160 h of chemical-looping combustion in a 10 kW reactor system with a NiO-based oxygen carrier

Chemical-looping combustion, CLC, is a technology with inherent separation of the greenhouse gas CO₂. The technique uses an oxygen carrier made up of particulate metal oxide to transfer oxygen from combustion air to fuel. In this work, an oxygen carrier consisting of 60% NiO and 40% NiAl₂O₄ was used in a 10 kW CLC reactor system for 160 h of operation with fuel. The first 3 h of fuel operation excepted, the test series was accomplished with the same batch of oxygen carrier particles. The fuel used in the experiments was natural gas, and a fuel conversion to CO₂ of approximately 99% was accomplished. Combustion conditions were very stable during the test period, except for the operation at sub-stoichiometric conditions. It was shown that the methane fraction in the fuel reactor exit gas was dependent upon the rate of solids circulation, with higher circulation leading to more unconverted methane. The carbon monoxide fraction was found to follow the thermodynamical equilibrium for all investigated fuel reactor temperatures, 660–950 °C. Thermal analysis of the fuel reactor at stable conditions enabled calculation of the particle circulation which was found to be approximately 4 kg/s, MW. The loss of fines, i.e. the amount of elutriated oxygen carrier particles with diameter <45 μm, decreased during the entire test period. After 160 h of operation the fractional loss of fines was 0.00022 h⁻¹, corresponding to a particle life time of 4500 h.     

Revisiting a statistical shortcoming when fitting the Langmuir model to sorption data

The Langmuir model is commonly used for describing the sorption behavior of reactive solutes to surfaces and is often fit to sorption data using nonlinear least squares regression. An important assumption of least squares regression is that the predictor variable is error free. In the case of sorption data, this assumption is not valid, and therefore the potential for parameter bias exists. Although alternative regression methods exist that either explicitly account for error in the predictor variable (Model II regression) or minimize the error in the predictor variable, these methods are not commonly used. Therefore, this paper more fully explores the differences in fitted parameters and model fits between these different data fitting methods by fitting P sorption data collected on 26 different soil samples using three different regression methods. For a majority of soils tested in this study, the differences in model fits between the three regression methods were not statistically significant. Statistical differences were observed in over a third of the soils, however, suggesting that errors in the predictor variable may be large enough to produce biased parameter estimates. These results suggest that multiple regression methods should be used when fitting the Langmuir model to sorption data to better assess the potential impact of error on model fits.     

The context and habits of accident investigation practices: A study of 108 Swedish investigators

The context and habits of accident investigation practices were explored by means of questionnaire data obtained from accident investigators in the healthcare, transportation, nuclear and rescue sectors in Sweden. Issues explored included; resources, training, time spent in different phases of an investigation, methods and procedures, beliefs about causes to accidents, communication issues, etc. Examples of findings were: differences in the extent to which the ‘human factor’ was perceived as a dominant cause to accidents; manning resources to support investigations were perceived as rather scarce; underutilization of data from safety related processes such as risk analysis and auditing data; the phase of suggesting remedial actions (recommendations) were comparatively brief and generally not well supported. A majority of the investigators thought that the investigations were free from pressures to follow a specific direction; the investigators also thought that performing an investigation in itself (regardless of the specific results) had positive influences on safety. A majority of the investigators thought that upper management had a relatively strong influence on safety in the organizations. The results are discussed in terms of suggestions for strategies to strengthen investigation practices – particularly those conducted as part-time work in organizations.     

Can focus on safety culture become an excuse for not rethinking design of technology?

Two generic organisational contexts associated with technological designs in relation to safety culture are discussed: (1) operating organisations using existing technologies, and (2) design organisations as producers of technologies. It is argued that the concept of safety culture, if misused, may lead to the adoption of non-effective change strategies in the operational context. On the other hand, it is also argued that design organisations should invest more attention to issues commonly subsumed under the concept of safety culture. In this case, however, the concept of safety culture has to be adapted to fit the demands facing design organisations. Issues of morality and their association with the safety culture concept will be discussed. It is suggested that a stronger focus on understanding innovation and safety together should nourish future research about culture’s influence on design and safety.     

The Ecotoxicological Recovery of Ely Creek and Tributaries (Lee County, Va) After Remediation of Acid Mine Drainage

The Ely Creek watershed (Lee County, VA) was determined in 1995 to be the most negatively affected by acid mine drainage (AMD) within the Virginia coalfield. This determination led the US Army Corps of Engineers to design and build passive wetland remediation systems at two major AMD seeps affecting Ely Creek. This study was undertaken to determine if ecological recovery had occurred in Ely Creek. The results indicate that remediation had a positive effect on all monitoring sites downstream of the remediated AMD seeps. At the site most impacted by AMD, mean pH was 2.93 prior to remediation and improved to 7.14 in 2004. Benthic macroinvertebrate surveys revealed that one AMD influenced site had increased taxa richness from zero taxa in 1997 to 24 in 2004. While in situ testing of Asian clams resulted in zero survival at five of seven AMD influenced sites prior to remediation, some clams survived at all sites after. Clam survival was found to be significantly less than upstream references at only two sites, both downstream of un-mitigated AMD seeps in 2004. An ecotoxicological rating (ETR) system that combined ten biotic and abiotic parameters was developed as an indicator of the ecological status for each study site. A comparison of ETRs from before and after remediation demonstrated that all sites downstream of the remediation had experienced some level of recovery. Although the remediation has improved the ecological health of Ely Creek, un-mitigated AMD discharges are still negatively impacting the watershed.     

Attitude of a group of Belgian stakeholders towards proposed agricultural countermeasures after a radioactive contamination: synthesis of the discussions within the Belgian EC-FARMING group

In the case of radioactive contamination of the environment with an impact on the food chain, the remediation strategy will not only be based on scientific knowledge and technical experience, but will also be dictated by peculiarities of the country. These characteristics include the agro-industrial structure, the local and international economical contexts and the political configuration including the distribution of responsibilities and competencies. This paper identifies and illustrates the most relevant characteristics of the Belgian agricultural system and political environment; it also describes the past experience with food chain contamination, which is expected to influence the attitude of Belgian stakeholders, who would be involved in the setting up of countermeasure strategies for maintaining agricultural production and food safety. The picture drawn explains why several countermeasures aiming to reduce the contamination in food products, although scientifically sound and technically feasible, are hardly acceptable or even not acceptable at all, to the stakeholders.     

Evaluation of a vertical frozen soil barrier at oak ridge national laboratory

Arctic Foundations, Inc. (AFI), of Anchorage, Alaska, has developed a freeze barrier system designed to hydraulically isolate a contaminant source area. The system can be used for long‐term or temporary containment of groundwater until appropriate remediation techniques can be applied. The technology was evaluated under the United States Environmental Protection Agency's (EPA's) Superfund Innovative Technology Evaluation (SITE) program at the United States Department of Energy's (DOE's) Oak Ridge National Laboratory (ORNL) facility in Oak Ridge, Tennessee. For the demonstration, an array of freeze pipes called “thermoprobes” was installed to a depth of 30 feet below ground surface around a former waste collection pond and keyed into bedrock. The system was used to establish an impermeable frozen soil barrier to hydraulically isolate the pond. Demonstration personnel collected independent data to evaluate the technology's performance. A variety of evaluation tools were used—including a groundwater dye tracing investigation, groundwater elevation measurements, and subsurface soil temperature data—to determine the effectiveness of the freeze barrier system in preventing horizontal groundwater flow beyond the limits of the frozen soil barrier. Data collected during the demonstration provided evidence that the frozen soil barrier was effective in hydraulically isolating the pond.