Optimizing Liquid Effluent Monitoring at a Large Nuclear Complex

Effluent monitoring typically requires a large number of analytes and samples during the initial or startup phase of a facility. Once a baseline is established, the analyte list and sampling frequency may be reduced. Although there is a large body of literature relevant to the initial design, few, if any, published papers exist on updating established effluent monitoring programs. This paper statistically evaluates four years of baseline data to optimize the liquid effluent monitoring efficiency of a centralized waste treatment and disposal facility at a large defense nuclear complex. Specific objectives were to: (1) assess temporal variability in analyte concentrations, (2) determine operational factors contributing to waste stream variability, (3) assess the probability of exceeding permit limits, and (4) streamline the sampling and analysis regime. Results indicated that the probability of exceeding permit limits was one in a million under normal facility operating conditions, sampling frequency could be reduced, and several analytes could be eliminated. Furthermore, indicators such as gross alpha and gross beta measurements could be used in lieu of more expensive specific isotopic analyses (radium, cesium-137, and strontium-90) for routine monitoring. Study results were used by the state regulatory agency to modify monitoring requirements for a new discharge permit, resulting in an annual cost savings of US $223,000. This case study demonstrates that statistical evaluation of effluent contaminant variability coupled with process knowledge can help plant managers and regulators streamline analyte lists and sampling frequencies based on detection history and environmental risk.     

The water footprint of hydroelectricity: a methodological comparison from a case study in New Zealand

Hydroelectricity has been rated to have a large water footprint (WF) on global average. We assessed the WF of hydroelectricity by three different methods using New Zealand as a case study. The first (WF-1) and second (WF-2) methods only consider the consumptive water use of the hydroelectricity generation system, while our third method (WF-3) accounts for the net water balance. Irrespective of the method, the WF of New Zealand’s hydroelectricity was found much smaller than the commonly cited international value of 22 m³ GJ⁻¹. Depending on the method, the national WF ranged from 1.55 m³ GJ⁻¹ (WF-3) to 6.05 m³ GJ⁻¹ (WF-1). The WF- 3 considers the net water balance including rainfall, which is the key driver for replenishing water resources. It provides meaningful information that helps our understanding of the differences of the WF in locations, which are diverse in terms of water resource availability. We highlight the effects of local climatic differences and the structural specifics of a hydroelectricity scheme on the WF. The large variation in the WF of hydropower across New Zealand illustrates the inappropriateness of using global average values. Local values, calculated using our hydrologically rational method, must be used.     

Previous experience matters in the stalk-eyed fly <Emphasis Type="Italic">Teleopsis dalmanni</Emphasis>

Previous experiences can play a significant role in determining future behaviors. Winner and loser effects, where the outcome of previous aggressive encounters influences the behavioral approach to and outcomes of future conflicts, have been documented in many taxa and illustrate this phenomenon. These effects are prevalent in species that interact frequently because modulation of these potentially costly social interactions may influence fitness. Stalk-eyed flies of the dimorphic species Teleopsis dalmanni engage in frequent fights over food resources, as well as over access to harems of females, with larger males typically prevailing when size disparities exist. However, whether and how prior experience influences fighting decisions and outcomes remains unexplored. To test for winner and loser effects in stalk-eyed flies, sexually mature flies were paired in size-mismatched dyads to establish winning and losing experiences. After their first contest, the flies were paired with size-matched individuals and allowed to interact. We determined whether an initial winning or losing experience significantly altered the outcome probabilities in the second size-matched encounter. Initial winning experience did not significantly affect the second interaction, providing no evidence for a winner effect. However, initial losers were significantly more likely to lose a subsequent interaction which provides evidence for a loser effect in stalk-eyed flies. In addition, smaller males experienced an increased probability of losing their second interaction regardless of prior winning or losing experience. This effect was not seen in large males. Our data suggest that the loser effects we observed, which were more pronounced in small males, could result from the energetic costs of fighting that they were less able to absorb than large males.     

