Influence of mature compost amendment on total and bioavailable polycyclic aromatic hydrocarbons in contaminated soils

A laboratory microcosm study was carried out to assess the influence of compost amendment on the degradation and bioavailability of PAHs in contaminated soils. Three soils, contaminated with diesel, coal ash and coal tar, respectively, were amended with two composts made from contrasting feedstock (green waste and predominantly meat waste) at two different rates (250 and 750 t ha^?1) and incubated for 8 months. During this period the treatments were sampled for PAH analysis after 0, 3, 6 and 8 months. Total and bioavailable fractions were obtained by sequential ultrasonic solvent extraction and hydroxypropyl-β-cyclodextrin extraction, respectively, and PAHs were identified and quantified by GC–MS. Bioavailability decrease due to sorption was only observed at the first 3 months in the diesel spiked soil. After 8 months, compost addition resulted in over 90% loss of total PAHs irrespective of soil types. Desorption and degradation contributed to 30% and 70%, respectively, of the PAH loss in the spiked soil, while PAH loss in the other two soils resulted from 40% enhanced desorption and 60% enhanced degradation. Compost type and application rates had little influence on PAH bioavailability, but higher PAH removal was observed at higher initial concentration during the early stage of incubation. The bioavailable fraction of PAH was inversely correlated to the number of benzene rings and the octanol–water partition coefficient. Further degradation was not likely after 8-month although over 30% of the residual PAHs were bioavailable, which highlighted the application of bioavailability concept during remediation activities.     

Capital and Operating Costs of Selected Air Pollution Control Systems-III

Pollution control systems will normally require some auxiliary equipment to capture and carry the gas stream to the control device. In general, this auxiliary equipment will consist of a hood or similar device to isolate and collect the pollutant-laden gas, ductwork to convey the gas stream to the control device, and dampers to control and modulate the flow. In this article, the equipment cost of canopy hoods, ducting, and dampers will be considered, together with their effect on the size, cost, and operation of the control device.     

Field Evidence of Dissolution and Degradation Rates Enhancement During ISCR and ENA Treatments of Chlorinated Solvents

This article presents field tests comparing two methods of treatment of chlorinated solvents undertaken at the same site. The site is an automobile factory where two chlorinated solvents (CS) plumes were identified. At the first source, in situ chemical reduction (ISCR) was applied, while at the second one, enhanced natural attenuation (ENA) was used. A set of specific multilevel sampling wells were installed approximately 20 m downgradient of the sources to estimate the efficiency of the treatments. The presence of a low‐permeability layer (source 1) or a thick oil lens (source 2) in the top part of the aquifer prevented the CS from reaching the bottom of the aquifer. These layers led to difficulties treating the contamination. At the ISCR and ENA treatment zones, the concentrations of tetrachloroethene (PCE) and trichloroethene (TCE) did not change significantly, while the concentration of metabolites (cis‐1,2‐DCE, vinyl chloride, and ethene) significantly increased 50 to 150 days after treatment. Due to high concentration of CS in the source zone, a mass balance calculation, including chlorine, was possible. It showed that around 1 to 2 percent of the injected products were used to reduce the CS. A detailed analysis and 1D analytical modeling of CS concentrations showed that the treatment led to a large (two to three times) increase in dissolution of the organic phase. This explains why, despite an efficient treatment, the PCE and TCE concentrations remained virtually unchanged. Degradation rates also increased due to the treatment. Due to some differences in the source‐zone chemistry, it was not possible to differentiate between the ISCR and ENA efficiencies. © 2013 Wiley Periodicals, Inc.     

Modelling concentrations of decamethylcyclopentasiloxane in two UK rivers using LF2000-WQX

Current regulatory environmental exposure assessments for decamethylcyclopentasiloxane (D₅), used in a range of personal care products, are based on a number of erroneous assumptions. Using an estimated D₅ flux to waste water of 11.6 mg cap⁻¹ d⁻¹, a 95.2% removal rate in Sewage Treatment Plants (STP) and a dilution factor of 10 results in modelled surface water concentrations that are up to an order of magnitude higher than concentrations observed downstream of STPs in two UK rivers. A GIS-based water quality model (LF2000-WQX) was used to predict concentrations of D₅ in two UK rivers. Assuming the STP removal rate is reasonable, a waste water flux of 2.4 mg cap⁻¹ d⁻¹ is needed in order to obtain a reasonable match between predicted and observed in-river concentrations. This flux is consistent with measured effluent concentrations. The results highlight major uncertainties in estimating chemical emission rates for volatile chemicals used in personal care products and suggest that measured concentrations in waste water are needed to refine exposure assessments.     

COVID-19: the impact of a global crisis on sustainable development teaching

Environment, Development and Sustainability - The COVID-19 pandemic has caused a global crisis, one which also influences the ways sustainability is being taught at universities. This paper...     

Identification of tetramethylarsonium in rice grains with elevated arsenic content

Tetramethylarsonium has for the first time been identified in a commercially grown food product, rice, constituting up to 5.8% of the total arsenic in the rice.     

