不同源类型农业非点源负荷特征研究——以新田小流域为例

以珠江三角洲北部新田小流域为研究对象,采用源类型法,在流域范围内建立林地、果园、旱地和水田四个全封闭的农业用地单元,并对四个单元出口处的径流量进行同步采样,分析COD、BOD、氨氮、总氮和总磷等污染物的负荷特征.结果表明:(1)流域地表水存在着明显非点源污染现象,不同源类型,地表径流的污染程度不同.(2)不同源类型农业非点源污染负荷强度不同,其中水田、旱地单位面积非点源负荷强度较大,果园、林地各项污染物的负荷强度相对最小.受地表扰动、施肥等人类活动影响,流域内水田、旱地是农业非点源污染发生的关键源区.(3)流域范围内,不同源类型农业非点源负荷总量不同,其中,果园各项污染物非点源负荷总量最大,其次是林地,水田、旱地非点源负荷输出总量较小,流域范围内,源面积成为影响非点源负荷总量的主要因素.(4)相应的非点源污染治理不仅是关键源区,同时应关注大面积流失区.     

Capacity estimation and preliminary strategy for reducing the release of dioxins in China

As a party of the Stockholm Convention on Persistent Organic Pollutants, China must submit its national implementation plan (NIP) for this convention. The strategy and action plan for reducing the release of dioxins in China are the most important components of the NIP. Three problems are key points for developing such strategy and action plan—what are the key sources for applying the best available technology/best environmental practice (BAT/BEP) to reduce the release of dioxins? How about the capacity for reducing the dioxins release from the key sources? Where are the areas of priority for applying BAT/BEP? This paper shows the efforts towards the solution of these problems. The list of key sources covering about half of the total dioxins release was determined considering four criteria. The capacity of key sources were estimated based on the difference between the emission factor corresponding to the actual situation in 2004 and that corresponding to the scenario that all key sources have been applied BAT/BEP to reduce the dioxins release. The priority analysis using the geographical information system (GIS) tool has revealed that castern provinces should be of high priority in the future reduction activities of dioxins release in China.     

Perfluorinated compounds in the Pearl River and Yangtze River of China

A total of 14 perfluorinated compounds (PFCs) were quantified in river water samples collected from tributaries of the Pearl River (Guangzhou Province, south China) and the Yangtze River (central China). Among the PFCs analyzed, perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA) were the two compounds with the highest concentrations. PFOS concentrations ranged from 0.90 to 99 ng/l and <0.01–14 ng/l in samples from the Pearl River and Yangtze River, respectively; whereas those for PFOA ranged from 0.85 to 13 ng/l and 2.0–260 ng/l. Lower concentrations were measured for perfluorobutane sulfonate (PFBS), perfluorohexane sulfonate (PFHxS), perfluorooctanesulfoamide (PFOSA), perfluorohexanoic acid (PFHxA), perfluoroheptanoic acid (PFHpA), perfluorononaoic acid (PFNA), perfluorodecanoic acid (PFDA), and perfluoroundecanoic acid (PFUnDA). Concentrations of several perfluorocarboxylic acids, including perfluorododecanoic acid (PFDoDA), perfluorotetradecanoic acid (PFTeDA), perfluorohexadecanoic acid (PFHxDA) and perfluorooctadecanoic acid (PFOcDA) were lower than the limits of quantification in all the samples analyzed. The highest concentrations of most PFCs were observed in water samples from the Yangtze River near Shanghai, the major industrial and financial centre in China. In addition, sampling locations in the lower reaches of the Yangtze River with a reduced flow rate might serve as a final sink for contaminants from the upstream river runoffs. Generally, PFOS was the dominant PFC found in samples from the Pearl River, while PFOA was the predominant PFC in water from the Yangtze River. Specifically, a considerable amount of PFBS (22.9–26.1% of total PFC analyzed) was measured in water collected near Nanjing, which indicates the presence of potential sources of PFBS in this part of China. Completely different PFC composition profiles were observed for samples from the Pearl River and the Yangtze River. This indicates the presence of dissimilar sources in these two regions.     

AERMOD在国内环境影响评价中的实例验证与应用

AERMOD是美国环保局推出的新一代空气质量模式系统,它由AERMET(气象数据预处理器)、AERMAP(地形数据预处理器)和AERMOD(大气扩散模型)3部分组成.结合宁波市北仑区域大气环境影响评价,对该模式系统进行模式验证,并应用于实际预测评价.验证结果表明,在采用适当的模型参数时,该系统预测值与实际监测值具有很好的一致性,SO2、NO2日均最高浓度预测准确率分别达到64.3%和85.7%.最后结合实际预测评价工作,提出AERMOD模式系统在国内环境影响评价工作中的优势及不足.     

