce problems with the distributional properties of the data. By dividing the data into four seasons care was taken as to seasonality. To avoid bias due to different laboratory analysis, only data from Nordic countries were used, whose results did not apparently depart from each other. Bias due to different sampling frequency was another problem. This was reduced by using only the last observation in each season for every station and year.The results suggested differences in the nutrient concentrations between basins. The two northernmost basins (Bothnian Bay and Bothnian Sea) had lower phosphate concentrations and higher silicate concentrations compared to the rest of the Sea. Bothnian Bay and the Gulf of Finland had higher nitrate concentrations.The concentration structure within basins was studied using transects in both latitudinal and longitudinal direction. A gradient for phosphate and nitrate was found in the Gulf of Finland, with lower concentrations at the mouth. The Bothnian Sea showed lower concentrations in the middle of the basin compared to the coasts. The highest concentrations of phosphate were found close to the Finnish coast and for silicate the highest concentrations were located near the Swedish coast. It was not possible to study variation in the west-east direction within the Baltic proper, due to data shortage. For the transects in the north-south direction no differences were detected for nitrate and silicate. Phosphate gave one significant result during autumn for the transect in the eastern part of the Baltic proper.This study revealed several problems associated with the data available. Uneven sampling in space and time put severe constraints on the study. A better design of the monitoring program is suggested, where spatial properties are considered explicitly. Revision of the program in this direction is needed for reasonable calculation of total amounts and concentrations representative for a basin.     

Biologie und Biochemie des Elements Selen

The importance of selenium as an essential trace element has progressively emerged during the last years due to the analysis of selenium deficiency diseases and to the identification and characterization of a number of selenoenzymes. Selenium is incorporated in the catalytic site of the enzymes as an integral selenocysteine residue. The pathway of selenocysteine biosynthesis and incorporation has been elucidated recently for Escherichia coli. This article presents an overview on these subjects and describes the mechanisms which confer selenocysteine specificity in the framework of protein biosynthesis. In addition, some considerations concerning the phylogeny of selenocysteine incorporation are presented and a model for the evolution of the selenocysteine pathway is proposed.