"The upper limits of vegetation on Mauna Loa, Hawaii": a 50th-anniversary reassessment

In January 1958, a survey of alpine flora was conducted along a recently constructed access road across the upper volcanic slopes of Mauna Loa, Hawaii (2525-3397 m). Only five native Hawaiian species were encountered on sparsely vegetated historic and prehistoric lava flows adjacent to the roadway. A resurvey of roadside flora in 2008 yielded a more than fourfold increase to 22 species, including nine native species not previously recorded. Eight new alien species have now invaded this alpine environment, although exclusively limited to a few individuals in ruderal habitat along the roadway. Alternative explanations for species invasion and altitudinal change over the past 50 years are evaluated: (1) changes related to continuing primary succession on ameliorating (weathering) young lava substrates; (2) local climate change; and (3) road improvements and increased vehicular access which promote enhanced car-borne dispersal of alien species derived from the expanding pool of potential colonizers naturalized on the island in recent decades. Unlike alpine environments in temperate latitudes, the energy component (warming) in climate change on Mauna Loa does not appear to be the unequivocal driver of plant invasion and range extension. Warming may be offset by other climate change factors including rainfall and evapotranspiration.     

Inf luence of Season and a Sympatric Congener on Habitat Use by Stephens' Kangaroo Rat

We examined habitat use by the endangered Stephens' kangaroo rat ( Dipodomys stephensi) in different seasons and assessed whether this may be influenced by a sympatric congener, the Pacific kangaroo rat (Dipodomys agilis). Trapping on three plots over 2 years revealed these species were rarely captured at the same trap stations. Spatial segregation was highly significant when both species were at high density. The spatial distribution of these species was temporally stable where both species were relatively abundant, but where D. agilis was relatively uncommon the distribution of D. stephensi varied from one census to another. The abundance of three microhabitats (grass, debris, and bare ground) followed a regular seasonal pattern of variation that was consistent across 2 years of substantially different rainfall. A canonical discriminant analysis showed that the five quantified microhabitats (those above and bush and rock cover) provided highly significant discrimination between the trap stations occupied by the two species. Dipodomys stephensi was associated with trap stations where grass cover and bare ground were abundant but where bush and rock were uncommon. Dipodomys agilis was associated with stations that had large amounts of bare ground and average abundances of bush and rock cover. The spatial segregation of these species appears to be mediated by habitat preferences; D. stephensi prefers grassland and D. agilis prefers sage scrub. This suggests that habitat management for D. stephensi should include (1) controlling the spread of shrubs into grassland and (2) creating dispersal corridors of open habitat to link areas of suitable habitat where none presently exist. Each of these options may be needed to maintain viable populations in all reserves designated for the conservation of D. stephensi.     

Describing and measuring ethno-entomological knowledge of rice pests: tradition and change among Asian rice farmers

The paper presents a methodology that guided several ethnoentomological research projects and goes on to examine and compare the results from two independent research locations in Asia. The first location is in the Philippines, a Green Revolution area that has been heavily impacted by extension messages and insecticide use. The second location is in Nepal which has a traditional subsistence orientation and has remained widely unaffected by agricultural modernization. The paper emphasizes the differences and similarities of the results from the two sites and discusses the role of the methodology and methods used in capturing ethnoentomological knowledge, particularly with regard to insect pests in rice. The results of both investigations share the importance of agronomic criteria among farmers in insect classification and sorting criteria, thus highlighting the relevance of functional criteria. Farmers at both research sites have difficulties in identifying the lifecycles of insects. We discuss the issues of tradition and change in farmer entomological knowledge and providing support to the knowledge base of farmers though programs like IPM-Farmer Field Schools as opposed to broad-based recommendations for crop pest management.Article type: MS-ENVI-SI ETHNOSCI MS04 Contribution to Environment, Development & Sustainability, special issue ‘Bridging the gap between natural resources and their human management for the future using ethnoscience’.     

Assessing the recycling potential of glass fibre reinforced plastic waste in concrete and cement composites

At present glass fibre reinforced plastic (GRP) waste recycling worldwide is very limited due to its intrinsic thermoset properties, lack of characterisation data and non availability of viable recycling and recovery routes. In the present study, efforts were made to recycle GRP waste powder and fibre in concrete and cement composites and assess its quality to comply with the British standards for use in construction applications. Results revealed that the mean compressive strength of concrete composites using 5%–50% GRP waste powder under water curing varied from 37 N/mm² to 19 N/mm². Increase in the concentration of GRP waste decreased the compressive strength. However, increase in curing duration (14–180 days) resulted in improving the compressive strength of concrete with 5% GRP application to 45.75 N/mm². Moreover, the density of concrete with 50% GRP waste was reduced by about 12% as compared to the control sample. The bending strength in terms of modules of rupture (MOR) of 12 mm thickness cement composites developed using 5% GRP waste fibre attained 16.5 N/mm². The findings of this work pave the way for further GRP waste recycling in precast construction products for use in various applications.