Trichloroethylene (TCE) removal in a single pulse suspension bioreactor

This work describes TCE biotic removal in a single-pulse bioreactor under aerobic conditions. Activated sludge from a wastewater-treatment plant was used for inoculation of the cultivator. The experiment focused on a more detailed verification of microbial composition of mixed heterotrophic culture during pulsed phenol dosage. Attention was given to suppressing eucaryotic organisms, particularly yeasts and fungi, by the addition of cycloheximide. The TCE-removal capacity of the heterotrophic culture, described by kinetic tests, was dependent on pulsed phenol injection and on cyclic addition of phenol and TCE. Maximum TCE degradation was determined in a batch test. It was found that the addition of cycloheximide (an antibiotic against propagation and growth of fungi and yeast) increased the TCE degradation activity of the mixed microbial suspension. A certain residual amount of TCE remained in some of the experiments.     

Short-term stability of genetic structure in populations of the sea anemone Metridium senile

Populations of the sea anemone Metridium senile (L.) were sampled from several locations in eastern North America in two series, one collected from 1977–1979 and the other from 1981–1985. Fourteen populations were sampled twice at one- to six-year intervals. Samples were analyzed for temporal differences in genetic composition at both the single locus and multiple locus levels. Overall patterns of geographic variation in allele frequency did not change between series. Regressions describing clines did not differ significantly, and loci not showing clinal variation in the first series remained similar in the second. Analysis of populations sampled twice produced no systematic evidence of change in allele frequency with time for any of four polymorphic loci. Comparisons with computer simulations of repeated sampling of multiple locus genotypes from panmictic populations with free recombination also revealed little temporal change at this level. One population showed possible evidence of recruitment from a different gene pool. Other significant departures from expectations reflected more reproducibility of genotype distributions between samples than expected for sexual populations. This excess stability likely results jointly from clonal reproduction and little sexual recruitment. Despite these indications of genetic stability in adult populations, newly settled juveniles were genetically different from resistant adults in one population, demonstrating the potential for genetic change by immigration. Successful sexual recruitment seems to be rare, even though larvae regularly settle from the plankton. Although interpretation of these results is somewhat limited by lack of knowledge of longevities and generation times, to the extent that they reflect longer-term trends, they suggest that at least some of the observed patterns of geographic variation in allele frequency probably result from natural selection.     

Life cycle engineering im Automobilbau

Ecobalance represents the basic principle for an environmental analysis and the starting point for the possibility of achieving improvements. Using the criteria related to both technology and ecology, this method has been expanded upon by IKP/PE and, over the course of many years, has proven to be a satisfactory method for those fields associated with industry and research. Data banks and software systems have been designed and are today applied in industry. An expansion of the holistic balancing to include the ‘social’ dimension is currently being developed by the IKP. Today, ecological decisions in technically and economically-associated areas are continuously being developed which place more emphasis on the preliminary developments than on a purely retrospective analysis. Aside from the continuous, further developments of these types of analysis with regard to never technical questions as well as the integration of newer aspects of optimization based on life cycle information (e.g. production balancing), the goal of further work includes the preparation of process-chain information in the respective in preliminary developments related to the design. The automobile industry consequently plays a significant role here, as was also the case in the initial transformation of methodology which was carried out in the 1990s. Finally, these developments are additionally motivated through the new ordinances presented to be employed throughout the entire EU. The responsibility attributed to a product over the course of its entire lifetime therefore plays a more prominent role. This is also reflected in ordinances like those related to the redemption of old automobiles or in the WEEE of the electronics industry (Directive on Waste Electrical and Electronic Equipment).     

Drivers for OSH interventions in small and medium-sized enterprises

The debate concerning occupational safety and health (OSH) interventions has recently focused on the need of improving the evaluation of interventions, and in particular on the need for providing information about why the intervention worked or not, under what circumstances and in which context. Key concepts in the analysis of the context are the drivers, i.e., those factors enabling, fostering or facilitating OSH interventions. However, the concept of driver for an OSH intervention is both confused and contested. Although the term is widely used, there is little consensus on how drivers should be understood, how important they are in different contexts and how they can facilitate interventions. This exploratory study based on interviews with the owner-managers and the safety officers of small and medium-sized enterprises (SMEs) gives an overview of the most characteristic drivers for OSH interventions. The results will be used to make an initial evaluation of SMEs' needs, and will help orient interventions and future research.     

Changes in hydrology and salinity accompanying a century of agricultural conversion in Argentina

Conversions of natural woodlands to agriculture can alter the hydrologic balance, aquifer recharge, and salinity of soils and groundwater in ways that influence productivity and sustainable land use. Using a land-use change chronosequence in semiarid woodlands of Argentina's Espinal province, we examined the distribution of moisture and solutes and estimated recharge rates on adjacent plots of native woodlands and rain-fed agriculture converted 6-90 years previously. Soil coring and geoelectrical profiling confirmed the presence of spatially extensive salt accumulations in dry woodlands and pervasive salt losses in areas converted to agriculture. A 1.1-km-long electrical resistivity transect traversing woodland, 70-year-old agriculture, and woodland, for instance, revealed a low-resistivity (high-salinity) horizon between approximately 3 m and 13 m depth in the woodlands that was virtually absent in the agricultural site because of leaching. Nine-meter-deep soil profiles indicated a 53% increase in soil water storage after 30 or more years of cultivation. Conservative groundwater-recharge estimates based on chloride tracer methods in agricultural plots ranged from approximately 12 to 45 mm/yr, a substantial increase from the <1 mm/yr recharge in dry woodlands. The onset of deep soil moisture drainage and increased recharge led to >95% loss of sulfate and chloride ions from the shallow vadose zone in most agriculture plots. These losses correspond to over 100 Mg of sulfate and chloride salts potentially released to the region's groundwater aquifers through time with each hectare of deforestation, including a capacity to increase groundwater salinity to >4000 mg/L from these ions alone. Similarities between our findings and those of the dryland salinity problems of deforested woodlands in Australia suggest an important warning about the potential ecohydrological risks brought by the current wave of deforestation in the Espinal and other regions of South America and the world.     