Assessing the organic composition of urban surface films using nuclear magnetic resonance spectroscopy

Recently it has been shown that urban surfaces are covered with a thin film which mediates the fate, distribution and accumulation of semi-volatile organic compounds in the environment. In this study we apply a combination of solution, semi-solids, and solid state nuclear magnetic resonance (NMR) methods to provide a general overview of the organic constituents. In surface film collected from 30 m2 of outside windows over an area of 12 km2 in downtown Toronto, we roughly estimate that the organic carbon is approximately 35% carbohydrate, approximately 35% aliphatics, approximately 20% aromatics, and approximately 10% carbonyl groups. Various aliphatic groups can be identified including a number of acids, alcohols, alkanes, and alkenes. Also, numerous intact aliphatic esters are apparent that have not been observed before, as well as carbohydrates. The aromatic species include a small portion that appears to be derived from a polymer of styrene, in addition a larger fraction is consistent with polyhydroxylated PAH derived material, although this assignment is tentative and based solely on 1-D NMR data only. In addition, signals from polybutadiene are present and while accurate quantification is not possible, it appears that this polymer may be up to a few percents by weight of the total organic material.     

The influences of ambient particle composition and size on particle infiltration in Los Angeles, CA, residences

Particle infiltration is a key determinant of the indoor concentrations of ambient particles. Few studies have examined the influence of particle composition on infiltration, particularly in areas with high concentrations of volatile particles, such as ammonium nitrate (NH4NO3). A comprehensive indoor monitoring study was conducted in 17 Los Angeles-area homes. As part of this study, indoor/outdoor concentration ratios during overnight (nonindoor source) periods were used to estimate the fraction of ambient particles remaining airborne indoors, or the particle infiltration factor (FINF), for fine particles (PM2.5), its nonvolatile (i.e., black carbon [BC]) and volatile (i.e., nitrate [NO3-]) components, and particle sizes ranging between 0.02 and 10 microm. FINF was highest for BC (median = 0.84) and lowest for NO3- (median = 0.18). The low FINF for NO3- was likely because of volatilization of NO3- particles once indoors, in addition to depositional losses upon building entry. The FINF for PM2.5 (median = 0.48) fell between those for BC and NO3-, reflecting the contributions of both particle components to PM25. FINF varied with particle size, air-exchange rate, and outdoor NO3- concentrations. The FINF for particles between 0.7 and 2 microm in size was considerably lower during periods of high as compared with low outdoor NO3- concentrations, suggesting that outdoor NO3- particles were of this size. This study demonstrates that infiltration of PM2.5 varies by particle component and is lowest for volatile species, such as NH4NO3. Our results suggest that volatile particle components may influence the ability for outdoor PM concentrations to represent indoor and, thus, personal exposures to particles of ambient origin, because volatilization of these particles causes the composition of PM2.5 to differ indoors and outdoors. Consequently, particle composition likely influences observed epidemiologic relationships based on outdoor PM concentrations, especially in areas with high concentrations of NH4NO3 and other volatile particles.     

An inexpensive dual-chamber particle monitor: laboratory characterization

In developing countries, high levels of particle pollution from the use of coal and biomass fuels for household cooking and heating are a major cause of ill health and premature mortality. The cost and complexity of existing monitoring equipment, combined with the need to sample many locations, make routine quantification of household particle pollution levels difficult. Recent advances in technology, however, have enabled the development of a small, portable, data-logging particle monitor modified from commercial smoke alarm technology that can meet the needs of surveys in the developing world at reasonable cost. Laboratory comparisons of a prototype particle monitor developed at the University of California at Berkeley (UCB) with gravimetric filters, a tapered element oscillating microbalance, and a TSI DustTrak to quantify the UCB particle monitor response as a function of both concentration and particle size and to examine sensor response in relation to changes in temperature, relative humidity, and elevation are presented here. UCB particle monitors showed good linearity in response to different concentrations of laboratory-generated oleic acid aerosols with a coarse (mass median diameter, 2.1 microm) and fine (mass median diameter, 0.27-0.42 microm) size distributions (average r2 = 0.997 +/- 0.005). The photoelectric and ionization chamber showed a wide range of responses based on particle size and, thus, require calibration with the aerosol of interest. The ionization chamber was five times more sensitive to fine rather than coarse particles, whereas the photoelectric chamber was five times more sensitive to coarse than fine. The ratio of the response between the two sensors has the potential for mass calibration of individual data points based on estimated parameters of the size distribution. The results demonstrate the significant potential of this monitor, which will facilitate the evaluation of interventions (improved fuels, stoves, and ventilation) on indoor air pollution levels and research on the impacts of indoor particle levels on health in developing countries.     