Effect of cadmium on nodulation and N2-fixation of soybean in contaminated soils

The effects of cadmium stress on nodulation, N2-fixation capabilities of the root nodule, the change in ultrastructure of the root nodule, soybean growth, and the distribution of cadmium in plants were studied. The results obtained show that the nodulation of soybean roots was greatly inhibited by the addition of Cd, especially at the addition level of 10 and 20 mg kg(-1) soil. The inhibition of plant growth, especially the root growth, increased as the cadmium concentration increased, with deleterious effects observed for the roots. The weight ratio of soybean root/leaf decreased as the Cd concentration increased, which might explain the reason for nodulation decreases. The results also indicate that N2-fixation of root nodule was stimulated to some extent at the low levels of Cd addition, but decreased sharply with further increase of the Cd concentration. High Cd levels were also associated with changes in the ultrastructure of root nodule, in which the effective N2-fixing area was reduced and the N2-fixing cells in the area also reduced. In addition, the results also reveal that the content of Cd in different parts of the plants was as follows: roots > stems > seeds, indicating that the accumulation of Cd by roots is much larger than that by any other part of the soybean plant, and might cause deleterious effects to root systems.     

湖泊水体中硫酸盐增高的环境效应研究

通过对高原３个硫酸盐浓度差异的湖泊沉积物水界面硫的形态分布、扩散通量和碎屑有机硫通量等估算，揭示了湖泊水体硫酸盐增加以后的环境效应和自然反馈机制．研究认为：水体向沉积物内部扩散和界面硫酸盐还原作用是高硫酸盐浓度水体硫酸盐的主要清除作用，随硫酸盐浓度的增加，它在水体清除硫酸盐作用的贡献逐渐增大，而低硫酸盐含量湖泊水体生物同化吸收作用是水体硫酸盐的主要清除机制，它在硫酸盐浓度不同的水体没有差异．     

间距对上保护层开采保护效果影响的相似模拟实验研究

为研究上保护层开采保护效果随层间距的变化规律,以南桐矿区作为实验背景,保持保护层倾向工作面开挖长度、煤层埋深、倾角、岩层物理力学性质相同,将层间多层岩层处理为复合岩层,分别进行近距离、远距离和超远距离上保护层开采相似模拟实验。综合分析被保护层卸压规律及基于被保护层垂直于层面的膨胀变形保护准则所得保护范围可知:上保护层开采被保护层卸压曲线呈“凸形”,且“凸形”中心线偏向下山方向。随层间距增加,“凸形”底部被保护层小于原岩应力的卸压范围与“凸形”顶部卸压曲线顶部较大卸压的范围均呈减小趋势;两者中心位置均向下山方向转移,且后者转移度大于前者;被保护层卸压曲线中卸压范围的卸压程度及应力集中范围的应力集中程度均呈减弱趋势;以垂直层面的膨胀变形量3‰确定的上下边界膨胀变形保护角均小于《防治煤与瓦斯突出规定》中相应条件的卸压角,因此以该方法确定的保护范围相对《防治煤与瓦斯突出规定》偏于安全,且随层间距增加保护范围长度呈加速减小趋势。     

Volcano-related materials in concretes: a comprehensive review

Massive volcano-related materials (VRMs) erupted from volcanoes bring the impacts to natural environment and humanity health worldwide, which include generally volcanic ash (VA), volcanic pumice (VP), volcanic tuff (VT), etc. Considering the pozzolanic activities and mechanical characters of these materials, civil engineers propose to use them in low carbon/cement and environment-friendly concrete industries as supplementary cementitious materials (SCMs) or artificial/natural aggregates. The utilization of VRMs in concretes has attracted increasing and pressing attentions from research community. Through a literature review, this paper presents comprehensively the properties of VRMs and VRM concretes (VRMCs), including the physical and chemical properties of raw VRMs and VRMCs, and the fresh, microstructural and mechanical properties of VRMCs. Besides, considering environmental impacts and the development of long-term properties, the durability and stability properties of VRMCs also are summarized in this paper. The former focuses on the resistance properties of VRMCs when subjected to aggressive environmental impacts such as chloride, sulfate, seawater, and freezing–thawing. The latter mainly includes the fatigue, creep, heat-insulating, and expansion properties of VRMCs. This study will be helpful to promote the sustainability in concrete industries, protect natural environment, and reduce the impacts of volcano disaster. Based on this review, some main conclusions are discussed and important recommendations regarding future research on the application of VRMs in concrete industries are provided.     

Nitrogen removal performance and bacterial communities in zeolite trickling filter under different influent C/N ratios

Environmental Science and Pollution Research - In this study, the degradation performance of nutrients in zeolite trickling filter (ZTF) with different influent C/N ratios and aeration conditions...     

Insertable thin film thermocouples for in situ transient temperature monitoring in ultrasonic metal welding of battery tabs

Real-time monitoring and control of temperature in ultrasonic joining of battery tabs and coupons are important for the quality improvement and cost reduction of battery assembly. However, there have always been difficulties in accurate and real-time measurement of temperature by conventional sensors for practical implementation. In this study, an innovative method is developed to provide an enabling technology for the in situ transient temperature monitoring, which could provide reliable feedback signals for potential control of ultrasonic joining processes. Micro thin film thermocouples (TFTCs) were fabricated on thin silicon substrates, which were then inserted in the welding anvil as a permanent feature so that the sensors were always located about 100 μm directly under the welding spot during joining of multilayer Ni-coated Cu thin sheets for battery assembly. Good repeatability was demonstrated while a temperature rise of up to 650 °C was obtained due to the closeness of the sensors to the welding spot. The inserts with thin film sensors remained functional after welding experiments. This method has a great potential for in situ transient temperature monitoring, and thus the control of ultrasonic joining processes to realize a practical smart joining system.