The policy consequences of defining rewilding

More than 30 years after it was first proposed as a biodiversity conservation strategy, rewilding remains a controversial concept. There is currently little agreement about what the goals of rewilding are, and how these are best achieved, limiting the utility of rewilding in mainstream conservation. Achieving consensus about rewilding requires agreeing about what “wild” means, but many different definitions exist, reflecting the diversity of values in conservation. There are three key debates that must be addressed to find a consensual definition of “wild”: (1) to which extent can people and “wild” nature co-exist?; (2) how much space does “wild” nature need? and (3) what kinds of “wild” nature do we value? Depending on the kinds of “wild” nature rewilding aims to create, rewilding policy will be faced with managing different opportunities and risks for biodiversity and people.Supplementary InformationThe online version contains supplementary material available at 10.1007/s13280-021-01560-8.     

Assessing Aerobic Biodegradability of Plastics in Aqueous Environment by GC-Analyzing Composition of Equilibrium Gaseous Phase

Testing biodegradability of plastics under varied conditions of the environment as well as under laboratory conditions in accordance with valid international standards is very laborious, lengthy and often also economically demanding. For this reason, applicability was verified of gas chromatography to analyze gaseous phase when investigating the biodegradation course of plastics in an aqueous environment as an alternative to customary employed methods. A mathematical model of acid–basic CO₂ equilibrium in a gas–liquid system was worked out, enabling to determine quantity of produced CO₂ through chromatographic analysis of gaseous phase, in dependence on ratio of liquid and gas phase volumes (V _l/V _g) and on actual pH of liquid phase. Experimental conditions for organizing the tests were optimized. A ratio that proved suitable was V _l/V _g ≅ 0.1 at pH ≈ 7.1 of liquid phase. Under these test conditions, biodegradability of model samples, PHB, Gellan gum and Xanthan gum, was explored; course of biodegradation was studied through produced CO₂ (values ) determined by analyzing gaseous phase through gas chromatography on the one hand, and through customary “titration” procedure on the other. With water-soluble polymers, the decrement in dissolved organic carbon (values D _DOC) was also studied. Difference between values does not exceed 5%. The procedures in question are alternative “substituting” procedures for observing course of aerobic biodegradation of substances in an aqueous environment.     

Fire Tests on E-vehicle Battery Cells and Packs

Objective: The purpose of this study was to investigate the effects of abuse conditions, including realistic crash scenarios, on Li ion battery systems in E-vehicles in order to develop safe practices and priorities when responding to accidents involving E-vehicles.

Method: External fire tests using a single burning item equipment were performed on commercial Li ion battery cells and battery packs for electric vehicle (E-vehicle) application. The 2 most common battery cell technologies were tested: Lithium iron phosphate (LFP) and mixed transition metal oxide (lithium nickel manganese cobalt oxide, NMC) cathodes against graphite anodes, respectively. The cell types investigated were “pouch” cells, with similar physical dimensions, but the NMC cells have double the electric capacity of the LFP cells due to the higher energy density of the NMC chemistry, 7 and 14 Ah, respectively.

Heat release rate (HRR) data and concentrations of toxic gases were acquired by oxygen consumption calorimetry and Fourier transform infrared spectroscopy (FTIR), respectively.

Results: The test results indicate that the state of charge (SOC) affects the HRR as well as the amount of toxic hydrogen fluoride (HF) gas formed during combustion. A larger number of cells increases the amount of HF formed per cell. There are significant differences in response to the fire exposure between the NMC and LFP cells in this study. The LFP cells generate a lot more HF per cell, but the overall reactivity of the NMC cells is higher. However, the total energy released by both batteries during combustion was independent of SOC, which indicates that the electric energy content of the test object contributes to the activation energy of the thermal and heat release process, whereas the chemical energy stored in the materials is the main source of thermal energy in the batteries.

Conclusions: The results imply that it is difficult to draw conclusions about higher order system behavior with respect to HF emissions based on data from tests on single cells or small assemblies of cells. This applies to energy release rates as well. The present data show that mass and shielding effects between cells in multicell assemblies affect the propagation of a thermal event.     

聚硅氯化铝(PASiC)混凝剂的特性及絮凝动态过程

 采用共聚与复合两种制备工艺,分别制备出具有不同碱化度(B)和不同Al/Si摩尔比系列的商用聚硅氯化铝(PASiC)混凝剂,并分别采用颗粒粒径测定方法和流动电流(SC)测定技术研究比较了PASiC和聚合氯化铝(PAC)混凝剂的颗粒大小、电动特性和凝聚絮凝动态过程.结果表明,Al/Si摩尔比、B值和制备工艺影响PASiC的聚合和带电特性.Al/Si摩尔比越小和B值越大,PASiC的颗粒就越大;在相同的B值下,PASiC较PAC具有更大的颗粒粒径.PASiC的电中和能力较PAC有所下降,且Al/Si摩尔比越小,PASiC的电中和能力下降越多;与PAC相比,PASiC具有更快的凝聚絮凝速度和形成更大的絮体;且Al/Si摩尔比越小,PASiC形成的絮体就越大.