Small-scale medical waste incinerators--experiences and trials in South Africa

Formal waste management services are not accessible for the majority of primary healthcare clinics on the African continent, and affordable and practicable technology solutions are required in the developing country context. In response, a protocol was established for the first quantitative and qualitative evaluation of relatively low cost small-scale incinerators for use at rural primary healthcare clinics. The protocol comprised the first phase of four, which defined the comprehensive trials of three incineration units. The trials showed that all of the units could be used to render medical waste non-infectious, and to destroy syringes or render needles unsuitable for reuse. Emission loads from the incinerators are higher than large-scale commercial incinerators, but a panel of experts considered the incinerators to be more acceptable compared to the other waste treatment and disposal options available in under-serviced rural areas. However, the incinerators must be used within a safe waste management programme that provides the necessary resources in the form of collection containers, maintenance support, acceptable energy sources, and understandable operational instructions for the incinerators, whilst minimising the exposure risks to emissions through the correct placement of the units in relation to the clinic and the surrounding communities. On-going training and awareness building are essential in order to ensure that the incinerators are correctly used as a sustainable waste treatment option.     

Do exurban communities want more development?

Most land-use surveys of exurban residents focus on eliciting preferences for residential development and open space conservation. This article, in contrast, reports on a stated preference study of exurban residents that assesses the relative attractiveness of a variety of commercial and recreational land uses. Focus group participants and town planners proclaimed a demand for certain commercial services such as modern grocery stores and fine-dining restaurants, but survey respondents generally exhibit a strong preference for no additional development beyond the current rate of development. Results show that if additional development is to occur, then recreational services are generally preferred over more traditional commercial development. Combining two commercial services in a single development project are strongly preferred to stand-alone developments. Our approach illustrates how planners may uncover misconceptions about and priorities for land conversion through examining residents’ preferences.     

Evaluating the longevity of a PFAS in situ colloidal activated carbon remedy

The remediation of per‐ and polyfluoroalkyl substances by injection of colloidal activated carbon (CAC) at a contaminated site in Central Canada was evaluated using various visualization and modeling methods. Radial diagrams were used to illustrate spatial and temporal trends in perfluoroalkyl acid (PFAA) concentrations, as well as various redox indicators. To assess the CAC adsorption capacity for perfluorooctane sulfonate (PFOS), laboratory Freundlich isotherms were derived for PFOS mixed with CAC in two solutions: (1) PFOS in a pH 7.5 synthetic water that was buffered by 1 millimolar NaHCO₃ (K_f = 142,800 mg^1‐a L^a/kg and a = 0.59); and (2) a groundwater sample (pH = 7.4) containing PFOS among other PFAS from a former fire‐training area in the United States (K_f = 4,900 mg^1‐a L^a/kg and a = 0.24). A mass balance approach was derived to facilitate the numerical modeling of mass redistribution after CAC injection, when mass transitions from a two‐phase system (aqueous and sorbed to organic matter) to a three‐phase system that also includes mass sorbed to CAC. An equilibrium mixing model of mass accumulation over time was developed using a finite‐difference solution and was verified by intermodel comparison for prediction of CAC longevity in the center of a source area. A three‐dimensional reactive transport model (ISR‐MT3DMS) was used to indicate that the CAC remedy implemented at the site is likely to be effective for PFOS remediation for decades. Model results are used to recommend remedial design and monitoring alternatives that account for the uncertainty in long‐term performance predictions.     

Real-World Vehicle Emissions: A Summary of the Ninth Coordinating Research Council On-Road Vehicle Emissions Workshop

ABSTRACT

In April 1999, the Coordinating Research Council sponsored a workshop focusing on our understanding of real-world emissions from motor vehicles. This summary presents the latest information on in-use light- and heavy-duty vehicle tailpipe and evaporative emissions, the effects of fuels on emissions, field programs designed to understand the contribution of mobile sources to emission inventories, efforts to evaluate and improve mobile source emission models, progress of vehicle inspection/ maintenance programs, and topics for future research. While significant progress has been made in understanding in-use vehicle emissions, further improvements are necessary. Moreover, the impact of current and future changes in emission control technologies and control programs will have to be monitored for effectiveness and incorporated into the emission factor models.